It is known that in the selected mapping (SLM) scheme for orthogonal frequency division multiplexing (OFDM), correlation (CORR) metric outperforms the peak-to-average power ratio (PAPR) metric in terms of bit error rate (BER) performance. It is also well known that four times oversampling is used for estimating the PAPR performance of continuous OFDM signal. In this paper, the oversampling effect of OFDM signal is analyzed when CORR metric is used for the SLM scheme in the presence of nonlinear high power amplifier. An analysis based on the correlation coefficients of the oversampled OFDM signals shows that CORR metric of two times oversampling in the SLM scheme is good enough to achieve the same BER performance as four times and 16 times oversampling cases. Simulation results confirm that for the SLM scheme using CORR metric, the BER performance for two times oversampling case is almost the same as that for four and 16 times oversampling cases.

This paper presents a Maximum Likelihood Location Estimation (MLLE) algorithm for the home network environments. We propose a deployment of cluster-tree topology in the ZigBee networks and derive the MLE under the log-normal models for the Received Signal Strength (RSS) measurements. Experiments are also conducted to validate the effectiveness of the proposed algorithm.

We propose a polynomial-time algorithm for the scheduling of real-time parallel tasks on multicore processors. The proposed algorithm always finds a feasible schedule using the minimum number of processing cores, where tasks have properties of linear speedup, flexible preemption, arbitrary deadlines and arrivals, and parallelism bound. The time complexity of the proposed algorithm is O(M3log N) for M tasks and N processors in the worst case.

The performance of ultra-wideband (UWB) multiple input multiple output (MIMO) receiver based on the RAKE maximal ratio combiner (MRC) followed by a zero forcing (ZF) detector is analytically examined. For a UWB MIMO system with NT transmit antennas, NR receive antennas, and L resolvable multipath components, the proposed MIMO detection scheme is shown to have the diversity order of LNR-NT+1 and its analytical error rate expression is presented in a log-normal fading channel. We also compare the analytical BERs with the simulated results.

This paper introduces a packet forwarding scheme based on interworking architecture that can provide quite a good QoS by minimizing processing delay which is the major part of the timeliness factor in New Generation IP-based networks. Based on path and resource reservation mechanism, the POSIA makes routers on the packet forwarding path synchronize with each other and then forward packets. We have shown that the POSIA outperforms the existing packet forwarding schemes like IntServ, DiffServ and MPLS through computer simulations using OPNET.

This paper proposes a new on-chip linearizer self-adapting to the input power and its implementation to high linear monolithic microwave integrated circuit (MMIC) power amplifier for 1.95 GHz wide-band code division multiple-access (W-CDMA) system. The linearizer consists of InGaP/GaAs heterojunction bipolar transistor (HBT) active bias circuit and reverse biased junction diode of which dynamic admittance to input power level functions adaptively to control the bias to the amplifier. The proposed linearizer has little insertion power loss, and more importantly, it consumes no additional die area and DC power. The HBT MMIC power amplifier with the integrated linearizer exhibits a maximum output power of 30.3 dBm, a power gain of 27.5 dB, a power added efficiency of 42% at the maximum output power under an operation voltage of 3.4 V, and adjacent channel leakage power ratio of -38 dBc at 27 dBm of output power.

The classical 4-phase constant-amplitude zero-autocorrelation (CAZAC) sequence with the length of 16 has been used for multifarious purposes such as channel estimation and frequency/timing synchronizations since it presents good performance even in low signal to noise ratio (SNR) conditions. However, as multiple transmit antennas are employed, its properties are easily destroyed by the effect of multipath. In this letter, we propose a technique which ensures that the conventional CAZAC sequence is reliable in a multi-antenna system by inserting nulls. The performance of the modified sequence is verified through the mean s quare error (MSE) performance with the least squares (LS) method.

Although shared caches allow the dynamic allocation of limited cache capacity among cores, traditional LRU replacement policies often cannot prevent negative interference among cores. To address the contention problem in shared caches, cache partitioning and application scheduling techniques have been extensively studied. Partitioning explicitly determines cache capacity for each core to maximize the overall throughput. On the other hand, application scheduling by operating systems groups the least interfering applications for each shared cache, when multiple shared caches exist in systems. Although application scheduling can mitigate the contention problem without any extra hardware support, its effect can be limited for some severe contentions. This paper proposes a low cost solution, based on application scheduling with a simple cache insertion control. Instead of using a full hardware-based cache partitioning mechanism, the proposed technique mostly relies on application scheduling. It selectively uses LRU insertion to the shared caches, which can be added with negligible hardware changes from the current commercial processor designs. For the completeness of cache interference evaluation, this paper examines all possible mixes from a set of applications, instead of using a just few selected mixes. The evaluation shows that the proposed technique can mitigate the cache contention problem effectively, close to the ideal scheduling and partitioning.

This letter presents results showing improved field uniformity in a reverberation chamber using quadratic residue diffusers. The optimal occupying ratio of the diffusers on one side wall of the chamber is presented. A reverberation chamber is an alternative to the semi-anechoic chamber, which is widely used for the analysis and measurement of electromagnetic interference and immunity. To analyze the field characteristics, quadratic residue diffusers were designed for the 1-3 GHz frequency band, and the FDTD method was used. At 1-3 GHz, the standard deviation of the test volume in the reverberation chamber was investigated. The reverberation chamber had good field uniformity when quadratic residue diffusers occupy 37.5-50% of one side wall of the reverberation chamber; the field uniformity saturated at the diffuser occupancy rate of 75%.

In this letter, we consider a novel ultra-wideband (UWB) spatial multiplexing (SM) multiple input multiple output (MIMO) structure, which consists of prerake diversity combiners in the transmitter and a zero forcing (ZF) detector in the receiver. For a UWB SM MIMO system with N transmit antennas, M receive antennas, and L resolvable multipath components, it is shown that the proposed prerake combining-based MIMO detection scheme has the diversity order of (LN-M+1) and its BER performance is analytically presented in a log-normal fading channel and also compared with that of a rake combining-based ZF scheme.

A high efficient HBT MMIC power amplifier with a new on-chip bias control circuit was proposed for PCS applications. By adjusting the quiescent current in accordance with the output power levels, the average power usage efficiency of the power amplifier is improved by a factor of 1.4. The bias controlled power amplifier, depending on low (high) output power levels, shows 62(103) mA of quiescent current, 16(28) dBm output power with 7.5(35.4)% of power-added efficiency(PAE), -46(-45) dBc of adjacent-channel power ratio (ACPR), and 23.7(26.9) dB of gain

In loudspeaker-based 3D audio systems, there are some acoustic crosstalk cancellation methods to enlarge the 'sweet spot' around a fixed listener position. However, these methods have common defect that most of them can be applied only to the specific narrow frequency band. In this letter, we propose the more robust acoustic crosstalk cancellation method so that we can cancel the crosstalk signal in far wider frequency band and enlarge 'sweet spot. ' For this goal, we apply a sum and difference filter to the conventional three loudspeaker-based 3D audio system.

This paper presents a heuristic algorithm that minimizes the delay of the given circuit through a two-pass cell selection in cell-based design. First, we introduce a new graph, called candidate web, which conveniently represents all cell combinations available for the implementation of the given circuit. We, then, present an efficient method to obtain a tentative set of optimal cells, while estimating the delay of the longest path between each cell and the primary output on the candidate web. In this step, multiple cells are allowed to bind the same logic gate. Finally, we describe how the proposed approach actually selects the optimal cells from the tentative set, which would minimize the circuit delay. Experimental results on a set of benchmarks show that the proposed approach is effective and efficient in minimizing the delay of the given circuit.

This paper proposes a new codec design method based on JPEG for face images and presents its application to face recognition. Quantization table is designed using the R-D optimization for the Yale face database. In order to use in the embedded systems, fast codec design is also considered. The proposed codec achieves better compression rates than JPEG codec for face images. In face recognition experiments using the linear discriminant analysis (LDA), the proposed codec shows better performance than JPEG codec.

The non-individualized head related transfer function (HRTF) is known to have a few problems, which are referred to as the 'hole in the middle' phenomenon and 'front-back reversals.' To overcome these problems, an HRTF refinement technique was introduced, but unfortunately, this refinement technique causes sudden degradation in sound quality and difficulty in cross-talk cancellation because of notch frequency exaggeration. In this paper, an HRTF refinement using directional weighting function is proposed. This newly proposed technique weights ordinary HRTF according to its direction to amplify frontal sound intensity. Since the proposed technique does not exaggerate the notch frequency, spectral differences in the 'cone-of-confusion' region become more pronounced within overall audible frequencies, resulting in mitigating the sound degradation. In addition, the cross-talk cancellation can be done more easily. We verified the superiority of the proposed technique over the existing one by means of the sound localization and sound quality tests in headphone and loudspeakers.

The electrostatic characteristics of broadside-coupled striplines in a shield are investigated with the mode-matching method. The Fourier series is employed to describe electrostatic potential distributions. Numerical results are shown for coupled transmission line cell applications.

A low-power switching method using a bootstrapping circuit is proposed for a high-speed output driver of transmitter. Compared with a conventional output driver, the proposed scheme employs only nMOSFETs to transmit data. The bootstrapping circuit ensures the proper switching of nMOSFET. The proposed scheme is simulated and fabricated using a 0.18 µm CMOS technology, showing 10.2% lower power consumption than a conventional switching driver at 2.5 Gb/s data rate.

Recently much attention is being devoted to a femtocell's potential for improving indoor cellular coverage with the provision of high data rate services in a wireless environment. Femtocells are usually deployed in homes and buildings and overlay existing macrocells, or microcells which cover wider service areas. In such an overlaid network structure, one of the important issues in network planning is the analysis of system capacity achievable by femtocells, which could be significantly affected by indoor radio propagation properties. This paper addresses a typical environmental scenario where a detailed indoor radio propagation model can be adopted. Moreover, a performance evaluation of embedded femteocell networks reflecting various environmental scenarios and factors is provided by the metrics of outage probability, dynamic range of spectral efficiency, and required separation distances for various wall structures, distance, and the number of walls between the home femtocell and the user. Our computer simulation and numerical analysis indicate an outage probability of 1%∼58%, dynamic range of spectral varies from around 2.2 to 7, while the required separation from the macrocell station is 25 m ∼ 327 m. This information could be useful for femtocell network planning.

In this paper, an effective congestion control algorithm is proposed to increase the end-to-end delivery success ratio of upstream traffic by reduction of buffer drop probabilities and their deviation in wireless sensor networks. According to the queue length of parent and child nodes, each child node chooses one of the parents as the next hop to the sink and controls the delay before transmission begins. It balances traffics among parents and mitigates congestion based on congestion level of a node. Simulation results show that the proposed algorithm reduces buffer drop probabilities and their deviation and increases the end-to-end delivery success ratio in wireless sensor networks.

For V-band applications, this paper presents a fully embedded multi-layer dielectric waveguide filter (DWGF) with very low insertion loss and small size, which does not need any more assemblies such as flip-chip bonding and bond wires. The top and bottom plane are grounded, and therefore, although we make a metal housing, there will be no resonance occurrences. Especially, the proposed structure is very suitable for MMICs interconnection because the in/output pads consist of conductor backed co-planar waveguide (CBCPW). The filter is formed incorporating metallized through holes in low temperature co-fired ceramic (LTCC) substrates with relative dielectric constant of 7.05. The total volume of the filter including transitions is 4.5 mm2.65 mm0.4 mm. A fabricated DWGF with four transitions shows an insertion loss and a return loss of 2.95 dB and less than 15 dB at the center frequency of 62.17 GHz, respectively. According to the authors' knowledge, the proposed filter shows the lowest insertion loss among the embedded multi-layer millimeter-wave filters ever reported for 60 GHz applications.