This paper describes an oversampling analog-to-digital converter (ADC) suitable for PCM codes. Non-linear 5-level quantizer is implemented to noise-shaping modulator. This ADC meets the specifications of ITU-T G.712, in spite of using first order delta-sigma modulator, and realizes low power operation. This chip is fabricated in 0.8 µm double-poly and double-metal CMOS process and occupies a chip area of 15 mm2. Maximum power consumption is 12.8 mW with a single +3 V power supply including DAC and TONE generator.

Tremendous progress has been made in magnetic data storage by applying theoretical considerations to technologies accumulated empirically through a great deal of research and development. In Japan, the recording demagnetization phenomenon was eagerly analyzed by many researchers because it was a serious problem in analogue signal recording such as video tape recording using a relatively thick magnetic recording medium. Consequently, perpendicular magnetic recording was proposed as a method for extremely high-bit-density recording. This paper describes the theoretical background which has resulted in the idea of perpendicular magnetic recording. Furthermore, the possibility of magnetic recording is discussed on the basis of the results obtained theoretically by magnetic recording simulators. Magnetic storage has the potential for extremely high-bit-density recording exceeding 1 Tb/cm2. We propose the idea of 'spinic data storage' in which binary digital data could be stored into each ferromagnetic single-domain columnar particle when the perpendicular magnetizing method is used.

The use of existing metallic local line facilities is being studied for providing "video on demand (VOD)" services to residential subscribers across asymmetric digital subscriber lines (ADSL). ADSL carries a high-rate channel in the downstream direction from a central office (CO) to the subscriber, and a low-rate channel in both directions on an existing 2-wire pair. Audio and video signals are compressed by the moving picture experts group's standardized algorithms (MPEG 1 and MPEG 2), and delivered to the subscriber in the high-rate channel. Control (demand and response) signals are transceived in the low-rate channel. This paper presents the line length coverage of ADSL systems given the environment of NTT's local networks. The bit rates in the downstream and upstream directions are assumed to be 1.6-9.2Mbit/s and 24kbit/s, respectively. Two types of ADSL systems are considered: transceiving ADSL signals using the plain old telephone service (POTS) line or the basic rate access (BRA; 320 kbaud ping-pong transmission system) line on the same 2-wire pair. 16-QAM, 32-QAM and 64-QAM are compared as transmission schemes. Intra-system crosstalk interference (interference between identical transmission systems) and inter-system crosstalk interference (interference between different transmission systems) with the existing digital subscriber lines (DSL) are estimated. It is shown that the inter-system crosstalk interference with BRA is most stringent, and ADSL with 16-QAM yields the best performance in NTT's local networks. This paper concludes that realizing ADSL with 16-QAM can achieve channel capacities of up to 9.2Mbit/s for fiber-in-the-feeder (FITF) access systems, but the possibility of applying ADSL to direct access systems is remote except for a restricted short haul use. Some comparisons regarding American local networks are also described.

Feasibility of 20 Gbit/s single channel transoceanic soliton transmission systems with a simple EDFA repeaters configuration has been studied. Both a simple and versatile soliton pulse generator and a polarization insensitive optical demultiplexer, which can provide a almost square shape optical gate with duration of full bit time period, have been proposed and demonstrated by using sinusoidally modulated electroabsorption modulators. The optical time-division multiplexing/demultiplexing scheme using the optical demultiplexer results in drastic improvement of bit error rate characteristics. We have experimentally confirmed that the use of alternating-amplitude solitons is an efficient way to mitigate not only soliton-soliton interaction but also Gordon-Haus timing jitter constraints in multi-ten Gbit/s soliton transmission. Timing jitter reduction using relatively wide band optical filter bas been investigated in 20 Gbit/s loop experiments and single-carrier, single-polarization 20 Gbit/s soliton data transmission over 11500 km with bit error rate of below 10-9 has been experimentally demonstrated, using the modulator-based soliton source, the optical demultiplexer, the alternation-amplitude solitons, and wide-band optical filters. Obtained 230 Tbit/skm transmission capacity shows the feasibility of 20 Gbit/s single channel soliton transoceanic systems using fully practical technologies.

We measured the longitudinal electric field of the electrical pulses with a rise time less than 1 ps on a coplanar transmission line by electrooptic sampling. The longitudinal component is a sharp pulse and is only observed at the wavefront. The transverse component has no overshoot or undershoot. The mixing of longitudinal component to the transverse component is discussed for C3v crystals whose electrooptic coefficient is large. We developed the method to estimate the longitudinal and the transverse component of the electric field by the polarization control of a probe light without changing the probe configuration which affects sensitivity severely. The waveform and the rise time of the transverse electric field were eatimated, for the first time, by subtracting the influence of the longitudinal component.

This paper discusses pulse responses of multi-conductor transmission lines terminated by linear and nonlinear subnetworks. At first step, the circuit is partitioned into a linear transmission lines and nonlinear subnetworks by the substitution voltage sources. Then, the linear subnetworks are solved by a well-known phasor technique, and the nonlinear subnetworks by a numerical integration technique. The variational value at each iteration is calculated by a frequency domain relaxation method to the associated linearized time-invariant sensitivity circuit. Although the algorithm can be efficiently applied to weakly nonlinear circuits, the convergence ratio for stiff nonlinear circuits becomes very small. Hence, we recommend to introduce a compensation element which plays very important role to weaken the nonlinearity. Thus, our algorithm is very simple and can be efficiently applied to wide classes of nonlinear circuits.

We introduce a generalized cln grammar (gclng), a generalization of a completely linearly nested context-free grammar (clncfg), of which variables are partitioned linearly and each rule satisfies similar conditions as those of clncfg related to its partition. We show that the class of languages generated by gclng's coincides with the class of quasi-rational languages, and consider the inclusion relations between languages generated by gclng's and those generated by clncfg's.

The problem of electromagnetic scattering by inductive discontinuities located in rectangular waveguides, in particular when dealing with discontinuous conductors of finite thickness, is analyzed using the modified residue-calculus method, and form of the equation suitable for a numerical calculation is derived. The incident wave is taken to be the dominant mode, and reflection and transmission properties of an asymmetric inductive iris are discussed. After the modal representation of the filed, the modal matching is apply to satisfy the boundary conditions at the discontinuity. And using the modified residue-calculus method, simultaneous infinite equations, which are concerned with the scattered mode coefficients, are derived. Then they are approximated at the thick diaphragm. The solutions obtained take on the form of an infinite product, and a numerical solution based on the method of successive approximations is presented as a technique for concretely determining the reflection coefficients. As confirmation, experiments are also carried out in the X-band and close agreement is shown between the calculated and experimental values.

This paper is concerned with an ITS designed for augmenting a student's capability in problem solving. Discussions are concentrated on helping students acquire strategic knowledge and assisting them to build it in their heads. In this paper, many kinds of strategies are treated from a unified point of view. Based on this consideration, a teaching paradigm of strategic knowledge is presented. The paradigm is realized in an ITS as a training environment for strategic knowledge. Assisting students to learn strategic knowledge, the system sets up an appropriate environment and gives them some appropriate advice in each environment. It is realized as a function of giving them appropriate problems and hints about it. In general, strategic knowledge is a kind of heuristics so that it is not easy to describe their application conditions deterministically and explicitly. For this reason, an ITS for strategic knowledge is required to be designed so as to cover not only the case where expertise is represented explicitly as an executable model but also the case where it is represented only implicitly. To realize this teaching paradigm, situation-dependent knowledge called reminding pattern is prepared in the system. It is represented by a triple of a strategy, a situation, and a key symbol in the situation. It denotes that the key usually reminds students of the strategy in the situation. The system gives students problems including positive/negative examples of applications of each strategy in its problem solving process and hints which remind them of an appropriate strategy and makes them resume the problem solving when they fall into an impasse. In this paper, the structure of the system realizing this teaching paradigm is explained in the domain of proving propositional formulas.

It is recognized in Japan that reformation of the national research institutions is urgently necessary. Present situation and constraints are shown and the action items are discussed.

Computing devices have reached data frequencies of 100 MHz, and have created a need for small-amplitude impedance-matched buses. We simulated signal transmission characteristics of two basic driver circuits, push-pull and open-drain,for a synchronous DRAM I/O bus. The push-pull driver caused less signal distortion with parasitic inductance and capacitance of packages, and thus has higher frequency limits than the open-drain GTL type. We describe a bus system using push-pull drivers which operates at over 125 MHz. The bus line is 70 cm with 8 I/O loads distributed along the line, each having 25 nH7pF parasitic inductance and capacitance.

In this paper, we quantitively analyzed speech data in seven different styles to make natural Japanese conversational speech synthesis. Three reading styles were produced at different speeds (slow, normal and fast), and four speaking styles were produced by enacting conversation in different situations (free, hurried, angry and polite). To clarify the differences in prosodic characteristics between conversational speech and read speech, means and standard deviations of vowel duration, vowel amplitude and fundamental frequency (F0) were analyzed. We found large variation in these prosodic parameters. To look more precisely at the segmental duration and segmental amplitude differences between conversational speech and read speech, control rules of prosodic parameters in reading styles were applied to conversational speech. F0 contours of different speaking styles are superposed by normalizing the segmental duration. The differences between estimated values and actual values were analyzed. Large differences were found at sentence final and key (focused) phrases. Sentence final positions showed lengthening of segmental vowel duration and increased segmental vowel amplitude. Key phrase positions featured raising F0.

In this study, an expression of the regression relationship with less information loss is concretely derived in the form suitable to the existence of amplitude constraint of the observed data and the prediction of response probability distribution. The effectiveness of the proposed method is confirmed experimentally by applying it to the actual acoustic data.

In this letter, we study on the sensitivity to the electrical stimulus pulse for biomedical electronics for the purpose to make a tactile vision substitution system for binds. We derive the equivalent circuit of finger by measuring sensitive voltages with various touch condition and various DC voltage. And we consider to the sensitivity of finger against electrical stimulus pulse. In order to convert the sense of sight to tactile sense, we consider four types of touch condition and various types of pulse. It is shown that the sensitivity of finger to electrical stimulus pulse is determined by duty-ratio, frequency, hight of pulse and the type of touch condition. In the case that duty-ratio is about 20%, frequency is within about 60-300Hz and touch condition is A-4 type, the sensitive voltage becomes the lowest. With this result, a tactile vision substitution system can be developed and the system will be used to transfer various infomations to blinds without paper.

A detailed numerical solution of the design criteria of in-phase lateral and single-longitudinal-mode operation GaInAsP/InP DFB laser arrays is presented. The analysis, including broad-area pumped and stripe-geometry pumped index-guided arrays, was carried out on the basis of the eigenvalue equation method. It is shown that there exists a cut-off array pitch co, at which all of the higher-order array modes are cut off. For the pitch larger than the cut-off pitch co, the modal discrimination is evaluated by the threshold gain difference between the in-phase lateral and higher-order array modes. As a result, the modal discrimination was found to decrease with the increase of the number of elements and the array pitch which is limited to be smaller than twice the cut-off pitch co to attain a stable in-phase lateral- and single-longitudinal-mode operation.

The quality of polycrystalline silicon films and electrical characteristics of polycrystalline silicon gate metal-oxide-semiconductor (MOS) capacitors were investigated under various processing conditions, including phosphorus doping. The stresses observed in Si films deposited in the amorphous phase show complex behavior during thermal treatment. The stresses in as-deposited Si films are compressive. They change to tensile with annealing at 800, and to compressive after an additional annealing at 900. The kind of charges trapped in the SiO2 film during the negative constant current stress in Polycrystalline silicon gate MOS capacitors differ with the maximum process temperature. The trapped charges of samples annealed at 800 were negative, while those of samples annealed at 900 were positive.