In this paper, an Ultra-Wideband (UWB) double-directional channel sounding measurement and spatio-temporal analysis of UWB propagation based on the clusterization approach were reported. After separating the propagation paths and diffuse components both on the transmitter (Tx) antenna and receiver (Rx) antenna positions, the propagation paths both on Tx and Rx positions were observed for clusters separately, while coupling the clusters between Tx and Rx position based on similar time of arrivals, and ray tracing by utilizing high temporal and spatial resolution, respectively. The relation between direction of departure and direction of arrival will then be investigated. For cluster properties, parameters of model characteristics are discussed and compared to other earlier works.

In this paper, the performance of narrow band interference (NBI) rejection scheme for direct sequence spread spectrum (DS/SS) is analyzed. A single-tapped complex FIR filter is used for filtering a chip code to suppress NBI. In this system, the spectrum of transmitted signal has a null at an arbitrary frequency. By choosing filter coefficients, we place this null at NBI center frequency to mitigate the effect of NBI. The performance of this scheme is theoretically analyzed and validated by simulation. We also compare the effectiveness against BPSK interference between the chip code filtering and received signal filtering. The results indicate the chip code filtering is effective against single-tone and BPSK interference, and gains better performance than the received signal filtering at certain level of SNR.

Diversity transmission using space-time block coding (STBC) shows a degraded performance in frequency selective fading (FSF) channel. In this paper, assuming the CSI is unknown at both transmitter and receiver while a pilot signal is available during the training period, we propose a MIMO transmission scheme using STBC by adopting subband adaptive array (SBAA) processing. The receive signal is converted into the frequency-domain and adaptive processing is done at each subband. A novel construction of SBAA is introduced to process received signal based on STBC. Simulation results demonstrate that the proposed scheme has a better performance compare to conventional STBC, and has a better performance and less computational load compare to STBC-TDLAA.

This paper overviews the high-speed power-line communication (PLC) technology, and the related standardization and regulatory activities are described. PLC modems of 200 Mbps class become a practical use stage in the West, and the standardization activity is active now. The discussion for deregulation is being continued in also Japan, and regulation values have been proposed. Another topic in this paper is a sensor network application of PLC, which is an indoor fine-grained localization system by acoustic Direct-Sequence Code Division Multiplexed (DS-CDM) signals. The obtained average accuracy of the localization in a 4 m2 plane was 1 cm if there was no obstacle. To realize the localization system, some novel ideas, such as PLC speakers, a synchronization method based on the zero-crossing timing of the mains frequency, and integrated wired/wireless PLC, are introduced.

In this paper, we compare two signal designs for uplink quasi-synchronous code division multiple access (CDMA) channels in order to optimize the trade-off between bandwidth efficiency and power efficiency. The design we call band-limited DS/CDMA design, is based on the time-domain assignment of Gold sequences, just as in the ordinary DS/CDMA, but with band-constrained cyclic chip interpolation functions, which is unlike the ordinary DS/CDMA. The other design, MC/CDMA design, is based on frequency-domain assignment of the sequences, as in the ordinary MC/CDMA. In both designs, we assume insertion of guard intervals at the transmitter and frequency-domain processing in reception. Assuming quasi-synchronous arrival of CDMA signals at the CDMA base station and FFT in the effective symbol interval, the intersymbol interference is evaded in both designs. First we identified the signal parameters that optimize bandwidth efficiency in each of the band-limited DS design and MC design. Second, we clarified the signal parameters that optimize the power efficiency as functions of frequency efficiency in each of the two designs. Finally, we derived and compared the trade-off between the bandwidth efficiency and power efficiency of band-limited DS and MC designs. We found a superiority of band-limited DS design over MC design with respect to the optimized trade-off.

Ultra wideband (UWB) signal propagation was measured and characterized in comparison with narrowband in a passenger-car compartment, to accommodate the design of new wireless devices for the safety and comfort of passengers. Spatial distributions of UWB and narrowband path gain, delay profiles, and delay spreads within the compartment were derived from frequency-domain responses (from 3.1 to 10.6 GHz) measured with a vector network analyzer. Whereas narrowband channels resulted in a number of dead spots (deep fading points), UWB yielded none, though some frequency dispersion was inevitable. Fading depth versus occupied bandwidth was also derived, which indicated superiority of UWB over narrowband systems from the viewpoint of link budget. Comparison with two other environments was also made in the received energy contained in a given number of multipath components.

This paper describes the design and evaluation of a massively parallel processor base on Matrix architecture which is suitable for portable multimedia applications. The proposed architecture in this paper achieves 40 GOPS of 16-bit fixed-point additions at 200 MHz clock frequency and 250 mW power dissipation. In addition, 1 M-bit SRAM for data registers and 2,048 2-bit processing elements connected by a flexible switching network are integrated in 3.1 mm2 in 90 nm low-power CMOS technology. The energy-efficient Matrix architecture supports 2,048-way parallel operations and the programmable functions required for multimedia SoCs.

Accurate and low-cost sensor localization is critical for deployment of wireless sensor networks. Distance between Ultra-wideband (UWB) sensor nodes can be obtained by measuring round trip flying time through two-way ranging (TWR) transaction. Because of difficulties in synchronization and channel estimate, the response delay of UWB node is the order of milliseconds. Comparing with the nanosecond propagation delay, relative clock offset between UWB nodes introduces big error in TWR. This paper presents the management of relative clock offset in TWR transaction. The relative clock offset between sensors is estimated by comparing the claimed and real frame duration. Simulation in the UWB channel model shows the relative clock offset after compensation can be reduced to less than 2 ppm.

This paper proposes a new method which simultaneously undertakes ranging and communications based on the PHY of MB-OFDM technology. A transmitter modulated one or multiple OFDM subcarriers with a low-frequency (1.05 MHz) ranging signal; and a receiver sampled the received signal at a 3.2-MHz sampling rate to estimate the time of arrival of the ranging signal. This configuration and an additional protocol supporting bidirectional ranging achieved a 140-mm resolution (equivalent to 2.15 GHz sampling). This method does not modify the PHY but only changes the baseband signal processing. The validity of this method was demonstrated using computer simulation and prototype experiments.

In various applications of signals transmission and processing, there is always a possibility of loss of samples. The iterative algorithm of Papoulis-Gerchberg (PG) is famous for solving the band-limited lost samples recovery problem. Two problems are known in this domain: (1) a band-limited signal practically is difficult to be obtained and (2) the convergence rate is too slow. By inserting a subtraction by a polynomial in the PG algorithm, using boundary-matched concept, a significant increase in performance and speed of its convergence has been achieved. In this paper, we propose an efficient approach to restore lost samples by adding a preprocess which meets the periodic boundary conditions of Fast Fourier transform in the iteration method. The accuracy of lost samples reconstruction by using the PG algorithm can be greatly improved with the aid of mapping the input data sequence of satisfying the boundary conditions. Further, we also developed another approach that force the signal to meet a new critical boundary conditions in Fourier domain that make the parameters of the preprocessing can be easily obtained. The simulation indicates that the mean square error (MSE) of the recovery and the convergence rate with the preprocess concept is better and faster than the one without preprocess concept. Our both proposed approaches can also be applied to other cases of signal restoration, which allow Cadzow's iterative processing method, with more convenience and flexibility.

This paper presents a linear constrained minimum variance multiuser detection (MUD) scheme for DS-CDMA systems, which makes full use of the available spreading sequences of the users as well as the relevant channel information of the incoming rays in the construction of the constraint matrix. To further enhance the performance, a statistical optimum filter bank in combination with the developed minimum variance MUD with the partitioned linear interference canceller (PLIC) as the underlying structure is also addressed. The determination of the filter bank coefficients, however, calls for computationally demanding nonlinear programming. To alleviate the computational overhead, an iterative procedure is also proposed, which solves the Rayleigh quotient in each iteration. Furthermore, the expressions of the output signal to interference plus noise ratio (SINR) are also determined to provide further insights into the proposed approach. Conducted simulations validate the new scheme.

An enhanced Ultra Wideband (UWB) signaling scheme that employs PSWF (Prolate Spheroidal Wave Functions)-based orthogonal chip pulses and ternary complementary code sets is proposed for Direct-Sequence (DS) UWB systems. Every information bit of each user is modulated and transmitted over a set of parallel sequences of PSWF-based orthogonal chip pulses and are further assigned to a ternary complementary code set with additional zero padding if necessary. Moreover, the ternary complementary code sets are generated to be mutually orthogonal and assigned to any pair of multiple users. Hence, the mitigation of multipath interference as well as multiple user interference (MUI) can be expected. Furthermore, the ternary code length can be greatly shortened by taking advantage of pulse and code orthogonality. Thus, the proposed transmission scheme is especially suitable for high data rate DS-UWB systems that offer very high flexibility.

This paper investigates the impact of chip duty factor (DF) in DS-UWB system with Rake receiver over AWGN and UWB indoor multipath environment corresponding to system parameters such as spreading bandwidth and chip length. Manipulating DF in DS-UWB system offers several advantages over multipath channel and thus, capable of improving system performance for better quality of communication. Although employing lower DF generally improves performance, in some exceptional cases on the other hand, degradation can be observed despite decreasing DF. Therefore, the objective of this paper is to clarify the relationship between DF and DS-UWB system performance. We discovered that with constant processing gain and spreading bandwidth, performance improvement can be observed at DF lower than 0.17. Additionally, with spreading bandwidth as tradeoff parameter, significant performance improvement can only be observed below DF of 0.85.

A novel linear transconductor using translinear cells is proposed. It consists of a voltage follower, a resistor, and a current follower. SPICE simulations using an 8 GHz bipolar transistor-array parameter show that the linear transconductor with a transconductance of 1 mS exhibits a linearity error of less than 0.75% over an input voltage range of 1 V for a supply voltage of 2.0 V. The temperature coefficient of the transconductance is less than 124 ppm/. The -3-dB frequency of the transconductance is more than 4.5 GHz. Applying the linear transconductor as a building block, the design of a bandpass filter with center frequency of 85 MHz and Q-factor of 80 is presented.

Consideration of manipulator dynamics and external disturbances in robot control system design can enhance the stability and performance properties of the whole system. In this paper, we present an approach to solve the control problem when the inertia parameters of robot are unknown, and at the same time robot is subjected to external force disturbances. This approach is based on simultaneous estimation of force signal and inertia parameters and utilizing them in the control law. The update laws and the control law are derived based on a single time-varying Lyapunov function, so that the global convergence of the tracking error is ensured. A theorem with a detailed proof is presented to guarantee the global uniform asymptotic stability of the whole system. Some simulations are made for a number of external forces to illustrate the effectiveness of the proposed approach.

In this letter, we aim at the study of an OFDM system that employs adaptive modulation techniques to achieve efficient transmission service. In adaptive modulation techniques, a banded AM technique can reduce the number of adaptive modulation information bits and signaling overhead. We evaluate the banded AM technique and compare with Subcarrier AM technique. Moreover, to evaluate the channel condition, we apply the SNR estimation method. Furthermore, to increase the performance of OFDM system, frequency domain pre-equalization is applied. The simulation results have been shown that the OFDM system with adaptive schemes can achieve the efficient transmission for multi-media services.

Providing multimedia services with a quality-of-service guarantee in mobile wireless networks presents more challenges due to user's mobility and limited bandwidth resource. In order to provide seamless multimedia services in the next-generation wireless networks, efficient call admission control algorithm must be developed. A novel borrowing-based call admission control policy is proposed in this paper as a solution to support quality-of-service guarantees in the mobile multimedia wireless networks. Based on the existing network conditions, the proposed scheme makes an adaptive decision for bandwidth allocation and call admission by employing attribute-measurement mechanism, dynamic time interval reservation strategy, and service-based borrowing strategy in each base station. We use the dynamically adaptive approaches to reduce the connection-blocking probability and connection-dropping probability, and to increase the bandwidth utilization, while the quality-of-service guarantees can be maintained at a comfortable level for mobile multimedia wireless networks. Extensive simulation results show that our proposed scheme outperforms the previously proposed scheme in terms of connection-blocking probability, connection-dropping probability, and bandwidth utilization, while providing highly satisfying degree of quality-of-service in mobile communication systems.

This paper studies a multiband mobile communication system to support both high data rate services and wide service coverage, using high and low frequency resources with different propagation characteristics. In the multiband system, multiple frequency bands are managed by a base station and one of the frequency bands is adaptively allocated to a terminal depending on his channel quality. By limiting the low frequency resources to a terminal not covered by the higher frequencies, the presented multiband system can accommodate many terminals providing wide coverage area, as if all radio resources have low frequency. From numerical results, the multiband system can provide wide service coverage area for much larger number of terminals than conventional systems. It is also found that an appropriate balance of multiple frequency resources is essential to achieve high capacity.

This paper proposes a wideband speech coder in which a G.711 bitstream is embedded. This coder has an advantage over conventional coders in that it has a high interoperability with existing terminals so costly transcoding involving decoding and re-encoding can be avoided. We also propose a partial mixing method that effectively reduces the mixing complexity in multiple-point remote conferences. To reduce the complexity, we take advantage of the scalable structure of the bitstream and mix only the lower band of the signal. For the higher band, the main speaker location is selected among remote locations and is redistributed with the mixed lower-band signal. By subjective evaluations, we show that the speech quality can be maintained even when the speech signals are partially mixed.

A compact open-loop resonator bandpass filter is presented to suppress the spurious passband using compensated compact microstrip resonant cell (C-CMRC) feeding structure. Based on the inherently compact and stopband characteristics of the C-CMRC feeding, the proposed filters shows a better spurious rejection performance than the only open-loop resonator filter. The suppression is -57.4 dB, -49.5 dB, and -43.9 dB at the 2nd, 3rd and 4th harmonic signal separately. All the performance of proposed filters have been verified by the measured results.