This paper proposes a suboptimal algorithm for the maximum likelihood detection (MLD) in multiple-input multiple-output (MIMO) communications. The proposed algorithm regards transmitted signals as continuous variables in the same way as a common method for the discrete optimization problem, and then searches for candidates of the transmitted signals in the direction of a modified gradient vector of the metric. The vector is almost proportional to the direction of the noise enhancement, from which zero-forcing (ZF) or minimum mean square error (MMSE) algorithms suffer. This method sets the initial guess to the solution by ZF or MMSE algorithms, which can be recursively calculated. Also, the proposed algorithm has the same complexity order as that of conventional suboptimal algorithms. Computer simulations demonstrate that it is much superior in BER performance to the conventional ones.

A 1-V operational sigma-delta modulator with a second-order passive switched capacitor filter is designed and fabricated by using a 90 nm CMOS process. No gate-voltage bootstrapped scheme is adopted to drive analog switches, and the voltage gain of a comparator is chosen to be 94 dB. The experimental results show that the peak SNR reached 68.9 dB with a frequency bandwidth of 40 kHz when the clock was 40 MHz.

A new method of cancellation of IM3 using current feedback has been proposed for a multi-stage RFIC amplifier. In order to cancel the IM3 present in an output signal of the amplifier, the IIP3 level and IM3 phase of the amplifier are adjusted by means of feedback circuit techniques, so that the target specification is satisfied. By estimating the IIP3 level and IM3 phase variations for two states in situations with and without feedback possessing linear factors, the parameters of a feedback circuit can be calculated. To confirm the validity of the method, we have investigated two approaches; one including an analytical approach to designing a two-stage feedback amplifier, achieving an IIP3 level improvement of 14.8 dB. The other method involves the fabrication of single-stage amplifiers with and without feedback, operating at 850 MHz, both of which were designed as an integrated circuit using a 0.18 µm SiGe BiCMOS process. The fabricated IC's were tested using a load-pull measurement system, and a good agreement between the estimated and measured IIP3 level and IM3 phase variations has been achieved. Further studies show that the error in these variations, as estimated by the method, has been found to be less than 1.5 dB and 15 degrees, respectively, when the load admittance at 1701 MHz was greater than 1/50 S.

With the rapid progress of electronic and information technology, an expectation for the realization of body area network (BAN) has risen. However, on-body transmission characteristics are greatly dependent on the frequency, and a high-speed transmission is difficult due to the remarkable signal attenuation at higher frequencies. In this study, we proposed a pulse transmission system with the frequencies at dozens of mega-hertzes. The system was based on an impulse radio (IR) scheme with bi-phase modulation. By using the frequency-dependent finite difference time domain (FD2TD) method, we investigated the on-body transmission characteristics and derived a path loss expression. Based on the transmission characteristics, we also investigated the influences of white Gaussian noises and other narrow-band interferences on the communication link budget and bit error rate (BER) performance. The results have shown the feasibility of the proposed on-body IR communication system.

An improved Max-Log-Map (MLM) turbo equalization algorithm called Scaled Max-Log-Map (SMLM) iterative equalization is presented. Simulations show that the scheme can dramatically outperform the MLM besides it is insensitive to SNR mismatch. Unfortunately, its performance is still much worse than that of Log-Map (LM) with exact SNR over high-loss channels. Accordingly, we also propose a new SNR estimation algorithm based on the reliability values of soft output extrinsic information of SMLM decoder. Using the new scheme, we obtain good performance close to that of LM with ideal knowledge of SNR.

In this research, the performance degradation of the digital electronic equipment under electromagnetic (EM) disturbance was studied in order to investigate the interference of intra-equipment. To develop the evaluation method of the performance degradation, some communication indexes were measured under EM disturbance. From some experimental results, it is known that the performance degradation of the electronic equipment was estimated by the degradation of "through-put," one of the communication performance indexes. For further investigation of the interference of intra-equipment, the near EM field from a PCB of the electronic equipment and its performance degradation under EM disturbance were measured and compared. From the measured results, the relationship between near field measurement and performance degradation could be obtained in some extent. These facts enable us that the weak area under the EM disturbance application on PCB can be foreseen by measuring the near field emission from the equipment and vise versa.

We propose a method of crosstalk analysis for two bent transmission lines with vias at both ends on a PCB using a circuit-concept approach in the quasi-static condition. In this condition, the electromagnetic fields can be approximately estimated by the quasi-static terms of the accurate Green's function in an inhomogeneous medium. Thus we obtain a circuit model in an ABCD matrix by taking account of the fields generated by a longitudinal line and a vertical via on a PCB. To verify the proposed approach, we conducted some experiments and compared our approach's results with measured results and a commercial electromagnetic solver's results.

The peak SAR values of two-element array antennas for mobile handsets in the vicinity of a spherical phantom of a human head are evaluated numerically as a function of the distance between the array antenna and the head phantom when the two elements of a two-element array antenna are either co-phase voltage-fed or reverse-phase voltage-fed. It is found that relation between the worst case of the SAR and the phase difference of array elements strongly depends on the distance. When part of the head phantom is located in the reactive near-field region of the array antenna, although the co-phase feed SAR value is slightly smaller than the reverse-phase feed SAR value, the SAR value is practically independent of the phase difference, but when the head is completely outside the reactive near-field region, the co-phase feed SAR value is larger than the reverse-phase feed SAR value.

An age-group classification method based on a fusion of different classifiers with different two-dimensional feature extraction algorithms is proposed. Theoretically, an integration of multiple classifiers can provide better performance compared to a single classifier. In this paper, we extract effective features from one sample image using different dimensional reduction methods, construct multiple classifiers in each subspace, and combine them to reduce age-group classification errors. As for the dimensional reduction methods, two-dimensional PCA (2DPCA) and two-dimensional LDA (2DLDA) are used. These algorithms are antisymmetric in the treatment of the rows and the columns of the images. We prepared the row-based and column-based algorithms to make two different classifiers with different error tendencies. By combining these classifiers with different errors, the performance can be improved. Experimental results show that our fusion-based age-group classification method achieves better performance than existing two-dimensional algorithms alone.

In this paper, we propose a predictive block-constrained trellis-coded quantization (BC-TCQ) to quantize cepstral coefficients for distributed speech recognition. For prediction of the cepstral coefficients, the first order auto-regressive (AR) predictor is used. To quantize the prediction error signal effectively, we use the BC-TCQ. The quantization is compared to the split vector quantizers used in the ETSI standard, and is shown to lower cepstral distance and bit rates.

This paper discusses the resistive termination of on-chip high-performance interconnects. Resistive termination is effective to improve the bandwidth of on-chip interconnects, on the other hands, increases the power dissipation and the area. Therefore trade-off analysis about resistive termination is necessary. This paper proposes a method to determine the termination of on-chip interconnects. The termination derived by the proposed method provides minimum sensitivity to process variation as well as maximum eye-opening in voltage.

A novel PND (PMOS-NMOS-Depletion MOS) technology for a single poly gate non-volatile memory cell design has been reported for the first time. This technology features memory cell design with a differential cell architecture which enables to provide the higher performance for the key specifications such as programming time, erasing time, and endurance characteristics. This memory cell consists of 3-Transistors, PMOS, NMOS, and Depletion MOS transistors (hereafter PND). The DMOS in this cell is used for the tunneling device in the erasing operation, while the NMOS and the PMOS are used for the tunneling device and the coupling capacitor in the programming operation, respectively. The proposed PND design can allow lower applied voltage of the erase-gate (EG) and control-gate (CG) in the erasing and the programming operations so that the endurance characteristics can be improved because the DMOS suppresses the potential of floating-gate (FG) and hence the effective potential difference between the EG and the FG can be increased in the erasing operation. Based on the measured data, it can be expected that the erasing speed of the PND cell can be 125-fold faster than that of our previously reported work (PN type). Therefore, high performance and high reliability CMOS non-volatile memory without any additional process can be realized using this proposed PND technology.

This paper presents a method for lossy compression of digital video data by parametric line and Natural cubic spline approximation. The method estimates the variation of pixel values in the temporal dimension by taking group of pixels together as keyblocks and interpolating them in Euclidean space. Break and fit criterion is used to minimize the number of keyblocks required for encoding and decoding of approximated data. Each group of pixels at fixed spatial location is encoded/decoded independently. The proposed method can easily be incorporated in the existing video data compression techniques based on Discrete Cosine Transform or Wavelet Transform.

Antimony tilt implantation has been utilized for source and drain extension formation of n-MOSFETs. The tilt implantation is a very convenient method to provide adequate overlap between the extensions and a gate electrode. MOSFET drive current was effectively improved by the tilt implantation without degrading short channel effects.

In this paper a multi-channel MAC protocol with dynamic channel allocation (MMAC-DCA) in CDMA Ad Hoc networks is proposed. Under MMAC-DCA, the service sub-channels are dynamically allocated by the RTS/CTS dialogue on the common sub-channel, only when a node has a packet to transmit. In addition, a Markov mode is presented to analyze the performance of MMAC-DCA.

An adaptive array code acquisition for direct-sequence/code-division multiple access (DS/CDMA) systems was recently proposed to enhance the performance of the conventional correlator-based method. The scheme consists of an adaptive spatial and an adaptive temporal filter, and can simultaneously perform beamforming and code-delay estimation. Unfortunately, the scheme uses a least-mean-square (LMS) adaptive algorithm, and its convergence is slow. Although the recursive-least-squares (RLS) algorithm can be applied, the computational complexity will greatly increase. In this paper, we solve the dilemma with a low-complexity conjugate gradient (LCG) algorithm, which can be considered as a special case of a modified conjugate gradient (MCG) algorithm. Unlike the original conjugate gradient (CG) algorithm developed for adaptive applications, the proposed method, exploiting the special structure inherent in the input correlation matrix, requires a low computational-complexity. It can be shown that the computational complexity of the proposed method is on the same order of the LMS algorithm. However, the convergence rate is improved significantly. Simulation results show that the performance of adaptive array code acquisition with the proposed CG algorithm is comparable to that with the original CG algorithm.

Blueweb is a self-organizing Bluetooth-based multihop network equipped with a scatternet formation algorithm and a modified source routing protocol. In this paper, we first review the basic Blueweb network. Then we focus on a heuristic automatic configuration algorithm which can be used to partition a large-scale Blueweb network. This algorithm contains three main functional blocks including route master selection, node assignment, and subnet number decision. The route master selection block selects new route masters at a low computation cost. The node assignment block assigns nodes to each newly configured subnet in order to minimize the average route query cost. The subnet number decision block determines the optimal number of subnet which achieves the largest system performance improvement ratio at minimum operation cost. With these three functional blocks, optimal network configuration for Blueweb routing protocol can be determined. Computer simulations show that a configured Blueweb achieves higher network capacity than an unconfigured Blueweb.

We propose a novel paging scheme with a variable paging interval for low power consumption and/or short paging delay. The proposed scheme is based on the fact that packet arrivals during a session follow the characteristics of self-similar process for Http service, while session arrival statistics can be modeled as the Poisson process. The adjustment of paging period provides a useful solution for efficient paging to the UE in the dormant state on packet-switched cellular networks, even though the paging performance is strongly dependent on the traffic arrival model.

In this letter we investigated the packet transmission control in downlink CDMA cellular systems. The downlink packet transmission control scheme based on the soft handoff status was proposed to enhance the system performance. The proposed scheme controls the downlink packet transmissions by employing a transmission window which is individually resolved to each mobile station according to its propagation condition and soft handoff status. Computer simulation shows that compared with the conventional scheme the proposed scheme improved the delay performance and fairness of service in packet reception.

Multiple antennas are used to an essential part in order to support high link quality in wireless communication systems. The diversity techniques with multiple antennas provide better reliability than existing systems. But these techniques generally require more than one antenna at the transmitter or receiver. So, the system with multiple antennas has several limitations including size, cost, hardware complexity, and antenna space. In this letter, we propose a cooperative transmission technique that uses space time delay code in OFDMA uplink system; DVB-RCT. The proposed technique overcomes these limitations and gives the diversity gain of cooperative transmission in a concept of virtual MIMO with single transmit antenna.