It is essential, as bandwidths of wireless communications get wider, to evaluate the imbalances among quadrature mixer ports, in terms of carrier phase offset, IQ gain imbalance, and IQ skew. Because it is time consuming to separate skew, gain imbalance and carrier phase offset evaluation during test is often performed using a composite value, without separation of the imbalance factors. This paper describes an algorithm for enabling separation among quadrature mixer gain imbalance, carrier phase offset, and skew. Since the test time is reduced by the proposed method, it can be applied during high volume production testing.

This paper presents novel phase-continuous frequency hopping (FH) control for a direct frequency synthesizer (DFS) using a quadrature mixer driven by two direct digital synthesizers (DDSs). To achieve wideband FH in both of the lower and the upper sidebands of a local frequency in a quadrature mixer, the proposed DFS decreases or increases the phase of DDS output signals corresponding to frequency offset from a local frequency of the quadrature mixer. To realize phase decrement, the proposed method adds a complement number in a phase accumulator of a DDS, while a conventional DDS does not use phase decrement but uses a switchable combiner. In addition, as the phase accumulator output changes continuously by summing phase increment, the proposed method always assures phase continuity of a DFS output signal, which ends up suppressing sidelobe level of frequency hopped signals. The calculation and measurement results indicate that a sidelobe of a signal spectrum using the proposed phase continuous method is approximately 10 dB better than that using a conventional phase discontinuous method.

This paper presents an even harmonic quadrature mixer (EH-QMIX) with a simple filter configuration and an integrated LTCC module including LNAs, band rejection filters (BRFs), and the proposed EH-QMIX for W-CDMA direct conversion receiver (DCR). Since the DCR has no spurious responses, a BRF instead of a high-Q band pass filter can be applicable for eliminating undesired signals and it can be built in the LTCC substrates easily. As LO frequency is half of RF frequency in the EH-QMIX, diplexer can be composed of simple filters and it can be also integrated in the substrates. As a result, the whole RF circuits of the EH-DCR using a proposed EH-QMIX are integrated in the LTCC module and miniaturization of the receiver is achieved. Moreover, in order to suppress the degradation of the amplitude and the phase imbalances in the quadrature mixer caused by interferences of signals, RF characteristics of the circuits in the mixer such as reflection coefficients, isolations are discussed. A developed LTCC module shows good performances for W-CDMA direct conversion receiver.

A broadband RF front-end having a direct conversion architecture has been developed. The RF front-end consists of two broadband quadrature mixers, a multi-band local oscillator, and a broadband low-noise variable gain amplifier (LNVGA). The mixer achieves broadband characteristics through the incorporation of an in-phase power divider and a 45-degree power divider. The in-phase power divider achieves broadband characteristics through the addition of a compensation capacitor. The 45-degree power divider achieves broadband phase characteristics through the addition of a compensation capacitor and a compensation resistor. The local oscillator, which is composed of two VCOs, two frequency dividers, and four switches, can cover three systems including one FDD system. The LNVGA achieves its broadband characteristics without the use of reactance elements, such as inductors or capacitors. In a trial demonstration, when the RF frequency was between 900 MHz and 2.5 GHz, the mixer for a demodulator experimentally demonstrated an amplitude balance of less than 1.6 dB and a quadrature phase error of less than 3 degrees. When the RF frequency was between 900 MHz and 2.5 GHz, the mixer for a modulator demonstrated an image ratio of less than -30 dBc. The local oscillator demonstrated multi-band characteristics, which are able to cover the target frequencies for three systems (PDC, PHS, 2.4 GHz WLAN). From 900 MHz to 2.5 GHz, the amplifier shows a noise figure of less than 2.1 dB and a gain of 28 1.6 dB.