In the letter, we propose an improved histogram shifting (HS) based reversible data hiding scheme for small payload embedding. Conventional HS based schemes are not suitable for low capacity embedding with relatively large distortion due to the inflexible side information selection. From an analysis of the whole HS process, we develop a rate-distortion model and provide an optimal adaptive searching approach for side information selection according to the given payload. Experiments demonstrate the superior performance of the proposed scheme in terms of performance curve for low payload embedding.

Ground truth based image segmentation evaluation paradigm plays an important role in objective evaluation of segmentation algorithms. So far, many evaluation methods in terms of comparing clusterings in machine learning field have been developed. However, most traditional pairwise similarity measures, which only compare a machine generated clustering to a “true” clustering, have their limitations in some cases, e.g. when multiple ground truths are available for the same image. In this letter, we propose utilizing an information theoretic measure, named NJMI (Normalized Joint Mutual Information), to handle the situations which the pairwise measures can not deal with. We illustrate the effectiveness of NJMI for both unsupervised and supervised segmentation evaluation.

Single front-end architecture with parasitic antenna element (PAE) in compact array system has been proposed for enhancing spectral efficiency and miniaturizing the receiver. Although most of studies paid attention to design optimal receiver with antenna mutual coupling on fading correlation, relatively little attention has been paid to noise. In this paper, we propose a low noise model for single front-end MIMO receiver system with PAE which includes arbitrary signal and noise coupling. The proposed model articulates physical noise sources and relates their spatial correlation with array receive antennas, parasitic element, front-end and matching circuit. A matching circuit is designed to achieve minimum noise figure. After that, the optimal PAE value is derived to maximize channel capacity. We present numerical analysis to verify the proposed system on certain conditions.

Compressing a JPEG image twice will greatly decrease the values of some of its DCT coefficients. This effect can be easily detected by statistics methods. To defend this forensic method, we establish a model to evaluate the security and image quality influenced by the re-compression. Base on the model, an optimized adjustment of the DCT coefficients is achieved by Genetic Algorithm. Results show that the traces of double compression are removed while preserving image quality.

This paper aims at channel modeling and bit error rate (BER) performance improvement with diversity reception for in-body to on-body ultra wideband (UWB) communication for capsule endoscope application. The channel characteristics are firstly extracted from 3.4 to 4.8 GHz by using finite difference time domain (FDTD) simulations incorporated with an anatomical human body model, and then a two-path impulse response channel model is proposed. Based on the two-path channel model, a spatial diversity reception technique is applied to improve the communication performance. Since the received signal power at each receiver location follows a lognormal distribution after summing the two path components, we investigate two methods to approximate the lognormal sum distribution in the combined diversity channel. As a result, the method matching a short Gauss-Hermite approximation of the moment generating function (MGF) of the lognormal sum with that of a lognormal distribution exhibits high accuracy and flexibility. With the derived probability density function (PDF) for the combined diversity signals, the average BER performances for impulse-radio (IR) UWB with non-coherent detection are investigated to clarify the diversity effect by both theoretical analysis and computer simulation. The results realize an improvement around 10 dB on Eb/No at BER of 10-3 for two-branch diversity reception.

This paper presents a simple 3-D array configuration for high-resolution 2-D Direction-Of-Arrival (DOA) estimation. Planar array structures like Uniform Rectangular Array (URA) or Uniform Circular Array (UCA) often well estimate azimuth angle but cannot well estimate elevation angle because of short antenna aperture in elevation direction. One may put more number of array elements to improve elevation angle estimation accuracy, however it will require very large hardware and software cost. This paper presents a simple 3-D array structure for high-resolution 2-D DOA estimation only by modifying the height of some array elements in a planar array. Based on the analysis of Cramer-Rao Lower Bound (CRLB) formulation and its dependency on the height of array elements, we develop a simple 3-D array structure which improves elevation angle estimation accuracy while preserving azimuth angle estimation accuracy.

This paper presents a novel similarity measure that computes similarity scores among scientific research papers. The text of a given paper in online scientific literature is often found to be incomplete in terms of its potential to be compared with others, which likely leads to inaccurate results. Our solution to this problem makes use of both text and link information of a paper in question for similarity scores in that the comparison text of the paper is strengthened by adding that of papers related to it. More accurate similarity scores can be computed by reinforcing the input with the citations of the paper as well as the citations included within the paper. The efficacy of the proposed measure is validated through our extensive performance evaluation study which demonstrates a substantial gain.

In this letter we propose a practical sensing-based opportunistic spectrum sharing scheme for cognitive radio (CR) downlink MIMO systems. Multi-antennas are exploited at the secondary transmitter to opportunistically access the primary spectrum and effectively achieve a balance between secondary throughput maximization and mitigation of interference probably caused to primary radio link. We first introduce a brief secondary frame structure, in which a sensing phase is exploited to estimate the effective interference channel. According to the sensing result and taking the interference caused by the primary link into account, we propose an enhanced signal-to-leakage-and-noise ratio (SLNR)-based precoding scheme for the secondary transmitter. Compared to conventional schemes where perfect knowledge of the channels over which the CR transmitter interferes with the primary receiver (PR) is assumed, our proposed scheme shows its superiority and simulation results validate this.

An ad hoc network is a decentralized network that consists of mobile nodes with wireless communication devices without the aid of access points. A Vehicular Ad-hoc NETwork (VANET) is one of the representative applications of the ad hoc network. Epidemic routing has been proposed as a routing protocol based on Store-Carry-Forward mechanism for VANET environment. However, in Epidemic Routing, network resources such as packet buffer of a node are significantly consumed because data packets are spread across the network. Therefore, this paper proposes a new autonomous clustering-based data transfer scheme using positions and moving direction of vehicles for VANETs. The autonomous clustering configures multiple clusters in the network and then only the cluster head that manages the cluster stores data packets. Whenever the cluster meets a new cluster, the cluster head of the cluster decides whether it should forward data packets to the new cluster based on its own position, the destination node's position, and moving direction of the cluster. Finally, this paper presents the simulation results to show the effectiveness of the proposed scheme.

Experiments were carried out at several voltages to clarify the influence of the voltage on various characteristics, i.e. arc duration, contact resistance, arc energy, and the change in electrode mass. The voltage was varied from DC100 V to 160 V, the load current was fixed at 5 A constant, and the electromagnetic contactor was operated continuously up to 100,000 times. The experiments were carried out under the three operation modes which are classified by the arc discharge. As a result, the relation between the operation mode and contact resistance was clarified. When only a make arc was generated, the contact resistance was smallest. In addition, the contact resistance was not affected by the source voltage.

In this paper, a contactless measurement technique of passive intermodulation (PIM) using a coaxial tube excited with standing waves is proposed. The principle of the proposed method is described using a two-port network model with the lumped resistances representing the losses of a specimen and test equipment. To show its validity, a test using nickel wires producing high PIM is carried out, and its PIM-dependency on DUT-position in the coaxial tube is simulated using the FDTD method. The simulated result shows a good agreement to the experiment. Through the examination, it is found that the power consumption by the PIM source in a specimen is essential in PIM production, and sensitive PIM detection does not require good matching condition. Finally, the relation between PIM-source size and generated PIM level is also examined. The result shows that at least 18 dB-PIM reduction is obtained by PIM source size in a half-wavelength conductive wire.

This letter presents a novel opportunistic cooperative positioning approach for orthogonal frequency-division multiple access (OFDMA) systems. The basic idea is to allow idle mobile terminals (MTs) opportunistically estimating the arrival timing of the training sequences for uplink synchronization from active MTs. The major advantage of the proposed approach over state-of-the-arts is that the positioning-related measurements among MTs are performed without the paid of training overhead. Moreover, Cramer-Rao lower bound (CRLB) is utilized to derive the positioning accuracy limit of the proposed approach, and the numerical results show that the proposed approach can improve the accuracy of non-cooperative approaches with the a-priori stochastic knowledge of clock bias among idle MTs.

This study proposes an improved per-survivor-processing (PSP) scheme to tackle the phase error issue in the convolutionally coded OFDM systems. The proposed approach takes advantage of the trellis structure of the convolutional codes to compensate the symbol-time-offset (STO) caused phase error in frequency domain. Unlike the traditional PSP scheme which simply estimates the phase error by using a state-based horizontal process, the proposed approach develops an extra state-wise vertical process which selects the most likely phase estimate as the survival phase in each trellis stage and then accordingly align the phase of all states to this survival phase before moving to next trellis stage of the PSP scheme. With the vertical process, the resultant phase estimate is more reliable than that of the conventional PSP scheme and hence improve the accuracy in data decoding. Computer simulations confirm the validity of the proposed approach.

There exists a considerable number of node placement models and algorithms for simulation of wireless multihop networks. However, the topologies created with the existing algorithms do not have properties of real networks. We have developed NPART (Node Placement Algorithm for Realistic Topologies) in order to resolve this fundamental issue in simulation methodology. We compare topologies generated by NPART with open wireless multihop network in Berlin. The NPART generated topologies have almost identical node degree distribution, number of cut-edges and vertices as the real network. Unlike them, topologies generated with the common node placement models have their own characteristics which are considerably different both from NPART and from reality. NPART algorithm has been developed into a tool. We propose a method and present a tool for integration of NPART with various realistic node mobility algorithms and tools, such as Citymob [1] and MOVE [2]. This integrated tool allows easy and time-efficient generation of highly complex, realistic simulation scenarios. We use the tool to evaluate effects of integration between existing open community wireless multi-hop networks and vehicular ad-hoc networks (VANETs). The evaluation shows that despite partial coverage and peculiar topological properties of open networks, they offer high levels of performance and network availability to the mobile end users, virtually identical to performance and availability of planned, dedicatedly deployed networks. Our results indicate that the integration of these networks may bring considerable benefits to all parties involved.

Tin (Sn) contacts are widely applied to connector contacts. Surfaces of plated tin layer are covered with an oxide film that results in high contact resistance. However, it is possible to obtain low contact resistance by using high contact load. Current downsizing trends often make it difficult to obtain high contact loads. Therefore, it is important to conduct basic studies of the contacts resistance characteristics under low contact load conditions. In this study, relationships between contact resistance and the changes of contact traces were examined. When a platinum (Pt) hemisphere contacted to tin plated flat coupon, it was found that the hemisphere surface sank into the softer tin plated flat surface during loading resulting in a piling up tin crystal grains along the periphery of the contact trace. During this process, sudden decrease in contact resistance was observed. To clarify the phenomenon, morphology changes of contact traces were observed by AFM, SEM and EBSD. FEM analysis was also used to analyze the mechanical stress distribution in the tin plated layer. Due to the peculiar distribution of stress, the crystal grains are separated and push out the contact area. This phenomenon is very different from commonly observed decrease in contact resistance due to elastic and plastic deformation inducing mechanical fracture of the surface oxide film.

A facial components based facial expression recognition algorithm with sparse representation classifier is proposed. Sparse representation classifier is based on sparse representation and computed by L1-norm minimization problem on facial components. The features of “important” training samples are selected to represent test sample. Furthermore, fuzzy integral is utilized to fuse individual classifiers for facial components. Experiments for frontal views and partially occluded facial images show that this method is efficient and robust to partial occlusion on facial images.

We consider wireless secure communications between a source and a destination aided by a multi-antenna relay, in the presence of an eavesdropper. In particular, two cooperation schemes of the relay are explored: cooperative relaying (CR) and cooperative jamming (CJ). We first investigate the transmit weight optimization of CR and CJ, for both cases with and without the eavesdropper's channel state information (ECSI). Then, for the case with ECSI, we derive the conditions under which CR achieves a higher secrecy rate than CJ; for the case without ECSI, we compare the secrecy rates of CR and CJ in high transmit power regimes. Building on this, we propose a novel hybrid scheme in which the relay utilizes both CR and CJ, and study the power allocation of the relay between CR and CJ for maximizing the secrecy rate under individual power constraints. Further, we study the case with imperfect channel state information (CSI) for both CR and CJ. At last, extensive numerical results are provided.

An exponential regression-based model with stochastic intensity is developed to describe the software reliability growth phenomena, where the software testing metrics depend on the intensity process. For such a generalized modeling framework, the common maximum likelihood method cannot be applied any more to the parameter estimation. In this paper, we propose to use the pseudo maximum likelihood method for the parameter estimation and to seek not only the model parameters but also the software reliability measures approximately. It is shown in numerical experiments with real software fault data that the resulting software reliability models based on four parametric approximations provide the better goodness-of-fit performance than the common non-homogeneous Poisson process models without testing metric information.

This paper proposes the test case prioritization in regression testing. The large size of a test suite to be executed in regression testing often causes large amount of testing cost. It is important to reduce the size of test cases according to prioritized test sequence. In this paper, we apply the Markov chain Monte Carlo random testing (MCMC-RT) scheme, which is a promising approach to effectively generate test cases in the framework of random testing. To apply MCMC-RT to the test case prioritization, we consider the coverage-based distance and develop the algorithm of the MCMC-RT test case prioritization using the coverage-based distance. Furthermore, the MCMC-RT test case prioritization technique is consistently comparable to coverage-based adaptive random testing (ART) prioritization techniques and involves much less time cost.

This letter presents a robust receiver using the generalized sidelobe canceller aided with the high-order derivative constraint technique for multicarrier code-division multiple-access (MC-CDMA) uplink against carrier frequency offset (CFO). Numerical results demonstrate the efficacy of the proposed receiver.