A new software based in-situ training (SBIST) method to achieve high accuracies is proposed for binarized neural networks inference accelerator chips in which measured offsets in sense amplifiers (activation binarizers) are transformed into biases in the training software. To expedite this individual training, the initial values for the weights are taken from results of a common forming training process which is conducted in advance by using the offset fluctuation distribution averaged over the fabrication line. SPICE simulation inference results for the accelerator predict that the accuracy recovers to higher than 90% even when the amplifier offset is as large as 40mV only after a few epochs of the individual training.

This paper presents a deep neural network (DNN) based symbol detection and modulation classification detector (SDMCD) for mixed blind signals detection. Unlike conventional methods that employ symbol detection after modulation classification, the proposed SDMCD can perform symbol recovery and modulation identification simultaneously. A cumulant and moment feature vector is presented in conjunction with a low complexity sparse autoencoder architecture to complete mixed signals detection. Numerical results show that SDMCD scheme has remarkable symbol error rate performance and modulation classification accuracy for various modulation formats in AWGN and Rayleigh fading channels. Furthermore, the proposed detector has robust performance under the impact of frequency and phase offsets.

Given a graph G=(V, E), where V and E are vertex and edge sets of G, and a subset VNT of vertices called a non-terminal set, a spanning tree with a non-terminal set VNT, denoted by STNT, is a connected and acyclic spanning subgraph of G that contains all vertices of V where each vertex in a non-terminal set is not a leaf. On general graphs, the problem of finding an STNT of G is known to be NP-hard. In this paper, we show that if G is a circular-arc graph then finding an STNT of G is polynomially solvable with respect to the number of vertices.

To reduce mutual coupling of a two-level nested array (TLNA) with an even number of sensors, we propose an improved array configuration that exhibits all the good properties of the prototype optimal configuration under the constraint of a fixed number of sensors N and achieves reduction of mutual coupling. Compared with the prototype optimal TLNA (POTLNA), which inner level and outer level both have N/2 sensors, those of the improved optimal TLNA (IOTLNA) are N/2-1 and N/2+1. It is proved that the physical aperture and uniform degrees of freedom (uDOFs) of IOTLNA are the same as those of POTLNA, and the number of sensor pairs with small separations of IOTLNA is reduced. We also construct an improved optimal second-order super nested array (SNA) by using the IOTLNA as the parent nested array, termed IOTLNA-SNA, which has the same physical aperture and the same uDOFs, as well as the IOTLNA. Numerical simulations demonstrate the better performance of the improved array configurations.

This paper describes a method to evaluate the modulated waveforms output by a high-speed external phase modulator over a wide wavelength range by using linear optical sampling (LOS) and a wavelength-swept light source. The phase-modulated waveform is sampled by LOS together with the reference signal before modulation, and the modulation waveform is observed by removing the phase noise of the light source extracted from the reference signal. In this process, the frequency offset caused by the optical-path length difference between the measurement and reference interferometers is removed by digital signal processing. A pseudo-random binary-sequence modulated signal is observed with a temporal resolution of 10ps. We obtained a dynamic range of ∼40dB for the measurement bandwidth of 10 nm. When the measurement bandwidth is expanded to entire C-Band (∼35nm), the dynamic ranges of 37∼46dB were observed, depending on the wavelengths. The measurement time was sub-seconds throughout the experiment.

To alleviate the problem of the dependency on the quantity of the training sample data in speech emotion recognition, a weighted gradient pre-train algorithm for low-resource speech emotion recognition is proposed. Multiple public emotion corpora are used for pre-training to generate shared hidden layer (SHL) parameters with the generalization ability. The parameters are used to initialize the downsteam network of the recognition task for the low-resource dataset, thereby improving the recognition performance on low-resource emotion corpora. However, the emotion categories are different among the public corpora, and the number of samples varies greatly, which will increase the difficulty of joint training on multiple emotion datasets. To this end, a weighted gradient (WG) algorithm is proposed to enable the shared layer to learn the generalized representation of different datasets without affecting the priority of the emotion recognition on each corpus. Experiments show that the accuracy is improved by using CASIA, IEMOCAP, and eNTERFACE as the known datasets to pre-train the emotion models of GEMEP, and the performance could be improved further by combining WG with gradient reversal layer.

Loan default prediction has been a significant problem in the financial domain because overdue loans may incur significant losses. Machine learning methods have been introduced to solve this problem, but there are still many challenges including feature multicollinearity, imbalanced labels, and small data sample problems. To replicate the success of deep learning in many areas, an effective regularization technique named muddling label regularization is introduced in this letter, and an ensemble of feed-forward neural networks is proposed, which outperforms machine learning and deep learning baselines in a real-world dataset.

Manufacturers are coping with increasing pressures in quality, cost and efficiency as more and more industries are moving from traditional setup to industry 4.0 based digitally transformed setup due to its numerous playbacks. Within the manufacturing domain organizational structures and processes are complex, therefore adopting industry 4.0 and finding an optimized re-engineered business process is difficult without using a systematic methodology. Authors have developed Business Process Re-engineering (BPR) and Business Process Optimization (BPO) methods but no consolidated methodology have been seen in the literature that is based on industry 4.0 and incorporates both the BPR and BPO. We have presented a consolidated and systematic re-engineering and optimization framework for a manufacturing industry setup. The proposed framework performs Evolutionary Multi-Objective Combinatorial Optimization using Multi-Objective Genetic Algorithm (MOGA). An example process from an aircraft manufacturing factory has been optimized and re-engineered with available set of technologies from industry 4.0 based on the criteria of lower cost, reduced processing time and reduced error rate. At the end to validate the proposed framework Business Process Model and Notation (BPMN) is used for simulations and perform comparison between AS-IS and TO-BE processes as it is widely used standard for business process specification. The proposed framework will be used in converting an industry from traditional setup to industry 4.0 resulting in cost reduction, increased performance and quality.

This letter presents an innovative solution for real-time interaction during online classes. Synchronous sharing enables instructors to provide real-time feedback to students. This encourages students to stay focused and feel engaged during class. Consequently, students evaluated anonymously that this solution significantly enhanced their learning experience during real-time online classes.

A robust saliency detection approach for images with a complex background is proposed. The absorbing Markov chain integrating low-level, mid-level and high-level cues dynamically evolves by using the similarity between pixels to detect saliency objects. The experimental results show that the proposed algorithm has advantages in saliency detection, especially for images with a chaotic background or low contrast.

To accelerate deep learning (DL) processes on the supercomputer Fugaku, the authors have ported and optimized oneDNN for Fugaku's CPU, the Fujitsu A64FX. oneDNN is an open-source DL processing library developed by Intel for the x86_64 architecture. The A64FX CPU is based on the Armv8-A architecture. oneDNN dynamically creates the execution code for the computation kernels, which are implemented at the granularity of x86_64 instructions using Xbyak, the Just-In-Time (JIT) assembler for x86_64 architecture. To port oneDNN to A64FX, it must be rewritten into Armv8-A instructions using Xbyak_aarch64, the JIT assembler for the Armv8-A architecture. This is challenging because the number of steps to be rewritten exceeds several tens of thousands of lines. This study presents the Xbyak_translator_aarch64. Xbyak_translator_aarch64 is a binary translator that at runtime converts dynamically produced executable codes for the x86_64 architecture into executable codes for the Armv8-A architecture. Xbyak_translator_aarch64 eliminates the need to rewrite the source code for porting oneDNN to A64FX and allows us to port oneDNN to A64FX quickly.

Side-channel analysis is one of the most investigated hardware Trojan detection approaches. However, nearly all the side-channel analysis approaches require golden chips for reference, which are hard to obtain actually. Besides, majority of existing Trojan detection algorithms focus on the data similarity and ignore the Trojan misclassification during the detection. In this paper, we propose a cost-sensitive golden chip-free hardware Trojan detection framework, which aims to minimize the probability of Trojan misclassification during the detection. The post-layout simulation data of voltage variations at different process corners is utilized as a golden reference. Further, a classification algorithm based on the combination of principal component analysis and Naïve bayes is exploited to identify the existence of hardware Trojan with a minimum misclassification risk. Experimental results on ASIC demonstrate that the proposed approach improves the detection accuracy ratio compared with the three detection algorithms and distinguishes the Trojan with only 0.27% area occupies even under ±15% process variations.

As the basis of fine breeding management and animal husbandry insurance, individual recognition of dairy cattle is an important issue in the animal husbandry management field. Due to the limitations of the traditional method of cow identification, such as being easy to drop and falsify, it can no longer meet the needs of modern intelligent pasture management. In recent years, with the rise of computer vision technology, deep learning has developed rapidly in the field of face recognition. The recognition accuracy has surpassed the level of human face recognition and has been widely used in the production environment. However, research on the facial recognition of large livestock, such as dairy cattle, needs to be developed and improved. According to the idea of a residual network, an improved convolutional neural network (Res_5_2Net) method for individual dairy cow recognition is proposed based on dairy cow facial images in this letter. The recognition accuracy on our self-built cow face database (3012 training sets, 1536 test sets) can reach 94.53%. The experimental results show that the efficiency of identification of dairy cows is effectively improved.

We propose an augmented-reality-based method for arranging furniture using natural markers extracted from the edges of the walls of rooms. The proposed method extracts natural markers and estimates the camera parameters from single images of rooms using deep neural networks. Experimental results show that in all the measurements, the superimposition error of the proposed method was lower than that of general marker-based methods that use practical-sized markers.

In this paper, we review the basic components of superconducting quantum computers. We mainly focus on the packaging and wiring technologies required to realize large-scalable superconducting quantum computers.

Pairing computations on elliptic curves with odd prime degrees are rarely studied as low efficiency. Recently, Clarisse, Duquesne and Sanders proposed two new curves with odd prime embedding degrees: BW13-P310 and BW19-P286, which are suitable for some special cryptographic schemes. In this paper, we propose efficient methods to compute the optimal ate pairing on this types of curves, instantiated by the BW13-P310 curve. We first extend the technique of lazy reduction into the finite field arithmetic. Then, we present a new method to execute Miller's algorithm. Compared with the standard Miller iteration formulas, the new ones provide a more efficient software implementation of pairing computations. At last, we also give a fast formula to perform the final exponentiation. Our implementation results indicate that it can be computed efficiently, while it is slower than that over the (BLS12-P446) curve at the same security level.

Most existing object detection methods and text detection methods are mainly designed to detect either text or objects. In some scenarios where the task is to find the target word pointed-at by an object, results of existing methods are far from satisfying. However, such scenarios happen often in human-computer interaction, when the computer needs to figure out which word the user is pointing at. Comparing with object detection, pointed-at word localization (PAWL) requires higher accuracy, especially in dense text scenarios. Moreover, in printed document, characters are much smaller than those in scene text detection datasets such as ICDAR-2013, ICDAR-2015 and ICPR-2018 etc. To address these problems, the authors propose a novel target word localization network (TWLN) to detect the pointed-at word in printed documents. In this work, a single deep neural network is trained to extract the features of markers and text sequentially. For each image, the location of the marker is predicted firstly, according to the predicted location, a smaller image is cropped from the original image and put into the same network, then the location of pointed-at word is predicted. To train and test the networks, an efficient approach is proposed to generate the dataset from PDF format documents by inserting markers pointing at the words in the documents, which avoids laborious labeling work. Experiments on the proposed dataset demonstrate that TWLN outperforms the compared object detection method and optical character recognition method on every category of targets, especially when the target is a single character that only occupies several pixels in the image. TWLN is also tested with real photographs, and the accuracy shows no significant differences, which proves the validity of the generating method to construct the dataset.

Music is often used for emotion induction because it can change the emotions of people. However, since we subjectively feel different emotions when listening to music, we propose an emotion induction system that generates music that is adapted to each individual. Our system automatically generates suitable music for emotion induction based on the emotions predicted from an electroencephalogram (EEG). We examined three elements for constructing our system: 1) a music generator that creates music that induces emotions that resemble the inputs, 2) emotion prediction using EEG in real-time, and 3) the control of a music generator using the predicted emotions for making music that is suitable for inducing emotions. We constructed our proposed system using these elements and evaluated it. The results showed its effectiveness for inducing emotions and suggest that feedback loops that tailor stimuli to individuals can successfully induce emotions.

This study tries to predict date of ear emergence of rice plants, based on cropping records over 25 years. Predicting ear emergence of rice plants is known to be crucial for practicing good harvesting quality, and has long been dependent upon old farmers who acquire skills of intuitive prediction based on their long term experiences. Facing with aging farmers, data driven approach for the prediction have been pursued. Nevertheless, they are not necessarily sufficient in terms of practical use. One of the issue is to adopt weather forecast as the feature so that the predictive performance is varied by the accuracy of the forecast. The other issue is that the performance is varied by region and the regional characteristics have not been used as the features for the prediction. With this background, we propose a feature engineering to quantify hidden regional characteristics as the feature for the prediction. Further the feature is engineered based only on observational data without any forecast. Applying our proposal to the data on the cropping records resulted in sufficient predictive performance, ±2.69days of RMSE.

With the rapid increase in the number of CPU cores, software that can utilize these many cores is required. A lock-free algorithm based on compare-and-swap (CAS) operations is one of the concurrency control methods to implement such multi-threading software. A multi-word CAS (MwCAS) operation is an extension of a CAS operation to swap multiple words atomically. However, we noticed that the performance of the existing MwCAS implementation is limited because of garbage collection even if in a low-contention environment. To achieve high performance in low-contention workloads, we propose a new MwCAS algorithm without garbage collection. Experimental results show that our approach is three to five times faster than implementation with garbage collection in low-contention workloads. Moreover, the performance of the proposed method is also superior in a high-contention environment.