We propose a noise suppression algorithm with the Kalman filter theory. The algorithm aims to achieve robust noise suppression for the additive white and colored disturbance from the canonical state space models with (i) a state equation composed of the speech signal and (ii) an observation equation composed of the speech signal and additive noise. The remarkable features of the proposed algorithm are (1) applied to adaptive white and colored noises where the additive colored noise uses babble noise, (2) realization of high performance noise suppression without sacrificing high quality of the speech signal despite simple noise suppression using only the Kalman filter algorithm, while many conventional methods based on the Kalman filter theory usually perform the noise suppression using the parameter estimation algorithm of AR (auto-regressive) system and the Kalman filter algorithm. We show the effectiveness of the proposed method, which utilizes the Kalman filter theory for the proposed canonical state space model with the colored driving source, using numerical results and subjective evaluation results.

With the rapid advances in wireless network communication, multimedia presentation has become more applicable. However, due to the limited wireless network resource and the mobility of Mobile Host (MH), QoS for wireless streaming is much more difficult to maintain. How to decrease Call Dropping Probability (CDP) in multimedia traffic while still keeping acceptable Call Block Probability (CBP) without sacrificing QoS has become an significant issue in providing wireless streaming services. In this paper, we propose a novel Dynamic Resources Adjustment (DRA) algorithm, which can dynamically borrow idle reserved resources in the serving cell or the target cell for handoffing MHs to compensate the shortage of bandwidth in media streaming. The experimental simulation results show that compared with traditional No Reservation (NR), and Resource Reservation in the six neighboring cells (RR-nb), and Resource Reservation in the target cell(RR-t), our proposed DRA algorithm can fully utilize unused reserved resources to effectively decrease the CDP while still keeping acceptable CBP with high bandwidth utilization.

Mesh networking technologies for both high-rate and low-rate wireless personal area networks (WPANs) are under development by several standardization bodies. They are considering to adopt distributed TDMA MAC protocols to provide seamless user mobility as well as a good peer-to-peer QoS in WPAN mesh. It has been, however, pointed out that the absence of a central controller in the wireless TDMA MAC may cause a severe performance degradation: e.g., fair allocation, service differentiation, and admission control may be hard to achieve or can not be provided. In this paper, we suggest a new framework of resource allocation for the distributed MAC protocols in WPANs. Simulation results show that our algorithm achieves both a fair resource allocation and flexible service differentiations in a fully distributed way for mesh WPANs where the devices have high mobility and various requirements. We also provide an analytical modeling to discuss about its unique equilibrium and to compute the lengths of reserved time slots at the stable point.

Recently, there has been extensive research on resource allocation schemes for multicast services that would satisfy the requirements of multimedia traffic. Although several schemes have been proposed to improve the performance of individual multicast groups, it is not easy to achieve both throughput efficiency and user fairness. In this study, we propose a new multicast scheduling scheme for achieving proportional fair (PF) allocation in wireless cellular systems. The basic idea of PF is to schedule the user whose corresponding instantaneous channel quality is the highest relative to the average channel condition over a given time scale. We first extend the PF metric to the extent that the scheduler can reflect the user's varying channel gain, and fairness, not only in the unicast case, but also in multicast transmissions. A multicast PF scheme maximizes the summation of the logarithmic average rate of all multicasting users. Thus, it improves the fairness to mobile users when compared to max-rate allocation, because the logarithmic rate gives more weight to lower rate users, while achieving high throughput. Moreover, the proposed scheme is less complex than max-rate allocation.

This paper describes 10-bit, 80-MSample/s pipelined A/D converters for wireless-communication terminals. To reduce power consumption, we employed the I/Q amplifier sharing technique [1] in which an amplifier is used for both I and Q channels. In addition, common-source, pseudo-differential (PD) amplifiers are used in all the conversion stages for further power reduction. Common-mode disturbances are removed by the proposed common-mode feedforward (CMFF) technique without using fully differential (FD) amplifiers. The converter was implemented in a 90-nm CMOS technology, and it consumes only 24 mW/ch from a 1.2-V power supply. The measured SNR and SNDR are 58.6 dB and 52.2 dB, respectively.

In the subcarrier and power allocation schemes in Multi-Input Multi-Output and Orthogonal Frequency Division Multiple Access (MIMO-OFDMA) systems, only equal fairness among users has been considered and no scheme for proportional data rate fairness has been considered. In this paper, a subcarrier, bit and power allocation scheme is proposed to maximize the total throughput under the constraints of total power and proportional data rate fairness among users. In the proposed scheme, joint subchannel allocation and adaptive bit loading is firstly performed by using singular value decomposition (SVD) of channel matrix under the constraint of users' data throughput requirements, and then adaptive power loading is applied. Simulation results show that effective performance of the system has been improved as well as each throughput is proportionally distributed among users in MIMO-OFDMA systems.

The Project Authorization Request (PAR) for the IEEE P1900.4 Working Group (WG), under the IEEE Standards Coordinating Committee 41 (SCC41) was approved in December 2006, leading to this WG being officially launched in February 2007 [1]. The scope of this standard is to devise a functional architecture comprising building blocks to enable coordinated network-device distributed decision making, with the goal of aiding the optimization of radio resource usage, including spectrum access control, in heterogeneous wireless access networks. This paper introduces the activities and work under progress in IEEE P1900.4, including its scope and purpose in Sects. 1 and 2, the reference usage scenarios where the standard would be applicable in Sect. 4, and its current system architecture in Sect. 5.

In this letter, we propose an efficient resource allocation scheme that improves the system performance by reducing the signaling overhead for voice over Internet protocol (VoIP) services in the IEEE 802.16e OFDMA system. We theoretically analyze the performance of the proposed allocation scheme and carry out a computer simulation to evaluate the FA scheme.

We propose a neurodynamical approach to a large-scale optimization problem in Cognitive Wireless Clouds, in which a huge number of mobile terminals with multiple different air interfaces autonomously utilize the most appropriate infrastructure wireless networks, by sensing available wireless networks, selecting the most appropriate one, and reconfiguring themselves with seamless handover to the target networks. To deal with such a cognitive radio network, game theory has been applied in order to analyze the stability of the dynamical systems consisting of the mobile terminals' distributed behaviors, but it is not a tool for globally optimizing the state of the network. As a natural optimization dynamical system model suitable for large-scale complex systems, we introduce the neural network dynamics which converges to an optimal state since its property is to continually decrease its energy function. In this paper, we apply such neurodynamics to the optimization problem of radio access technology selection. We compose a neural network that solves the problem, and we show that it is possible to improve total average throughput simply by using distributed and autonomous neuron updates on the terminal side.

Various wireless systems are being developed to meet users' needs, and the rapid increase in frequency demand that accompanies the increasing popularity of wireless services means that more effective use of frequency resources is urgently needed. However, existing base stations are making no effort to use frequency resources effectively, and cooperation among wireless system base stations is needed to use frequency resources more effectively. Base stations can cooperate more efficiently if they are able to use multiple channels of many wireless systems simultaneously. We propose an autonomous adaptive base station (AABS) that can switch among various wireless systems the way software defined radio (SDR) base stations do. AABS can autonomously select and use the most suitable wireless system on the basis of user traffic and its hardware resources. Moreover, frequency resources are used effectively because AABS prevents unnecessary radio wave transmission when the number of users in the wireless systems decreases. AABS is also suitable for "multi-link communication" because it can use multiple channels of multiple wireless systems simultaneously. We developed AABS prototype and evaluated its performance. Our experimental and computer simulation results show the performance of AABS and its efficiency.

FeedForward (FF-) Blind Source Separation (BSS) systems have some degree of freedom in the solution space. Therefore, signal distortion is likely to occur. First, a criterion for the signal distortion is discussed. Properties of conventional methods proposed to suppress the signal distortion are analyzed. Next, a general condition for complete separation and distortion-free is derived for multi-channel FF-BSS systems. This condition is incorporated in learning algorithms as a distortion-free constraint. Computer simulations using speech signals and stationary colored signals are performed for the conventional methods and for the new learning algorithms employing the proposed distortion-free constraint. The proposed method can well suppress signal distortion, while maintaining a high source separation performance.

Assuming there are short time periods in which only one source is active, a new approach for source separation is proposed. An affine projection adaptation algorithm with a non-orthogonal constraint shows excellent noise immunity, a high convergence rate, and good tracking capability to efficiently obtain a solution to the separation filters.

High power consumption is a constraining factor for the growth of programmable logic devices. We propose two techniques in order to reduce power consumption. The first is a technique for creating contexts. This technique uses data-dependent circuits and wire sharing between contexts. The second is a technique for switching the contexts. In this paper, we evaluate the capability of the two techniques to reduce power consumption using a multi-context logic device. As a result, as compared with the original circuit, our multi-context circuits reduced the power consumption by 9.1% on an average and by a maximum of 19.0%. Furthermore, applying our resource sharing technique to these circuits, we achieved a reduction of 10.6% on an average and a maximum reduction of 18.8%.

Simple-relay aided resource allocation (SRARA) schemes are incorporated with throughput guarantee scheduling (TGS) in IEEE 802.16 type time division duplex--orthogonal frequency division multiple access (TDD-OFDMA) downlink in order to enhance service coverage, where the amount of resources at each relay is limited due to either its available power which is much smaller than base station (BS) power or the required overhead. The performance of SRARA schemes is evaluated with both proportional fair (PF) and TGS schedulers at 64 kbps and 128 kbps user throughput requirements when total RS power is set to 500 mW or 1 W. For SRARA with RSs of relatively lower power (500 mW), schemes that put total power into only one subchannel offer larger coverage than when both subchnnels are used with equal power allocation, while the RS with evenly power-allocated two subchannels could provide larger coverage gain for a relatively higher power (1 W). Depending upon the target throughputs it is shown which of the relay scheme or scheduler design would play more important role in improving coverage. In a lower target (64 kbps), more improvement comes from relay scheme rather than scheduler design. For a relatively higher level (128 kbps), it comes from scheduler design rather than relay due to the fact that simple relay can't help using strictly limited amount of resources.

The time division duplex cellular system can support various downlink and uplink traffic ratios by setting the downlink and uplink transmission periods appropriately. However, it causes severe co-channel interference problem when some cells are active in the downlink while the others are in the uplink [2]. To mitigate this problem, a resource allocation scheme combined with sectorization is proposed for orthogonal frequency division multiple access. Simulations demonstrate that the proposed scheme improves both spectral efficiency and outage performance compared to the conventional allocation schemes.

This paper describes IP encapsulation technologies for the Mobile RSVP tunnel in next generation networks. Bandwidth is inherently a scarce network resource, and hence signaling overhead should be minimized as much as possible. However, because of duplicate RSVP messages, the existing RSVP tunnel-based mechanism suffers from bandwidth overhead and tunnel problems. The waste of network resources prevents low-cost network construction and the maximization of integrated network utility, which are the goals of next generation networks, and can lower the reliability of networks with the increase of service subscribers and resultant expansion of resource consumption. To solve these problems and to support end-to-end QoS efficiently, RSVP needs to be changed at a minimum degree. In this paper, a new IP encapsulation mechanism for saving of network resources in the Mobile RSVP tunnel (IPEnc-RSVP) is proposed. In order to compare the proposed mechanism and the existing RSVP tunnel-based mechanism in Mobile IP-based networks, we perform a comparative analysis of bandwidth consumption gain, throughput, mean packet delay, etc., and demonstrate the superiority of the proposed mechanism. In addition, we analyze several performance factors of RSVP protocols by applying the existing RSVP tunnel-based mechanism and the proposed mechanism, respectively.

The objective of this paper is to analyze a pull type multi-product, multi-line and multi-stage flexible manufacturing system whose resources are subject to planned and unplanned breakdown conditions. To ensure a continual supply of the finished products, under breakdown conditions, parts/materials flow through alternate routes exhibiting routing flexibility. The machine resources are flexible in this study and are capable of producing more than one item. Every machining and assembly station has been equipped with automated inspection units to ensure the quality of the products. The system is modelled through coloured Petri net methodology and the impact of input factors have been shown on the performance of the system. The study has been extended to explore near-optimal conditions of the system using design of experiment and response surface methods.

The antidictionary of a string is the set of all words of minimal length that never appear in this string. Antidictionaries are in particular useful for source coding. We present a fast and memory-efficient algorithm to construct an antidictionary using a suffix tree. It is proved that the complexity of this algorithm is linear in space and time, and its effectiveness is demonstrated by simulation results.

We have built a CLQA (Cross Language Question Answering) system for a source language with limited data resources (e.g. Indonesian) using a machine learning approach. The CLQA system consists of four modules: question analyzer, keyword translator, passage retriever and answer finder. We used machine learning in two modules, the question classifier (part of the question analyzer) and the answer finder. In the question classifier, we classify the EAT (Expected Answer Type) of a question by using SVM (Support Vector Machine) method. Features for the classification module are basically the output of our shallow question parsing module. To improve the classification score, we use statistical information extracted from our Indonesian corpus. In the answer finder module, using an approach different from the common approach in which answer is located by matching the named entity of the word corpus with the EAT of question, we locate the answer by text chunking the word corpus. The features for the SVM based text chunking process consist of question features, word corpus features and similarity scores between the word corpus and the question keyword. In this way, we eliminate the named entity tagging process for the target document. As for the keyword translator module, we use an Indonesian-English dictionary to translate Indonesian keywords into English. We also use some simple patterns to transform some borrowed English words. The keywords are then combined in boolean queries in order to retrieve relevant passages using IDF scores. We first conducted an experiment using 2,837 questions (about 10% are used as the test data) obtained from 18 Indonesian college students. We next conducted a similar experiment using the NTCIR (NII Test Collection for IR Systems) 2005 CLQA task by translating the English questions into Indonesian. Compared to the Japanese-English and Chinese-English CLQA results in the NTCIR 2005, we found that our system is superior to others except for one system that uses a high data resource employing 3 dictionaries. Further, a rough comparison with two other Indonesian-English CLQA systems revealed that our system achieved higher accuracy score.

Synchronization has gained attention in science recently. In electrical engineering, a power network requires generators and loads to be in synchronization. The increase in distributed dc power sources without sophisticated controls has made synchronization more difficult. This paper proposes a synchronous inverter designed for linking distributed power sources within a power network. The linkage inverters should have high confidential characteristics to keep the network stable. The frequency and phase synchronization between synchronous generators in power network has been acheived through power transmission systems. The synchronous inverters contribute in the development of the sophisticated power networks by providing distributed power sources that maintain synchronous operation.