This paper addresses linear quadratic control with state-dependent noise for singularly perturbed stochastic systems (SPSS). First, the asymptotic structure of the stochastic algebraic Riccati equation (SARE) is established for two cases. Second, a new iterative algorithm that combines Newton's method with the fixed point algorithm is established. As a result, the quadratic convergence and the reduced-order computation in the same dimension of the subsystem are attained. As another important feature, a high-order state feedback controller that uses the obtained iterative solution is given and the degradation of the cost performance is investigated for the stochastic case for the first time. Furthermore, the parameter independent controller is also given in case the singular perturbation is unknown. Finally, in order to demonstrate the efficiency of the proposed algorithm, a numerical example is given for the practical megawatt-frequency control problem.

In this paper, we investigate the smallest value of p for which a (J,L,p)-QC LDPC code with girth 6 exists for J=3 and J=4. For J=3, we determine the smallest value of p for any L. For J=4, we determine the smallest value of p for L ≤ 301. Furthermore we provide examples of specific constructions meeting these smallest values of p.

Hybrid automatic repeat request (HARQ) is employed for the Evolved Universal Terrestrial Radio Access (E-UTRA) downlink. The ACK/NACK signals from each user equipment (UE) are multiplexed by code division multiple access (CDMA) and transmitted via a physical uplink control channel (PUCCH). The ACK/NACK signals are code spread by the cyclic shift (CS) sequences made from zero auto-correlation (ZAC) sequences; however, the orthogonality of these sequences is not guaranteed depending on the propagation channels; moreover, the amount of inter-code interference (ICI) depends on the delay spread of the channel and the transmitting timing control error of each UE. In the conventional PUCCH structure, ICI between two ACK signals does not degrade their detection performance, whereas ICI between an ACK signal and a NACK signal degrades the detection performance. This causes a serious gap between the detection performances of ACK and NACK signals, because generally in a PUCCH, there are more ACK signals than NACK signals. In this paper, we propose a novel phase rotation scheme on the constellations of ACK/NACK signals that can resolve this issue, and the simulation evaluation results confirm the benefits of the proposed phase rotation scheme.

In this letter, we propose a simple adaptive switching scheme to enhance the performance of space-time/frequency block coded OFDM systems (STBC/SFBC-OFDM). Since STBC-OFDM and SFBC-OFDM undergo severe performance degradation in time- and frequency-selective fading channels, respectively, performance enhancement can be achieved by switching between STBC-OFDM and SFBC-OFDM over a continuously varying channel environments. Thus, a new switching scheme based on the characteristics of the actual channel is proposed. The effectiveness of the proposed scheme is demonstrated by computer simulations.

This paper proposes a frequency asynchronous cross-polarization interference canceller for Vertical/Horizontal (V/H) polarization multiplexing satellite communications. In satellite communications, V/H polarization signals are likely to experience different frequency fluctuations, and so the cross-polarization undergoes two different frequency fluctuations. To cancel this cross-polarization interference, a new frequency asynchronous cross-polarization interference canceller that removes interference and frequency offsets is proposed. Computer simulations are carried out to evaluate its fundamental performance. The results show that the proposed canceller can remove the cross-polarization interference created by the two different frequency offsets, simultaneously.

This paper presents the field uniformity characteristics in a triangular prism reverberation chamber that can be substituted for an open area test site or an anechoic chamber to measure electromagnetic interference. To improve size problems of a stirrer that is an official unit to generate a uniform field in the reverberation chamber, we suggest a diffuser of Quadratic Residue Sequence method. To validate the substitution of a diffuser for a stirrer, a diffuser is designed for 1-3 GHz, and three types of equilateral triangular prism reverberation chambers are modeled. Afterwards, the field distributions in these three reverberation chambers are both simulated and tested. Using XFDTD 6.2 of finite difference time domain method, field deviations of each structure are simulated and compared to each other. An evaluation of field uniformity is done by cumulative probability distribution which is specified in the IEC 61000-4-21. The result shows that the field uniformity in the chamber is within 6 dB tolerance and also within 3 dB standard deviation, which means a diffuser can satisfy the requirement of international standards.

A simple detector named QR-LRL for MIMO systems was proposed in and it was shown that QR-LRL approached the hard-output ML performance. However, its soft-output performance is not capable of approaching the near ML performance. In this letter, we propose a novel detection method which can generate reliable soft-outputs while avoiding the empty vector set problem. The proposed detector efficiently uses the upper triangular structure in QR decomposition. Simulation results show that the proposed detector can approach the near soft-output ML performance as well as hard-output with feasible complexity.

In this paper, we propose a scheme of frequency sub-band allocation to obtain maximum throughput in an orthogonal frequency division multiple access (OFDMA) system where each user has a finite number of packets to transmit, which are generated from packet calls with arbitrary size and arbitrary arrival rate. The proposed scheme is evaluated in terms of throughput and user fairness in comparison with the proportional fairness (PF) scheme and the Greedy scheme under the finite queue length condition. Numerical results show that the proposed scheme is superior to the Greedy scheme in terms of both throughput and fairness for finite queue length.

An exact expression of error rate is developed for maximal ratio combining (MRC) in an independent but not necessarily identically distributed frequency selective Nakagami fading channel taking into account inter-symbol, co-channel and adjacent channel interferences (ISI, CCI and ACI respectively). The characteristic function (CF) method is adopted. While accurate analysis of MRC performance cannot be seen in frequency selective channel taking ISI (and CCI) into account, such analysis for ACI has not been addressed yet. The general analysis presented in this paper solves a problem of past and present interest, which has so far been studied either approximately or in simulations. The exact method presented also lets us obtain an approximate error rate expression based on Gaussian approximation (GA) of the interferences. It is shown, especially while the channel is lightly faded, has fewer multipath components and a decaying delay profile, the GA may be substantially inaccurate at high signal-to-noise ratio. However, the exact results also reveal an important finding that there is a range of parameters where the simpler GA is reasonably accurate and hence, we don't have to go for more involved exact expression.

A replacement of an expensive MgO protective layer with relatively inexpensive Lanthanum Hexa Boride (LaB6) has already been proposed. Since LaB6 is not transparent, unlike MgO, the LaB6 panel employs a long sustain gap structure. Since the sustain gap is 2.6 times larger than the distance between sustain and address electrodes, different driving methods from those of the conventional PDPs have to be adopted. For the driving technique of the sustain period, an application of delayed auxiliary pulses on A electrode and the overlap sustain pulse drive are proposed. Luminance degradation with higher sustain frequency driving can be compensated by use of a 2step sustain pulse driving. Low reset luminance and low address voltage are achieved with a square-ramp technique for the reset period. TV operation is successfully realized on AC PDP which incorporated the LaB6 cathodes.

The self-organized microwrinkles can serve as a surface alignment layer to align nematic liquid crystals, which is primarily based on the groove mechanism. The azimuthal anchoring energy is discussed and estimated from the groove topography and the actual twist angle in the twisted nematic cell.

By using multiple repeated signal replicas to formulate the accumulative observed noisy signal sequence (AONSS) or the differential observed noisy signal sequence (DONSS) in the hybrid ARQ system, a novel data-aided maximum likelihood (DA ML) SNR estimation and a blind ML SNR estimation technique are proposed for the AWGN channel. It is revealed that the conventional DA ML estimate is a special case of the novel DA ML estimate, and both the proposed DA ML and the proposed blind ML SNR estimation techniques can offer satisfactory SNR estimation without introducing significant additional complexity to the existing hybrid ARQ scheme. Based on the AONSS, both the generalized deterministic and the random Cramer-Rao lower bounds (GCRLBs), which include the traditional Cramer-Rao lower bounds (CRLBs) as special cases, are also derived. Finally, the applicability of the proposed SNR estimation techniques based on the AONSS and the DONSS are validated through numerical analysis and simulation results.

Direct conversion receivers in orthogonal frequency division multiplexing (OFDM) systems suffer from direct current (DC) offset, frequency offset, and IQ imbalance. We have proposed an IQ imbalance estimation scheme in the presence of DC offset and frequency offset, which uses preamble signals in the time domain. In this scheme, the DC offset is eliminated by a differential filter. However, the accuracy of IQ imbalance estimation is deteriorated when the frequency offset is small. To overcome this problem, a new IQ imbalance estimation scheme in the frequency domain with the differential filter has been proposed in this paper. The IQ imbalance is estimated with pilot subcarriers. Numerical results obtained through computer simulation show that estimation accuracy and bit error rate (BER) performance can be improved even if the frequency offset is small.

Incremental Redundancy Hybrid ARQ (IR-HARQ) based on rate-compatible punctured low-density parity-check (LDPC) codes can achieve high throughput over a wide range of SNRs. One drawback of such IR-HARQ schemes is high computational complexity of decoding for early transmission at high rates. In order to overcome this problem, a HARQ scheme based on rate-compatible LDPC codes by shortening and extending is presented in this paper. In the HARQ scheme, a high-rate mother code is transmitted at first, and parity-bits of a shortened code are transmitted for early retransmission requests. With a low-complexity decoder of the high-rate mother code, this shortened-code approach would result in low computational complexity of decoding, but it causes smaller length and larger number of shortened codes to be decoded as retransmission repeats. To prevent the resultant degradation of performance and complexity, extending is efficiently applied to the shortened codes after predetermined retransmission-times. A multi-edge type code-design is employed to construct irregular LDPC codes that meet the requirement of the HARQ scheme. Simulation results show that the HARQ scheme can achieve lower computational complexity of decoding than a conventional IR-HARQ scheme with good throughput over a wide range of SNRs.

Quantification of the hip cartilages is clinically important. In this study, we propose an automatic technique for segmentation and visualization of the acetabular and femoral head cartilages based on clinically obtained multi-slice T1-weighted MR data and a hybrid approach. We follow a knowledge based approach by employing several features such as the anatomical shapes of the hip femoral and acetabular cartilages and corresponding image intensities. We estimate the center of the femoral head by a Hough transform and then automatically select the volume of interest. We then automatically segment the hip bones by a self-adaptive vector quantization technique. Next, we localize the articular central line by a modified canny edge detector based on the first and second derivative filters along the radial lines originated from the femoral head center and anatomical constraint. We then roughly segment the acetabular and femoral head cartilages using derivative images obtained in the previous step and a top-hat filter. Final masks of the acetabular and femoral head cartilages are automatically performed by employing the rough results, the estimated articular center line and the anatomical knowledge. Next, we generate a thickness map for each cartilage in the radial direction based on a Euclidian distance. Three dimensional pelvic bones, acetabular and femoral cartilages and corresponding thicknesses are overlaid and visualized. The techniques have been implemented in C++ and MATLAB environment. We have evaluated and clarified the usefulness of the proposed techniques in the presence of 40 clinical hips multi-slice MR images.

Packet classification categorizes incoming packets into multiple forwarding classes based on pre-defined filters. This categorization makes information accessible for quality of service or security handling in the network. In this paper, we propose a scheme which combines the Aggregate Bit Vector algorithm and the Pruned Tuple Space Search algorithm to improve the performance of packet classification in terms of speed and storage. We also present the procedures of incremental update. Our scheme is evaluated with filter databases of varying sizes and characteristics. The experimental results demonstrate that our scheme is feasible and scalable.

Combining the sphere decoding (SD) algorithm and the sequential detection method, we propose an adaptive group detection (AGD) scheme based on the sort-descending QRD (S-D-QRD) for V-BLAST architectures over an i.i.d. Rayleigh flat fading channel. Simulation results show that the proposed scheme, which encompasses the SD algorithm and the sequential detection method as two extreme cases in a probability sense, can achieve a very flexible tradeoff between the detection performance and computational complexity by adjusting the group parameter.

In this paper, we propose a novel frequency-hopping scheme in order to improve the BER (Bit Error Rate) performance of the Partial Block MC-CDMA (PB/MC-CDMA) system. The joint carrier distribution and frequency hopping (JDFH) scheme achieves the optimal frequency diversity gain while avoiding interference. By contrast, the conventional FH scheme only avoids interference, and the frequency interleaving scheme achieves only frequency diversity. The JDFH scheme thus performs better than conventional schemes, such as carrier FH, block FH, or frequency interleaving. Through computer simulations, we confirmed the superior performance of the PB/MC-CDMA system when using the JDFH scheme.

This paper describes the architecture and implementations of an automatic digital tuning circuit for a complex bandpass filter (BPF) in a low-power and low-cost transceiver for applications such as personal authentication and wireless sensor network systems. The architectural design analysis demonstrates that an active RC filter in a low-IF architecture can be at least 47.7% smaller in area than a conventional gm-C filter; in addition, it features a simple implementation of an associated tuning circuit. The principle of simultaneous tuning of both the center frequency and bandwidth through calibration of a capacitor array is illustrated as based on an analysis of filter characteristics, and a scalable automatic digital tuning circuit with simple analog blocks and control logic having only 835 gates is introduced. The developed capacitor tuning technique can achieve a tuning error of less than 3.5% and lower a peaking in the passband filter characteristics. An experimental complex BPF using 0.18 µm CMOS technology can successfully reduce the tuning error from an initial value of -20% to less than 2.5% after tuning. The filter block dimensions are 1.22 mm1.01 mm; and in measurement results of the developed complex BPF with the automatic digital tuning circuit, current consumption is 705 µA and the image rejection ratio is 40.3 dB. Complete evaluation of the BPF indicates that this technique can be applied to low-power, low-cost transceivers.

This letter proposes a windowing frequency domain adaptive algorithm, which reuses the filtering error to apply window function in the filter updating symmetrically. By using a proper window function to reduce the negative influence of the spectral leakage, the proposed algorithm can significantly improve the performance of the acoustic echo cancellation for speech signals.