In this paper, we discuss the use of convolutional codes with a multi-antenna transmission scheme for DS/CDMA systems. The binary input data to a rate 1/M encoder produces M coded bits, which, in turn, are assigned to M different antennas and transmitted from each antenna simultaneously. An intentional delay of several chips duration is introduced at each antenna before transmission, which enables a receiver to distinguish the signals from different antennas. Because the proposed scheme utilizes spatial and time domains for coding, it can achieve not only implicit time-diversity through the use of coding with interleaving, but also space-diversity through the transmission from multiple antennas. Multi-antenna schemes with convolutional codes can perform better than conventional single antenna schemes with the same codes and transmission diversity technique with the same number of transmitting antennas, especially when a fading is relatively slow and interleaving size is limited.

Pre-decorrelation is a method of achieving orthogonalization between multiple signals on the forward link. This technique can achieve orthogonalization in a flat fading channel, however, the orthogonality does not clearly appear in a multipath fading channel because of interchip interference. In order to eliminate the effect of multipath and prevent interchip interference, multicarrier modulation can be employed. In this paper we propose a multicarrier pre-decorrelation technique which combines multicarrier modulation with pre-decorrelation. Computer simulation results show that the proposed technique can achieve orthogonalization in a multipath fading channel.

This paper proposes an analysis method of scaling-factor-quantization error in fractal image coding using a state-space approach with the statistical analysis method. It is shown that the statistical analysis method is appropriate and leads to a simple result, whereas the deterministic analysis method is not appropriate and leads to a complex result for the analysis of fractal image coding. We derive the output error variance matrix for the measure of error and define the output error variance by scalar quantity as the mean of diagonal elements of the output error variance matrix. Examples are given to show that the scaling-factor-quantization error due to iterative computation with finite-wordlength scaling factors degrades the quality of decoded images. A quantitative comparison of experimental scaling-factor-quantization error with analytical result is made for the output error variance. The result shows that our analysis method is valid for the fractal image coding.

In supervisory control, discrete event dynamic systems (DEDSs) are modeled by finite-state automata, and their behaviors described by the associated formal languages; control is exercised by a supervisor, whose control action is to enable or disable the controllable events. In this paper we present a general stability concept for DEDSs, stability in the sense of Lyapunov with resiliency, by incorporating Lyapunov stability concepts with the concept of stability in the sense of error recovery. We also provide algorithms for verifying stability and obtaining a domain of attraction. Relations between the notion of stability and the notion of fault-tolerance are addressed.

Phase-Locked Loop (PLL) designers have two major problems with regard to the production of practical, portable multimedia communication systems. The first is the difficulty of achieving both fast lock time and low jitter operation simultaneously. This can be particularly difficult because the increase in loop stability needed to reduce jitter increases the lock time. The second is the problem caused by circuits operating at low voltage supplies. Low voltage supplies adversely effect the performance of phase-frequency detectors and charge pump circuits, and they can decrease the noise immunity of oscillators. We have developed a hot-standby architecture, which can achieve both fast lock time and low jitter operation simultaneously, and low-voltage circuit techniques, such as a noise-immune adaptive-gain voltage-controlled oscillator, for a fabricated PLL. This PLL is fully integrated onto a 480-µm450-µm die area with 0.18-µm CMOS technology. It can operate from 0.5 V to 1.2 V, and with a lock range from 40 MHz to 170 MHz at 0.5 V. The jitter is less than 200 ps and the lock time is less than 500 ns.

This paper proposes a direct-sequence spread spectrum (DS/SS) communication system with a new diversity technique designed for indoor multi-path fading channels where path diversity isn't available. In this system, the transmitter sends a same signal from multiple antennas at the same time with intentional time delays, which allows the receiver to distinguish and combine the signals from different antennas. We also consider the combination of this scheme with the conventional receiving antenna diversity for additional diversity gain. Furthermore, it is found that the use of the multiple transmitting antennas decreases the effect of the multiple access interference.

In addition to additive thermal noise, a received direct-sequence spread spectrum (DS/SS) signal may suffer from intersymbol interference (ISI) and interference caused by cochannel narrowband users or other narrowband radio frequency interference (RFI). This paper presents a workable solution for removing narrowband interference (NBI) and reducing ISI or inter-chip interference (ICI) when the communication channel can be modeled as an FIR filter and the NBI comes from multiple CW tones, an AR-modeled Gaussian process, or a BPSK signal. Unlike earlier solutions, the proposed scheme is capable of performing the functions of NBI-rejection, ISI/ICI suppression and data detection (code despreading) simultaneously. It is easy to implement and, more importantly, it yields lower bit error rate (BER) and smaller mean squared error (MSE).

The purpose of this report is to predict far-field EMI spectrum emitted from a signal line on a digital PCB based on near-field EMI measurement. The relation between near magnetic field and far electric field is shown. A method of predicting far electric field from near magnetic field is proposed. Current flowing along a signal line is calculated from measured near magnetic field. Far electric field is estimated from the current. Measurement and prediction of EM emission are carried out using a simple PCB. The result of prediction and measurement of far-field EMI spectrum coincide within the error of 3 dB.

In this paper, we illustrate the analysis of microstrip structures with a large number of unknowns using the sparse-matrix/canonical grid method. This fast Fourier thansform (FFT) based iterative method reduces both CPU time and computer storage memory requirements. We employ the Mixed-Potential Integral Equation (MPIE) formulation in conjunction with the RWG triangular discretization. The required spatial-domain Green's functions are obtained efficiently and accurately using the Complex Image Method (CIM). The impedance matrix is decomposed into a sparse matrix which corresponds to near interactions and its complementary matrix which corresponds to far interactions among the subsectional current elements on the microstrip structures. During the iterative process, the near-interaction portion of the matrix -vector multiplication is computed directly as the conventional MPIE formulation. The far-interaction portion of the matrix-vector multiplication is computed indirectly using fast Fourier transforms (FFTs). This is achieved by a Taylor series expansion of the Green's function about the grid points of a uniformly-spaced canonical grid overlaying the triangular discretization.

Recently, the low earth orbit satellite communications has been attracting much attention. These communications have many strong features, however, the communication performances are influenced by carrier frequency offset (CFO) and, particularly, it is hard to acquire the synchronization. A large number of publications have so far been made on the synchronization acquisition of DS/SS systems under CFO and most of them make use of the maximum likelihood decision in finding the maximum values of Fourier transform outputs. However, the implementations of Fourier transforms usually require high cost and large space. In this paper, we propose a new simple acquisition scheme using half-symbol differential decoding technique for DS/SS systems under CFO. This scheme makes use of the addition and subtraction of baseband signals and their delayed versions, (omitting Fourier transforms), together with integrations by recursive integrators, and thus resulting in much simpler implementation. In general, it is shown that the proposed scheme can acquire the code synchronization under carrier frequency offset with much smaller computational complexities and the sacrifice of longer acquisition time.

Bit-interleaving can enhance performance of a trellis coded modulation system over a fading channel. A combined system with decision feedback equalization is proposed. In the system, TCM decoded symbols are fed back for equalization. To avoid a bad effect of decoding delay, a deinterleaver is utilized effectively. Information sequence is divided into three subsequences and encoded by three encoders. Among the 3 code vectors from the encoders, bits are interleaved and decoding proceeds in parallel. Simulation results show that the proposed system realizes 0.6 dB more coding gain than a symbol interleaved system. A calculation method of a branch metric for decoding is proposed. Performance with the branch metric is shown to be nearly independent from the desired/undesired power ratio of a intersymbol interference channel. An approximate upper bound is analyzed for the proposed system, and the optimum code is searched.

The redundancy of universal lossy data compression for discrete memoryless sources is considered in terms of type and d-ball covering. It is shown that there exists a universal d-semifaithful code whose rate redundancy is upper bounded by (A-1/2)n-1ln n+o(n-1ln n), where A is the cardinality of source alphabet and n is the block length of the code. This new bound is tighter than known ones, and moreover, it turns out to be the attainable minimum of the universal coding proposed by Davisson.

The numerical property of the recursive least squares (RLS) algorithm has been extensively, studied. However, very few investigations are reported concerning the numerical behavior of the predictor-based least squares (PLS) algorithms which provide the same least squares solutions as the RLS algorithm. In Ref. [9], we gave a comparative study on the numerical performances of the RLS and the backward PLS (BPLS) algorithms. It was shown that the numerical property of the BPLS algorithm is much superior to that of the RLS algorithm under a finite-precision arithmetic because several main instability sources encountered in the RLS algorithm do not appear in the BPLS algorithm. This paper theoretically shows the stability of the BPLS algorithm by error propagation analysis. Since the time-variant nature of the BPLS algorithm, we prove the stability of the BPLS algorithm by using the method as shown in Ref. [6]. The expectation of the transition matrix in the BPLS algorithm is analyzed and its eigenvalues are shown to have values within the unit circle. Therefore we can say that the BPLS algorithm is numerically stable.

In this paper the conventional symbol-aided estimation methods are extended to use not only the known pilot symbols but also the previously estimated fading values to extract more information on fading channels. The proposed estimation method is evaluated using theoretical analyses. Recursive formulae are derived for calculating the mean square estimation errors, which are then used to calculate the BER performance of a BPSK system employing the proposed fading estimation method. The results show strong BER performance of the proposed system in the region of high signal to noise ratio under fast fading compared to that of the conventional system. Moreover, the proposed system still sustains its performance under mismatched conditions, where the conventional system degrades exhibiting error floors. Finally the theoretical results are verified by using computer simulations.

The present paper gives a new formulation for rough surface scattering in terms of a stochastic integral equation which can be dealt with by means of stochastic functional approach. The random surface is assumed to be infinite and a homogeneous Gaussian random process. The random wave field is represented in the stochastic Floquet form due to the homogeneity of the surface, and in the non-Rayleigh form consisting of both upward and downward going scattered waves, as well as in the extended Voronovich form based on the consideration of the level-shift invariance. The stochastic integral equations of the first and the second kind are derived for the unknown surface source function which is a functional of the derivative or the increment of the surface profile function. It is also shown that the inhomogeneous term of the stochastic integral equation of the second kind automatically gives the solution of the Kirchhoff approximation for infinite surface.

Equivalence of physical optics (PO) and aperture field integration method (AFIM) in the full 360 observation angle is discussed for polyhedron approximate reflectors; the necessary conditions of integration surface in AFIM for the equivalence to PO are presented. In addition to the condition that complete equivalent currents consisting of both geometrical optics (GO) reflected fields from the reflector and direct incident fields from the feed source are used, the integration surface should cap the reflector perfectly and should be in the illuminated region of the GO reflected field. Validity of the conditions is numerically confirmed for a two-dimensional (2-D) strip reflector, 3-D corner reflectors and a 2-D polyhedron approximate reflector.

The capture effect caused by some of power assignment, Rayleigh fading, and near-far effect, can improve the performance of random-access techniques in mobile radio environment. Moreover, if we consider the overall effect of them, the system performance can be noticeably improved. In this paper, the combined effect of fixed power assignment scheme, Rayleigh fading, and near-far effect on the performance of slotted ALOHA are studied. Plus, the performance degradation caused by AWGN is also investigated. The type of signal capture to be considered is the one that a signal involved in a collision survives if its power level exceeds the sum of the other signals participating in the same collision. Numerical calculations are used to demonstrate the degree of improvement and degradation.

This paper deals with a probabilistic formulation of the diffraction and scattering of a plane wave from a periodic surface randomly deformed by a binary sequence. The scattered wave is shown to have a stochastic Floquet's form, that is a product of a periodic stationary random function and an exponential phase factor. Such a periodic stationary random function is then represented in terms of a harmonic series representation similar to Fourier series, where `Fourier coefficients' are mutually correlated stationary processes rather than constants. The mutually correlated stationary processes are written by binary orthogonal functionals with unknown binary kernels. When the surface deformations are small compared with wavelength, an approximate solution is obtained for low-order binary kernels, from which the scattering cross section, coherently diffracted power and the optical theorem are numerically calculated and are illustrated in figures.

Clothoid or cornu spiral segments were used as transition spirals forming C-and S-shaped curves between circles as well as straight lines in various situations of highway road design. These transitions are the center lines of rail, highway road design. The above C and S-shaped form curves consist one or more transition segments. We study the possibility of using the single transition spirals in the situations that use many transition spirals to form smooth transition spline between circles as well as straight lines. We also compute the bounds for the scaling of such single spirals using the practical equation. This paper is aimed to give a method avoiding non-linear equations by finding range for the scaling factor of the clothoids which can take initially an appropriate closer value from this range.

The electric field intensity of the THz radiation from YBCO thin films excited by ultrashort laser pulses has been enhanced by a factor of 3 using a-axis oriented films instead of c-axis oriented ones used previously under the same excitation conditions. This corresponds to the enhancement of a factor of 10 for the radiation power. From the transmittance measurements of the millimeter wave for a-and c-axis oriented films, the origin of the enhancement is attributed to the increased fraction of the THz electromagnetic wave power transmitted from the YBCO film to free space. This result indicates that the utilization of the anisotropic properties of high-Tc superconductors is effective to enhance the radiation power.