We propose an implementation of the tapped delay line adaptive array (TDLAA) at the base station for improving the BER performance of asynchronous multi-user mobile communication over fast fading channels using multiple antennas. The data of each user at the mobile station, which applies two transmit antennas, are encoded by Space Time Block Code (STBC). The proposed scheme transmits the pilot signal and information data in alternate time slots. We derive performance criteria for designing such a scheme under the assumption that the fading is classified as fast fading. We show that the proposed scheme can suppress co-channel interference (CCI) and defeat Doppler spread effectively.

To estimate the impact of electromagnetic disturbances on multi-carrier wireless systems, a method for converting an amplitude probability distribution (APD) of disturbance measured at a frequency to be valid for another frequency is presented. The conversion uses two parameters, the receiver noise power of the APD measuring equipment and a scale factor that can be estimated from a measured disturbance spectrum. The method is based on the assumption that the difference in measurement frequency affects only the relative scale of the probability distribution of band-limited disturbance amplitude, and is applicable to disturbances of practically importance such as 1) continuous or pulse-modulated wideband Gaussian noise, 2) disturbance with a much narrower bandwidth than receiver bandwidth B, and 3) repetitive short pulses with similar waveforms with an interval much longer than 1/B. The validity of the proposed method is examined by measurements of actual disturbances.

This paper proposes a combination of adaptive equalizer and Least Mean Square-RAKE (LMS-RAKE) combining scheme receiver system for Direct Sequence-Ultra Wideband (DS-UWB) multipath channel model. The main purpose of the proposed system is to overcome the performance degradation for UWB transmission due to the occurrence of Inter-Symbol Interference (ISI) during high speed transmission of ultra short pulses in a multipath channel. The proposed system improves the system performance by mitigating the multipath effect using LMS-RAKE receiver and suppressing the ISI effect with the adaptive equalizer. Simulation results verify that significant equalization gain can be obtained by the proposed system especially in UWB multipath channel models such as channel CM3 and channel CM4 that suffered severe ISI effect.

Impacts of electromagnetic (EM) interference (immunity) on operation of LSI circuits in a QFP-packaged and PCB-mounted environment are studied. EM power injection to a power-supply system leads to malfunction, where the power is translated into voltage bounces through combined on- and off- chip impedances, affecting power supply and ground, as well as signal nodes in a die, seen from on-chip waveform measurements. A lumped power-supply impedance model and the minimum amplitude of voltage bounce induced by EM power for malfunction, both of which can be derived from external measurements to a given packaged LSI, formulate an EM interference model that is helpful in the PCB design toward high immunity. The technique can be generally applied to systems-on-chip applications.

Efforts have been devoted to maximizing memory array densities. However, as the devices are scaled down in dimension and getting closer to each other, electrical interference phenomena among devices become more prominent. Various features of 3-D memory devices are proposed for the enhancement of memory array density. In this study, we mention 3-D NAND flash memory device having pillar structure as the representative, and investigate the paired cell interference (PCI) which inevitably occurs in the read operation for 3-D memory devices in this feature. Furthermore, criteria for setting up the read operation bias schemes are also examined in existence with PCI.

Conventional narrowband interference (NBI) rejection algorithms often assumed perfect pseudo-noise (PN) code synchronization. The functions of NBI rejection and code tracking are performed separately and independently by an adaptive filter and a code tracking loop, respectively. This paper presents two new receiver structures for direct sequence spread spectrum (DS/SS) systems, one operates in coherent mode and the other operates in noncoherent mode. Both receivers are designed to suppress NBI and minimize tracking jitter. Numerical results show that the proposed coherent receiver performs as good as the conventional receiver that uses an LMS NBI rejection filter with zero tracking jitter. The noncoherent receiver, when compared with the coherent one, suffers less than 3 dB degradation for bit error probability smaller than 10-3.

This paper proposes a new parameter estimation method for the MIMO-OFDM MAP receiver with spatial-temporal filters. The proposed method employs eigenvalue decomposition (EVD) so as to attain precise estimates especially under interference-limited conditions in MIMO-OFDM mobile communications. Recursive EVD is introduced to reduce the computational complexity compared to the nonrecursive EVD. The spatial-temporal prewhitening is placed prior to FFT because this arrangement is superior to that of conventional prewhitening posterior to FFT in accuracy of the parameter estimation. In order to improve tracking capability to fast fading, the proposed scheme applies a decision-directed algorithm to the parameter estimation by using log-likelihood ratios of coded bits. Computer simulations demonstrate that the proposed scheme can track fast fading and reduce the complexity to 18 percents of the conventional one, and that the spatial-temporal filtering prior to FFT outperforms the conventional one posterior to FFT.

Digital TV (DTV) protection from the potential interference caused to a communication system using the cognitive radio (CR) technologies is so important for the frequency sharing between a DTV station and a communication system. In this letter, two results of the interference analysis at the co-channel bandwidth of 6 MHz are provided. One is the requirement of the protection ratio (PR) to a DTV station, which means the received signal strength of a DTV station to the interfering signal strength of a communication system ratio. The other shows the interference effect to the service area of a DTV station, when the transmit power of a communication system is either 100 W or 4 W, and the PR of a DTV station is 15 dB. Their results describe that an interferer's transmit power should be limited, because of protecting DTV station and sharing co-channel frequencies.

We propose a new broadcast strategy for a multiple-input multiple-output (MIMO) system with N transmit antennas at the transmitter and M≤N single antenna receivers. The proposed method, based on dirty-paper coding (DPC), spatially separates the M users but does not suffer from the power loss of classical spatial division multiple access (SDMA). For the special case of M=N=2 and when the two single antenna receivers are assumed to be co-located, the proposed scheme produces a 2 transmit, 2 receiver antenna MIMO transmission system that doubles the symbol rate of MIMO space-time block code (STBC) systems from one to two symbol per transmission time. It is proved theoretically and experimentally that the proposed scheme provides the same performance level as that of MIMO STBC systems (i.e., the Alamouti scheme) for the first symbol, and the same performance as the Bell labs layered space-time (BLAST) system for the second symbol. When compared to the BLAST system, the proposed scheme has the same symbol rate, but achieves significantly better performance, since it provides 2 level diversity per symbol on the first symbol while the BLAST system does not provide any diversity.

In this paper, an architecture of MIMO mesh network which avoids co-channel interference and supplies link multiplexing simultaneously, namely MIMO spatial spectrum sharing, is proposed. As a MIMO transmission scheme, linear (such as zero-forcing) and nonlinear (such as dirty paper coding and successive interference cancellation) MIMO algorithm are developed for the proposed mesh network. It is found from numerical analysis that the proposed MIMO mesh network achieves significantly higher channel capacity than that of conventional mesh networks.

In a Cognitive Radio system, it is essential to recognize and avoid sources of interference signals. This paper describes a study on a location sensing scheme for interference signals, which utilizes multi-beam phased array antenna for cognitive wireless networks. This paper also elucidates its estimation accuracy of the interference location for the radio communication link using an OFDM signal such as WiMAX. Furthermore, we use the frequency spectrum of the received OFDM interference signal, to create a method that can estimate the propagation status. This spectrum can be monitored by using a software defined radio receiver.

Cognitive radio, which utilizes the radio frequency spectrum efficiently by recognizing radio resource availability, is an attractive technology for overcoming the shortage of radio frequency. From the perspective of networking, cognitive radio technologies are also useful since they allow flexible network construction. This paper proposes base station networks using cognitive radio technologies. In order to achieve efficient utilization of the radio frequency spectrum and flexible network construction, we also propose a topology management and route control method for our proposed base station network. Our method shares the status of the wireless links along with topology information and establishes routes by using this information. Through simulation, we evaluate that our method significantly improves the throughput by efficient utilization of the radio frequency spectrum. Moreover, we demonstrate that our method works well when the size of the network gets larger.

In this letter, we propose that directional antennas, combined with power management, be incorporated to reduce intersystem interference in a shared band overlaid high altitude platform station (HAPS)-terrestrial code division multiple access (CDMA) system. To eliminate the HAPS to terrestrial interference, the HAPS is accessed only via directional antennas under the proposed scheme. By doing so, the uplink power to the HAPS can accordingly be increased, so that the terrestrial to HAPS interference is also effectively suppressed.

A low complexity minimum mean squared error (MMSE) equalizer for orthogonal frequency division multiplexing (OFDM) systems over time-varying channels is presented. It uses a small matrix of dominant partial channel information and recursive calculation of matrix inverse to significantly reduce the complexity. Theoretical analysis and simulations results are provided to validate its significant performance or complexity advantages over the previously published MMSE equalizers.

Reliable detection of other radio systems is crucial for systems that share the same frequency band. In wireless communication channels, there is uncertainty in the received signal level due to multipath fading and shadowing. Cooperative sensing techniques in which radio stations share their sensing information can improve the detection probability of other systems. In this paper, a new cooperative sensing scheme that reduces the false detection probability while maintaining the outage probability of other systems is investigated. In the proposed system, sensing information is collected using multi-hop transmission from all sensing stations that detect other systems, and transmission decisions are based on the received sensing information. The proposed system also controls the transmit power based on the received CINRs from the sensing stations. Simulation results reveal that the proposed system can reduce the outage probability of other systems, or improve its link success probability.

This paper proposes a novel Orthogonal frequency-division multiplexing (OFDM) system based on polynomial cancellation coded OFDM (PCC-OFDM). This proposed system can reduce peak-to-average power ratio (PAPR) by our neural phase rotator and it does not need any side information to transmit phase rotation factors. Moreover, this system can compensate the common phase error (CPE) by a proposed technique which allows estimating frequency offset at receiver. From numerical experiments, it is shown that our system can reduce PAPR and ICI at the same time and improve BER performance effectively.

In this paper, we propose an adaptive guard symbol insertion method for one-cell reuse TDMA cellular systems in which co-channel interference is reduced by adaptively selecting the best transmit-pulse waveform with different guard (null-) symbols according to the average error power (AEP) corresponding to signal-to-interference and noise power ratio (SINR), even though the same frequency channel is used at all base stations. Using the proposed system, current TDMA-based systems are readily extensible to one-cell reuse systems, which achieves higher spectrum efficiency. The system capacity is enhanced using the proposed method; moreover, the required qualities such as blocking probability and outage probability are retained.

A training-based vector channel estimation method has been proposed for single-user code-division multiple access (CDMA) systems in fast-varying correlated multipath fading channels. In this paper, we extend it in an iterative way to multiuser multiple-input multiple-output (MIMO) CDMA systems where both the transmitter and receiver have multiple antennas. In the training period, we propose to add the minimum mean square error (MMSE) front end before channel estimation to suppress multiuser interference (MUI) from substreams with difference spreading codes, so then we can get good initial vector channel estimation for each user. In the data transmission period, we proposed to add MMSE/parallel interference cancellation (PIC) front end to suppress MUI, interference suppression, and vector channel estimation in an iterative way. The perfect channel estimation is assumed in Liu et al., and the inter-play between channel estimation and multiuser detection is not discussed either. On the contrary, the novelty of the proposed method is that we add MMSE/PIC front end (in addition to matched filter) before channel estimation and we repeatedly switch between MMSE/PIC front end and channel estimation.

In this paper, the performance of narrow band interference (NBI) rejection scheme for direct sequence spread spectrum (DS/SS) is analyzed. A 2-tapped complex FIR filter is used for filtering a chip code to suppress NBI. In this system, the spectrum of transmitted signal has a null at an arbitrary frequency. By choosing filter coefficients, the authors place this null at NBI center frequency to mitigate the effect of NBI. In this paper, an OFDM signal is considered as NBI. The performance of this scheme is theoretically analyzed by introducing Queueing model, and validated via simulation.

A novel low-complexity iterative receiver for coded multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems is proposed in this letter. The iterative receiver uses the parallel interference cancellation (PIC)-maximum ratio combining (MRC) detector for MIMO-OFDM detection, which is a popular alternative to the minimum mean square error (MMSE) detector due to its lower computational complexity. However, we have found that the conventional PIC-MRC detector tends to underestimate the magnitude of its output log likelihood ratios (LLRs). Based on this discovery, we propose to multiply these LLRs by a constant factor, which is optimized according to the extrinsic information transfer (EXIT) chart of the soft-in soft-out (SISO) detector. Simulation results show that the proposed scheme significantly improves the performance of the PIC-MRC-based receiver with little additional cost in computational complexity, allowing it to closely approach the performance of receiver using the much more complex MMSE detector.