Gallium nitride high electron mobility transistors (GaN HEMTs) were developed for millimeter-wave high power amplifier applications. The device with a gate length of 80 nm and an InAlN barrier layer exhibited high drain current of more than 1.2 A/mm and high breakdown voltage of 73,V. A cut-off frequency $ extrm{f}_{ extrm{T}}$ of 113,GHz and maximum oscillation frequency $ extrm{f}_{ extrm{max}}$ of 230,GHz were achieved. The output power density reached 1 W/mm with a linear gain of 6.4,dB at load-pull measurements at 90,GHz. And we extracted equivalent circuit model parameters of the millimeter-wave InAlN/GaN HEMT and showed that the model was useful in simulating the millimeter-wave power performance. Also, we report a preliminary constant bias stress test result.

This paper presents recent progress on high frequency and wide bandwidth GaN high power amplifiers (PAs) that are usable for high-data-rate wireless communications and modern radar systems. The key devices and design techniques for PA are described in this paper. The results of the state-of-the art GaN PAs for microwave to millimeter-wave applications and design methodology for ultra-wideband GaN PAs are shown. In order to realize high output power density, InAlGaN/GaN HEMTs were employed. An output power density of 14.8 W/mm in S-band was achieved which is 1.5 times higher than that of the conventional AlGaN/GaN HEMTs. This technique was applied to the millimeter-wave GaN PAs, and a measured power density at 96 GHz was 3 W/mm. The modified Angelov model was employed for a millimeter-wave design. W-band GaN MMIC achieved the maximum Pout of 1.15 W under CW operation. The PA with Lange coupler achieved 2.6 W at 94 GHz. The authors also developed a wideband PA. A power combiner with an impedance transformation function based on the transmission line transformer (TLT) technique was adopted for the wideband PA design. The fabricated PA exhibited an average Pout of 233 W, an average PAE of 42 %, in the frequency range of 0.5 GHz to 2.1 GHz.

A high-efficiency uniform/selective heating microwave oven was developed. Because the power amplifier requires high-efficiency characteristics to function as a microwave source, a free-standing Gallium Nitride (GaN) substrate was applied in this study. By applying a harmonic tuning circuit, an output power of 71 W and PAE of 73% were achieved in pulsed operation, and an output power of 63 W and PAE of 69% were achieved in CW operation. Moreover, we fabricated a prototype PA module that consists of an oscillator, a driver amplifier, PA, and other RF circuits. The output power was controlled by pulse width modulation to maintain high efficiency regardless of output power. We evaluated the arrangement of antenna polarizations to isolate each antenna. By suppressing the interference of output from adjacent antennas, it is possible to irradiate the object on the top surface of the antenna, thereby demonstrating heating characteristics with small temperature unevenness. The prototype microwave oven successfully demonstrated uniform/selective heating.

This work shows a broadband, high-efficiency power amplifier (PA) monolithic microwave integrated circuit (MMIC) that uses InP-based metal-oxide-semiconductor (MOS) high-electron-mobility transistors (HEMTs) with an extended drain-side access region and broadband conjugate matching topology. Advanced device technologies, namely, double-side-doped structures, MOS gate structures, and asymmetric gate recess, were adopted, and the length of the drain-side access region was optimized to simultaneously obtain high power and efficiency. A common-source PA MMIC based on InP-based MOS-HEMTs was fabricated, and an interstage circuit was designed to maximize the S21 per unit stage in the broadband, resulting in a record-high power-added efficiency and wide bandwidth.