We have developed a high-efficiency charge-pump power supply circuit with large output current capability for mobile equipment. However, during the commercialization phase, we found that the large inrush current of 270 mA at charge-pump circuit startup-time could cause problems. In this paper we analyze the mechanism that causes this inrush current, and we propose circuitry to reduce it. We show SPICE simulation and measurement results for our proposed circuitry that confirm its effectiveness. By incorporating this circuitry, startup-time inrush current was reduced to 30 mA.

This paper proposes a new architecture for multibit complex bandpass ΔΣAD modulators with built-in Switched-Capacitor (SC) circuits for application to Low-IF receivers such as used for Bluetooth and WLAN. In the realization of complex bandpass ΔΣAD modulators, we face the following problems: (i) SNR of AD converter is deteriorated by mismatches between internal analog I and Q paths. (ii) Layout design becomes complicated because of signal lines crossing by complex filter and feedback from DAC for I and Q paths in the complex modulator, and this increases required chip area. We propose a new structure for a complex bandpass ΔΣAD modulator which can be completely divided into two paths without layout crossing, and solves the problems mentioned above. The two parts of signal paths and circuits in the modulator are changed for I and Q while CLK is changed for High/Low by adding multiplexers. Symmetric circuits are used for I and Q paths at a certain timing, and they are switched by multiplexers to those used for Q and I paths at another timing. Therefore the influence from mismatches between I and Q paths is reduced by dynamic matching. As a result, the modulator is divided into two separate parts without crossing signal lines between I and Q paths and its layout design can be greatly simplified compared with conventional modulators. We have conducted MATLAB simulations to confirm the effectiveness of the proposed structure.