This paper proposes a novel quad-band branched monopole antenna with a filter. The proposed antenna has a simple configuration in which branch-elements are added to a basic configuration consisting of a mast and dielectric wires. The antenna is characterized by performances such as wideband impedance matching, gain stabilization, and gain enhancement. Wideband impedance characteristics satisfying the voltage standing ratio of less than 2 are obtained by exciting a parallel resonance at the lowest band and multi-resonance at high bands. The filter suppressing higher order modes is used for gain stabilization, so that averaged gains above 5dBi are obtained at the quad-band. The antenna has a high gain of 11.1dBi because the branch-elements work as an end-fire array antenna at the highest band. Furthermore, it is clarified that an operating frequency is switched by using a variable bandpass filter at the lowest band. Last, a scale model of the antenna is fabricated and measured, then the effectiveness of the proposed antenna is demonstrated.

Multiple-input multiple-output (MIMO) technology is a useful means of achieving the higher data rates needed in the latest wireless devices. However, weighting calculations for MIMO transmission become complicated when there are a large number of antennas. Thus, developing a simpler way to transmit and receive multiple streams is an idea worth considering. With this in mind, we propose a spatial division method using orthogonal directivities formed by using higher order modes of rectangular microstrip antennas. Each of them is formed by one antenna element so that channels are orthogonalized only by antennas. We verify antenna radiation characteristics by using higher order mode microstrip antennas and confirm that orthogonal directivities are obtained with them. Measurement of two stream transmission reveals that the method achieves almost the same channel capacity as that of an eigenmode-beamforming method because of the high multiplexing gain it achieves.

Active frequency-tuning beam-scanning leaky-mode antenna arrays have been demonstrated in this paper. These antennas integrated one or several microstrip leaky-wave antenna elements with a single varactor-tuned HEMT VCO as an active source. Noted that the measured scan angles of the 11 and 14 antennas were approximately 24 and the scanning range of the 12 antenna was 20. Furthermore, reflected wave due to the open end of each leaky-wave antenna element has been suppressed by the symmetric configuration of this antenna array and the antenna efficiency increases. When comparing with the measured radiation pattern of the single element antenna, we found that the 12 and 14 antenna arrays can effectively suppress the reflected power by more than 5.5 dB and 10.5 dB, respectively, at 10.2 GHz. The power gain are more than 2 dB and 3.16 dB higher than the single element antenna with a measured EIRP of 18.67 dBm.

Finite element analysis is carried out to provide an engineering design approach of a newly proposed Triple-TEM cell (TTEM cell). Important characteristics such as characteristic impedance, TEM mode field distribution, as well as TE and TM modes cutoff frequencies can be analyzed by using the software developed in this paper. Design guidelines have been provided for the TTEM cell. Reasonable geometric structure of the cross-sectional area of the TTEM cell would thereupon be resolved. Numerical results of the local higher order modes along the length of the cell are presented in this paper.