The previously-proposed model of the writing process in TDMR is modified based on the Stoner-Wohlfarth reversal mechanism. The BER performance for a neuro-ITI canceller is obtained via computer simulation using the R/W channel model based on the writing process, and it is compared to those for well-known TDMR equalization techniques.

This paper presents a fast and accurate volume correspondence matching method using 3D Phase-Only Correlation (POC). The proposed method employs (i) a coarse-to-fine strategy using multi-scale volume pyramids for correspondence search and (ii) high-accuracy POC-based local block matching for finding dense volume correspondence with sub-voxel displacement accuracy. This paper also proposes its GPU implementation to achieve fast and practical computation of volume registration. Experimental evaluation shows that the proposed approach exhibits higher accuracy and lower computational cost compared with conventional method. We also demonstrate that the GPU implementation of the proposed method can align two volume data in several seconds, which is suitable for practical use in the image-guided radiation therapy.

According to the process scaling, radiation-hard devices are becoming sensitive to soft errors caused by Multiple Cell Upset (MCUs). In this paper, the parasitic bipolar effects are utilized to suppress MCUs of the radiation-hard dual-modular flip-flops. Device simulations reveal that a simultaneous flip of redundant latches is suppressed by storing opposite values instead of storing the same value due to its asymmetrical structure. The state of latches becomes a specific value after a particle hit due to the bipolar effects. Spallation neutron irradiation proves that MCUs are effectively suppressed in the D-FF arrays in which adjacent two latches in different FFs store opposite values. The redundant latch structure storing the opposite values is robust to the simultaneous flip.

This paper proposes an alternate time-switched transmission technique for single carrier modulation system with frequency domain equalization. Additional maximal ratio combining diversity gain is obtained by adding a transmit antenna and a switch. Alternating transmit symbols result in zeros which make maximal ratio receive combining possible in the receiver. Simulation results show that it has better performance than the traditional algorithm at the expense of one additional antenna.

This paper presents a basic investigation of the power imbalance problem with regard to maximum ratio combining (MRC) array antennas for digital TV broadcast reception. First, the relationship between the decrease in the diversity gain and reduction in the received power was investigated using two-element and four-element dipole array antennas by means of a Monte Carlo simulation. The relationship between the decrease in the diversity gain and the number of branches imposed to reduce the received power was also investigated. Then, a simple method of predicting the reduction in the diversity gain under imbalanced power conditions is given using the simulation results. The objective is to determine a criterion associated with the gain reduction that allows us to achieve the required system performance. Finally, the proposed method is confirmed by analysis using a model representing a typical portable digital broadcasting TV set held with both hands that simulates the power imbalance condition.

A dual-band dual-polarization array antenna with improved bandwidth for an advanced multi-function radio function concept (AMRFC) radar application is proposed. To improve the S-band impedance bandwidth, the proposed antenna uses modified coupling feed patch. The measured bandwidth of the prototype array is 19.8% and 25.7% for the S- and X-band, respectively. The isolation between the two orthogonal polarizations is higher than 15 dB and cross-polarization level is less than -17 dB for both S- and X-bands.

This paper describes a simulation platform for use in the quantitative assessment of different respiratory motion correction techniques in Coronary MR angiography (CMRA). The simulator incorporates acquisition of motion parameters from heart motion tracking and applies it to a deformable heart model. To simulate respiratory motion, a high-resolution 3-D coronary heart reference image is deformed using the estimated linear transformation from a series of volunteer coronal scout scans. The deformed and motion-affected 3-D coronary images are used to generate segmented k-space data to represent MR data acquisition affected by respiratory motion. The acquired k-space data are then corrected using different respiratory motion correction methods and converted back to image data. The resulting images are quantitatively compared with each other using image-quality measures. Simulation experiment results are validated by acquiring CMRA scans using the correction methods used in the simulation.

Sensor networks, in which many small terminals are wirelessly connected, have recently received considerable interest according to the development of wireless technology and electronic circuit. To provide advanced applications and services by the sensor networks, data collection including node location is essential. Hence the location estimation is important and many localization schemes have been proposed. Time of arrival (TOA) localization is one of the popular schemes because of its high estimation accuracy in ultra wide-band (UWB) sensor networks. However, a non-line-of-sight (NLOS) environment between the target and the anchor nodes causes a serious estimation error because the time is delayed more than its true one. Thus, the NLOS nodes should be detected and eliminated for estimation. As a well-known NLOS detection scheme, an iterative minimum residual (IMR) scheme which has low calculation complexity is used for detection. However, the detection error exists in IMR scheme due to the measurement error. Therefore, in this paper, we propose a new IMR-based NLOS detection scheme and show its performance improvement by computer simulations.

This letter presents a robust receiver using the generalized sidelobe canceller aided with the high-order derivative constraint technique for multicarrier code-division multiple-access (MC-CDMA) uplink against carrier frequency offset (CFO). Numerical results demonstrate the efficacy of the proposed receiver.

This paper proposes an alternate time-switched transmission technique for orthogonal frequency division multiplexing systems. There are two antennas in the transmitter but it still has only one baseband/RF and a switch that alternates between the antennas at every symbol timing. Alternating transmit symbols result in zeros which make maximal ratio receive combining possible in the receiver. Simulation results show that it has better performance than the traditional algorithm at the expense of one additional antenna.

In parallel computing systems using the master/worker model for distributed grid computing, as the size of handling data grows, the increase in the data transmission time degrades the performance. For divisible workload applications, therefore, multiple-round scheduling algorithms have been being developed to mitigate the adverse effect of longer data transmission time by dividing the data into chunks to be sent out in multiple rounds, thus overlapping the times required for computation and transmission. However, a standard multiple-round scheduling algorithm, Uniform Multi-Round (UMR), adopts a sequential transmission model where the master communicates with one worker at a time, thus the transmission capacity of the link attached to the master cannot be fully utilized due to the limits of worker-side capacity. In the present study, a Parallel Transferable Uniform Multi-Round algorithm (PTUMR) is proposed. It efficiently utilizes the data transmission capacity of network links by allowing chunks to be transmitted in parallel to workers. This algorithm divides workers into groups in a way that fully uses the link bandwidth of the master under some constraints and considers each group of workers as one virtual worker. In particular, introducing a Grouping Threshold effectively deals with very heterogeneous workers in both data transmission and computation capacities. Then, the master schedules sequential data transmissions to the virtual workers in an optimal way like in UMR. The performance evaluations show that the proposed algorithm achieves significantly shorter turnaround times (i.e., makespan) compared with UMR regardless of heterogeneity of workers, which are close to the theoretical lower limits.

Network structures can be found in almost any kind of natural or artificial systems as transport medium for communication between the respective nodes. In this paper we study certain key topological features of brain functional networks obtained from functional magnetic resonance imaging (fMRI) measurements. We compare complex network measures of the extracted topologies with those from Internet service providers (ISPs). Our goal is to identify important features which will be helpful in designing more robust and adaptive future information network architectures.

We present MIMO-OFDM based broadband power line communication (BPLC) that uses antenna and fading diversity. We evaluate the proposed MIMO-OFDM over BPLC channels, with or without cross-talk between antenna paths. The proposed scheme employs maximum ratio combining (MRC) that effectively combines both multiple antenna diversity gain and multipath fading diversity gain over 3-phase (22 MIMO, outdoor) or 1-phase (SISO, indoor) power line channels. Simulation results prove the performance advantage of the proposed scheme, whether or not cross-talk exists, over existing schemes.

A new codebook mapping algorithm for artificial bandwidth extension (ABE) is introduced in this paper. We design a wideband line spectrum pair (LSP) codebook which is coupled with the same index as the LSP codebook of a narrowband speech codec. The received narrowband LSP codebook indices are used to directly induce wideband LSP codewords. Thus, the proposed scheme eliminates codebook search processing to estimate the wideband spectrum envelope. We apply the proposed scheme to bandwidth extension in adaptive multi-rate (AMR) compressed domain. Its performance is assessed via the perceptual evaluation of speech quality (PESQ), informal listening tests, and weighted million operations per second (WMOPS) calculations.

Mobility Robustness Optimization (MRO) is one of the most important goals in LTE-Advanced Self-Organizing Networks (SON). Seamless handover in femtocell network is urgent and challenging, which has not been paid enough attention. Handover decision parameters, such as Time-To-Trigger (TTT), Hysteresis, Cell Individual Offset (CIO), have great effect on mobility performance, which may lead to Radio Link Failures (RLFs) and Unnecessary Handover. This letter proposes a handover parameters optimization approach based on Ant Colony Algorithm in the femtocell networks. The simulation result shows that the proposed scheme has a better performance than the fixed parameters method.

Concomitantly with the progress of wireless communications, cognitive radio has attracted attention as a solution for depleted frequency bands. Cognitive radio is suitable for wireless sensor networks because it reduces collisions and thereby achieves energy-efficient communication. To make cognitive radio practical, we propose a low-power multi-resolution spectrum sensing (MRSS) architecture that has flexibility in sensing frequency bands. The conventional MRSS scheme consumes much power and can be adapted only slightly to process scaling because it comprises analog circuits. In contrast, the proposed architecture carries out signal processing in a digital domain and can detect occupied frequency bands at multiple resolutions and with low power. Our digital MRSS module can be implemented in 180-nm and 65-nm CMOS processes using Verilog-HDL. We confirmed that the processes respectively dissipate 9.97 mW and 3.45 mW.

In this study, the design and fabrication of a 110–140-GHz varistor mode frequency tripler made with four Schottky diodes pair are presented. Nonlinear simulations were performed to calculate the optimum diode embedding impedance and the required input power. A compact microstrip resonant cell (CMRC) filter was introduced for the first time in submillimeter multiplier, instead of the traditional low-and-high impedance microstrip filter. The shorter size and the wider stop band of the CMRC filter improved the performance of the tripler. The tripler exhibited the best conversion efficiency of 5.2% at 129 GHz and peak output power of 5.3 mW at 125 GHz. Furthermore, within the output bandwidth from 110 to 140 GHz, the conversion efficiency was greater than 1.5%.

In this paper, we show that the covariance-eigenvalue approach converges much faster than using cumulative distribution function (CDF) for determining diversity gain from channel measurements in reverberation chamber. The covariance-eigenvalue approach can be used for arbitrary multi-port antennas, but it is limited to Maximum Ratio Combining (MRC).

In this study, we demonstrate an acceleration of flexible generalized minimal residual algorithm (FGMRES) implemented with the method of moments and the fast multipole method (FMM), based on a combined tangential formulation. For the implementation of the FGMRES incorporated with the FMM concept, we propose a new definition of the truncation number for the FMM operator within the inner solver. The proposed truncation number provides an optimal variable preconditioner by controlling the accuracy and computational cost of the inner iteration. Moreover, to further accelerate the convergence, we introduce the concept of a multistage preconditioner. Numerical experiments reveal that our new version of FGMRES, based on the proposed truncation number for the inner solver and the multistage preconditioner, achieves outstanding acceleration of the convergence for large-scale and practical electromagnetic scattering and radiation problems with several levels of geometrical complexity.

In this paper, we propose a new method to estimate and effectively reduce the effect of thermal asperity (TA) in the perpendicular magnetic recording (PMR) channels with the state trellis. The TA is estimated from the state trellis, then its average is used to modify the equalized signal entering the Viterbi detector. For the partial response (PR) targets with DC component, the proposed method with a maximum-likelihood detector can improve the bit error rate performance by more than an order of magnitude when TA occurs and degrades when the giant magneto-resistive (GMR) nonlinearity and base line wander (BLW) effects are present. Unlike the previous studies, this method allows the use of PR targets with DC component under the presence of TA.