As technology nodes continue to shrink, the impact of radiation-induced soft error on processor reliability increases. Estimation of processor reliability and identification of vulnerable flip-flops requires accurate soft error rate (SER) analysis techniques. This paper presents a proposal for a soft error propagation analysis technique. We specifically examine single event upset (SEU) occurring at a flip-flop in sequential circuits. When SEUs propagate in sequential circuits, the faults can be masked temporally and logically. Conventional soft error propagation analysis techniques do not consider error convergent timing on re-convergent paths. The proposed technique can analyze soft error propagation while considering error-convergent timing on a re-convergent path by combinational analysis of temporal and logical effects. The proposed technique also considers the case in which the temporal masking is disabled with an enable signal of the erroneous flip-flop negated. Experimental results show that the proposed technique improves inaccuracy by 70.5%, on average, compared with conventional techniques using ITC 99 and ISCAS 89 benchmark circuits when the enable probability is 1/3, while the runtime overhead is only 1.7% on average.

This paper presents a resilient cache memory for dynamic variation tolerance in a 40-nm CMOS. The cache can perform sustained operations under a large-amplitude voltage droop. To realize sustained operation, the resilient cache exploits 7T/14T bit-enhancing SRAM and on-chip voltage/temperature monitoring circuit. 7T/14T bit-enhancing SRAM can reconfigure itself dynamically to a reliable bit-enhancing mode. The on-chip voltage/temperature monitoring circuit can sense a precise supply voltage level of a power rail of the cache. The proposed cache can dynamically change its operation mode using the voltage/temperature monitoring result and can operate reliably under a large-amplitude voltage droop. Experimental result shows that it does not fail with 25% and 30% droop of Vdd and it provides 91 times better failure rate with a 35% droop of Vdd compared with the conventional design.

This paper presents a novel architecture for a fault-tolerant and dual modular redundancy (DMR) system using a checkpoint recovery approach. The architecture features exploitation of SRAM with simultaneous copy and instantaneous compare function. It can perform low-latency data copying between dual cores. Therefore, it can carry out fast backup and rollback. Furthermore, it can reduce the power consumption during data comparison process compared to the cyclic redundancy check (CRC). Evaluation results show that, compared with the conventional checkpoint/restart DMR, the proposed architecture reduces the cycle overhead by 97.8% and achieves a 3.28% low-latency execution cycle even if a one-time fault occurs when executing the task. The proposed architecture provides high reliability for systems with a real-time requirement.