A wavelength-insensitive reflector is demonstrated with a fibre loop which has an asymmetry in the constituent coupler. The reflector is made by thinning one of two identical fibres. The reflected power is more than 0.6 dB (87%) over the wavelength region of 1.2-1.35 µm and 1.42-1.65 µm. The transmitted power is less than 30 dB in the 1.23-1.63 µm region and less than 40 dB at 1.3 and 1.55 µm.

This paper proposes a new subscriber distribution method called FTTA (Fiber To The Area), which uses millimeter-wave radio band to connect subscribers with base station and optical fiber to connect base station with control station in order to obtain broad-band transmission. Usually two main causes of signal degradation, i.e., rainfall attenuation on radio channel and intermodulation distortion on optical channel are considered in this system. Taking into considerations of these two factors, we analyze the available capacity of FTTA system for various 22nQAM modulation levels. The analysis clarifies that there exists an optimum modulation level that can maxize the available capacity, and AGC circuit in the base station is useful to compensate the rainfall attenuation. It is shown that 18.0Gbps is available under the optimum modulation method of the 64QAM with AGC and 12.0Gbps under the 16QAM without AGC when 20 carriers are used.

In multidimensional signal sampling, the orthogonal sampling scheme is the simplest one and is employed in various applications, while a non-orthogonal sampling scheme is its alternative candidate. The latter sampling scheme is used mainly in application where the reduction of the sampling rate is important. In three-dimensional (3-D) signal processing, there are two typical sampling schemes which belong to the non-orthogonal samplings; one is face-centered cubic sampling (FCCS) and the other is body-centered cubic sampling (BCCS). This paper proposes a new design method for 3-D band-limiting FIR filters required for such non-orthogonal sampling schemes. The proposed method employs the McClellan transformation technique. Unlike the usual 3-D McClellan transformation, however, the proposed design method uses 2-D prototype filters and 2-D transformation filters to obtain 3-D FIR filters. First, 3-D general sampling theory is discussed and the two types of typical non-orthogonal sampling schemes, FCCS and BCCS, are explained. Then, the proposed design method of 3-D bandlimiting filters for these sampling schemes is explained and an effective implementation of the designed filters is discussed briefly. Finally, design examples are given and the proposed method is compared with other method to show the effectiveness of our methos.

This paper discusses the performance of asynchronous direct-sequence spread-spectrum multiple-access systems using binary or quaternary phase-shift keyed signals with the strict bandwidth-limitation by Nyquist filtering. The signal-to-noise plus interference ratio (SNIR) at the output from the correlation receiver is derived analytically taking the cross-correlation characteristics of spreading sequences into account, and also an approximated SNIR of a simple form is presented for the systems employing Gold sequences. Based on the analyzed result of SNIR, bit error rate performance and spectral efficiency are also estimated.

An automatic tap assignment method in sub-band adaptive filter is proposed in this letter. The number of taps of the adaptive filter in each band is controlled by the mean-squared error. The numbers of taps increase in the bands which have large errors, while they decrease in the bands having small errors, until residual errors in all the bands become the same. In this way, the number of taps in a band is roughly proportional to the length of the impulse response of the unknown system in this band. The convergence rate and the residual error are improved, in comparison with existing uniform tap assignment. Effectiveness of the proposed method has been confirmed through computer simulation.

It is known that the resolution conversion based on orthogonal transform has a problem that is difference of luminance between the converted image and the original. In this paper, the scale factor of the system employing various orthogonal transforms is generally formulated by considering the DC gain, and the condition of alias free for DC component is indicated. If the condition is satisfied, then the scale factor is determined by only the basis functions.

Sea clutter was measured using an X-band radar at very high grazing angles between 8.2 and 17.5. The sea state was 7 with the wave height of 6 to 9m. The wind velocity was 25m/s. It is shown that sea clutter amplitudes obey the log-normal and K distributions using the Akaike Information Criterion (AIC) , which is more rigorous fit to the distribution to the data than the least squares method.

A wavelength path (WP) network management scheme is proposed for a photonic network. Multimedia data streams are integrated into a single-mode fiber using wave-length division WP multiplexing; both analog/digital and STM/ATM communications are handled. The WP management scheme using WP blocks (WPBs) with guard bands is described. An initially assigned WP does not use the guard band and most bandwidth changes made to accommodate WP changes occur within the original WPB using the guard band. An effective WP assignment method based on a recursive packing scheme is also proposed. The proposed WP packing scheme with guard band realizes a maximum network efficiency of 98%, and the probability of WP reassignment is under 10%. The techniques introduced in this paper permit the realization of flexible and effective multimedia services with a multimedia photonic network.

In a cellular system for mobile communications, every service area is divided into a number of cells for utilizing the frequency spectrum efficiently. Service areas for such systems are two dimensional, however, the analysis of the characteristics of the communication traffic for the areas are quite complicated, since the motion of the vehicles in the area can not be predicted precisely. For making the analysis easily, the areas are assumed to be band-shaped like a highway. Furthermore, in the analysis, the traffic offered to a cell is assumed to be stationary. In actual systems, the density of vehicles and the offered communication traffic is not stationary, so that many differences exist between the analysis and the actual systems. This paper presents an analysis method using state equations. The equations represent the transient characteristics of mobile communication traffic when a band-shaped service area is assumed. The transition is made by accidents or congestion, and causes the rapid offered traffic change in a communication system. In the method, numerical analysis is made under the consideration of "handoff" operation. The operation consists of surrendering the channel used in the previous cell and reassigning a new channel when the vehicle crosses the cell boundary. The analytical results are compared with the simulations, and the two results show good agreement. The method presented in this paper can be used for designing the switching system when the offered traffic changes rapidly due to accidents or congestion.

A wideband high power amplifier design using a novel band-pass filter with FET's parasitic reactances has been developed. The feature of this design is in that it can provide wide bandwidth and high gain of high power amplifiers. Furthermore, the lower cutoff frequency and bandwidth can be varied independently. With the use of this design, a Ku-band two-stage high power amplifier having a bandwidth of 18% has achieved a linear gain of 9.751.75 dB, a saturated output power of greater than 37 dBm, and a power-added efficiency of greater than 10.4%.

This paper describes bandpass filters using linear tapered transmission line resonators (LTLR's). Bandpass filters are designed on the basis of the approximate description of LTLR's with cascaded multi-sections of uniform transmission lines whose widths are slightly different. By this design method, the fundamental characteristics of LTLR's and filter design parameters can be easily obtained using a general-purpose microwave circuit simulator. Trial LTLR bandpass filters showed excellent performance such as low insertion losses and the ability to control spurious responses, then their measured responses indicated close correspondence with the design results.

A novel sampling comparator circuit is presented for extending the pull-in range of microwave phase-locked oscillators (PLOs). It performs both phase and frequency detection without any frequency dividers, and a GaAs MMIC prototype is developed and tested. The proposed comparator improves the pull-in range by about 10 times more than is possible with conventional sampling phase detectors.

We propose a design method for a two-channel perfect reconstruction FIR filter banks employing linear-phase filters. This type of filter bank is especially important in splitting image signals into frequency bands for subband image cording. Because in such an application, it is necessary to use the combination of linear-phase filters and symmetric image signal, namely linear phase signal to avoid the increase in image size caused by filtering. In this paper, first we summarize the design conditions for two-channel filter banks. Next, we show that the design problem is reduced to a very simple linear equation, by using a half-band filter as a lowpass filter. Also the proposed method is available to lead filters with fewer complexity, which enable us to use simple arithmetic operations. For subband coding, the property is important because it reduces hardware complexity.

The transmission of HDTV signals on digital networks requires adoption of sophisticated compression techniques to limit the bit-rate requirements and to provide a high-quality and reliable services to customers. This paper describes system design and transmission characteristics of an adaptive subband DCT codec that can encode original 1.2Gb/s HDTV signals at 156Mb/s. The performance of the codec was evaluated using motion picture signals. The characteristics obtained with the codec was found to maintain good picture quality.

Broadband ISDN, using asynchronous transfer mode, are expected to carry traffic of different classes, each with its own set of traffic characteristics and performance requirements. To achieve the quality of service in ATM networks, a suitable buffer management scheme is needed. In this paper, we propose a buffer management scheme using a priority service discipline to improve the delay time of delay-sensitive class and the packet loss ratio of loss-sensitive class. The proposed priority scheme requires simple buffer management logic and minor processing overhead. We also analyze the delay time and the packet loss ratio for each class of service. The results indicate that the required buffer size of the proposed priority scheme is reduced and the delay time of each class of service is controlled by a parameter. If the control parameter is appropriately chosen, the quality of service of each class is improved.

The evolution of Multiple-Valued Logic (MVL) circuits has been inexorably tied to the rapid technological changes induced by evolving needs and emerging developments in computing methodologies. Unfortunately for MVL, the numbers of designers of technologies and circuits whose lives are dedicated to the improvement of binary techniques, are large and overwhelming. Correspondingly, technological developments in MVL typically await the appearance of a problem or technique in the larger binary world to motivate and/or make possible some new advance. Such opportunities are inevitably quite transient since each such problem is simultaneously attacked by many others of a more conventional bent, and, as well, each technological change begets yet another, quickly. It is in the sensing of this reality that the present paper is written. Correspondingly, its thrust is two-fold: One target is the possibility of encouraging a leap ahead through modest technological projection. The other is the possibility of identifying application areas that already exist in this unbalanced competition, but which are specially suited to multiple-valued solutions. For example, it has been clear for decades that one such area is that of arithmetic. Correspondingly, we in MVL must strive quickly to concentrate our efforts on applications that exploit such demonstrable strengths. Some such applications are includes here; others are visible historically, many probably remain to be found: Search on!

A field trial was conducted to evaluate the technical performance of land mobile message communication in different environments. The OmniTRACS system and the Ku-band JCSAT satellite were utilized as the mobile communications system and the satellite, respectively. The trial took place in September 1990 at different areas in Japan. Data collected correspond to about 65 hours of operation, during which a large number of messages were sent via the satellite. Two land mobile terminals operated simultaneously, each terminal having a function of generating messages automatically which simulates a large volume of traffic corresponding to about 50 terminals. Thus, the system was evaluated under the condition that 100 mobile terminals were in operation. Obtained data have been analyzed with a particular focus on the message transmission correlating with actual environments. The analysis was done by classifying environments into five categories: overall condition, type of roads, terrain, areas and weather conditions. The average transmission count per message experienced under all conditions is equal to 1.432 for forward messages transmitted from the hub station to mobiles, and 1.157 for return messages transmitted from mobiles to the hub station. With respect to the classification by the type of roads, for enample it becomes obvious that the performance is generally good except along roads of North-South orientation through dense urban areas. It is concluded that the message communications from/to mobiles are feasible in a wide range of environments, with the performance of success essentially depending on the visibility of satellite.

A new type of analog-to-digital (A/D) converter is introduced. The structure is based on a magnitude-preserving quadrature mirror filter (QMF) bank where the analysis bank is composed on IIR switched-capacitor (SC) filters. The analog output samples of the analysis filters are converted into digital form using individual A/D converters and combined by an IIR digital filter synthesis filter bank. This A/D converter is useful in applications where only the magnitude of the spectrum of the analog signal needs to be preserved. The structure incorporates the advantages of sub-band coding and reduces considerably the effect of mismatches among the sub-band A/D converters. In addition, the proposed scheme leads to an increase in the conversion speed by a factor of M when an M-channel QMF bank is used. An illustrative example verifying the good performance of the proposed approach is included.

A multicarrier modulation is considered as an effective technique in high speed digital transmission under the multipath fading. In this paper, we theoretically analyze the bit error rate (BER) performance of the multicarrier modulation/differential detection scheme, and show the trade-offs between the BERs and the number of carriers or the guard period to clarify the optimum values to minimize the BER in the number of carriers and the guard period.

Several research institutions in Europe have developed set-ups for wide-band mobile radio communication measurements. The performance and evaluation has been coordinated in the framework of the cooperation in the field of scientific and technical research within the committees COST 207 COST 231. New parameters have been defined to improve the insight into performance limits of digital radio communication systems which are caused by propagation phenomena. The definitions of these new parameters are presented in the paper. Channel sounders developed in Norway, Denmark, the United Kingdom, Switzerland, France and Germany are described. They are based on considerably different technical principles for evaluation and recording of the measured results. A few results gained in European measurement campaigns are also presented.