Content-Centric Networking (CCN) employs a hierarchical but location independent content naming scheme. While such a location independent naming brings various benefits including efficient content delivery, mobility, and multihoming, location independent name prefixes are hard to aggregate. This poses a serious scaling issue on the efficiency of looking up content names in a huge Forwarding Information Base (FIB) by longest prefix matching, which requires seeking the longest matching prefix through all candidate prefix lengths. We propose a new scheme for efficiently looking up non-aggregatable name prefixes in a large FIB. The proposed scheme is based on the observation that the bottleneck of FIB lookup is the random accesses to the high-latency off-chip DRAM for prefix seeking and this can be reduced by exploiting the information on the longest matching prefix length in the previous hop. Our evaluation results show that the proposed scheme significantly improves FIB lookup latency with a reasonable traffic parameters observed in today's Internet.

In this paper, joint transmit/receive frequency-domain equalization (FDE) is proposed for analog network coded (ANC) single-carrier (SC) bi-directional multi-antenna relay. In the proposed scheme, diversity transmission using transmit FDE is performed at relay station (RS) equipped with multiple antennas while receive FDE is carried out at base station (BS) and mobile terminal (MT) both equipped with single antenna. The transmit and receive FDE weights are jointly optimized so as to minimize the end-to-end mean square error (MSE). We evaluate, by computer simulation, the throughput performance and show that the joint transmit/receive FDE obtains the spatial and frequency diversity gains and accordingly achieve better throughput performance compared to either the transmit FDE only or the receive FDE only. It is also shown that ANC SC bi-directional multi-antenna relay can extend the communication coverage area for the given required throughput compared to conventional direct transmission.

In this paper, we propose and implement an automated route planning framework for milk-run transport logistics by applying model checking techniques. First, we develop a formal specification framework for milk-run transport logistics. The framework adopts LTL (Linear Temporal Logic), a language based on temporal logics, as a specification language for users to be able to flexibly and formally specify complex delivery requirements for trucks. Then by applying the bounded semantics of LTL, the framework then defines the notion of “optimal truck routes”, which mean truck routes on a given route map that satisfy given delivery requirements (specified by LTL) with the minimum cost. We implement the framework as an automated route planner using the NuSMV model checker, a state-of-the-art bounded model checker. The automated route planner, given route map and delivery requirements, automatically finds optimal trucks routes on the route map satisfying the given delivery requirements. The feasibility of the implementation design is investigated by analysing its computational complexity and by showing experimental results.

Active measurement is an end-to-end measurement technique that can estimate network performance. The active measurement techniques of PASTA-based probing and periodic-probing are widely used. However, for the active measurement of delay and loss, Baccelli et al. reported that there are many other probing policies that can achieve appropriate estimation if we can assume the non-intrusive context (the load of the probe packets is ignored in the non-intrusive context). While the best policy in terms of accuracy is periodic-probing with fixed interval, it suffers from the phase-lock phenomenon created by synchronization with network congestion. The important point in avoiding the phase-lock phenomenon is to shift the cycle of the probe packet injection by adding fluctuations. In this paper, we analyse the optimal magnitude of fluctuations corresponding to the given autocovariance function of the target process. Moreover, we introduce some evaluation examples to provide guidance on designing experiments to network researchers and practitioners. The examples yield insights on the relationships among measurement parameters, network parameters, and the optimal fluctuation magnitude.

Many EMD-type data hiding schemes have been proposed. However, the data hiding capacity is less than 2bpp when the embedding procedure uses formula operations. In order to improve the data hiding capacity from 1bpp to 4.5bpp, a new data hiding scheme is proposed in this paper based on a formula using the fully exploiting modification directions method (FEMD). By using our proposed theorem, the secret data can be embedded by formula operations directly without using a lookup matrix. The simulation results and performance analysis show the proposed scheme not only maintains good embedding capacity and stegoimage quality but also solves the overflow problem. It does so without using extra memory resources and performs within a reasonable computing time. The resource usage and capabilities of this scheme are well matched to the constraints and requirements of resource-scarce mobile devices.

In this paper, we propose the construction of quasi-cyclic (QC) LDPC codes based on the modified progressive edge-growth (PEG) algorithm to achieve the maximum local girth. Although the previously designed QC-LDPC codes based on the PEG algorithm has more flexible code rates than the conventional QC-LDPC code, in the design process, multiple choices of the edges may be chosen. In the proposed algorithm, we aim to maximize the girth property by choosing the suitable edges and thus improve the error correcting performance. Simulation results show that the QC-LDPC codes constructed from the proposed method give higher proportion of high local girths than other methods, particularly, at high code rates. In addition, the proposed codes offer superior bit error rate and block error rate performances to the previous PEG-QC codes over the additive white Gaussian noise (AWGN) channel.

Under random linear coding (RLC) scheme, we present a simple expression of the probability distribution p(D=K) for decoding delay D incurred by the lossy channel, where K is a positive integer. In contrast with the previous contribution, our focus is firstly on deriving the cumulative distribution function of the discrete random variable D over a perfect channel. One benefit of such dispose is that, from the overall viewpoint, computing the cumulative distribution function of delay D can be related with calculating the cardinalities of sets of some special matrices, so that the former can be obtained from the latter. Moreover, our expression of the probability distribution is an explicit form, and is valid for any number of packets M, freewill field size q and arbitrary channel loss rate ε.

This paper, presents a high-speed full swing driver for a heavy-load flat-panel scan-line circuit. The high driving capability is achieved using the proposed Complementary Dual-Bootstrap (CDUB) technique. The scan-line CDUB driver was fabricated in a 0.35-µm CMOS technology. The measured results, under the flat-panel scan-line load model, indicate that the delay time is within 2.8µs and the average power is 0.74mW for a 5V supply voltage.

This paper introduces our developed noise robust speech communication techniques and describes its implementation to a smart info-media system, i.e., a small robot. Our designed speech communication system consists of automatic speech detection, recognition, and rejection. By using automatic speech detection and recognition, an observed speech waveform can be recognized without a manual trigger. In addition, using speech rejection, this system only accepts registered speech phrases and rejects any other words. In other words, although an arbitrary input speech waveform can be fed into this system and recognized, the system responds only to the registered speech phrases. The developed noise robust speech processing can reduce various noises in many environments. In addition to the design of noise robust speech recognition, the LSI design of this system has been introduced. By using the design of speech recognition application specific IC (ASIC), we can simultaneously realize low power consumption and real-time processing. This paper describes the LSI architecture of this system and its performances in some field experiments. In terms of current speech recognition accuracy, the system can realize 85-99% under 0-20dB SNR and echo environments.

Broadcasting is an essential function in almost all wireless networks. Because of the dynamic nature of environment, broadcasting in cognitive radio ad hoc networks is a great challenge. Cognitive radio network technology has been well studied for more than a decade as a new way to improve the spectral efficiency of wireless networks and numerous precious works have been proposed. However, very few existing works consider how to broadcast messages in cognitive radio networks that operate in multichannel environments and none of these provides a full broadcast mechanism. Therefore, in this paper, we propose a broadcasting mechanism for multichannel cognitive radio ad hoc networks. Then, we analyze the mechanism regarding the speed of message dissemination, number of transmissions, fraction of the users that receive the broadcast message and so forth.

This paper presents a VLSI design of a Tomlinson-Harashima (TH) precoder for multi-user MIMO (MU-MIMO) systems. The TH precoder consists of LQ decomposition (LQD), interference cancellation (IC), and weight coefficient multiplication (WCM) units. The LQ decomposition unit is based on an application specific instruction-set processor (ASIP) architecture with floating-point arithmetic for high accuracy operations. In the IC and WCM units with fixed-point arithmetic, the proposed architecture uses an arrayed pipeline structure to shorten a circuit critical path delay. The implementation result shows that the proposed architecture reduces circuit area and power consumption by 11% and 15%, respectively.

In tooth contour extraction there is insufficient intensity difference in x-ray images between the tooth and dental bone. This difference must be enhanced in order to improve the accuracy of tooth segmentation. This paper proposes a method to improve the intensity between the tooth and dental bone. This method consists of an estimation of tooth orientation (intensity projection, smoothing filter, and peak detection) and PCA-Stacked Gabor with ellipse Gabor banks. Tooth orientation estimation is performed to determine the angle of a single oriented tooth. PCA-Stacked Gabor with ellipse Gabor banks is then used, in particular to enhance the border between the tooth and dental bone. Finally, active contour extraction is performed in order to determine tooth contour. In the experiment, in comparison with the conventional active contour without edge (ACWE) method, the average mean square error (MSE) values of extracted tooth contour points are reduced from 26.93% and 16.02% to 19.07% and 13.42% for tooth x-ray type I and type H images, respectively.

This paper proposes novel robust speech F0 estimation using Summation Residual Harmonics (SRH) based on TV-CAR (Time-Varying Complex AR) analysis. The SRH-based F0 estimation was proposed by A. Alwan, in which the criterion is calculated from LP residual signals. The criterion is summation of residual spectrum value for harmonics. In this paper, we propose SRH-based F0 estimation based on the TV-CAR analysis, in which the criterion is calculated from the complex AR residual. Since complex AR residual provides higher resolution of spectrum, it can be considered that the criterion is effective for F0 estimation. The experimental results demonstrate that the proposed method performs better than conventional methods; weighted auto-correlation and YIN.

In an orthogonal frequency division multiplexing (OFDM) communication system, two users use the same frequencies and number of sub-carriers so as to increase spectrum efficiency. When the codewords employed by them form a Golay complementary sequence (CS) mate, this system enjoys the upper bound of peak-to-mean envelope power ratio (PMEPR) as low as 4. This letter presents a construction method for producing S16-QAM and A16-QAM Golay CS mates, which arrives at the upper bound 4 of PMEPR. And when used as a Golay CS pair, they have an upper bound 2 of PMEPR, which is the same ones in both [18] and [17]. However, both cannot produce such mates.

In this letter, by using Whiteman's generalized cyclotomy of order 2 over Zpq, where p, q are twin primes, we construct new perfect Gaussian integer sequences of period pq.

This paper proposes a robust bilateral filter which can handle mixed Gaussian and impulsive noise by hybridizing the conventional bilateral filter and the switching median filter. The effectiveness of the proposed method is verified in comparison with other conventional methods by some experiments using the natural digital images.

The paper introduces a novel pheromone update strategy to improve the functionality of ant colony optimization algorithms. This modification tries to extend the search area by an optimistic reinforcement strategy in which not only the most desirable sub-solution is reinforced in each step, but some of the other partial solutions with acceptable levels of optimality are also favored. therefore, it improves the desire for the other potential solutions to be selected by the following artificial ants towards a more exhaustive algorithm by increasing the overall exploration. The modifications can be adopted in all ant-based optimization algorithms; however, this paper focuses on two static problems of travelling salesman problem and classification rule mining. To work on these challenging problems we considered two ACO algorithms of ACS (Ant Colony System) and AntMiner 3.0 and modified their pheromone update strategy. As shown by simulation experiments, the novel pheromone update method can improve the behavior of both algorithms regarding almost all the performance evaluation metrics.