Compressive sensing (CS) shows that a sparse or compressible signal can be exactly recovered from its linear measurements at a rate significantly lower than the Nyquist rate. As an extreme case, 1-bit compressive sensing (1-bit CS) states that an original sparse signal can be recovered from the 1-bit measurements. In this paper, we intrduce a Fast and Accurate Two-Stage (FATS) algorithm for 1-bit compressive sensing. Simulations show that FATS not only significantly increases the signal reconstruction speed but also improves the reconstruction accuracy.

Streak cameras are now widely used for measurements of ultra short phenomena, such as those in semi conductor luminescence and plasma gaseous discharge. To further improve the temporal resolution and carry out higher-dimensional measurements, it is necessary to understand the electron beam behavior in detail. Thus, numerical simulations play an important role in the analysis of the streak camera. The authors have been working on the development of a numerical simulation code that uses the finite difference method (FDM) for electric field analysis, the Runge-Kutta (R-K) method for charged particle motion determination, and the particle-in-cell (PIC) method for charge density calculation. However, the use of the PIC method leads to inaccuracy in the charge density calculation in cases of high-density electron beams. To improve the accuracy of the conventional analysis of the streak camera, we perform the boundary element (BE) analysis of the streak camera.

For the modeling of multipath propagation in every wireless systems, the ray tracing method has been widely studied. However, large errors may result due to the approximation of geometrical optics in curved surfaces. This paper therefore focused on the curved surfaces and edges, which are difficult to handle in ray tracing. Examples of curved surfaces can be found in arched cross-section tunnels which are common in highway networks of mountainous areas. The traditional ray tracing method of dividing the curved surface into smaller flat plates is not so accurate as the size of smaller plates may not satisfy the geometrical optics assumption, and the reflection point which satisfies Fermat's principle may not exist. In this work, a new ray tracing method is proposed with 2 contributions. The first one is the implementation of the reflection coefficient for curved surfaces in ray tracing. The second is applying the physical optics method on the caustics region. To evaluate these methods, path gain simulation results for an arched cross-section model are compared with measurements made inside an arched tunnel. To further improve the simulation results, the effect of rough surface is introduced, and the results are again compared with measurement.

We deal with the scattering of a scalar plane wave by a half plane with a sinusoidally deformed edge from a straight edge by a physical optics approximation. The normal incidence of a plane wave to an edge is assumed. A contribution of an edge to the field integral is asymptotically evaluated and the basic properties of the scattering caused by the edge deformation is clarified. The scattering pattern has peaks at specific scattering angles, which agree with diffraction angles calculated by the well-known grating formula for normal incidence. Some numerical examples are shown and it is shown that the results are in good agreement with the results obtained by the GTD method for low angle incidence.

Fault-based attacks are very powerful to recover the secret key for cryptographic implementations. In this work, we consider the faulty output value under a certain fault injection intensity as a new type of leakage called faulty behavior. We examine the data-dependency of the faulty behavior and propose a related side-channel attack called fault behavior analysis (FBA). To verify the validity of the proposed attack, we first show that our attack can work effectively on AES-COMP of SASEBO-R. Then we show how to apply the similar attack on two AES implementations with masking countermeasures, i.e., AES-MAO and AES-TI. Finally we compare the proposed FBA attack with the DFA attack and the FSA attack, trying to complete the research map for the fault-based attack based on setup-time violations.

Product return is a critical but controversial issue. To deal with such a vague return problem, businesses must improve their information transparency in order to administrate the product return behaviour of their end users. This study proposes an intelligent return administration expert system (iRAES) to provide product return forecasting and decision support for returned product administration. The iRAES consists of two intelligent agents that adopt a hybrid data mining algorithm. The return diagnosis agent generates different alarms for certain types of product return, based on forecasts of the return possibility. The return recommender agent is implemented on the basis of case-based reasoning, and provides the return centre clerk with a recommendation for returned product administration. We present a 3C-iShop scenario to demonstrate the feasibility and efficiency of the iRAES architecture. Our experiments identify a particularly interesting return, for which iRAES generates a recommendation for returned product administration. On average, iRAES decreases the effort required to generate a recommendation by 70% compared to previous return administration systems, and improves performance via return decision support by 37%. iRAES is designed to accelerate product return administration, and improve the performance of product return knowledge management.

The cooperative orthogonal frequency-division multiplexing (OFDM) relaying system is widely regarded as a key design for future broadband mobile cellular systems. This paper focuses on channel estimation in such a system that uses amplify-and-forward (AF) as the relaying strategy. In the cooperative AF relaying, the destination requires the individual (disintegrated) channel state information (CSI) of the source-relay (S-R) and relay-destination (R-D) links for optimum combination of the signals received from source and relay. Traditionally, the disintegrated CSIs are obtained with two channel estimators: one at the relay and the other at the destination. That is, the CSI of the S-R link is estimated at relay and passed to destination, and the CSI of the R-D link is estimated at destination with the help of pilot symbols transmitted by relay. In this paper, a new disintegrated channel estimator is proposed; based on an expectation-maximization (EM) algorithm, the disintegrated CSIs can be estimated solely by the estimator at destination. Therefore, the new method requires neither signaling overhead for passing the CSI of the S-R link to destination nor pilot symbols for the estimation of the R-D link. Computer simulations show that the proposed estimator works well under the signal-to-noise ratios of interest.

This paper describes a simulation platform for use in the quantitative assessment of different respiratory motion correction techniques in Coronary MR angiography (CMRA). The simulator incorporates acquisition of motion parameters from heart motion tracking and applies it to a deformable heart model. To simulate respiratory motion, a high-resolution 3-D coronary heart reference image is deformed using the estimated linear transformation from a series of volunteer coronal scout scans. The deformed and motion-affected 3-D coronary images are used to generate segmented k-space data to represent MR data acquisition affected by respiratory motion. The acquired k-space data are then corrected using different respiratory motion correction methods and converted back to image data. The resulting images are quantitatively compared with each other using image-quality measures. Simulation experiment results are validated by acquiring CMRA scans using the correction methods used in the simulation.

In this note we suggest a new parallelizable mode of operation for message authentication codes (MACs). The new MAC algorithm iterates a pseudo-random function (PRF) FK:{0,1}m → {0,1}n, where K is a key and m,n are positive integers such that m ≥ 2n. The new construction is an improvement over a sequential MAC algorithm presented at FSE2008, solving positively an open problem posed in the paper – the new mode is capable of fully parallel execution while achieving rate-1 efficiency and “full n-bit” security. Interestingly enough, PMAC-like parallel structure, rather than CBC-like serial iteration, has beneficial side effects on security. That is, the new construction is provided with a more straightforward security proof and with an even better (“-free”) security bound than the FSE 2008 construction.

Existing salient object detection methods either simply use a threshold to detect desired salient objects from saliency map or search the most promising rectangular window covering salient objects on the saliency map. There are two problems in the existing methods: 1) The performance of threshold-dependent methods depends on a threshold selection and it is difficult to select an appropriate threshold value. 2) The rectangular window not only covers the salient object but also contains background pixels, which leads to imprecise salient object detection. For solving these problems, a novel saliency threshold-free method for detecting the salient object with a well-defined boundary is proposed in this paper. We propose a novel window search algorithm to locate a rectangular window on our saliency map, which contains as many as possible pixels belonging the salient object and as few as possible background pixels. Once the window is determined, GrabCut is applied to extract salient object with a well-defined boundary. Compared with existing methods, our approach doesn't need any threshold to binarize the saliency map and additional operations. Experimental results show that our approach outperforms 4 state-of-the-art salient object detection methods, yielding higher precision and better F-Measure.

The thermionic emission properties of diamond micropowders were investigated. The thermionic emission current was observed at a low temperature of 702 K, and a work function of approximately 1.97 eV was obtained. Band bending in diamond micropowders induced by an applied electric field had a considerable influence on decreasing the work function.

Clock network synthesis is one of the most important and limiting factors in VLSI designs. Hence, the clock skew variation reduction is one of the most important objectives in clock distribution methodology. Cross-link insertion is proposed in [1], however, it is based on empirical methods and does not use variation information for link insertion location choice. [17] considers the delay variation, but it is slow even for small clock trees. In this paper, we propose a fast link insertion algorithm that considers the delay variation information directly during link selection process. Experimental results show that our algorithm is very fast and achieves better skew variability reduction while utilizing considerably lesser routing resources compared with existing methods.

Network slicing for wide-area coordinated packet processing has attracted attentions for improving efficiency of handling network traffic. We have recently proposed a tag-based network slicing mechanism called OpenTag, and introduced the prototype implementation of the OpenTag redirector on an evaluation board. In this paper, we investigate the integration of the OpenTag redirector into a commercial network device. Our contributions are three-fold: (1) designing the architecture aiming OpenTag-capable intermediaries embedded on commercial network devices, (2) implementing a prototype of the embedded OpenTag redirector using the Advanced Mezzanine Card (AMC) which has an OCTEON network processor, (3) showing our implementation can tolerate high bandwidth environment.

The current amplify and forward (AF) model causes interference at a mobile terminal (MT) because of relay delay or noise amplification. Therefore, this paper proposes a MIMO phase control relaying system without amplification. The proposed scheme enhances both the communication quality and the channel capacity. Computer simulations indicate the effectiveness of the proposed scheme.

The broadcast scheduling problem (BSP) in wireless ad-hoc networks is a well-known NP-complete combinatorial optimization problem. The BSP aims at finding a transmission schedule whose time slots are collision free in a wireless ad-hoc network with time-division multiple access (TDMA). The transmission schedule is optimized for minimizing the frame length of the node transmissions and maximizing the utilization of the shared channel. Recently, many metaheuristics can optimally solve smaller problem instances of the BSP. However, for complex problem instances, the computation of metaheuristics can be quite time and memory consuming. In this work, we propose a greedy genetic algorithm for solving the BSP with a large number of nodes. We present three heuristic genetic operators, including a greedy crossover and two greedy mutation operators, to optimize both objectives of the BSP. These heuristic genetic operators can generate good solutions. Our experiments use both benchmark data sets and randomly generated problem instances. The experimental results show that our genetic algorithm is effective in solving the BSP problem instances of large-scale networks with 2,500 nodes.

Electromagnetic emissions leak confidential data of cryptographic devices. Electromagnetic Analysis (EMA) exploits such emission for cryptanalysis. The performance of EMA dramatically decreases when correlated noise, which is caused by the interference of clock network and exhibits strong correlation with encryption signal, is present in the acquired EM signal. In this paper, three techniques are proposed to reduce the correlated noise. Based on the observation that the clock signal has a high variance at the signal edges, the first technique: single-sample Singular Value Decomposition (SVD), extracts the clock signal with only one EM sample. The second technique: multi-sample SVD is capable of suppressing the clock signal with short sampling length. The third one: averaged subtraction is suitable for estimation of correlated noise when background samplings are included. Experiments on the EM signal during AES encryption on the FPGA and ASIC implementation demonstrate that the proposed techniques increase SNR as much as 22.94 dB, and the success rates of EMA show that the data-independent information is retained and the performance of EMA is improved.

We propose a new analytical method for a composite dielectric grating embedded with conducting strips using scattering factors in the shadow theory. The scattering factor in the shadow theory plays an important role instead of the conventional diffraction amplitude. By specifying the relation between scattering factors and spectral-domain Green's functions, we derive expressions of the Green's functions directly for unit surface electric and magnetic current densities, and apply the spectral Galerkin method to our formulation. From some numerical results, we show that the expressions of the Green's functions are valid, and analyze scattering characteristics by composite gratings.

The electrostatic characteristics of broadside-coupled striplines in a shield are investigated with the mode-matching method. The Fourier series is employed to describe electrostatic potential distributions. Numerical results are shown for coupled transmission line cell applications.

Facial micro-expressions are fast and subtle facial motions that are considered as one of the most useful external signs for detecting hidden emotional changes in a person. However, they are not easy to detect and measure as they appear only for a short time, with small muscle contraction in the facial areas where salient features are not available. We propose a new computer vision method for detecting and measuring timing characteristics of facial micro-expressions. The core of this method is based on a descriptor that combines pre-processing masks, histograms and concatenation of spatial-temporal gradient vectors. Presented 3D gradient histogram descriptor is able to detect and measure the timing characteristics of the fast and subtle changes of the facial skin surface. This method is specifically designed for analysis of videos recorded using a hi-speed 200 fps camera. Final classification of micro expressions is done by using a k-mean classifier and a voting procedure. The Facial Action Coding System was utilized to annotate the appearance and dynamics of the expressions in our new hi-speed micro-expressions video database. The efficiency of the proposed approach was validated using our new hi-speed video database.

Orthogonal frequency division multiplexing (OFDM) is very sensitive to the frequency errors caused by phase noise and Doppler shift. These errors will disturb the orthogonality among subcarriers and cause intercarrier interference (ICI). A simple method to combat ICI is proposed in this letter. The main idea is to map each data symbol onto a couple of subcarriers rather to a single subcarrier. Different from the conventional adjacent coupling and symmetric coupling methods, the frequency diversity can be utilized more efficiently by the proposed adaptive coupling method based on optimal subcarrier spacing. Numerical results show that our proposed method provides a robust signal-to-noise ratio (SNR) improvement over the conventional coupling methods.