A distributed congestion avoidance scheme, the End-to-End Rate Control Algorithm (EERCA), has been proposed for Available Bit Rate (ABR) service. In this work, we enhance EERCA by replacing the Queue Occupancy Reduction with the queuing delay control (QDC), which manipulates the queue occupancy more efficiently with less functional complexity. Furthermore, it alleviates per-VC accounting requirement and thus reduces the complexity of a switch. From both the analysis and the simulation, it shows that the proposed virtual queue occupancy precisely reflects the variation of the actual queue occupancy. This enhanced EERCA features higher efficiency and more stable queue occupancy than the original algorithm.

To realize S-band mobile satellite communications and broadcasting systems, the onboard mission system and equipment were designed for the Japanese Engineering Test Satellite VIII. The system performs voice communications using handheld terminals, high-speed data communications, and multimedia broadcasting through a geostationary satellite. To enhance system efficiency and flexibility, the onboard mission system features phased-array-fed reflector antennas with large antenna diameter and baseband switching through onboard processors. Configurations and performance of the subsystems and key onboard equipment, large deployable reflectors, feed arrays, beam forming networks and onboard processors, are presented. The S-band mobile systems and onboard equipment will be verified through in-orbit experiments scheduled for 2002.

In this paper, fast algorithms for the CMA (constant modulus algorithm), which is one of the widely used algorithms for blind equalizationi are presented. We propose the FBCMA (frequency domain block CMA) which takes advantage of fast linear convolution in the DFT domain by using the overlap save method. For the FBCMA, a nonlinear error function in the frequency domain is derived using Parseval's relation. Also, an adaptive algorithm in the DFT domain is introduced to adjust the frequency domain filter coefficients. For a block size and filter length of N, the multiplications required for the conventional CMA and proposed FBCMA are on the order of O(N2) and O(N log N), respectively.

The relationships between lattice orientation of the electron-beam evaporated MgO layer used as protecting layer for ac plasma displays (ac-PDPs) and the discharge characteristics of color ac-PDPs were investigated by the measurements of ion-induced secondary electron emission. It is proved that values of γi for MgO are large in the order of (220) orientation, (200) orientation, and (111) orientation, that is, γi(220) > γi(200) > γi(111). The values of φ for different lattice orientation are obtained by the measurements of thermionic emission and photo emission. The aging measurements for testing panels with the different lattice orientation of MgO layer revealed that performance of those panels are excellent in the order of (220), (200), and (111). In particular, luminance and luminous efficiency become larger in the order of (220), (200), and (111). It is pointed out that the degree of longevity, sustaining voltage, and memory margin for ac-PDPs with protecting materials as MgO are estimated by the measurements of γi.

We investigated the relationship between the film characteristics and the sputtering rate of the MgO protecting layer in AC-PDP. As possible elements for determining the sputtering rate, we considered the density, orientation, and surface morphology. With respect to the orientation, we found that the sputtering rate increased for the sequence of (200) < (220) < (111). However, we noticed that orientation and surface structure are not really decisive factors affecting the sputtering rate; the density of the film is most important.

For the realization of low-voltage full-color FEDs, requirements for phosphor for the FED are proposed. Especially, the influence of released gases or substances from phosphors on the field emission within the FED was made clear. It was clarified that the analysis of F-N plots of the V-I curve of field emission characteristics was helpful to know the interaction of field emission and phosphors. In the experiment, we first obtained the depth from the phosphor surface of the low voltage electron excitation in case of ZnGa2O4, where the region available for cathodoluminescence at the anode voltage of 400 V is about 63 nm deep from the surface. The characteristic of the 12.4 cm-320(trio)240 pixels low-voltage full-color FED is reported. The luminance of 154 cd/m2 was attained at the anode voltage of 400 V and the duty factor of 1/241. Supported by the high potential of the FED as a flat panel, each problem shall be steadily solved to secure the firm stand as a new full color flat display in new applications.

We have realized excellent viewing angle characteristics for the π cell, by combining a discotic negative birefringence film, which has a hybrid alignment structure, and a positive a-plate. The negative birefringence of the film completely compensates the positive birefringence of the π cell liquid crystals in the dark-state. The roll of a c-plate, which should be accompanied by the a-plate to suppress the light leakage from crossed polarizer at oblique incident angles, was substituted for the vertically aligned component of the π cell liquid crystal. Taking into account the fast electrooptical response, which is one order faster than that of the twisted-nematic liquid-crystal display, the π cell is one of the most promising liquid-crystal-display modes.

We proposed a new method to evaluate display legibility as a function of resolution. This method was able to evaluated display legibility without being restricted to the display resolution. Using this method, subjective psychological experiments were carried out to investigate display resolution, which provides legibility, in observing small characters. Samples viewed by subjects were images displayed on a high-resolution TFT-LCD that we developed, CRT images and printed documents for comparison. We have found that TFT-LCD legibility was much better than that of CRT, and that minimum resolution of about 175 dpi was needed for use in legible document viewers.

In this paper, we describe an experimental evaluation of visual fatigue in a binocular disparity type 3-D display system. To evaluate this fatigue, we use a subjective assessment method and focus on mismatching between convergence and accommodation, which is a major weakness of binocular disparity 3-D displays. For this subjective assessment, we use a newly-developed binocular disparity 3-D display system with a compensation function for accommodation. Because this equipment only allowed us to compare the terms of the mismatching itself, the evaluation is more accurate than similar previous works.

Experiment is reported of enhanced backscattering of light in binary and ternary suspensions of rutile and/or alumina particles. With a conventional CCD camera system for observing the phenomena, the angular line shape and the enhancement factor were agreed with the theoretically predicted curve and value. Observation of the angular distribution scattered at the backscattered direction supported the hypothesis proposed by Pine et al. , in which the transport mean free path of the polydisperse mixture can be expressed in terms of summing its reciprocal values weighted over the particle sizes.

The dynamics is investigated on the delayed regulation model under period-2 perturbation described as x(t+1)={A+(-1)te}x(t){1-x(t-1)}, t=1, 2, 3 . . . The e-dependences of the bifurcation points are analyzed through usual stability analysis of fixed point and periodic solution, however one of them is derived through the stability analysis of the "virtual" period-2 solution.

Wireless communication systems are affected by several factors in the indoor environment. The complexity of this environment, however, has hampered the development of methods for analyzing it. Reported here is our investigation of the relationship between the propagation characteristics and performance of a 2.4-GHz ISM-band wireless LAN in various indoor environments. Our objective was to develop guidelines for designing ideal indoor environments for wireless LANs. A booth constructed of a ceiling, floor, and wall materials that could be changed was used for our investigation. The transmission loss and delay spread were measured for four environments; they were calculated by using a ray-tracing method to verify the effectiveness of the ray tracing calculation. The throughput and BER characteristics were measured for the same environments. The following results were obtained. (1) The transmission loss and delay spread could be estimated by using this ray tracing method because the deviations between the calculated and measured data were within 5 dB for the transmission loss and within 10 ns for the delay spread. (2) Reflections from the walls caused a serious interference problem: throughput was 0.0 at more than 30% of the positions along the center line of the booth when the walls were constructed of high-reflection-coefficient material. (3) The throughput and BER were closely correlated with the delay spread; the number of positions meeting a certain throughput was estimated by the method based on the delay spread calculated using the ray tracing method. It was within 10% of the number measured. The results obtained can be used to design ideal indoor environments for 2.4-GHz ISM-band LAN systems.

We proposed a soft-decision decoding algorithm for cyclic codes based on energy minimization principle. This letter presents the algorithm which improves decoding performance and decoding complexity of the previous method by giving more initial positions and introducing a new criterion for terminating the decoding procedure. Computer simulation results show that both the decoded block error rate and the decoding complexity decrease by this method more than by the previous method.

In this paper, we focus on regularity and set-valued functions. Regularity was first introduced by S. C. Kleene in the propositional operations of his ternary logic. Then, M. Mukaidono investigated some properties of ternary functions, which can be represented by regular operations. He called such ternary functions "regular ternary logic functions". Regular ternary logic functions are useful for representing and analyzing ambiguities such as transient states or initial states in binary logic circuits that Boolean functions cannot cope with. Furthermore, they are also applied to studies of fail-safe systems for binary logic circuits. In this paper, we will discuss an extension of regular ternary logic functions into r-valued set-valued functions, which are defined as mappings on a set of nonempty subsets of the r-valued set {0, 1, . . . , r-1}. First, the paper will show a method by which operations on the r-valued set {0, 1, . . . , r-1} can be expanded into operations on the set of nonempty subsets of {0, 1, . . . , r-1}. These operations will be called regular since this method is identical with the way that Kleene expanded operations of binary logic into his ternary logic. Finally, explicit expressions of set-valued functions monotonic in subset will be presented.

In this paper, we show that the principle of quantum cryptography can be applied not only to a key distribution scheme but also to a data transmission scheme. We propose a secure data transmission scheme in which an eavesdropping can be detected based on sharing the bases Alice (the sender) and Bob (the receiver) have. We also show properties of this scheme.

This paper investigates the performance of relative rate (RR) switch algorithms for available bit rate (ABR) flow control in asynchronous transfer mode (ATM) networks. An RR switch can be implemented differently according to the congestion detection and notification methods used. This paper proposes three implementation schemes for an RR switch using various congestion detection and notification methods, and then analyzes the allowed cell rate (ACR) of a source and the queue length at a switch in steady state. The upper and lower bounds for the maximum and minimum queue lengths are also determined for each scheme, respectively, thereby investigating the effects of ABR parameter values on a queue length. Furthermore, a selection method for rate increase factor (RIF) and rate decrease factor (RDF) parameter values is suggested to prevent buffer overflow and underflow.

In this paper, we state some noteworthy facts in connection with simplification of the BCJR algorithm using the bidirectional Viterbi algorithm (BIVA). That is, we clarify the necessity of metric correction in the case that the BIVA is applied to reliability estimation, where information symbols uj obey non-uniform probability distributions.

The growth behavior of copper particle on crystalline and amorphous silicon surfaces has been investigated. The study reveals that the growth behavior of copper particle depends on the substrate condition. When samples are intentionally contaminated in ultrapure water, both crystalline and amorphous silicon surfaces show no difference in their contamination levels. However, copper particles were not observed on an amorphous silicon surface except dipping in dilute CuCl2 solution. The copper concentration on an amorphous silicon surface after dipping in a 0.5% HF solution is similar to the level after contaminating in ultrapure water. The copper contamination level on a crystalline silicon surface, except from CuCl2 solution, decreased two orders of magnitude as compared with ultrapure water. The copper impurity level on crystalline silicon surface was reduced by two orders by cleaning in a sulfuric acid-hydrogen peroxide mixture. The sulfuric acid-hydrogen peroxide mixture cleaning was not effective on an amorphous silicon surface. When native oxide pre-existed on an amorphous silicon surface before contamination, however, the sulfuric acid-hydrogen peroxide mixture cleaning was effective for removing copper impurity. Our results suggest that copper contamination on an amorphous silicon surface have the characteristics of bonding directly with silicon and/or existing in the native oxide, in contrast with the situation on crystalline silicon surface. After contamination with 1000 ppm copper in CuF2 solution, the etch rate of an amorphous silicon film in a 0.5% HF solution was approximately one order of magnitude faster than that of crystalline silicon. This is attributed to the difference in crystalline structure between crystalline silicon and amorphous silicon.

In this paper, we propose a preemptive priority handoff scheme for integrated voice/data cellular mobile systems. In our scheme, calls are divided into three different classes: handoff voice calls, originating voice calls, and data calls. In each cell of the system there is a queue only for data calls. Priority is given to handoff voice calls over the other two kinds of calls. That is, the right to preempt the service of data is given to a handoff voice call if on arrival it finds no idle channels. The interrupted data call returns to the queue. The system is modeled by a two-dimensional Markov chain. We apply the Successive Over-Relaxation (SOR) method to obtain the equilibrium state probabilities. Blocking and forced termination probabilities for voice calls are obtained. Moreover, average queue length and average transmission delay of data calls are evaluated. The results are compared with another handoff scheme for integrated voice/data cellular mobile systems where some numbers of channels are reserved for voice handoff calls. It is shown that, when the data traffic is not very light, the new scheme can provide lower blocking probability for originating voice calls, lower forced termination probability for ongoing voice calls, and shorter average queue length and less average transmission delay for data calls.

Synchronization and continuity are essential for multimedia presentation, but because network resources and available bandwidth are both limited, synchronization quality and continuity quality have to be traded off in response to the fluctuating network conditions. This paper therefore introduces an algorithm for intramedia synchronization with adaptive quality of service (QoS) control handled at different layers of multimedia streams. The work described here is an extension of our earlier proposal of a synchronization algorithm by delay compensation protocol with two resynchronization mechanisms: retrieval offset adjustment and data unit skipping. That algorithm has been extended by the introduction of QoS control mechanisms in the QoS plane of a distributed control platform. The extended approach results not only in better synchronization and continuity, but also integrates the QoS adjustment into the existing architecture. Unexpected QoS variations are coped with by an adaptive QoS control designed to maintain the desired application qualities within the fluctuating environment. Simulations implemented on a UDP/IP network have verified the effectiveness of the proposed scheme.