Multi-cycle paths are paths between registers where 2 or more clock cycles are allowed to propagate signals, and the detection of multi-cycle paths is important in deciding proper clock period, timing verification and logic optimization. This paper presents a satisfiability-based multi-cycle path detection method, where the detection problems are reduced to CNF formulae and the satisfiability is checked using SAT provers. We also show heuristics on conversion from multi-level circuits into CNF formulae. We have applied our method to ISCAS'89 benchmarks and other sample circuits. Experimental results show the remarkable improvements on the size of manipulatable circuits.

This paper introduces a new kind of false path, which is sensitizable but does not affect the decision of the maximum clock frequency. Such false paths exist in multi-clock operations controlled by waiting states, and the delay time of these paths can be greater than the clock period. This paper proposes a method to detect these waiting false paths based on the symbolic state traversal. In this method, the maximum allowable clock cycle of each path is computed using update cycles of each register.

The discrete time analysis of logic circuits is usually more efficient than the continuous time analysis, but the preciseness of the discrete time analysis is not guaranteed. The paper shows a method to decide a unit time for a logic circuit under which the analysis result is the same as the result based on the continuous time. The delay time of an element is specified with an interval between the minimum and maximum delay times, and we assume an analysis method which enumerates all possible delay cases under the deisrete time. Our main theorem is as follows: refine the unit time by a factor of 1/2, and if the analysis result with a unit time u and that with a unit time u/2 are the same, then u is the expected unit time.

The objective of this work is to demonstrate a new hierarchical timing analysis technique for multi-phase clocked designs with feedback loops including level sensitive latches. By using this technique, large synchronous designs can be analyzed accurately without loop breaking.

The paper proposes a combined delay model to manipulate the variance of the delay time of logic elements and a new timing verification method based on the theory of regular expressions. With the delay time of logic elements such as TTL SN7400, the minimum delay time (dm), the maximum delay time (dM), and the typical delay time are specified in the manual, and the delay time of an element is one in the interval between dm and dM. Here we assume a discrete time, and we manipulate the variance of the delay time as a set of output strings corresponding to each delay time. We call the model as the combined delay model. Since many output strings are generated with a single input string, the usual timing simulation method cannot be applied. We propose a timing verification method using a behavior extraction method of logic circuits with respect to a time string set: with respect to the specified input set, the method extracts the output string set of each element in the circuit. We devised (1) a mechanism to keep the correspondence between a primary input string and an output string with respect to the primary input string, (2) a mechanism to manipulate the nondeterminism included in the combined delay model, and (3) an event-driven like data compaction method in representing finite automata. We focused on the hazard detection problem and the verification of asynchronous circuits, and show the effectiveness of our method with medium sized circuit with 100 elements or so. The method includes the state explosion, but the data compaction method and the extraction for only the specified input set are useful to control the state explosion.

In this paper we propose a new timing verification technique named coded time-symbolic simulation, CTSS. Our interest is on simulation of logic circuits consisting of gates whose delay is specified only by its minimum and maximum values. Conventional logic simulation based on min/max delay model leads to over-pessimistic results. In our new method, the cases of possible delay values of each gate are encoded by binary vectors. The circuit behavior for all the possible combinations of the delay values are simulated based on symbolic simulation by assigning Boolean variables to the binary vectors. This simulation technique can deal with logic circuits containing feedback loops as well as combinational circuits. We implemented an efficient simulator by using shared binary decision diagrams (SBDD's) as internal representation of Boolean functions. We also propose novel techniques of analyzing the results of CTSS.