Youngchol KIM Keunsik KIM Shunji MANABE
In recent works [1],[4], it has been shown that the damping of a linear time invariant system relates to the so-called characteristic ratios (αk, k=1,…, n-1) which are defined by coefficients of the denominator of the transfer function. However, the exact relations are not yet fully understood. For the purpose of exploring the issue, this paper presents the analysis of time response sensitivity to the characteristic ratio change. We begin with the sensitivity of output to the perturbations of coefficients of the system denominator and then the first order approximation of the αk perturbation effect is computed by an explicit transfer function. The results are extended to all-pole systems in order to investigate which characteristic ratios act dominantly on step response. The same analysis is also performed to a special class of systems whose denominator is composed of so called K-polynomial. Finally, some illustrative examples are given.
Arata KAWAMURA Youji IIGUNI Yoshio ITOH
A parallel notch filter (PNF) for eliminating a sinusoidal signal whose frequency and phase are unknown, has been proposed previously. The PNF achieves both fast convergence and high estimation accuracy when the step-size for adaptation is appropriately determined. However, there has been no discussion of how to determine the appropriate step-size. In this paper, we derive the convergence condition on the step-size, and propose an adaptive algorithm with variable step-size so that convergence of the PNF is automatically satisfied. Moreover, we present a new filtering structure of the PNF that increases the convergence speed while keeping the estimation accuracy. We also derive a variable step-size scheme for the new PNF to guarantee the convergence. Simulation results show the effectiveness of the proposed method.
Shinya WATANABE Youichi KAKUTA Osamu HASHIMOTO
In this paper, Constrained Interpolation Profile (CIP) method is applied to Maxwell's equation including complex permittivity and permeability and the validity of CIP method applied to the equation is confirmed compared with the FDTD method. And the dependency on CFL (Courant-Friedrich-Lewy) condition, cell size and estimates of , and of the absorbing characteristics of one-layer EM-absorber are calculated using CIP method and compared with that by FDTD method. As a result, it is confirmed that the characteristics obtained by CIP method is different from that by FDTD method.
Daiyuan PENG Pingzhi FAN Naoki SUEHIRO
In order to judge the goodness of zero correlation zone sequence sets, a new concept, called ZCZ characteristic, is proposed. Then by defining a sequence operation, i.e. correlation product, and establishing its basic properties, a new approach to construct sets of sequences with a large zero correlation zone is presented.
Eun-Su KIM Sung-Hak LEE Soo-Wook JANG Kyu-Ik SOHNG
The RGB signals generated by different cameras are not equal for the same scene. Therefore, cameras are characterized based on a CIE standard colorimetric observer. One method of deriving a colorimetric characterization matrix between camera RGB output signals and CIE XYZ tristimulus values is least squares polynomial modeling. Yet, this involves tedious experiments to obtain a camera transfer matrix under various white balance points for the same camera. Accordingly, the current paper proposes a new method for obtaining camera transfer matrices under different white balances using a 33 camera transfer matrix under a specific white balance point.
We propose a learning method combining query learning and a "genetic translator" we previously developed. Query learning is a useful technique for high-accuracy, high-speed learning and reduction of training sample size. However, it has not been applied to practical optical character readers (OCRs) because human beings cannot recognize queries as character images in the feature space used in practical OCR devices. We previously proposed a character image reconstruction method using a genetic algorithm. This method is applied as a "translator" from feature space for query learning of character recognition. The results of an experiment with hand-written numeral recognition show the possibility of training sample size reduction.
Kiyoshi HOSHINO Takanobu TANIMOTO
The authors propose a system for searching the shape of human hands and fingers in real time and with high accuracy, without using any special peripheral equipment such as range sensor, PC cluster, etc., by a method of retrieving similar image quickly with high accuracy from a large volume of image database containing the complicated shapes and self-occlusions. In designing the system, we constructed a database in a way to be adaptable even to differences among individuals, and searched CG images of hand similar to unknown hand image, through extraction of characteristics using high-order local autocorrelational patterns, reduction of the amount of characteristics centering on principal component analysis, and prior rearrangement of data corresponding to the amount of characteristics. As a result of experiments, our system performed high-accuracy estimation of human hand shape where mean error was 7 degrees in finger joint angles, with the processing speed of 30 fps or over.
In this letter a planar tapered-slot-fed annular slot antenna with band-notched characteristics is presented for ultra-wideband radios. By etching a narrowband resonance slit on the non-radiating part of the antenna, the proposed antenna is capable of not only reducing the interference at the WLAN bands but also of avoiding the spatial-dependent bandstop characteristics that have commonly occurred in previous works.
Yiping YANG Bilan ZHU Masaki NAKAGAWA
This paper proposes a "structuring search space" (SSS) method aimed to accelerate recognition of large character sets. We divide the feature space of character categories into smaller clusters and derive the centroid of each cluster as a pivot. Given an input pattern, it is compared with all the pivots and only a limited number of clusters whose pivots have higher similarity (or smaller distance) to the input pattern are searched in, thus accelerating the recognition speed. This is based on the assumption that the search space is a distance space. We also consider two ways of candidate selection and finally combine them the method has been applied to a practical off-line Japanese character recognizer with the result that the coarse classification time is reduced to 56% and the whole recognition time is reduced to 52% while keeping its recognition rate as the original.
Honggang XIANG Degui CHEN Xingwen LI Zhipeng LI Weixiong TONG
A method is proposed to investigate the dynamic characteristics of a magnet release in molded case circuit breaker. With the static field assumption, two grids of the magnetic torque and flux linkage are calculated with the variation of the current and air gap, firstly. Considering the influence of tripping torque, coupled with circuit equation and mechanism motion equation, the dynamic characteristics may be obtained with Runge-Kutta 4 method. Experiments have been done to verify the method, and the difference between the calculated results and the experimental results is below 10%. In addition, the influence of the reaction spring on the protection characteristics is analyzed using this method. It demonstrates that the setting current varies with the initial angle and the stiffness of the reaction spring, and the variation with the initial angle of the reaction spring is closely linear but the stiffness nonlinear.
Short gap arc V-I characteristics are essential to discussions on behavior of contact arc at opening and closing. From this point of view, some conventional arc V-I characteristics were reviewed and inconvenient points of them for practical use were pointed out: (1) not a few electrode-material-dependent constants needed in the equation of V-I relation, (2) difficulty in the prediction of real arc extinction phenomena. In order to overcome these inconveniences, the author measured short gap arc V-I characteristics originally, and tried to formulate them into a simple form on the assumption that the arc column V-I characteristics are little dependent on electrode materials but the unstable arc region is strongly dependent on electrode materials. Measured arc column voltage was directly proportional to the square root of gap length and inversely proportional to the cube root of arc current. Arc became unstable when arc current decreased near to the value generally known as the minimum arc current. It was not necessarily the case that the arc extinguished completely at the minimum arc current, but, depending on the circuit conditions, the arc often existed discontinuously below the so-called minimum arc current. Simple empirical V-I characteristics were proposed for practical use, together with the unstable arc region as the information for arc extinction phenomena.
Nagayoshi MORITA Katsuhito OHNO
Radiation characteristics of various microstrip MIC passive elements are investigated in detail on the basis of accurate numerical analysis. For this purpose, the FD-TD method combined with the radiation mode theory is used. Summarized results are presented mainly from the viewpoint of making clear how radiation characteristics differ depending upon typical features of element structures and operating frequencies. Particularly important features of this paper are that not only radiation into the space region but also that in the substrate region is studied in detail for the first time. Suggestive remarks are given on positioning of active devices in MIC for avoiding interference from nearby elements.
Masaki NAKAGAWA Bilan ZHU Motoki ONUMA
This paper presents a model and its effect for on-line handwritten Japanese text recognition free from line-direction constraint and writing format constraint such as character writing boxes or ruled lines. The model evaluates the likelihood composed of character segmentation, character recognition, character pattern structure and context. The likelihood of character pattern structure considers the plausible height, width and inner gaps within a character pattern that appear in Chinese characters composed of multiple radicals (subpatterns). The recognition system incorporating this model separates freely written text into text line elements, estimates the average character size of each element, hypothetically segments it into characters using geometric features, applies character recognition to segmented patterns and employs the model to search the text interpretation that maximizes likelihood as Japanese text. We show the effectiveness of the model through recognition experiments and clarify how the newly modeled factors in the likelihood affect the overall recognition rate.
Motoki ONUMA Akihito KITADAI Bilan ZHU Masaki NAKAGAWA
This paper describes an on-line handwritten Japanese text recognition system that is liberated from constraints on line direction and character orientation. The recognition system first separates freely written text into text line elements, second estimates the line direction and character orientation using the time sequence information of pen-tip coordinates, third hypothetically segment it into characters using geometric features and apply character recognition. The final step is to select the most plausible interpretation by evaluating the likelihood composed of character segmentation, character recognition, character pattern structure and context. The method can cope with a mixture of vertical, horizontal and skewed text lines with arbitrary character orientations. It is expected useful for tablet PC's, interactive electronic whiteboards and so on.
Tohru IWAI Kennichi HATAKEYAMA
We calculated the shielding characteristic of a three-dimensional array of strip conductors by using the electric field integral equation method and its expansion to an array structure. From reflection coefficients, the effective permittivity of the array is calculated. The effective permittivity becomes negative in the frequency range above resonance, in which the electromagnetic waves travel through the material in an evanescent mode and the transmission coefficient becomes very small.
This paper presents a survey of elastic matching (EM) techniques employed in handwritten character recognition. EM is often called deformable template, flexible matching, or nonlinear template matching, and defined as the optimization problem of two-dimensional warping (2DW) which specifies the pixel-to-pixel correspondence between two subjected character image patterns. The pattern distance evaluated under optimized 2DW is invariant to a certain range of geometric deformations. Thus, by using the EM distance as a discriminant function, recognition systems robust to the deformations of handwritten characters can be realized. In this paper, EM techniques are classified according to the type of 2DW and the properties of each class are outlined. Several topics around EM, such as the category-dependent deformation tendency of handwritten characters, are also discussed.
Kouji WADA Ramesh K. POKHAREL Takanobu OHNO Osamu HASHIMOTO
In a partially coupled-line bandpass filter (BPF), a combination of two microstrip line resonators which are partially coupled, are considered, where one resonator is half-wavelength (λ/2)-long, and another whose one end is grounded, is only quarter-wavelength (λ/4)-long. Therefore, the length of a coupled-line section can be varied based on the position of the grounding end, and five conditions of the movable coupling length have been simulated which will greatly influence the spurious responses of a BPF. This property is numerically investigated in this paper. The analysis shows that, based on the grounding position, this method is capable of realizing the improved out-of-band characteristics by locating the multiple attenuation poles in the stopband and improved spurious responses up to five times of the center frequency (5f0). A few empirical models of BPF are fabricated, and the numerical results are ensured by comparing with the experimental results.
Recently, efficient algorithms have been proposed for finding all characteristic curves of one-port piecewise-linear resistive circuits. Using these algorithms, a middle scale one-port circuit can be represented by a piecewise-linear resistor that is neither voltage nor current controlled. In this letter, an efficient algorithm is proposed for finding all dc operating points of piecewise-linear circuits containing such neither voltage nor current controlled resistors.
Screen pattern used in offset-printed documents has been one of great obstacles in developing document recognition systems that handle color documents. This paper proposes a selective smoothing method for filtering the screen patterns/noise in high-resolution color document images. Experimental results show that the method yields significant improvements in character pattern extraction.
Shoichi KAJIWARA Atsushi YAMAMOTO Koichi OGAWA Akihiro OZAKI Yoshio KOYANAGI
This paper addresses the variation of the attenuation characteristics of the Specific Absorption Rate (SAR) in a lossy medium as a function of the distance between an antenna and the medium with different EM-source sizes. Analysis and measurements were performed using a dipole antenna at 900 MHz and a COST244 cubic phantom. From this, an empirical equation has been derived, representing the attenuation characteristics of the SAR. The equation takes into consideration an energy loss due to the spatial spread of electromagnetic waves. In the case where an antenna is placed more than λ/2π away from the medium, the attenuation characteristics of the SAR are those obtained from plane waves in the lossy medium. In the case where a half-wavelength dipole antenna is located close to the medium, at a distance of less than λ/2π, the attenuation characteristics of the SAR are calculated from an equation that includes a loss caused by the spread of energy as a cylindrical wave. Moreover, when the length of antenna is short, it is found that a spatial attenuation factor appropriate to a spherical wave should be taken into account.