A linear-in-dB VGA of the current-divider type is fabricated in 0.25 µm CMOS technology. Two gain compensation techniques are proposed in order to compensate the gain deviations due to a MOSFET which has a square-law characteristic or an exponential-law characteristic determined by its current density. Temperature compensation techniques are also proposed. Measure results obtained at 380 MHz are a gain range of 80 dB, a gain error of 3 dB, and an NF of 11 dB.

This paper presents a modified microwave radio-thermometer (MRTM) with material characteristic estimator and multiple temperature conversion tables to measure subcutaneous temperature of a living body. This estimator provides a temperature retrieval unit with material characteristics such as permittivity, conductivity, thickness and geometry of the living body. The temperature retrieval unit with multiple temperature conversion tables can select one of the tables and compute temperature value corresponding to measured radiation power. In the experiments, it was shown that the radio-thermometer could reduce measurement errors of about 0.82 to 7.68 for the cases of distilled water and mixed liquid # 5 with thickness of 29.5 cm and 9.5 cm at the temperature of 37.

This paper describes the design of a 2.7 V operational, 200 MS/s, 14-bit CMOS D/A converter (DAC). The DAC consists of 63 current cells in matrix form for an upper 6-bit sub-DAC, and 8 current cells and R-2R ladder resistors for a lower 8-bit sub-DAC. A source degeneration resistor, for which a transistor in the triode operational region is used, is connected to the source of a MOS current source transistor in a current cell in order to reduce the influence of threshold voltage (Vth) variation and to satisfy the differential nonlinearity error specification as a 14-bit DAC. In conventional high-speed and high-resolution DACs that have the same design specifications described here, spurious-free dynamic range (SFDR) characteristics commonly deteriorate drastically as the frequency of the reconstructed waveform increases. The causes of this deterioration were carefully examined in the present study, finding that the deterioration is caused in part by the input-data-dependent time-constant change at the output terminal. Unexpected current flow in parasitic capacitors associated with current sources causes the change in the output current depending on the input data, resulting in time-constant change. In order to solve this problem, we propose a new output circuit to fix the voltage at the node where the outputs of the current sources are combined. SPICE circuit simulation demonstrates that 63 dB of SFDR characteristics for the 90 MHz reconstructed waveform at the output can be realizable when the supply voltage is 2.7 V, the clock rate is 200 MS/s, and the power dissipation is estimated to be 300 mW.

Appropriate test signals defined by formula or generated by algorithm are used for measuring objective QoS (Quality of Services) for voice operated telecommunication devices such as telephone and speech codec (coder-decoder). However, that for measuring residual echo characteristics in hands-free telecommunications equipped with acoustic echo canceller is under study in ITU-T Recommendation G.167. This paper describes comparative assessment of test signals for measurement of residual echo characteristics. In hands-free telecommunications, acoustical echo canceller has been developed to remove a room echo signal through the loudspeaker to the microphone in the receiving end. Performance of the echo canceller system is evaluated by residual echo characteristics expressed in echo return loss enhancement (ERLE). The ERLE can be conventionally measured by putting white noise into the echo canceller system. However, white noise is not adequate as the test signal for measuring the performance of the echo canceller, since the performance may depend on the characteristics of input test signal, and the characteristics of the white noise differ from those of real voice. Therefore, this paper discusses appropriate characteristics of real voice required for objective quality evaluation of echo canceller system. The test signals used for this verification tests were real voice (RV), white noise (WN), frequency weighted noise (FWN), artificial voice (AV), and composite source signal (CSS) depending on the approximation of real voice characteristics. As the comparative assessment results, the ERLE characteristics measured by artificial voice conforming to ITU-T Recommendation P.50 having average characteristics of real voices in time and frequency domains are almost equivalent to those of real voice and best among those test signals. It is concluded that artificial voice P.50 is satisfied with measurement of residual echo characteristics.

A design methodology of bandpass filters (BPFs) using λ/4 resonators for improving out-of-band characteristics is proposed. Firstly, the basic characteristics of various λ/4 resonators are examined. In this study, we focus on four types of λ/4 resonators, i.e., (1) direct-coupled λ/4 resonator, (2) loaded-element λ/4 resonator, (3) tapped λ/4 resonator and (4) loaded-element tapped λ/4 resonator. Secondly, the application examples of BPFs with improved out-of-band characteristics are provided. We examine the improvement of filter characteristics, i.e., sharp skirt characteristics and low spurious responses. The results of this study lead us to the conclusion that the methodology is very useful for improving the out-of-band characteristics of the BPFs using the λ/4 resonators.

For an uncertain discrete event system (DES) modeled as a set of some possible nondeterministic automata, we address robust supervisory control problems. Based on language models, this paper presents the existence conditions of a robust nonblocking (RN) supervisor that guarantees the absence of blocked states in a closed-loop system. We show that an RN supervisor achieves both a given language specification and the nonblocking characteristics of any nondeterministic automata of the set.

In cryptography, we want a Boolean function which satisfies PC(l) of order k for many (l,k). Let PCn(l,k) be a set of Boolean functions with n input bits satisfying PC(l) of order k. From a view point of construction, it is desirable that there exists (l0,k0) such that PCn(l0, k0) PCn(li,ki) for many i 1. In this paper, we show a negative result for this problem. We prove that PCn(l1,k1) PCn(l2,k2) for a large class of l1, k1, l2 and k2.

We propose an enhanced packet access scheme for IMT-2000/UMTS random access channel (RACH). In the proposed scheme, 2-level preamble detection threshold and 2-level message transmission power are used to mitigate the power imbalance in RACH. Simulation results demonstrate that the proposed scheme improves the interference characteristics of the conventional RACH and makes wider range of the detection threshold available.

The fields in the junctions between straight and curved rectangular waveguides are analyzed by using the method of separating variables. This method was succeeded because the authors developed the method of numerical calculation of the cylindrical functions of complex order. As a result, we numerically calculate the reflection and transmission coefficients in the junctions in various situations, and we compare these results with the results by the perturbation method and with the results by Jui-Pang et al.

We design a four-reflector offset antenna satisfying the cross-polarization elimination condition and the broadband characteristics condition which consists of one primary horn, three subreflectors and one main reflector. The cross-polarization elimination condition for the four-reflector offset antennas is expressed by the equations of hyperbolas with the coordinate axes of the reciprocal of equivalent focal lengths. The configurations of the reflector system are derived simply from the graphical representation because four-reflector offset antennas satisfying these relationships exist on the hyperbolas with the coordinate axes of the reciprocal of equivalent focal lengths. Furthermore, we clarified that the derived condition for having planar phase front applying the broadband characteristics condition is independent of frequency. An actual design example for the four-reflector offset antennas satisfying the cross-polarization elimination condition and the condition for having planar phase front, both of which are independent of frequency is shown. The design method using the graphical representation is simpler than that of the tri-reflector offset antennas.

Reactive near field reflection characteristics of commercial RF absorbers are investigated to determine the minimum size of a reactive-field anechoic box necessary for measuring the reactive near field of an ESPAR antenna. The reflectivity of the absorber placed in close proximity to an antenna is inversely proportional to the distance between the antenna and the absorber. For carbon filled urethane foam tapered absorbers, we find that the backscattered reflection characteristics mainly depend on their tapered height rather than the thickness of absorber base. As a result, we show that carbon filled urethane foam pyramidal and wave surface shaped absorbers can be used to make reactive-field anechoic boxes. A prototype of a reactive-field anechoic box is presented and the distance from the absorber to the antenna is reduced to a wavelength. The prototype is verified by comparing its performance with that obtained from a large anechoic chamber.

Many researches have been conducted on the recognition of Thai characters. Different approaches, such as neural network, syntactic, and structural methods, have been proposed. However, the success in recognizing Thai characters is still limited, compared to English characters. This paper proposes an approach to recognize the printed Thai characters using the hybrid of global feature, local features, fuzzy membership function and the neural network. The global feature classifies all characters into seven main groups. Then the local features and the neural network are applied to identify the characters.

In this paper, we present a method to analyze the steady-state performance of a complex coefficient adaptive IIR notch filter which is useful for the rejection of multiple narrow-band interferences from broad-band signals in quadrature phase shift keying (QPSK) spread-spectrum communication systems. The adaptive notch filter based on the simplified gradient algorithm is considered. Analytical expressions have been developed for the conditional mean and variance of notch filter output. The signal-to-noise ratio improvement factor is also obtained from which the validity of the use of the notch filter can be concluded. Finally, the results of computer simulations are shown which confirm the theoretical predictions.

In order to design oscillators and switches phase noise characteristic is the key to obtain high quality frequency spectrums. Since the phase noise is directly affected by the 1/f noise of transistors in the circuit, 1/f noise measurement and modeling are important. This paper describes 1/f noise measurement, frequency and bias dependent flicker noise model, and noise parameter extraction method of MOSFET's. Also, for MOSFET's geometry dependencies of drain current 1/f noise are analyzed and modeled. The model has been verified by measuring the noise current spectral density of MOSFET's in two different process devices.

In this paper, we discuss an IF image rejection system with variable bandwidth and center frequency. The system is consists of a pair of frequency mixers multiplied by the complex sinusoid and a complex analog filter. By employing the complex leapfrog structure using OTA-C configuration and the frequency transformation from the normalized LPF, the proposed system is capable of variable bandwidth and center frequency characteristics. SPICE simulations result more than 43 [dB] image rejection is achieved for 6 [kHz] and 12 [kHz] bandwidths at 50 [kHz] IF.

In this study, synchronization phenomena in chaotic oscillators coupled by a transmission line are investigated. In particular investigation using real circuits is done for the first time. It is confirmed that the chaotic subsystems synchronize, although signals propagating along the transmission line are affected by the time delay. Further the period-doubling bifurcation with varying the time delay and anti-phase synchronization phenomena are observed in our circuit model. Also the voltage distribution of transmission line is simulated in order to investigate whether the current flowing through the transmission line is constant or not. It is found that the subsystems synchronize although the current through the transmission line keeps on varying.

Power supply rejection ratio (PSRR) characteristics of a switched capacitor filter (SCF) is improved when using an equal level diagram design of a leapfrog type filter. By using this design method, it is shown that PSRR of a SCF measured is improved about 20 dB.

This paper introduces current-mode biquad using multiple current output operational transconductance amplifiers (OTAs) and grounded capacitors. The circuit configuration is obtained from a second-order integrator loop structure with loss-less and lossy integrators. The proposed circuit can realize low-pass, band-pass, high-pass, band-stop and all-pass transfer functions by suitably choosing the input and output terminals. And the circuit characteristics can be electronically tuned through adjusting the transconductance gains of OTAs. It is also made clear that the proposed circuit has very low sensitivities with respect to the circuit active and passive elements. An example is given together with simulated results by PSpice.

New equivalent characterizations are derived for Schur stability property of real polynomials. They involve a single scalar parameter, which can be regarded as a freedom incorporated in the given polynomials so long as the stability is concerned. Possible applications of the expressions are suggested to the latest results for stability robustness analysis in parameter space. Further, an extension of the characterizations is made to the matrix case, yielding one-parameter expressions of Schur matrices.

The current voltage characteristics of the ballistic metal oxide semiconductor field effect transistor (MOSFET) is reviewed. Reducing the carrier scattering by employing e.g. the intrinsic channel structure and the low temperature operation, nanometer to sub-0.1 µm size MOSFETs operation approaches the ballistic transport. The drain current is derived by analyzing the carrier behavior in the vicinity of the potential maximum in the channel. The carrier degeneracy and the predominant carrier distribution in the lowest subband around the maximum point have critical effects on the current value. A convenient approximation of the current in terms of terminal voltages is given. The current control mechanism is discussed with use of the "Injection velocity," with which carriers are injected from the source to the channel. An index to represent the ballisticity is given, and some published experimental data are analyzed. Transport of the quasi-ballistic MOSFET is discussed.