An RF CMOS active inductor with a novel loss compensation circuit network is proposed. Performance of this active inductor can be improved by adding a novel network, which simultaneously reduces parallel and series losses. Consequently, this technique not only increases Q value, inductance, and operating frequency, but also reduces power consumption and circuit complexity. Simulation results show that better performance indices can be achieved, such as minimum total equivalent loss of 1 mΩ, maximum Q value about 3E5, and inductance value from 20 nH to 45 nH in the RF range of 0.6 GHz to 1.6 GHz. Power dissipation is around 1.76 mW under 2.5 V dc supply voltage.

VoIP is one of the key technologies for recent telecommunication services. The quality of its services should be discussed in subjective terms. Since subjective quality assessment is time-consuming and expensive, however, objective quality assessment which estimates subjective quality without carrying out subjective quality experiments is desirable. This paper discusses the performance of the objective quality measure that was standardized as ITU-T Recommendation P.862 and clarifies the quality factors that can be evaluated with satisfactory accuracy based on it. We found that P.862 can be applied to the evaluation of coding distortion, tandeming of codecs, transmission bit-errors, packet loss, and silence compression in a codec, at least for clean Japanese speech. In addition, we propose a method of estimating the subjective quality evaluation value from objective measurement results and show the validity of this method. We also evaluate the uniqueness of objective quality assessment based on P.862 from the viewpoints of the effect of measurement noise and the variation of test speech samples, and propose how to improve the reproducibility of objective quality assessment.

A fully integrated RF front-end for W-CDMA applications including a low noise amplifier, a down conversion mixer, a digitally programmable gain amplifier, an on-chip VCO, and a fractional-N frequency synthesizer is designed using a 0.35-µm CMOS process. A multi-stage ring shaped on-chip LC-VCO exhibiting bandpass characteristics overcomes the limitation of low-Q components in the tank circuits and improves the phase noise performance. The measured phase noise of the on-chip VCO is -134 dBc/Hz at 1 MHz offset. The receiver RF front-end achieves a NF of 3.5 dB, an IIP3 of -16 dBm, and a maximum gain of 80 dB. The receiver consumes 52 mA with a 3-V supply and occupies only 2 mm2 die area with minimal external components.

This paper proposes a novel method of identifying the design parameters for a practical implementation of the fair queueing discipline, which is capable of class-level delay control. The notion of class weight is introduced at first, and then the session weights are determined. This two-phase approach is favorable in terms of the scalability;that is, the overall complexity is dependent upon the number of classes only. We propose a packet scheduler referred to as the DPS (Delay-centric Processor Sharing) scheme which employs those design parameters to deliver class-wise delay bound services. The associated admission policy for delay guarantee is also derived. System analysis and derivation of the parameters have their origins in the understanding of the so-called system equation, which describes the dynamics of the class-level service share. The proposed design parameters are QoS-aware in that they are consistently refined depending on the system status. Several numerical and simulation results show that the DPS scheme is advantageous over other ones in terms of both resource efficiency and the robustness. Concerning the scalability, we show that an alternative tagging process of the DPS scheme is implementable with O(1) complexity with no significant degradation in delay performance.

We propose a new method to recover scene points from a single calibrated view using a subset of distances among the points. This paper first introduces the problem and its relationship with the perspective n point problem. Then the number of distances required to uniquely recover scene points are explored. The result is then developed into a practical vision algorithm to calculate the initial points' coordinates using distance constraints. Finally SQP (Sequential Quadratic Programming) is used to optimize the initial estimations. It can minimize a cost function defined as the sum of squared reprojection errors while keeping the specified distance constraints strictly satisfied. Both simulation data and real scene images have been used to test the proposed method, and good results have been obtained.

A new class of ternary sequence having a zero-correlation zone (zcz), based on Hadamard matrices, is presented. The proposed sequence construction can simultaneously generate a finite-length ternary zcz sequence set and a periodic ternary zcz sequence set. The generated finite-length ternary zcz sequence set has a zero-correlation zone for an aperiodic function. The generated periodic ternary zcz sequence set has a zero-correlation zone for even and odd correlation functions.

Multi-Carrier Code Division Multiple Access (MC-CDMA) is one of candidates for the next generation wireless communication systems. In an uplink, the MC-CDMA system suffers from the different access timing (asynchronous transmission), the different fading, and the different frequency offsets of each active user. In this paper we analyze the effects of the frequency offset compensation with MMSE-MUD (minimum mean square error based multi-user detection) for MC-CDMA in a quasi-synchronous uplink. We consider the MC-CDMA system with two subcarrier mapping schemes, the continuous mapping scheme and the discrete mapping scheme. From our theoretical analysis and computer simulation, we show that the MMSE-MUD can compensate the different frequency offsets among users. We also show that the MMSE-MUD significantly improves the bit error rate (BER) for the MC-CDMA system with the continuous mapping scheme.

An information retrieval (IR) system with query expansion on a low-cost high-performance PC cluster environment is implemented. We study how query performance is affected by query expansion and two declustering methods using two standard Korean test collections. According to the experiments, the greedy method shows about 20% enhancement overall when compared with the lexical method.

In this paper, we consider QoS-guaranteed wavelength allocation for WDM networks with limited-range wavelength conversion. In the wavelength allocation, the pre-determined number of wavelengths are allocated to each QoS class depending on the required loss probability. Moreover, we consider two wavelength selection rules and three combinations of the rules. We analyze the connection loss probability of each QoS class for a single link using continuous-time Markov chain. We also investigate the connection loss probability for a uni-directional ring network by simulation. In numerical examples, we compare connection loss probabilities for three combinations of selection rules and show how each combination of selection rules affects the connection loss probability of each QoS class. Furthermore, we show how wavelength conversion capability affects the connection loss probability. It is shown that the proposed allocation with appropriate wavelength selection rule is effective for QoS provisioning when the number of wavelengths is large. We also show the effective combination of wavelength selection rules for the case with small wavelength conversion capability.

In this paper, we proposed a novel two-stage channel estimation (2S-CE) method. In contrast to conventional channel estimation methods, this method makes the maximum use of the information contributed by the known data in every transmission burst. In the first stage, the least-squares (LS) algorithm was used to estimate the channel impulse response (CIR) based on the normal training sequence. Then the maximum channel memory was estimated and used to locate the uncorrupted data in the guard interval. In the second stage, the uncorrupted data together with the normal training sequence were sent to the LS algorithm again to obtain the fine-tuned CIR. To verify the efficiency of the proposed 2S-CE method, both a theoretical analysis and computer simulations have been done. Computer simulation results confirm the analysis results and demonstrate that the proposed 2S-CE method outperforms a conventional single-stage channel estimation method.

An automatic-repeat-request (ARQ) scheme for improving the system throughput efficiency is evaluated in coded multiple-input multiple-output (MIMO) transmissions. Supplementary trellis-coded modulation (TCM) code has been proposed for hybrid ARQ schemes. The free distance of the TCM after code combining can be increased by employing different TCM codes for retransmissions. The MIMO scheme offers additional flexibility in preventing successive frame errors by changing the connections between transmitters and transmit antennas upon retransmission. In this paper, an ARQ strategy employing both TCM reassignment and antenna permutation technique is investigated. It is shown through computer simulations that this ARQ scheme achieves high throughput even in severe conditions of low signal-to-noise ratio and high Rician factor over spatially and temporally correlated Nakagami-Rice fading MIMO channels.

We had previously proposed a fuzzy logic-based buffer management scheme (BMS) called fuzzy early detection (FED), which was designed to improve transmission control protocol (TCP) performance over the unspecified bit rate (UBR) service of asynchronous transfer mode (ATM) networks. Since a weakness in FED was discovered later, we present a refined version of it named FED+ here. Maintaining the design architecture and the algorithm of FED, FED+ further adopts a specific per virtual connection accounting algorithm to achieve its design goals. The effects of TCP implementation, TCP maximum segment size, switch buffer size and network propagation delay on FED+ performance are studied through simulation. Its performance is then compared with those of pure early packet discard (EPD), P-random early detection (P-RED) and FED. Our evaluations show that FED+ is superior to the others if the issues of efficiency, fairness, robustness, buffer requirement and the ease of tuning control parameters of a BMS are considered collectively.

This paper considers the problem of providing relative service differentiation in IEEE 802.11 Wireless LAN by using different Medium Access Control (MAC) parameters for different service classes. We present an analytical model which predicts the saturation throughput of IEEE 802.11 Distributed Coordination Function with multiple classes of service. This model allows us to show that relative service differentiation can be achieved by varying the initial contention window alone. In this case, the saturation throughput of a station can be shown to be approximately inversely proportional to the initial contention window size being used by that station. The simulation results validate our analytical model.

We propose a new data link protocol with an adaptive frame length control scheme for satellite networks. The wireless communication channel in satellite networks is subject to errors that occur with time variance. The frame length of the data link layer is another important factor that affects throughput performance in dynamic channel environments. If the frame length could be chosen adaptively in response to changes in the dynamically varying satellite channel, maximum throughput could be achieved under both noisy and non-noisy error conditions. So, we propose a frame length control scheme that acts adaptively to counter errors that occur with time variance. We model the satellite channel as a two-state Markov block interference (BI) model. The estimation of the channel error status is based on the short-term bit error rate and the duty cycle of noise bursts. Numerical and computer simulation results show that the proposed scheme can achieve high throughput for both dense and diffuse burst noise channels.

Sequential estimation of arrival angles allows us to resolve closely located sources that the standard MUSIC fails to do so. A new sequential estimation method is proposed which utilizes only the signal subspace components of the steering vectors for some estimates of the arrival angles. It is theoretically shown that the asymptotic performance of the proposed method is better than that of the conventional sequential method which exploits both the signal and the noise subspace components. Simulation results show that the former outperforms the latter in correlated sources as well as in uncorrelated sources.

DNA Sequence Design Problem is a crucial problem in information-based biotechnology such as DNA computing. In this paper, we introduce a powerful design strategy for DNA sequences by refining Random Generator. Random Generator is one of the design strategies and offers great advantages, but it is not a good algorithm for generating a large set of DNA sequences. We propose a Two-Step Search algorithm, then show that TSS can generate a larger set of DNA sequences than Random Generator by computer simulation.

The artifacts of low-bit rate quantization in images cannot be removed satisfactorily by known methods. We propose decomposition of images as HSI and LSI (higher- and lower- significance images), followed by subsampling and reconstruction methods for LSI. Experiments show significant improvement in image quality, as compared to other methods.

A rigorous analysis for a TM010 mode cylindrical cavity with insertion holes is presented on the basis of the Ritz-Galerkin method to realize accurate measurements of the complex permittivity of liquid. The effects of sample insertion holes, a dielectric tube, and air-gaps between a dielectric tube and sample insertion holes are taken into account in this analysis. The validity of this method is verified from measured results of some kinds of liquid.

This paper is focused on the measurement of the complex permittivity of a liquid phantom by the transmission line method using a coaxial line for measuring high-permittivity and high-loss materials. First, the complex permittivity of the liquid phantom material is measured under various physical lengths of the coaxial line for accurate measurement. Secondly, comparison between the measured result and the result obtained by the coaxial probe method is carried out in the frequency range from 0.5 to 3 GHz. Finally, the measurement error included in the complex permittivity is estimated quantitatively. The discussions lead to the conclusion that accurate measurement of the liquid material with high-permittivity and high-loss is possible by the presented method.

Finite-ground microstrip line (FGMSL) open-end discontinuities are characterized via a self-calibrated method of moments (MoM) as a unified circuit model with a fringing capacitance and radiation conductance. By integrating the short-open calibration (SOC) procedure into a determinant MoM, the model parameters are extracted without needing the alternative port impedance. Regardless of non-ideal voltage sources, extracted parameters are observed to achieve a stable convergence as the feeding line is sufficiently extended. After extracted capacitance of a FGMSL open-end with equal strip and finite-ground widths are validated against its traditional MSL counterpart with infinite ground, extensive results are given to originally demonstrate that the capacitance increases as a decelerated function of the finite-ground width and length while the conductance is negligibly small as compared with its imaginary part.