We investigate and propose the utilization of regenerative and non-regenerative relaying terminals in downlink cooperative MIMO communications, such as in base-station/router-relay-user transmission under different schemes. The source is equipped with multiple antennas, while the relays and destination are single-antenna terminals. From the source to the relays, symbols are transmitted using MIMO spatial-multiplexing technique. Depending on the type of relaying scheme, the relays either fully decode or amplify the received signal before retransmitting it to the destination using simple TDM transmission or Alamouti's space-time coding. We show that the proposed system realizes MIMO performance in single-antenna system environment, and performance-wise it is superior to existing transmission schemes, especially in low-SNR conditions. Furthermore, the proposed system is shown to give a diversity order of N-M+1, similar to that of MIMO V-BLAST system.

This paper describes a novel channel allocation scheme that enables data to be collected from observation points throughout the ultra-wide area covered by a satellite communication system. Most of the earth stations in the system acquire pre-scheduled type data such as that pertaining to rainfall and temperature measurements, but a few of them acquire event-driven type data such as that pertaining to earthquakes. Therefore, the main issue pertaining to this scheme is how to effectively accommodate demand for the channels by a huge number of earth stations with limited satellite frequency bandwidth regardless of their acquired data types. To tackle this issue, we propose a channel allocation scheme built on a pre-assigned scheme to gather pre-scheduled type data but that also includes an additional procedure to gather event-driven type data reliably. Performance evaluations show that the proposed scheme achieves higher throughput and lower packet loss rate than conventional schemes.

This paper presents a realization of a simple antenna system for land vehicle satellite communication that is tested in experiments conducted on the Engineering Test Satellite-VIII (ETS-VIII). The developed antenna system which was mounted onto a vehicle roof is compact, light weight with simple satellite-tracking operation. In order to realize compact antennas, an onboard-power divider and switching circuit for antenna feeding control are mounted under the array antenna. A Global Positioning System (GPS) module is used to provide accurate information on the vehicle's position and bearing during travelling. A personal computer (PC) is used as the control unit and data logger, which was specifically designed for this application, allow the switching circuit control as well as the retrieving of the received power levels and error rate. The field tests reported in this paper mainly address the tracking performance of the proposed antenna system. Satisfactory results were obtained. Good received power levels and bit error rate (BER) for tracking the ETS-VIII satellite were confirmed. Furthermore, in order to grasp the environmental factors that impact the quality of land vehicle communications, we carefully captured data at obstacles such as buildings, foliages, utility poles and highway overpasses. The results showed blockage and shadowing was confirmed. Additionally, when the antenna was tested at the inclined-road for simple propagation characteristics in elevation direction, stable reception of the satellite signals was realized.

This study develops a form of digital baseband Intra-Body communication for wideband transmission. A simplified circuit model of signal and noise is constructed to analyze the contribution of the high pass filter function of the electrostatic coupling Intra-Body communication system to wideband digital transmission in electrostatic coupling Intra-Body communication. A unit step function is presented to determine the maximum high pass 3 dB pole that can ensure favorable signal quality in a baseband Intra-Body communication system. Body noise is measured to estimate the range of the high pass 3 dB pole with good Signal to Noise Ratio. A 3.3 Volt battery-powered FPGA is experimentally implemented to confirm the feasibility of the wideband Intra-Body communication system. The experimental results indicate that the digital baseband Intra-Body communication system supports a data rate of more than 16MPS.

We develop an optimum code allocation scheme by investigating the peak to average power ratio (PAPR) characteristic of a down-link multi-carrier (MC)-CDMA system using Walsh-Hadamard code. It is shown that PAPR of a MC-CDMA system is highly dependent upon the selection of code combination. Based on this fact, we develop the allocation method which minimizes PAPR according to the number of active users. In addition, an efficient suboptimum code combination search scheme is also proposed for near minimum PAPR.

In this letter, power allocation methods are devised for Amplify-and-Forward (AF) opportunistic relaying systems aiming at minimizing the outage probability. First, we extend the result on outage probability in and develop an approximate expression to simplify the power allocation problem. A corresponding optimization problem is constructed and proved to be convex. Then an iterative numerical method is proposed to find the optimal power allocation factor. We also propose a near-optimal method which can directly calculate the power allocation factor to reduce computational complexity. Numerical results show that the proposed methods have a similar performance with the ideal one, and outperform equal power allocation significantly with little overhead.

Current trend in telecommunications is "broadband" and "ubiquitous." To achieve this goal, satellite communications systems are expected to play an important role in cooperation with terrestrial communications systems. Along with the advancement of optical fiber transmission systems, the role of satellite communications was dramatically changed from long distance transmission to various applications utilizing unique features of satellite communications. This paper overviews recent Japanese R&D in satellite communications.

This paper analyzes transient behaviors of the polarization-mode-dispersion (PMD) vector for the Foschini and Poole's birefringence vector model. We find an asymptotic solution of the corresponding Fokker-Planck equation representing the solution as a superposition of angular components characterized by the Legendre polynomials. The distribution tail for the PMD vector magnitude evolves slowly to the Maxwellian owing to the residual couplings between adjacent angular components. Of particular interest, the distribution tail for the PMD vector magnitude lies well below the Maxwellian fit during the transient.

This paper presents the mixed time-frequency steady-state analysis method for efficient simulation of circuits whose excitation frequencies are widely separated. These circuits can be written by multitime partial differential equations. In this paper, an axis of the slow time-scale is formulated in the time domain and another axis of the fast time-scale is formulated in the frequency domain. We show that computational cost, however, is not dependent on the interval of frequencies, whereas for the harmonic balance or transient analysis, it increases as the interval of frequencies increases.

This paper proposes an enhanced method for estimating the a priori Signal-to-Disturbance Ratio (SDR) to be employed in the Acoustic Echo and Noise Suppression (AENS) system for full-duplex hands-free communications. The proposed a priori SDR estimation technique is modified based upon the Two-Step Noise Reduction (TSNR) algorithm to suppress the background noise while preserving speech spectral components. In addition, a practical approach to determine accurately the Echo Spectrum Variance (ESV) is presented based upon the linear relationship assumption between the power spectrum of far-end speech and acoustic echo signals. The ESV estimation technique is then employed to alleviate the acoustic echo problem. The performance of the AENS system that employs these two proposed estimation techniques is evaluated through the Echo Attenuation (EA), Noise Attenuation (NA), and two speech distortion measures. Simulation results based upon real speech signals guarantee that our improved AENS system is able to mitigate efficiently the problem of acoustic echo and background noise, while preserving the speech quality and speech intelligibility.

This paper proposes a new antenna array calibration technique which uses frequency selection in orthogonal frequency division multiple access (OFDMA)/time division duplexing (TDD) systems. In the proposed method, subbands or frequencies of good channel conditions are initially selected for channel measurements. The relative calibration is performed at the selected subbands, which compensates for mismatch of analogue gains in multiple antennas using the measured uplink and downlink channel parameters. Furthermore, the calibration parameters are interpolated in the frequency domain for the whole bandwidth. The proposed calibration maintains accurate channel reciprocity for the whole bandwidth compared to the conventional calibration which does not use the frequency selection. The proposed calibration technique is effective in exploiting channel reciprocity at both base station and terminals with feasible amount of feedback and low-cost operation.

Compared with traditional static anonymous communication networks, the P2P architecture can provide higher anonymity in communication. However, the P2P architecture also leads to more challenges, such as route, stability, trust and so on. In this paper, we present WindTalker, a P2P-based low-latency anonymous communication network. It is a pure decentralized mix network and can provide low-latency services which help users hide their real identity in communication. In order to ensure stability and reliability, WindTalker imports "seed nodes" to help a peer join in the P2P network and the peer nodes can use gossip-based protocol to exchange active information. Moreover, WindTalker uses layer encryption to ensure the information of relayed messages cannot be leaked. In addition, malicious nodes in the network are the major threat to anonymity of P2P anonymous communication, so WindTalker imports a trust mechanism which can help the P2P network exclude malicious nodes and optimize the strategy of peer discovery, tunnel construction, and relaying etc. in anonymous communications. We deploy peer nodes of WindTalker in our campus network to test reliability and analyze anonymity in theory. The network measurement and simulation analysis shows that WindTalker can provide low-latency and reliable anonymous communication services.

This paper describes the architecture of an integrated platform developed for improving the development efficiency of system LSIs built into digital consumer electronics equipment such as flat-panel TVs and optical disc recorders. The reason for developing an integrated platform is to improve the development efficiency of system LSIs that serve the principal functions of the said equipment. The key is to build a common interface between each software layer, with the system LSI located at the lowest layer. To make this possible, the hardware architecture of the system LSI is divided into five blocks according to its main functionality. In addition, a middleware layer is placed over the operating system to improve the ease of porting old applications and developing new applications in the higher layer. Based on this platform, a system LSI called UniPhierTM has been developed and used in 156 product families of digital consumer electronics equipment (as of December 2008).

The attenuation effect of the walls of a building on the electromagnetic (EM) field generated by an indoor power line communication (PLC) system is numerically investigated using the finite integration (FI) method. In particular, we focus on the frequency range 2-6 MHz, for which the attenuation effect has not yet been sufficiently analyzed. We model a single, finite-sized wall instead of an entire house, to focus on the dependence of the EM field on the wall structure and also reduce the computational resources required. The EM field strength is evaluated at many points on a view plane 10 m from the wall model, and the results are statistically processed to determine the attenuation effect of the wall. We show that the leakage of an EM field at 2-6 MHz is suppressed by about 30 dB by a reinforced concrete wall. We also show that the main contributor to the attenuation effect is the rebar in the wall. We then investigate the relation between the attenuation effect of a single-wall model and that of a house model. The results show that the attenuation effect of a house model is almost the same as that of a 15-m-wall model. We conclude that the use of a single-wall model instead of a house model is effective in determining the attenuation of the EM leakage. This simple structure reduces analytic space, time, and memory in the evaluation of the dependence on the wall structure of the EM leakage from indoor PLC systems.

This paper presents a new signaling architecture for radio-access control in wireless communications systems. Called THREP (for THREe-phase link set-up Process), it enables systems with low-cost configurations to provide tetherless access and wide-ranging mobility by using autonomous radio-link controls for fast cell searching and distributed call management. A signaling architecture generally consists of a radio-access part and a service-entity-access part. In THREP, the latter part is divided into two steps: preparing a communication channel, and sustaining it. Access control in THREP is thus composed of three separated parts, or protocol phases. The specifications of each phase are determined independently according to system requirements. In the proposed architecture, the first phase uses autonomous radio-link control because we want to construct low-power indoor wireless communications systems. Evaluation of channel usage efficiency and hand-over loss probability in the personal handy-phone system (PHS) shows that THREP makes the radio-access sub-system operations in a practical application model highly efficient, and the results of a field experiment show that THREP provides sufficient protection against severe fast CNR degradation in practical indoor propagation environments.

We investigate numerically the applicability of photonic crystal fiber (PCF) with a uniform air hole structure as a wide-band transmission medium. We show that accumulated dispersion over the PCF can be reduced effectively by optimizing the index profile of dispersion compensating fiber (DCF). We also show that a bandwidth of more than 300 nm will be available for 40 Gbit/s NRZ transmission by using the PCF as a transmission medium instead of conventional 1.3 µm zero-dispersion single-mode fiber (SMF).

A novel video retrieval method based on Web community extraction using audio and visual features and textual features of video materials is proposed in this paper. In this proposed method, canonical correlation analysis is applied to these three features calculated from video materials and their Web pages, and transformation of each feature into the same variate space is possible. The transformed variates are based on the relationships between visual, audio and textual features of video materials, and the similarity between video materials in the same feature space for each feature can be calculated. Next, the proposed method introduces the obtained similarities of video materials into the link relationship between their Web pages. Furthermore, by performing link analysis of the obtained weighted link relationship, this approach extracts Web communities including similar topics and provides the degree of attribution of video materials in each Web community for each feature. Therefore, by calculating similarities of the degrees of attribution between the Web communities extracted from the three kinds of features, the desired ones are automatically selected. Consequently, by monitoring the degrees of attribution of the obtained Web communities, the proposed method can perform effective video retrieval. Some experimental results obtained by applying the proposed method to video materials obtained from actual Web pages are shown to verify the effectiveness of the proposed method.

In this paper, a method for adaptive reconstruction of missing textures based on kernel canonical correlation analysis (CCA) with a new clustering scheme is presented. The proposed method estimates the correlation between two areas, which respectively correspond to a missing area and its neighboring area, from known parts within the target image and realizes reconstruction of the missing texture. In order to obtain this correlation, the kernel CCA is applied to each cluster containing the same kind of textures, and the optimal result is selected for the target missing area. Specifically, a new approach monitoring errors caused in the above kernel CCA-based reconstruction process enables selection of the optimal result. This approach provides a solution to the problem in traditional methods of not being able to perform adaptive reconstruction of the target textures due to missing intensities. Consequently, all of the missing textures are successfully estimated by the optimal cluster's correlation, which provides accurate reconstruction of the same kinds of textures. In addition, the proposed method can obtain the correlation more accurately than our previous works, and more successful reconstruction performance can be expected. Experimental results show impressive improvement of the proposed reconstruction technique over previously reported reconstruction techniques.

Time-Triggered Controller Area Network is widely accepted as a viable solution for real-time communication systems such as in-vehicle communications. However, although TTCAN has been designed to support both periodic and sporadic real-time messages, previous studies mostly focused on providing deterministic real-time guarantees for periodic messages while barely addressing the performance issue of sporadic messages. In this paper, we present an O(n2) scheduling algorithm that can minimize the maximum duration of exclusive windows occupied by periodic messages, thereby minimizing the worst-case scheduling delays experienced by sporadic messages.

Adaptive polarization mode dispersion (PMD) compensation is required for the speed-up and advancement of the present optical communications. The combination of a tunable PMD compensator and its adaptive control method achieves adaptive PMD compensation. In this paper, we report an effective search control algorithm for the feedback control of the PMD compensator. The algorithm is based on the hill-climbing method. However, the step size changes randomly to prevent the convergence from being trapped at a local maximum or a flat, unlike the conventional hill-climbing method. The randomness depends on the Gaussian probability density functions. We conducted transmission simulations at 160 Gb/s and the results show that the proposed method provides more optimal compensator control than the conventional hill-climbing method.