A leakage-aware Coordinated Scheduling/Coordinated Beamforming (CS/CB) scheme for heterogeneous networks with layered limited feedback is proposed. In particular, all pico cells cooperatively select an optimal beamforming vector for the macro cell within a CoMP cluster so as to minimizing leakage power from the macro cell. Simulations show that the proposed scheme outperforms the conventional non-CoMP scheme with perfect channel state information at teansmitter (CSIT). Furthermore, the feedback amount and scheduler complexity is decreased greatly.

In this letter, we reduce the computational complexity of the conventional iterative MMSE-ML signal detection method for multiple input multiple output (MIMO) single carrier FDMA (SC-FDMA) systems, without compromising the error performance. Complexity analysis confirms the efficacy of the proposed modification.

Streak cameras are now widely used for measurements of ultra short phenomena, such as those in semi conductor luminescence and plasma gaseous discharge. To further improve the temporal resolution and carry out higher-dimensional measurements, it is necessary to understand the electron beam behavior in detail. Thus, numerical simulations play an important role in the analysis of the streak camera. The authors have been working on the development of a numerical simulation code that uses the finite difference method (FDM) for electric field analysis, the Runge-Kutta (R-K) method for charged particle motion determination, and the particle-in-cell (PIC) method for charge density calculation. However, the use of the PIC method leads to inaccuracy in the charge density calculation in cases of high-density electron beams. To improve the accuracy of the conventional analysis of the streak camera, we perform the boundary element (BE) analysis of the streak camera.

For the modeling of multipath propagation in every wireless systems, the ray tracing method has been widely studied. However, large errors may result due to the approximation of geometrical optics in curved surfaces. This paper therefore focused on the curved surfaces and edges, which are difficult to handle in ray tracing. Examples of curved surfaces can be found in arched cross-section tunnels which are common in highway networks of mountainous areas. The traditional ray tracing method of dividing the curved surface into smaller flat plates is not so accurate as the size of smaller plates may not satisfy the geometrical optics assumption, and the reflection point which satisfies Fermat's principle may not exist. In this work, a new ray tracing method is proposed with 2 contributions. The first one is the implementation of the reflection coefficient for curved surfaces in ray tracing. The second is applying the physical optics method on the caustics region. To evaluate these methods, path gain simulation results for an arched cross-section model are compared with measurements made inside an arched tunnel. To further improve the simulation results, the effect of rough surface is introduced, and the results are again compared with measurement.

We deal with the scattering of a scalar plane wave by a half plane with a sinusoidally deformed edge from a straight edge by a physical optics approximation. The normal incidence of a plane wave to an edge is assumed. A contribution of an edge to the field integral is asymptotically evaluated and the basic properties of the scattering caused by the edge deformation is clarified. The scattering pattern has peaks at specific scattering angles, which agree with diffraction angles calculated by the well-known grating formula for normal incidence. Some numerical examples are shown and it is shown that the results are in good agreement with the results obtained by the GTD method for low angle incidence.

To reduce the power dissipation of the receiver in accordance with the intensity of the received signal, we developed the first intra-symbol intermittent (ISI) radio-frequency (RF) front end with 0.35-µm CMOS technology. In the demodulation mechanism, the RF output of the low-noise amplifier (LNA) is down-converted to an intermediate frequency (IF) by the mixer, and the LNA and mixer operate synchronously and intermittently within the length of a single symbol. Because the time-averaged power consumption is proportional to the operating time, the demodulation can be performed with low power by making the total operating time short. We experimentally demonstrate that demodulation (BPSK: 9.6 kbps) is properly achieved with the operating-time ratio of 12%. This ISI operation of the RF front end is enabled by a newly devised fast-transition LNA and mixer. A theoretical analysis of aliasing noise reveals that RF ISI operation is more useful than current-control with continuous operation and that an operating-time ratio of 10% is optimal.

A semi-analytical method for a planar periodic array formed by a finite number of magnetized ferrite circular cylinders is presented using a model of layered cylindrical structures. The method uses the T-matrix approach and the extraction of the reflection and transmission matrices based on the cylindrical harmonic mode expansion. Based on the proposed method, plane wave scattering by the finite number of magnetized ferrite circular cylinders is numerically studied from the viewpoint of realization the electronic switching and electronic scanning effects by varying the applied magnetic field.

Product return is a critical but controversial issue. To deal with such a vague return problem, businesses must improve their information transparency in order to administrate the product return behaviour of their end users. This study proposes an intelligent return administration expert system (iRAES) to provide product return forecasting and decision support for returned product administration. The iRAES consists of two intelligent agents that adopt a hybrid data mining algorithm. The return diagnosis agent generates different alarms for certain types of product return, based on forecasts of the return possibility. The return recommender agent is implemented on the basis of case-based reasoning, and provides the return centre clerk with a recommendation for returned product administration. We present a 3C-iShop scenario to demonstrate the feasibility and efficiency of the iRAES architecture. Our experiments identify a particularly interesting return, for which iRAES generates a recommendation for returned product administration. On average, iRAES decreases the effort required to generate a recommendation by 70% compared to previous return administration systems, and improves performance via return decision support by 37%. iRAES is designed to accelerate product return administration, and improve the performance of product return knowledge management.

Compressive sensing (CS) shows that a sparse or compressible signal can be exactly recovered from its linear measurements at a rate significantly lower than the Nyquist rate. As an extreme case, 1-bit compressive sensing (1-bit CS) states that an original sparse signal can be recovered from the 1-bit measurements. In this paper, we intrduce a Fast and Accurate Two-Stage (FATS) algorithm for 1-bit compressive sensing. Simulations show that FATS not only significantly increases the signal reconstruction speed but also improves the reconstruction accuracy.

This paper describes downlink throughput performances measured in a mobile broadband wireless access (MBWA) system field trial with Fast Low-latency Access with Seamless Handoff Orthogonal Frequency Division Multiplexing (FLASH-OFDM). The field trial results show that the downlink cell sizes are 0.4 km2, 0.6 km2, and 1.7 km2 when the sector antenna heights are 19 m, 58 m, and 84 m, respectively, assuming the following items. (1) The cell shape is circular. (2) The cell edge is defined as the location where the average downlink throughput is 1.5 Mbit/s.

Fault-based attacks are very powerful to recover the secret key for cryptographic implementations. In this work, we consider the faulty output value under a certain fault injection intensity as a new type of leakage called faulty behavior. We examine the data-dependency of the faulty behavior and propose a related side-channel attack called fault behavior analysis (FBA). To verify the validity of the proposed attack, we first show that our attack can work effectively on AES-COMP of SASEBO-R. Then we show how to apply the similar attack on two AES implementations with masking countermeasures, i.e., AES-MAO and AES-TI. Finally we compare the proposed FBA attack with the DFA attack and the FSA attack, trying to complete the research map for the fault-based attack based on setup-time violations.

Context awareness is one of the ultimate goals of ubiquitous computing, and spatial information plays an important role in building context awareness. In this paper, we propose a new interoperable spatial information model, which is based on ucode relation (ucR) and Place Identifier (PI), for realizing ubiquitous spatial infrastructure. In addition, we propose a design environment for spatial information database using our model. Our model is based on ucode and its relation. ucode is 128 bits number and the number itself has no meaning. Hence, it is difficult to manage the relation between ucodes without using a tool. Our design environment provides to describe connection between each ucode visually and is able to manipulate data using the target space map interactively. To evaluate the proposed model and environment, we designed three spaces using our tool. In addition, we developed a web application using our spatial model. From evaluation, we have been showed that our model is effective and our design environment is useful to develop our spatial information model.

Repairing embedded memories (e-memories) on an advanced system-on-chip (SoC) product is a key technique used to improve product yield. However, increasing the die area of SoC products equipped with various types of e-memories on the die is an issue. A fuse scheme can be used to resolve this issue. However, several fuse schemes that have been proposed to decrease the die area result in an increased repair time. Therefore, in this paper, we propose a novel fuse scheme that decreases both die area and repair time. Moreover, our approach is applied to a 65 nm SoC product. The results indicate that the proposed fuse scheme effectively decreases the die area and repair time of advanced SoC products.

In this letter, a low complexity decoder for non-binary low-density parity-check (LDPC) codes in a multiple-input and multiple-output (MIMO) channel is proposed employing Quasi-orthogonal space-time block code (QOSTBC). The complexity of the proposed decoding algorithm involved grows linearly with the number of transmit antennas and order of Galois Field.

The thermionic emission properties of diamond micropowders were investigated. The thermionic emission current was observed at a low temperature of 702 K, and a work function of approximately 1.97 eV was obtained. Band bending in diamond micropowders induced by an applied electric field had a considerable influence on decreasing the work function.

We study the security of AES in the open-key setting by showing an analysis on hash function modes instantiating AES including Davies-Meyer, Matyas-Meyer-Oseas, and Miyaguchi-Preneel modes. In particular, we propose preimage attacks on these constructions, while most of previous work focused their attention on collision attacks or distinguishers using non-ideal differential properties. This research is based on the motivation that we should evaluate classical and important security notions for hash functions and avoid complicated attack models that seem to have little relevance in practice. We apply a recently developed meet-in-the-middle preimage approach. As a result, we obtain a preimage attack on 7 rounds of Davies-Meyer AES and a second preimage attack on 7 rounds of Matyas-Meyer-Oseas and Miyaguchi-Preneel AES. Considering that the previous best collision attack only can work up to 6 rounds, the number of attacked rounds reaches the best in terms of the classical security notions. In our attacks, the key is regarded as a known constant, and the attacks thus can work for any key length in common.

In this paper, we put forward a new method to construct n-variable Boolean functions with optimal algebraic immunity based on the factorization of n. Computer investigations for small values of n indicate that a class of Boolean functions constructed by the new method has a very good nonlinearity and also a good behavior against fast algebraic attacks.

Self-encoded spread spectrum (SESS) derives its spreading codes from the random information source rather than using traditional pseudo-random codes. It has been shown that the memory in SESS modulated signals not only can deliver a 3 dB gain in additive white Gaussian noise (AWGN) channels, but also can be exploited to achieve time diversity and robust bit-error rate (BER) performance in fading channels. In this paper, we propose an extension to SESS, namely coded-sequence self-encoded spread spectrum (CS-SESS), and show that it can further improve the BER performance. We describe the CS-SESS scheme and present the theoretical analysis and simulation results for AWGN and fading channels. Iterative detector is developed to exploit the inherent temporal diversity of CS-SESS modulation. The simulation results show that it can achieve the expected 4.7 dB gain with a complexity that increases linearly with the spreading sequence length under AWGN. In Rayleigh fading channel, it can effectively mitigate the fading effects by exploiting the overall diversity gain. Chip interleaving is shown to yield a performance improvement of around 4.7 dB when compared to an chip interleaved direct sequence spread spectrum (DSSS) system.

In large-scale data centers, two types of network are implemented: local area networks (LANs) and storage area networks (SANs). To achieve simple network management, integration of these two networks by Ethernet technology is of great interest. A SAN requires a significantly low frame loss rate. To integrate LANs and SANs, a multi-hop Ethernet configuration is generally used, and congestion may occur in traffic hot spots. Therefore, layer-2 congestion control that prevents frame loss in multi-hop Ethernet, Quantized Congestion Notification (QCN), is now discussed in IEEE 802.1Qau. In this paper, we evaluate QCN's throughput performance and reveal a technical problem with fairness among active flows. We also propose Adaptive BC_LIMIT for QCN where BC_LIMIT is adaptively decided according to current transmission rate of flows. Simulation results show that our proposed method significantly improves fairness among QCN flows.