Dynamic instruction window resizing (DIWR) is a scheme that effectively exploits both memory-level parallelism and instruction-level parallelism by configuring the instruction window size appropriately for exploiting each parallelism. Although a previous study has shown that the DIWR processor achieves a significant speedup, power consumption has not been explored. The power consumption is increased in DIWR because the instruction window resources are enlarged in memory-intensive phases. If the power consumption exceeds the power budget determined by certain requirements, the DIWR processor must save power and thus, the performance previously presented cannot be achieved. In this paper, we explore to what extent the DIWR processor can achieve improved performance for a given power budget, assuming that dynamic voltage and frequency scaling (DVFS) is introduced as a power saving technique. Evaluation results using the SPEC2006 benchmark programs show that the DIWR processor, even with a constrained power budget, achieves a speedup over the conventional processor over a wide range of given power budgets. At the most important power budget point, i.e., when the power a conventional processor consumes without any power constraint is supplied, DIWR achieves a 16% speedup.

Detecting small infrared targets is a difficult but important task in highly cluttered coastal surveillance. The paper proposed a method called low-rank and sparse decomposition based frame difference to improve the detection performance of a surveillance system. First, the frame difference is used in adjacent frames to detect the candidate object regions which we are most interested in. Then we further exclude clutters by low-rank and sparse matrix recovery. Finally, the targets are extracted from the recovered target component by a local self-adaptive threshold. The experiment results show that, the method could effectively enhance the system's signal-to-clutter ratio gain and background suppression factor, and precisely extract target in highly cluttered coastal scene.

This letter presents a new time-digital single-slope ADC (TDSS) architecture for CMOS image sensors. In the proposed ADC, a conventional single-slope ADC is used in coarse phase and a time to digital convertor is employed in fine phase. Through second comparison of the two different slope voltages (discharge input voltage and ramp voltage), the proposed ADC achieves low bit precision compensation. Compared with multiple-ramp single-slope (MRSS) ADC, the proposed ADC not only has a simple digital judgment circuit, but also increases conversion speed without complicated structure of ramp generator. A 10-bit TDSS ADC consisting of 7-bit conventional single-slope ADC and 3-bit time to digital converter was realized in a 0.13µm CIS process. Simulations demonstrate that the conversion speed of a TDSS ADC is almost 3.5 times faster than that of a single-slope ADC.

The inertia weight is the control parameter that tunes the balance between the exploration and exploitation movements in particle swarm optimization searches. Since the introduction of inertia weight, various strategies have been proposed for determining the appropriate inertia weight value. This paper presents a brief review of the various types of inertia weight strategies which are classified and discussed in four categories: static, time varying, dynamic, and adaptive. Furthermore, a novel entropy-based gain regulator (EGR) is proposed to detect the evolutionary state of particle swarm optimization in terms of the distances from particles to the current global best. And then apply proper inertia weights with respect to the corresponding distinct states. Experimental results on five widely applied benchmark functions show that the EGR produced significant improvements of particle swarm optimization.

One of the patterns that the design of parallel file systems has to solve stems from the difficulty of handling the metadata-intensive I/O generated by parallel applications accessing a single large directory. We demonstrate a middleware design called SFS to support existing parallel file systems for distributed and scalable directory service. SFS distributes directory entries over data servers instead of metadata servers to offer increased scalability and performance. Firstly, SFS exploits an adaptive directory partitioning based on extendible hashing to support concurrent and unsynchronized partition splitting. Secondly, SFS describes an optimization based on recursive split-ordering that emphasizes speeding up the splitting process. Thirdly, SFS applies a write-optimized index structure to convert slow, small, random metadata updates into fast, large, sequential writes. Finally, SFS gracefully tolerates stale mapping at the clients while maintaining the correctness and consistency of the system. Our performance results on a cluster of 32-servers show our implementation can deliver more than 250,000 file creations per second on average.

Vanishing point estimation is an important issue for vision based road detection, especially in unstructured roads. However, most of the existing methods suffer from the long calculating time. This paper focuses on improving the efficiency of vanishing point estimation by using a heuristic voting method based on particle swarm optimization (PSO). Experiments prove that with our proposed method, the efficiency of vanishing point estimation is significantly improved with almost no loss in accuracy. Moreover, for sequenced images, this method is further improved and can get even better performance, by making full use of inter-frame information to optimize the performance of PSO.

Random forest regressor has recently been proposed as a local landmark estimator in the face alignment problem. It has been shown that random forest regressor can achieve accurate, fast, and robust performance when coupled with a global face-shape regularizer. In this paper, we extend this approach and propose a new Local Forest Classification and Regression (LFCR) framework in order to handle face images with large yaw angles. Specifically, the LFCR has an additional classification step prior to the regression step. Our experiment results show that this additional classification step is useful in rejecting outliers prior to the regression step, thus improving the face alignment results. We also analyze each system component through detailed experiments. In addition to the selection of feature descriptors and several important tuning parameters of the random forest regressor, we examine different initialization and shape regularization processes. We compare our best outcomes to the state-of-the-art system and show that our method outperforms other parametric shape-fitting approaches.

In a public-key encryption scheme, if a sender is not concerned about the security of a message and is unwilling to generate costly randomness, the security of the encrypted message can be compromised. In this work, we characterize such lazy parties, who are regarded as honest parties, but are unwilling to perform a costly task when they are not concerned about the security. Specifically, we consider a rather simple setting in which the costly task is to generate randomness used in algorithms, and parties can choose either perfect randomness or a fixed string. We model lazy parties as rational players who behave rationally to maximize their utilities, and define a security game between the parties and an adversary. Since a standard secure encryption scheme does not work in this setting, we provide constructions of secure encryption schemes in various settings.

Virtualization is no longer an emerging research area since the virtual processor and memory operate as efficiently as the physical ones. However, I/O performance is still restricted by the virtualization overhead caused by the costly and complex I/O virtualization mechanism, in particular by massive exits occurring on the guest-host switch and redundant processing of the I/O stacks at both guest and host. A para-virtual device driver may reduce the number of exits to the hypervisor, whereas the network stacks in the guest OS are still duplicated. Previous work proposed a socket-outsourcing technique that bypasses the redundant guest network stack by delivering the network request directly to the host. However, even by bypassing the redundant network paths in the guest OS, the obtained performance was still below 60% of the native device, since notifications of completion still depended on the hypervisor. In this paper, we propose vCanal, a novel network virtualization framework, to improve the performance of network access in the virtual machine toward that of the native machine. Implementation of vCanal reached 96% of the native TCP throughput, increasing the UDP latency by only 4% compared to the native latency.

The acquisition of accurate channel state information at the transmitter (CSIT) is a difficult task in multiple-input multiple-output (MIMO) systems. Partial CSIT is a more realistic assumption, especially for high-mobility mobile users (MUs) whose channel varies very rapidly. In this letter, we propose a MIMO two-way relaying (MTWR) scheme, in which the communication between the BS and a high-mobility MU is assisted by other low-mobility MUs serving as relays. This produces a beamforming effect that can significantly improve the performance of the high-mobility MU, especially for a large number of MUs and unreliable CSIT.

Although many 3D structures have been solved for proteins to date, functions of some proteins remain unknown. To predict protein functions, comparison of local structures of proteins with pre-defined model structures, whose functions have been elucidated, is widely performed. For the comparison, the root mean square deviation (RMSD) has been used as a conventional index. In this work, adaptive deviation was incorporated, along with Bregmann Divergence Regularized Machine, in order to detect analogous local structures with such model structures more effectively than the conventional index.

In this paper, a method of calculating the mean channel capacity based on S-parameter of MIMO (Multiple-Input Multiple-Output) antenna is proposed. This method exploits the correlation matrix calculated from the antenna S-parameter matrix, and offers highly accurate estimates of the mean channel capacity without dependence on SNR (Signal-to-Noise Ratio). The numerical and experimental results revealed that the proposed method can calculate the channel capacity with fair accuracy independent of the number and spacing of the antenna elements if the radiation efficiency is sufficiently high.

We propose part-segment (PS) features for estimating an articulated pose in still images. The PS feature evaluates the image likelihood of each body part (e.g. head, torso, and arms) robustly to background clutter and nuisance textures on the body. While general gradient features (e.g. HOG) might include many nuisance responses, the PS feature represents only the region of the body part by iterative segmentation while updating the shape prior of each part. In contrast to similar segmentation features, part segmentation is improved by part-specific shape priors that are optimized by training images with fully-automatically obtained seeds. The shape priors are modeled efficiently based on clustering for fast extraction of PS features. The PS feature is fused complementarily with gradient features using discriminative training and adaptive weighting for robust and accurate evaluation of part similarity. Comparative experiments with public datasets demonstrate improvement in pose estimation by the PS features.

Recent work on joint word segmentation, POS (Part Of Speech) tagging, and dependency parsing in Chinese has two key problems: the first is that word segmentation based on character and dependency parsing based on word were not combined well in the transition-based framework, and the second is that the joint model suffers from the insufficiency of annotated corpus. In order to resolve the first problem, we propose to transform the traditional word-based dependency tree into character-based dependency tree by using the internal structure of words and then propose a novel character-level joint model for the three tasks. In order to resolve the second problem, we propose a novel semi-supervised joint model for exploiting n-gram feature and dependency subtree feature from partially-annotated corpus. Experimental results on the Chinese Treebank show that our joint model achieved 98.31%, 94.84% and 81.71% for Chinese word segmentation, POS tagging, and dependency parsing, respectively. Our model outperforms the pipeline model of the three tasks by 0.92%, 1.77% and 3.95%, respectively. Particularly, the F1 value of word segmentation and POS tagging achieved the best result compared with those reported until now.

Facial paralysis is a popular clinical condition occurring in 30 to 40 patients per 100,000 people per year. A quantitative tool to support medical diagnostics is necessary. This paper proposes a simple, visual and robust method that can objectively measure the degree of the facial paralysis by the use of spatiotemporal features. The main contribution of this paper is the proposal of an effective spatiotemporal feature extraction method based on a tracking of landmarks. Our method overcomes the drawbacks of the other techniques such as the influence of irrelevant regions, noise, illumination change and time-consuming process. In addition, the method is simple and visual. The simplification helps to reduce the time-consuming process. Also, the movements of landmarks, which relate to muscle movement ability, are visual. Therefore, the visualization helps reveal regions of serious facial paralysis. For recognition rate, experimental results show that our proposed method outperformed the other techniques tested on a dynamic facial expression image database.

The challenges of providing a divide-and-conquer strategy for tackling large geospatial raster data input/output (I/O) are longstanding. Solutions need to change with advances in the technology and hardware. After analyzing the reason for the problems of traditional parallel raster I/O mode, a parallel I/O strategy using file view is proposed to solve these problems. Message Passing Interface I/O (MPI-IO) is used to implement this strategy. Experimental results show how a file view approach can be effectively married to General Parallel File System (GPFS). A suitable file view setting provides an efficient solution to parallel geospatial raster data I/O.

Determining an effective way to reduce computation complexity is an essential task for adaptive echo cancellation applications. Recently, a family of partial update (PU) adaptive algorithms has been proposed to effectively reduce computational complexity. However, because a PU algorithm updates only a portion of the weights of the adaptive filters, the rate of convergence is reduced. To address this issue, this paper proposes an enhanced switching-based variable step-size (ES-VSS) approach to the M-max PU least mean square (LMS) algorithm. The step-size is determined by the correlation between the error signals and their noise-free versions. Noise-free error signals are approximated according to the level of convergence achieved during the adaptation process. The approximation of the noise-free error signals switches among four modes, such that the resulting step-size is as close to its optimal value as possible. Simulation results show that when only a half of all taps are updated in a single iteration, the proposed method significantly enhances the convergence rate of the M-max PU LMS algorithm.

In the literature, many cryptosystems have been proposed to be secure under the Strong Diffie-Hellman (SDH) and related problems. For example, there is a cryptosystem that is based on the SDH/related problem or allows the Diffie-Hellman oracle. If the cryptosystem employs general domain parameters, this leads to a significant security loss caused by Cheon's algorithm [14], [15]. However, all elliptic curve domain parameters explicitly recommended in the standards (e.g., ANSI X9.62/63 [1], [2], FIPS PUB 186-4 [43], SEC 2 [50], [51]) are susceptible to Cheon's algorithm [14], [15]. In this paper, we first prove that (q-1)(q+1) is always divisible by 24 for any prime order q>3. Based on this result and depending on small divisors d1,d2≤(log q)2, we classify primes q>3, such that both (q-1)/d1 and (q+1)/d2 are primes, into Perfect, Semiperfect, SEC1v2 and Acceptable. Then, we describe algorithmic procedures and show their simulation results of secure elliptic curve domain parameters over prime/character 2 finite fields resistant to Cheon's algorithm [14], [15]. Also, several examples of the secure elliptic curve domain parameters (including Perfect or Semiperfect prime q) are followed.

The RO (Ring-Oscillator)-based sensor is one of easily-implementable variation sensors, but for decomposing the observed variability into multiple unique device-parameter variations, a large number of ROs with different structures and sensitivities to device-parameters is required. This paper proposes an area efficient device parameter estimation method with sensitivity-configurable ring oscillator (RO). This sensitivity-configurable RO has a number of configurations and the proposed method exploits this property for reducing sensor area and/or improving estimation accuracy. The proposed method selects multiple sets of sensitivity configurations, obtains multiple estimates and computes the average of them for accuracy improvement exploiting an averaging effect. Experimental results with a 32-nm predictive technology model show that the proposed averaging with multiple estimates can reduce the estimation error by 49% or reduce the sensor area by 75% while keeping the accuracy. Compared to previous work with iterative estimation, 23% accuracy improvement is achieved.

This paper presents a 20GHz Class-C VCO using a noise sensitivity mitigation technique. A radio frequency Class-C VCO suffers from the AM-PM conversion, caused by the non-linear capacitance of cross coupled pair. In this paper, the phase noise degradation mechanism is discussed, and a desensitization technique of AM-PM noise is proposed. In the proposed technique, AM-PM sensitivity is canceled by tuning the tail impedance, which consists of 4-bit resistor switches. A 65-nm CMOS prototype of the proposed VCO demonstrates the oscillation frequency from 19.27 to 22.4GHz, and the phase noise of -105.7dBc/Hz at 1-MHz offset with the power dissipation of 6.84mW, which is equivalent to a Figure-of-Merit of -183.73dBc/Hz.