We introduce stepwise resonant excitation by two-color optical near fields in order to detect Rb atoms with a slit-type detector. Blue fluorescence of the second D2 line is monitored for background-free detection. Feasibility of the method is shown from an experiment with a Rb vapor cell, where a sub-Doppler spectrum with the FWHM of 80 MHz is obtained. The detection efficiency is estimated at about 3% for cold Rb atoms.

Finding corresponding edges is considered being the most difficult part of edge-based stereo matching algorithms. Usually, correspondence for a feature point in the first image is obtained by searching in a predefined region of the second image, based on epipolar line and maximum disparity. Reduction of search region can increase performances of the matching process, in the context of execution time and accuracy. Traditionally, hierarchical multiresolution techniques, as the fastest methods are used to decrease the search space and therefore increase the processing speed. Considering maximum of directional derivative of disparity in real scenes, we formulated some relations between maximum search space in the second images with respect to relative displacement of connected edges (as the feature points), in successive scan lines of the first images. Then we proposed a new matching strategy to reduce the search space for edge-based stereo matching algorithms. Afterward, we developed some fast stereo matching algorithms based on the proposed matching strategy and the hierarchical multiresolution techniques. The proposed algorithms have two stages: feature extraction and feature matching. We applied these new algorithms on some stereo images and compared their results with those of some hierarchical multiresolution ones. The execution times of our proposed methods are decreased between 30% to 55%, in the feature matching stage. Moreover, the execution time of the overall algorithms (including the feature extraction and the feature matching) is decreased between 15% to 40% in real scenes. Meanwhile in some cases, the accuracy is increased too. Theoretical investigation and experimental results show that our algorithms have a very good performance with real complex scenes, therefore these new algorithms are very suitable for fast edge-based stereo applications in real scenes like robotic applications.

An efficient algorithm is proposed for finding all dc solutions of piecewise-linear (PWL) circuits. This algorithm is based on a powerful test (termed the LP test) for nonexistence of a solution to a system of PWL equations in a given region using the dual simplex method. The proposed algorithm also uses a special technique that decreases the number of regions on which the LP test is performed. By numerical examples, it is shown that the proposed algorithm could find all solutions of large scale problems, including those where the number of variables is 500 and the number of linear regions is 10500, in practical computation time.

We present an efficient scheme for progressive fractal coding in a wavelet multiresolution pyramid. In our proposed scheme, range blocks are selectively coded, based on energy localization in wavelet bands. In order to form domain pools with blocks yielding less distortion, domain blocks are also selectively searched in the wavelet bands of either the same or a different orientation from that of each range block at the next lower resolution. It is shown that the performance of the non-hybrid fractal coder presented is much better than that of predictive pyramid coding (PPC).

The ranging algorithm allows active stations to measure their distances to the headend for synchronization purpose in Hybrid Fiber Coax (HFC) networks. A practicable mechanism to resolve contention among numerous stations is to randomly delay the transmission of their control messages. Since shorter contention cycle time increases slot throughput, this study develops three mechanisms, fixed random delay, variable random delay, and optimal random delay, to minimize the contention cycle time. Simulation demonstrates that the optimal random delay effectively minimizes the contention cycle time and approaches the theoretical optimum throughput of 0.18 from pure ALOHA. Furthermore, over-estimation reduces the impact on contention cycle time more than under-estimation through sensitivity analysis, and both phenomenon damage slot throughput. Two estimation schemes, maximum likelihood and average likelihood, are thereby presented to estimate the number of active stations for each contention resolution round. Simulation proofs that the proposed estimation schemes are effective even when the estimated number of active stations in initial contention round is inaccurate.

An effective spatial resolution enhancement method for distributed strain measurement by BOTDR is proposed. An optical fiber is glued to a structure by a length less than the spatial resolution defined by the pulse width, and the Brillouin spectrum of the light scattered from the glued optical fiber is investigated theoretically. The apparent strain xp observed in the fiber is found to be proportional to the accurate strain a. The ratio r=xp/a coincides with the ratio of the glued length to the spatial resolution. Spatial resolution as small as 0.2 m is demonstrated experimentally for small strains of less than 10-3.

A multi-range resolution radar using sideband spectrum energy is investigated. The basic system consists of a sharpening processor and least-error energy shaping filters. First, the sharpening processor makes long flat pulses sharpened. Next, the least-error shaping filters compress the input pulse into the desired pulse width. Then the output pulse width can become narrower than the reciprocal of the input bandwidth, because the least-error shaping filters make the equivalent bandwidth expanded by the enhancement of the sideband spectrum energy and the suppression of the main spectrum. The transmitted signals with simple phase modulation are studied to obtain the multi-range resolution where the pulse is compressed into a pulse with the same bandwidth and another pulse width equal to the reciprocal of the input bandwidth. The peak-to-sidelobe ratio after the pulse compression and the improvement factor of the output signal-to-noise ratio are measured. Further, the experimental results are shown to verify our proposed technique.

This paper proposes a quasi-coherent equivalent-time sampling method to acquire repetitive wideband waveform signals with high throughput. We have already proposed a new sampling system which incorporates the pre-trigger ability and the time jitter reduction function for a fluctuated input signal while maintaining the waveform recording efficiency. The quasi-coherent sampling method proposed in this paper can be adopted to it in order to improve its data acquisition throughput significantly. Numerical simulation results show effectiveness of our proposed method.

The constant-Q based wavelet transform is the most effective means of quantitatively characterizing high frequency transient signals. This study develops a novel non constant-Q based multi-resolution transform (NCQM) and provides a precision analysis descriptor for both low and high frequency transients. The properties of this novel NCQM kernel are thoroughly examined and then the striking conceptual resemblance, energy conservation characteristic, and power spectrum close forms are derived. The rapid algorithm of NCQM is also presented and its excellent performance in noisy environments is demonstrated.

We have developed and demonstrated a novel technique for electrical inspection and electrical failure analysis, which can detect open, high-resistance, and short circuits without the need for electrical contact with the outside of the LSI chip or the board on which the LSI chip is mounted. The basic idea of the technique is the detection of the magnetic field produced by OBIC (optical beam induced current) or photo current. A DC-SQUID (superconducting quantum interference device) magnetometer is used to detect the magnetic field. This scanning laser-SQUID microscopy ("laser-SQUID" for short) has a spatial resolution of about 1.3 µm. It can be used to distinguish defective chips before bonding pad patterning or after bonding without pin-selection. It can localize any defective site in the chip to within a few square microns.

The purpose of our study is to estimate the imaging of ischemic myocardial muscles in rats. The magnetocardiograms (MCG) of rats were measured by a 12-channel high resolution gradiometer, which consisted of 5 mm diameter pick-up coils with a 7.5 mm distance between each coil. MCGs of seven male rats were measured in a magnetically shielded room pre and post coronary artery occlusion. The source imaging was estimated by minimum norm estimation (MNE). Changes of the current source imaging pre- and post coronary artery occlusion were clarified. As a result, in the ST segment, the current distribution significantly increased at the ischemic area. In the T wave, the direction of the current distribution clearly shifted to the left thorax. We proved that the increased area of the current distribution in the ST segment was related to the ischemic area of the ventricular muscles.

We summarize recent studies on performance improvement in the correlation-based continuous-wave technique for optical fiber distributed strain measurement using Brillouin scattering, that had been proposed previously. The correlation-based technique enables the spatial resolution of 1 cm, which is difficult for conventional sensing techniques using Brillouin scattering to achieve. Though the correlation-based technique left a problem with measurement range, we have proposed methods to overcome it with keeping high spatial resolution. In addition, we verified usefulness of the technique for smart materials by measuring strain distribution along surface of a ring structure.

This paper describes how the symmetry of a three-phase circuit prevents the symmetric modes of several subharmonic oscillations. First, we make mathematically it clear that the generation of symmetrical 1/3l-subharmonic oscillations (l=1,2,) are impossible in the three-phase circuit. As far as 1/(3l+1)-subharmonic oscillations (l=1,2,) and 1/(3l+2)-subharmonic oscillations (l=0,1,) are concerned, the former in negative-phase sequence and the latter in positive-phase sequence are shown to be impossible. Further, in order to confirm the above results, we apply the method of interval analysis to the circuit equations and obtain all steady state solutions with unsymmetric modes.

Recently a high-resolution image that has more than one million pixels is available easily. However, such an image requires much processing time and memory for an image understanding system. In this paper, we propose an integrated image understanding system of multi-resolution analysis and multi-agent-based architecture for high-resolution images. The system we propose in this paper has capability to treat with a high-resolution image effectively without much extra cost. We implemented an experimental system for images of indoor scenes.

We have manufactured a trial 'Digital Packet Video (PV) Link' system for super high-resolution display. 'Digital PV Link' is a new data transmission protocol where the host transfers video data with attributes for only a selected area such as a motion picture window. This protocol handles the video data with an ID, which can be used for handling between plural hosts and plural displays such as multi display. This ID also makes the display to handle plural windows in accordance with different parameter such as scaling factor, color-adjust, and so on. In this protocol, error handling is a key because the video data is transferred only when the host wants to change display data. So, we have examined transmission errors and capability for motion pictures by using this trial system. In this report, we will introduce the concept and the characteristics of 'Digital PV Link,' and the result of examination.

Recently, an efficient algorithm has been proposed for finding all solutions of systems of nonlinear equations using inverses of approximate Jacobian matrices. In this letter, an effective technique is proposed for improving the computational efficiency of the algorithm with a little bit of computational effort.

We show some results concerning the number of solutions of the equation y+Ax=b (yTx=0, y0, x0) which plays a central role in the dc analysis of transistor circuits. In particular, we give sufficient conditions for the equation to possess exactly 2l (ln) solutions, where n is the dimension of the vector x.

This paper presents a novel image coding scheme based on separate coding of region and residue sources. In a subband image coding scheme, quantization errors in each subimage spread over the reconstructed image and result in a blurring or a boundary artifact. To obtain high compression ratio without considerable degradation, an input image, in our scheme, is separated into region and residue sources which are coded using different coding schemes. The region source is coded by adaptive arithmetic coder. The residue source is coded using multiresolution subimages generated by applying a subband filter. Each block in the subimages is predicted by an affine transformation of blocks in lower resolution subimages. Experimental results show that a high coding efficiency is achieved using the proposed scheme, especially in terms of the subjective visual quality and PSNR at low bit-rate compression.

Feasibility of a color shutter using ferroelectric liquid crystal polymer panel and a field sequential ultra high-resolution CRT with the color shutter as a color field-switching device was studied. The color shutter consists of ferroelectric liquid crystal polymer panels and color polarizers. First, evaluation indices of the color shutter, such as the color gamut, the average transmittance and the white chromaticity shift, were formulated, and the simulation of evaluation indices was examined, where the spectral transmittance characteristics of the polarizer were changed in steps. It was indicated that there was a tradeoff between the color gamut and the average transmittance of the color shutter, and the shutter configuration that provides 0.096 (63% to NTSC) color gamut and 4.3% average transmittance was selected based on the simulation results. Next, the three-line simultaneous scanning method of the monochrome CRT was improved so that the disturbance due to the raster modulation was eliminated by averaging the distribution of beam luminance apparently. To confirm results of the study, the prototype of 21-inch screen size was produced, and the following display characteristics was obtained: luminance of 71 cd/m2, contrast ratio of 146:1 and color gamut of 0.096 (63% to NTSC) under the standard room lighting environment.

This paper proposes resolution enhancement techniques for high-speed multi-stage pipelined analog-to-digital converters (ADC's) based on a multi-bit/stage multiplying digital-to-analog converter. The proposed techniques increase ADC resolution and simultaneously minimize chip area, power dissipation, and circuit complexity by removing the gain-proration procedure, which is required in conventional digitally calibrated multi-stage ADC's to reduce unavoidable gain errors between stages with more than two stages calibrated. The resolution of the proposed ADC can be extended furthermore by combining a conventional commutated feedback-capacitor switching scheme with the digital-domain self calibration.