This letter proposes a new retransmission persistence management scheme for selective repeat automatic repeat request (SR-ARQ). By considering the overall traffic load that has to be managed by SR-ARQ, the proposed scheme arbitrates the retransmission persistence to prevent an abrupt delay increment due to excessive link-level local retransmissions. OPNET simulations show that SR-ARQ performs better with the proposed scheme than with a fixed value of retransmission persistence in terms of the throughput of transmission control protocol (TCP).

We propose a novel adaptive segment repair mechanism to improve traditional MPLS (Multi-Protocol Label Switching) failure recovery. The proposed mechanism protects one or more contiguous high failure probability links by dynamic setup of segment protection. Simulations demonstrate that the proposed mechanism reduces failure recovery time while also increasing network resource utilization.

In a Direct-Sequence/Spread-Spectrum (DS/SS) system, a RAKE receiver is used to improve a bit error rate (BER) performance. The RAKE receiver can collect more signal energy through independent paths and achieve path diversity. The RAKE receiver obtains further diversity gain through fractional sampling. However, the power consumption of the RAKE receiver increases in proportion to a sampling rate and does not always maximize the signal-to-noise ratio (SNR). Therefore, sampling rate selection schemes have been proposed to reduce the average sampling rate without degrading the BER. These schemes select the tap positions and the sampling rate depending on channel conditions and the power consumption can be reduced. In this paper, sampling rate selection schemes for the DS/SS system are investigated through an experiment since there have been no numerical results through an experiment. Numerical results show that the power consumption can be reduced even through the experiment without the degradation of the BER.

A method was developed for deriving the control input for a multi-dimensional discrete-time nonlinear system so that a performance index is approximately minimized. First, a moment vector equation (MVE) is derived; it is a multi-dimensional linear equation that approximates a nonlinear system in the whole domain of the system state and control input. Next, the performance index is approximated by using a quadratic form with respect to the moment vector. On the basis of the MVE and the quadratic form, an approximate optimal controller is derived by solving the linear quadratic optimal control problem. A bilinear optimal control problem and a mountain-car problem were solved using this method, and the solutions were nearly optimal.

IEEE 802.15.4 is a new standard, uniquely designed for low rate wireless personal area networks (LR-WPANs). It targets ultra-low complexity, cost, and power, for low-data-rate wireless connectivity. However, one of the main problems of this new standard is its insufficient, and inefficient, media access control (MAC) for priority data. This paper introduces an extended contention access period (XCAP) concept for priority packets, also an traffic adaptive contention differentiation utilizing the XCAP (TACDX). The TACDX determines appropriate transmission policy alternatively according to the traffic conditions and type of packet. TACDX achieves not only enhanced transmission for priority packets but it also has a high energy efficiency for the overall network. The proposed TACDX is verified with simulations to measure the performances.

Let us introduce n ( ≥ 2) mappings fi (i=1,,n ≡ 0) defined on reflexive real Banach spaces Xi-1 and let fi:Xi-1 → Yi be completely continuous on bounded convex closed subsets Xi-1(0) ⊂ Xi-1. Moreover, let us introduce n set-valued mappings Fi : Xi-1 Yi → Fc(Xi) (the family of all non-empty compact subsets of Xi), (i=1,,n ≡ 0). Here, we have a fixed point theorem in weak topology on the successively recurrent system of set-valued mapping equations:xi ∈ Fi(xi-1, fi(xi-1)), (i=1,,n ≡ 0). This theorem can be applied immediately to analysis of the availability of system of circular networks of channels undergone by uncertain fluctuations and to evaluation of the tolerability of behaviors of those systems.

In this paper, we study low complexity transceiver for double space time transmit diversity (DSTTD) and orthogonal frequency division multiplexing (OFDM) system with antenna shuffling. Firstly, we propose a novel antenna shuffling method based on the criterion of minimizing the condition number of channel correlation matrix. The condition number is an indicator about the quality of the channel. By selecting the minimum of condition number which has better channel quality, consequently, a linear detector with respect to this new channel may achieve better performance results. A low complexity variant of the condition number calculation is also proposed, and it is shown that this criterion can be reduced to the minimum mean square error (MMSE) based criterion. Furthermore, the weighted soft decision Viterbi decoding is applied to mitigate noise enhancement inherent to zero forcing (ZF) and MMSE linear receivers and improve error rate performance. Next, we propose an algorithm to reduce the amount of feedback by exploiting the fact that the channel frequency responses across OFDM subcarriers are correlated. In the proposed algorithm, subcarriers are clustered in blocks, which are allocated the same shuffling pattern with the largest number of the shuffling patterns in the cluster. This way, the signaling overhead can be reduced in comparison with each subcarrier based feedback. Extensive simulations show that the proposed techniques for DSTTD-OFDM system outperform other existing techniques under both uncorrelated and highly spatial correlated frequency selective MIMO fading channels.

Switching a communication path from one Access Point (AP) to another in inter-domain WLANs is a critical challenge for delay-sensitive applications such as Voice over IP (VoIP) because communication quality during handover (HO) is more likely to be deteriorated. To maintain VoIP quality during HO, we need to solve many problems. In particular, in bi-directional communication such as VoIP, an AP becomes a bottleneck with the increase of VoIP calls. As a result, packets queued in the AP buffer may experience a large queuing delay or packet losses due to increase in queue length or buffer overflow, thereby causing the degradation of VoIP quality for the Mobile Nodes (MNs) side. To avoid this degradation, MNs need to appropriately and autonomously execute HO in response to the change in wireless network condition, i.e., the deterioration of wireless link quality and the congestion state at the AP. In this paper, we propose an HO decision strategy considering frame retries, AP queue length, and transmission rate at an MN for maintaining VoIP quality during HO. Through simulation experiments, we then show that our proposed method can maintain VoIP quality during HO by properly detecting the wireless network condition.

This paper clarifies the adequacy of the linear channel coding approach for Slepian-Wolf coding of individual sequences. A sufficient condition for ensembles of linear codes from which a universal Slepian-Wolf code can be constructed is given. Our result reveals that an ensemble of LDPC codes gives a universal code for Slepian-Wolf coding of individual sequences.

The RFID tag system has received attention as an identification source. Each RFID tag is attached to some object. With the unique ID of the RFID tag, a user identifies the object provided with the RFID tag, and derives appropriate information about the object. One of important applications of the RFID technology is the position estimation of RFID tags. It can be very useful to acquire the location information concerning the RFID tags. It can be applied to navigation systems and positional detection systems for robots etc. In this paper, we propose a new position estimation method of RFID tags by using a probabilistic approach. In this method, mobile objects (person and robot, etc.) with RFID readers estimate the positions of RFID tags with multiple communication ranges. We show the effectiveness of the proposed method by computer simulations.

When we design a robust vector quantizer (VQ) for noisy channels, an appropriate index assignment function should be contrived to minimize the channel-error effect. For relatively high rates, the complexity for finding an optimal index assignment function is too high to be implemented. To overcome such a problem, we use a structurally constrained VQ, which is called the sample-adaptive product quantizer (SAPQ) [12], for low complexities of quantization and index assignment. The product quantizer (PQ) and its variation SAPQ [13], which are based on the scalar quantizer (SQ) and thus belong to a class of the binary lattice VQ [16], have inherent error resilience even though the conventional affine index assignment functions, such as the natural binary code, are employed. The error resilience of SAPQ is observed in a weak sense through worst-case bounds. Using SAPQ for noisy channels is useful especially for high rates, e.g., > 1 bit/sample, and it is numerically shown that the channel-limit performance of SAPQ is comparable to that of the best codebook permutation of binary switching algorithm (BSA) [23]. Further, the PQ or SAPQ codebook with an affine index assignment function is used for the initial guess of the conventional clustering algorithm, and it is shown that the performance of the best BSA can be easily achieved.

Mobility-aware quality of service (QoS) signaling is crucial to provide seamless multimedia services in the ambient environment where mobile nodes may move frequently between different wireless access networks. The mobility of an IP-based node in ambient networks affects routing paths, and as a result, can have a significant impact on the operation and state management of QoS signaling protocols. In this paper, we first analyze the impact of mobility on QoS signaling protocols and how the protocols operate in mobility scenarios. We then propose an efficient mobility-aware QoS signaling protocol which can operate adaptively in ambient networks. The key features of the protocol include the fast discovery of a crossover node where the old and new paths converge or diverge due to handover and the localized state management for seamless services. Our analytical and simulation/experimental results show that the proposed/implemented protocol works better than existing protocols in the IP-based mobile environment.

This Letter proposes a new kind of features for color image retrieval based on Distance-weighted Boundary Predictive Vector Quantization (DWBPVQ) Index Histograms. For each color image in the database, 6 histograms (2 for each color component) are calculated from the six corresponding DWBPVQ index sequences. The retrieval simulation results show that, compared with the traditional Spatial-domain Color-Histogram-based (SCH) features and the DCTVQ index histogram-based (DCTVQIH) features, the proposed DWBPVQIH features can greatly improve the recall and precision performance.

In OLSR (Optimized Link State Routing Protocol), the multipoint relay mechanism has been introduced to minimize routing overhead for flooding control traffic. In order to achieve as low a routing overhead as possible, the selection of MPRs (multipoint relays) is designed to limit the overall number of such relays in the network. OLSR provides the shortest paths in terms of hops; however, it does not take into account the QoS (quality of service) requirements. Therefore, QOLSR (Quality OLSR), which adds a QoS extension to the OLSR, has been proposed. Although QOLSR provides the best QoS path, its selection process does not consider the number of MPRs, which causes an increase in the routing overhead. In this paper, we focus on the selection process of MPRs in link state QoS routing protocol. We propose three heuristics for high-efficiency selections: MIMS, MQES, and MCIS. The basic approach of these selections is to determine a smaller set of MPRs that provide better QoS paths between any two nodes. The main objective in doing so is to maximize the QoS effect while limiting the routing overhead. In addition, we evaluate the performance of the routing protocols with the proposed selections by simulation. The results indicate that MIMS and MCIS achieve high-efficiency selection; as compared to QOLSR, MIMS reduces the maintenance cost by 30%, while the throughput of the resultant path is decreased by 13%, and MCIS reduces the cost by 21% without any decrease in the throughput.

Wireless LAN access is now being offered by small personal terminals in addition to laptops. Since these terminals have very limited battery capacity, wireless LAN interfaces that offer some form of power saving are essential. IEEE802.11. specifies PSM (Power save management); it reduces power consumption by suspending some communications functions. However, since Multicasting and Broadcasting are invariably received by all terminals regardless of PSM, the terminals unnecessarily consume electric power, even if the terminal is not multicast subscriber. This paper clarifies this problem, and proposes a scheme for reducing power consumption. The results of an experiment confirm its excellent performance.

This paper proposes a robust adaptive fuzzy PID control scheme augmented with a supervisory controller for unknown systems. In this scheme, a generalized fuzzy model is used to describe a class of unknown systems. The control strategy allows each part of the control law, i.e., a supervisory controller, a compensator, and an adaptive fuzzy PID controller, to be designed incrementally according to different guidelines. The supervisory controller in the outer loop aims at enhancing system robustness in the face of extra disturbances, variation in system parameters, and parameter drift in the adaptation law. Furthermore, an H∞ control design method using the fuzzy Lyapunov function is presented for the design of the initial control gains that guarantees transient performance at the start of closed-loop control, which is generally overlooked in many adaptive control systems. This design of the initial control gains is a compound search strategy called conditional linear matrix inequality (CLMI) approach with IROA (Improved random optimal algorithm), it leads to less complex designs than a standard LMI method by fuzzy Lyapunov function. Numerical studies of the tracking control of an uncertain inverted pendulum system demonstrate the effectiveness of the control strategy. From results of this simulation, the generalized fuzzy model reduces the rule number of T-S fuzzy model indeed.

In modern VLSI physical design, huge integration scale necessitates hierarchical design and IP reuse to cope with design complexity. Besides, interconnect delay becomes dominant to overall circuit performance. These critical factors require some modules to be placed along designated boundaries to effectively facilitate hierarchical design and interconnection optimization related problems. In this paper, boundary constraints of general floorplan are solved smoothly based on the novel representation Single-Sequence (SS). Necessary and sufficient conditions of rooms along specified boundaries of a floorplan are proposed and proved. By assigning constrained modules to proper boundary rooms, our proposed algorithm always guarantees a feasible SS code with appropriate boundary constraints in each perturbation. Time complexity of the proposed algorithm is O(n). Experimental results on MCNC benchmarks show effectiveness and efficiency of the proposed method.

A semi-distributed resource allocation scheme based on multihop equilibrium is proposed for OFDM-relay networks. This method aims to reduce the amount of feedback information from the relay nodes (RNs). Moreover, it utilizes radio resource by striking an efficient balance between the capacities of the BS-RN link and RN-MS link. Simulation results show that the proposed semi-distributed scheme achieves good performances in terms of throughputs and fraction of satisfied users.

The IEEE 802.16e standard specifies the sleep mode and the idle mode of a mobile station (MS) for power saving. In this paper, to reduce the energy consumption of the MS, we employ the sleep mode while the MS is on-session, and the idle mode while it is off-session. Under the assumption that the time duration from the end of a session to the arrival of a new downlink session request follows an exponential distribution of the mean and that arrivals of messages during an on-session follow a Poisson process with rate λ, we analyze the awake mode period and the sleep mode period by using the busy period analysis of the M/G/1 queue, and then we derive the total mean length of an on-session which consists of a geometric number of awake mode periods and sleep mode periods. Since the sum of an on-session and an off-session constitutes a cycle, we can express the average power consumption in terms of the mean lengths of an awake mode period, a sleep mode period and an idle mode period. The average power consumption indicates how much the MS can save energy by employing the sleep mode and the idle mode. We also derive the Laplace Stieltjes transform (and the mean) of the queueing delay of messages to examine a tradeoff between the power consumption and the delay of messages. Analytical results, which are shown to be well-matched by simulations, address that our employment of the sleep mode and the idle mode provides a considerable reduction in the energy consumption of the MS.

This investigation proposes two methods for embedding backdoors in the RSA modulus N=pq rather than in the public exponent e. This strategy not only permits manufacturers to embed backdoors in an RSA system, but also allows users to choose any desired public exponent, such as e=216+1, to ensure efficient encryption. This work utilizes lattice attack and exhaustive attack to embed backdoors in two proposed methods, called RSASBLT and RSASBES, respectively. Both approaches involve straightforward steps, making their running time roughly the same as that of normal RSA key-generation time, implying that no one can detect the backdoor by observing time imparity.