A low voltage stochastic flash ADC (analog-to-digital converter) is presented, with an inverter-based comparative unit which is used to replace comparator for comparison. Aiming at the low voltage and low power consumption, a key of our design is in the simplicity of the structure. The inverter-based comparative unit replacing a comparator enables us to decrease the number of transistors for area saving and power reduction. We insert the inverter-chain in front of the comparative unit for the signal stability and discuss an appropriate circuit structure for the resolution by analyzing three different ones. Finally, we design the whole stochastic flash ADC for verifying our idea, where the supply voltage can go down to 0.6V on the 65nm CMOS process, and through post-layout simulation result, we can observe its advantage visually in voltage, area and power consumption.

This paper presents a new asynchronous multiplier. The original array structure is divided into two asymmetric arrays, called an upper array and a lower array. For the lower array, Left to Right scheme is applied to take advantage of a fast computation and low power consumption as well. Simulation results show that the proposed multiplier has 40% of performance improvement with a relatively lower power consumption. The multiplier has been implemented in a CMOS 0.35 µm technology and proved functionally correct.

This paper describes a new algorithm for configuring the array of adders used to add the partial products in a multiplier circuit. The new algorithm reduces not only the number of half adders in an adder tree, but also the number of operands passed to the block generating the final product in a multiplier. The arrays obtained with this algorithm are smaller than Wallace's ones and have fewer outputs than Dadda's arrays. We show some evaluation figures and preliminary simulation results of 4, 8 and 16-bit tree configurations.

This report describes 4-2 compressors composed of Complementary Pass-Transistor Logic (CPL). We will show that circuit designs of the 4-2 compressors can be optimized for high speed and small size using only exclusive-OR's and multiplexers. According to a circuit simulation with 0.8µm CMOS device parameters, the maximum propagation delay and the average power consumption per unit adder are 1.32 ns and 11.6 pJ, respectively.