A periodic array of InSb spheres on a substrate is numerically analyzed at terahertz frequencies. The incident field is shown to be coupled to the substrate due to the guided-mode resonance. The effect of the background refractive index on the transmission characteristics is investigated for sensor applications.

Volume integral equations combined with orthogonality of guided mode and non-guided field are proposed for the TE incidence of two-dimensional optical slab waveguide. The slab waveguide is assumed to satisfy the single mode condition. The formulation of the integral equations are described in detail. The matrix equation obtained by applying the method of moments to the integral equations is shown. Numerical results for step, gap, and grating waveguides are given. They are compared to published papers to validate the proposed method.

To achieve smooth beam injection in operation of synchrotron radiation facilities, pulsed multipole magnet beam injectors are developed. It is found that the developed beam injector causes serious disturbance in the circulating storage beam in the Aichi synchrotron radiation center, and that such the unexpected disturbance of the storage beam may be caused by eddy current induced on thin titanium coating inside a beam duct. In this work, the induced eddy current on the titanium layer is evaluated quantitatively by numerical simulations and improvement for the developed beam injector is discussed based on the numerical simulation.

In this paper, the scattering far-field from a circular electric conducting cylinder has been analyzed by physical optics (PO) approximation for both H and E polarizations. The evaluation of radiation integrations due to the PO current is conducted numerically and analytically. While non-uniform and uniform asymptotic solutions have been derived by the saddle point method, a separate approximation has been made for forward scattering direction. Comparisons among our approximation, direct numerical integration and exact solution results yield a good agreement for electrically large cylinders.

Near-field beamforming has played an important role in many scenarios such as radar imaging and acoustic detection. In this paper, the near-field beamforming is implemented in the time modulated array with the harmonic. The beam pattern with a low sidelobe level in precise position is achieved by controlling the switching sequence in time modulated cross array. Numerical results verify the correctness of the proposed method.

High Frequency Surface Wave Radar (HFSWR) can achieve over-the-horizon detection, which can effectively detect and track the ships and ultra-low altitude aircrafts, as well as the acquisition of sea state information such as icebergs and ocean currents and so on. However, HFSWR is seriously affected by the clutters, especially sea clutter and ionospheric clutter. In this paper, we propose a deep learning image semantic segmentation method based on optimized Deeplabv3+ network to achieve the automatic detection of sea clutter and ionospheric clutter using the measured R-D spectrum images of HFSWR during the typhoon as experimental data, which avoids the disadvantage of traditional detection methods that require a large amount of a priori knowledge and provides a basis for subsequent the clutter suppression or the clutter characteristics research.

The energy efficiency of intelligent reflecting surface (IRS) enabled internet of things (IoT) networks is studied in this letter. The energy efficiency is mathematically expressed, respectively, as the number of reflecting elements and the spectral efficiency of the network and is shown to scale in the logarithm of the reflecting elements number in the high regime of transmit power from source node. Furthermore, it is revealed that the energy efficiency scales linearly over the spectral efficiency in the high regime of transmit power, in contrast to conventional studies on energy and spectral efficiency trade-offs in the non-IRS wireless IoT networks. Numerical simulations are carried out to verify the derived results for the IRS enabled IoT networks.

In this paper, a novel method of resource abstraction and an abstracted-resource model for dynamic resource control in optical access networks are proposed. Based on this proposal, an implementation assuming application to 5G mobile fronthaul and backhaul is presented. Finally, an evaluation of the processing time for resource allocation using this method is performed using a software prototype of the control function. From the results of the evaluation, it is confirmed that the proposed method offers better characteristics than former approaches, and is suitable for dynamic resource control in 5G applications.

For recent datacenter networks, RDMA (Remote Direct Memory Access) can ease the overhead of the TCP/IP protocol suite. The RoCEv2 (RDMA over Converged Ethernet version 2) standard enables RDMA on widely deployed Ethernet technology. RoCEv2 leverages priority-based flow control (PFC) for realizing the lossless environment required by RDMA. However, PFC is well-known to have the technical weakness of head-of-line blocking. Congestion control for RDMA is a very hot research topic for datacenter networks. In this paper, we propose a novel congestion control algorithm for RoCEv2, TIDD (Timer-based Increase and Delay-based Decrease). TIDD basically combines the timer-based increase of DCQCN and delay-based decrease of TIMELY. Extensive simulation results show that TIDD satisfies the high throughput and low latency required for datacenter networks.

In our previous paper, we have proposed a new numerical technique for transient scattering problem of periodically arrayed dispersion media by using a combination of the fast inversion Laplace transform (FILT) method and Fourier series expansion method (FSEM), and analyzed the pulse response for several widths of the dispersion media or rectangular cavities. From the numerical results, we examined the influence of a periodically arrayed dispersion media with a rectangular cavity on the pulse response. In this paper, we analyzed the transient scattering problem for the case of dispersion media with slanted air regions by utilizing a combination of the FILT, FSEM, and multilayer division method (MDM), and investigated an influence for the slanted angle of an air region. In addition, we verified the computational accuracy for term of the MDM and truncation mode number of the electromagnetic fields.

To maintain blockchain-based services with ensuring its security, it is an important issue how to decide a mining reward so that the number of miners participating in the mining increases. We propose a dynamical model of decision-making for miners using an evolutionary game approach and analyze the stability of equilibrium points of the proposed model. The proposed model is described by the 1st-order differential equation. So, it is simple but its theoretical analysis gives an insight into the characteristics of the decision-making. Through the analysis of the equilibrium points, we show the transcritical bifurcations and hysteresis phenomena of the equilibrium points. We also design a controller that determines the mining reward based on the number of participating miners to stabilize the state where all miners participate in the mining. Numerical simulation shows that there is a trade-off in the choice of the design parameters.

A rep-cube is a polyomino that is a net of a cube, and it can be divided into some polyominoes such that each of them can be folded into a cube. This notion was invented in 2017, which is inspired by the notions of polyomino and rep-tile, which were introduced by Solomon W. Golomb. A rep-cube is called regular if it can be divided into the nets of the same area. A regular rep-cube is of order k if it is divided into k nets. Moreover, it is called uniform if it can be divided into the congruent nets. In this paper, we focus on these special rep-cubes and solve several open problems.

To realize a stable and efficient wireless power transfer (WPT) system that can be used in any environment, it is necessary to inspect the influence of environmental interference along the power transmission path of the WPT system. In this paper, attempts have been made to reduce the influence of the medium with a dielectric and conductive loss on the WPT system using spiral resonators for resonator-coupled type wireless power transfer (RC-WPT) system. An important element of the RC-WPT system is the resonators because they improve resonant characteristics by changing the shape or combination of spiral resonators to confine the electric field that mainly causes electrical loss in the system as much as possible inside the resonator. We proposed a novel dual-spiral resonator as a candidate and compared the basic characteristics of the RC-WPT system with conventional single-spiral and dual-spiral resonators. The parametric values of the spiral resonators, such as the quality factors and the coupling coefficients between resonators with and without a lossy medium in the power transmission path, were examined. For the lossy mediums, pure water or tap water filled with acryl bases was used. The maximum transmission efficiency of the RC-WPT system was then observed by tuning the matching condition of the system. Following that, the transmission efficiency of the system with and without lossy medium was investigated. These inspections revealed that the performance of the RC-WPT system with the lossy medium using the modified shape spiral resonator, which is the dual-spiral resonator proposed in our laboratory, outperformed the system using the conventional single-spiral resonator.

Betweenness centrality is one of the most significant and commonly used centralities, where centrality is a notion of measuring the importance of nodes in networks. In 2001, Brandes proposed an algorithm for computing betweenness centrality efficiently, and it can compute those values for all nodes in O(nm) time for unweighted networks, where n and m denote the number of nodes and links in networks, respectively. However, even Brandes' algorithm is not fast enough for recent large-scale real-world networks, and therefore, much faster algorithms are expected. The objective of this research is to theoretically improve the efficiency of Brandes' algorithm by introducing graph decompositions, and to verify the practical effectiveness of our approaches by implementing them as computer programs and by applying them to various kinds of real-world networks. A series of computational experiments shows that our proposed algorithms run several times faster than the original Brandes' algorithm, which are guaranteed by theoretical analyses.

A three-stage padding configuration providing a larger continuous virtual aperture and achieving more degrees-of-freedom (DOFs) for the direction-of-arrival (DOA) estimation is presented. The improvement is realized by appropriately cascading three-stages of an identical inter-element spacing. Each stage advantageously exhibits a continuous virtual array, which subsequently produces a hole-free resulting uniform linear array. The geometrical approach remains applicable for any existing sparse array structures with a hole-free coarray, as well as designed in the future. In addition to enlarging the continuous virtual aperture and DOFs, the proposed design offers flexibility so that it can be realized for any given number of antennas. Moreover, a special padding configuration is demonstrated, which further increases the number of continuous virtual sensors. The precise antenna locations and the number of continuous virtual positions are benefited from the closed-form expressions. Experimental works are carried out to demonstrate the effectiveness of the proposed configuration.

The prediction of the malfunction timing of wind turbines is essential for maintaining the high profitability of the wind power generation industry. Studies have been conducted on machine learning methods that use condition monitoring system data, such as vibration data, and supervisory control and data acquisition (SCADA) data to detect and predict anomalies in wind turbines automatically. Autoencoder-based techniques that use unsupervised learning where the anomaly pattern is unknown have attracted significant interest in the area of anomaly detection and prediction. In particular, vibration data are considered useful because they include the changes that occur in the early stages of a malfunction. However, when autoencoder-based techniques are applied for prediction purposes, in the training process it is difficult to distinguish the difference between operating and non-operating condition data, which leads to the degradation of the prediction performance. In this letter, we propose a method in which both vibration data and SCADA data are utilized to improve the prediction performance, namely, a method that uses a power curve composed of active power and wind speed. We evaluated the method's performance using vibration and SCADA data obtained from an actual wind farm.

Multiparty computation (MPC) is the technology that computes an arbitrary function represented as a circuit without revealing input values. Typical MPC uses secret sharing (SS) schemes, garbled circuit (GC), and homomorphic encryption (HE). These cryptographic technologies have a trade-off relationship for the computation cost, communication cost, and type of computable circuit. Hence, the optimal choice depends on the computing resources, communication environment, and function related to applications. The private decision tree evaluation (PDTE) is one of the important applications of secure computation. There exist several PDTE protocols with constant communication rounds using GC, HE, and SS-MPC over the field. However, to the best of our knowledge, PDTE protocols with constant communication rounds using MPC based on SS over the ring (requiring only lower computation costs and communication complexity) are non-trivial and still missing. In this paper, we propose a PDTE protocol based on a three-party computation (3PC) protocol over the ring with one corruption. We also propose another three-party PDTE protocol over the field with one corruption that is more efficient than the naive construction.

In this paper, we consider the transmission needs of communication networks for two classes of secondary users (SUs), named SU1 and SU2 (lowest priority) in cognitive radio networks (CRNs). In such CRNs, primary users (PUs) have preemptive priority over both SU1's users (SU1s) and SU2's users (SU2s). We propose a preemptive scheme (referred to as the P Scheme) and a non-preemptive scheme (referred to as the Non-P Scheme) when considering the interactions between SU1s and SU2s. Focusing on the transmission interruptions to SU2 packets, we present a probabilistic returning scheme with a returning probability to realize feedback control for SU2 packets. We present a Markov chain model to develop some formulas for SU1 and SU2 packets, and compare the influences of the P Scheme and the Non-P Scheme in the proposed probabilistic returning scheme. Numerical analyses compare the impact of the returning probability on the P Scheme and the Non-P Scheme. Furthermore, we optimize the returning probability and compare the optimal numerical results yielded by the P Scheme and the Non-P Scheme.

This letter investigates the information-theoretic privacy-utility tradeoff. We analyze the minimum information leakage (f-leakage) under the utility constraint that the excess distortion probability is allowed up to ε∈[0, 1). The derived upper bound is characterized by the ε-cutoff random transformation and a distortion ball.

In this paper, a linear array of 4 leaf-shaped bowtie slot antennas is proposed for use in quasi-millimeter wave band. The slot antennas array is designed to operate at 28GHz frequency band. The leaf-shaped bowtie slot antenna is a type of self-complementary antenna with low profile and low cost of fabrication. The proposed antenna structure offers improvement in radiation pattern, gain, and -10dB impedance bandwidth. Through out of this paper radiation pattern, actual gain, and -10dB impedance bandwidth are evaluated by Finite Different Time Domain (FDTD) simulation. Antenna characteristics are analyzed in the frequency range of 27GHz to 29GHz. To improve antenna characteristics such as actual gain and -10dB impedance bandwidth, a dielectric superstrate layer with relative permittivity of 10.2 is placed on top of ground plane of the slot antennas array. Three antenna structures are introduced and compared. With two layers of dielectric superstrate on top of the antennas ground plane, analysis results show that -10dB impedance bandwidth occupies the frequency range of 27.17GHz to 28.39GHz. Therefore, the operational impedance bandwidth is 1.22GHz. Maximum actual gain of the slot antennas array with two dielectric superstrate layers is 20.49dBi and -3dB gain bandwidth occupies the frequency range of 27.02GHz to 28.57GHz. To validate the analysis results, prototype of the designed slot antennas array is fabricated. Characteristics of the slot antennas array are measured and compared with the analysis results.