A high-speed serial, 10-Gb/s, passive optical network (PON) is a good candidate for a future PON system. However, there are several issues to be solved in extending the physical speed to 10 Gb/s. The issues focused on here are not only the data rate, which is eight times higher than that of a conventional GE-PON, but also the instantaneous amplification and synchronization of AC-coupling burst-input data without a reset signal. An input amplifier with data-edge detection can both detect level-varying input due to AC-coupling and respond to the first bit of a burst packet. Another issue discussed here is tolerance to long consecutive identical digits (CIDs). A burst-mode clock-and-data recovery (CDR) using dual gated VCOs (G-VCOs) is designed for 10-Gb/s operation. The relation between the frequency difference of the dual G-VCOs and CID tolerance is derived with a frequency tunable G-VCO circuit. The burst-mode CDR IC is implemented in a 0.13-µm CMOS process. It successfully operates at a data rate of 10.3125 Gb/s. The CDR IC using the edge-detection input amplifier and the G-VCO CDR core achieves amplification and synchronization in 0.2 ns with AC-coupling without a reset signal. The IC also demonstrates 1001 bits of CID tolerance, which is more than enough tolerance for 65-bit CIDs in the 64B/66B code of 10 Gigabit Ethernet. Measured data suggest that dual G-VCOs on a die have over a 20-MHz frequency difference and that the frequency adjusting between the G-VCOs is effective for increasing CID tolerance.

We developed a compact, 16-channel integrated optical subscriber module for one-fiber bi-directional optical access systems. They can support more subscribers in a limited mounting space. For ultimate compactness, we created 8-channel integrated super-compact optical modules, 4-channel integrated limiting amplifiers, and 4-channel integrated LD drivers for Fast Ethernet. We introduce a new simulation method to analyze the electrical crosstalk that degrades sensitivity of the optical module. A new IC architecture is applied to reduce electrical crosstalk. We manufactured the optical subscriber module with these optical modules and ICs. Experiments confirm that the module offers a sensitivity of -27.3 dBm under 16-channel 125 Mbit/s simultaneous operation.

Fiber-optic passive double star (PDS) network is described as an access network for microcellular radio communication systems. The intrinsic characteristics of the PDS network, reduction in the optical fiber count and flexible access capability, are examined. A unit cell structure is introduced which enables the PDS network to be effectively incorporated into the access portion of microcellular radio communication systems. The reduced total fiber length in the unit cell structure based on the PDS network is discussed in comparison with the conventional architecture. Calculations show that there is an optimum splitting ratio that minimizes the total fiber length. When the microcell radius and service area radius are 100m and 10km, respectively, the total fiber length of the PDS network is reduced to only about 9% of that of the conventional single star (SS) network for a splitting ratio of 34. Resource sharing and handover between microcells in a unit cell are performed by using the dynamic channel allocation function of the PDS system. Substantial performance improvement for loaded traffic can be obtained by resource sharing. When the splitting ratio is 32, the available traffic of a base station (BS) increases from 0.9 [erl/BS] to 3.4 [erl/BS] by adopting dynamic channel allocation for the lost call probability of 0.01.

We describe the transmission characteristics of a wavelength independent wavelength division multiplexing passive optical network (WDM-PON) based on a wavelength channel data rewriter (WCDR). The WCDR is composed of a linear amplifier (LA) and a saturated semiconductor optical amplifier (SOA), and by using the WCDR in optical network units (ONUs), we can erase the downstream signal and modulate the same wavelength channel with the upstream signal. In this paper, we analyze the data rewriting characteristic, the frequency chirp characteristic and the bit error rate (BER) degradation occasioned by the use of saturated SOAs. Furthermore, we report high-speed transmission with power penalty of less than 1 dB at bit rates of 1.25 Gbit/s, 2.5 Gbit/s and 10 Gbit/s for downstream signals and 1.25 Gbit/s for upstream signals after transmission through 40 km of single-mode fiber.

We propose the network on demand concept to yield the optical access network system that well handles the diversity in user demands and support technologies such as module and devices configuration. In this proposal, the network accommodation equipment, such as OLT needed for each service, is installed ‘virtually' using WDM, and the physical rate can adapt to the user-demanded service rate by using the WDM parallel transmission technique. It well handles the diversity in user demands/services and lowers system power consumption.

This paper describes a flexible point-to-multipoint access protocol for the fiber-optic passive double star (PDS) system. To provide various types of services, and permit flexibility in changing transport capacity, a time division multiple access (TDMA) scheme for the PDS system is considered. Dynamic time slot multiplexing based on TDMA is proposed to provide required time slots efficiently according to service changes. The effectiveness of dynamic time slot multiplexing is calculated and compared to fixed time slot multiplexing for telephony services. A TCM/TDMA frame structure and an access protocol enabling dynamic time slot multiplexing are proposed. ONU bandwidth is dynamically assigned by using a set of pointers. The ONU access protocol causes no interruption to operating ONUs on the same PDS system during the configuration or reconfiguration of an ONU. The access time is analyzed to estimate the performance of the access protocol. The probability density of access time is calculated for the number of ONUs connected. The calculation results indicate that a PDS system can accommodate up to around 60 ONUs within the maximum access time specified by ITU-T. The experimental results also agree fairly well with the theoretical values.

This paper proposes a power saving mechanism with variable sleep period to reduce the power consumed by optical network units (ONUs) in passive optical network (PON) systems. In the PON systems based on time division multiplexing (TDM), sleep and periodic wake-up (SPW) control is an effective ONU power saving technique. However, the effectiveness of SPW control is fully realized only if the sleep period changes in accordance with the traffic conditions. This paper proposes an SPW control mechanism with variable sleep period. The proposed mechanism sets the sleep period according to traffic conditions, which greatly improves the power saving effect. In addition, the protocols needed between an optical line terminal (OLT) and ONUs are described on the assumption that the proposed mechanism is applied to 10 Gigabit (10G) class PON systems, i.e. IEEE 802.3av 10G-EPON and FSAN/ITU-T 10G-PON systems. The validity of the proposed mechanism is confirmed by numerical simulations.

The essential functions of the passive double star (PDS) system are clarified by comparing them to the functions of the single star (SS) and the active double star (ADS) system. A layered structure describing the functional characteristics of the PDS system is proposed for flexible transport capability. The functions of the optical network unit (ONU) on the customer premises are systematically partitioned into four layers. The functions of the optical subscriber unit (OSU) in the central office are described using five layers. Call by call activation and deactivation techniques are described on the basis of a layered architecture. The reduction of ONU power consumption by adopting activation and deactivation control is also discussed.