We investigated performance improvement in a cellular system by introducing direct communication between terminals. Previous research has indicated that direct communication efficiently uses channels; however, this is not always so. We studied two factors that affect how much efficiency improves. One is the distribution of terminals. We defined some typical distributions with localization of terminals and analyzed how the difference between the distributions affected the performance improvement by direct communication. Another factor is the mobility of terminals, because mobility shortens the length of time during which terminals are directly connected. We analyzed how mobility affected performance improvement by direct communication. For the analyses, we used some theoretical techniques.

An HEMT CCD (charge-coupled-device) matched filter for spread-spectrum communication was developed. For higher data rates, it was fabricated using a two-phase CCD based on HEMT technology. It operates at 1.6 GHz, and its calculated data rate is 100 Mbps with a PN data length of 16 bits (PN data rate is 1.6 GHz). And it attains a charge transfer efficiency (CTE) of 0.975 at 2 GHz. The HEMT CCD matched filter dissipates 173 mW from a 10-Vp-p supply, and its chip size is 0.961.03 mm. It will thus be useful for optical communication and other high-data-rate applications utilizing spread-spectrum (SS) communication.

To obtain large capacity, high quality mobile satellite communication systems in the future, we must use a multi-beam that can cope with extremely high levels of frequency reuse. This paper describes a novel resource allocation algorithm for multi-beam satellite communication systems that can dynamically adapt to maximum communication capacity without compromising quality. The algorithm combines two resource allocation schemes that enable it to contend with the ever-changing user distribution and inter-beam interference conditions. The first scheme optimizes the resources amongst beams. To minimize interference, the optimal constraint conditions are clarified when all clusters share and occupy the same bandwidth completely. These constraints are used in the optimization algorithm. The second scheme manages the various required resources and adapts them to the beam gain and interference levels at various user locations within a single beam. We propose a fixed power adaptive modulation scheme to obtain stable communications. This two-layered scheme can satisfactorily allocate multi-beam satellite resources to contend with the increasing communication capacity and still improve the quality.

The EDD connection admission control scheme has been proposed for supporting real-time communication in packet-switched networks. In the scheme, when a connection establishment request occurs, the worst-case link delay in each link along the connection is calculated to determine whether the request can be accepted or not. In order to calculate the worst-case link delay, we must perform a check called the point schedulability check for each of some discrete time instants (checkpoints). Therefore when there are many checkpoints, the worst-case link delay calculation is time-consuming. We have proposed a high-speed calculation method. The method finds some checkpoints for which the point schedulability check need not be performed and removes such unnecessary checkpoints in advance before a connection establishment request occurs, and the check is performed for each of the remaining checkpoints after the request occurs. However, the method is not so effective under the situation that the maximum packet length in networks is large, because the method can find few unnecessary checkpoints under the situation. This paper proposes a new high-speed calculation method. We relax the condition which determines whether or not the point schedulability check need not be performed for each checkpoint in our previous method and derive a new condition for finding unnecessary checkpoints. Using the proposed method based on the new condition, we can increase the number of unnecessary checkpoints compared to our previous method. Numerical examples which are obtained by extensive simulation show that the proposed method can attain as much as about 50 times speedup.

We describe a layer 3 diversity reception scheme that enhances the transmission characteristics of Ku-band mobile satellite communication systems. This scheme can realize high-speed communication for vehicles that experience shadowing caused by terrestrial obstacles such as tunnels, buildings and bridges, especially for trains that frequently experience shadowing from the trolley wire structures. Layer 3 diversity was chosen for long distance diversity to prevent signal shadowing caused by terrestrial obstacles while minimizing the alterations of existing receivers. The technology enables high-speed communication under shadowing conditions in a running train environment.

In this paper, we propose an interactive instruction system named IMPRESSION, which allows performance of interactive presentations using multimedia educational materials in class. In recent years, although many practices of educational methodology with information technology and presentation tools using multimedia resources as educational materials have come into common use, instructors can only present such materials in a slide-sheet form through the use of such presentation tools in class. Therefore, instructors can neither do formative evaluations nor can they present suitable materials according to students' reactions in class. Our proposed methodology employs a scenario-based approach in a double loop instructional design process to overcome such problems. Instructors design an instructional plan as a scenario, and subsequently implement and modify the plan through formative evaluation during the class. They then conduct a summative evaluation based on planned and implemented instructions for redesign. To realize our methodology, in this paper we propose and design an instruction system that provides functions to select and present multimedia materials interactively provided on the Internet during the class; we then record these instructions. After implementing it, we confirmed that we can conduct the class flexibly based on our methodology through its practical use in an actual classroom environment.

Assistive technology (AT) is becoming increasingly important for improving the mobility and language learning capabilities of persons with disabilities, thus enabling them to function independently and to improve their social opportunities. The Morse code has been shown to be a valuable tool in assistive technology, augmentative and alternative communication, and rehabilitation for people with neuromuscular diseases such as amyotrophic lateral sclerosis, multiple sclerosis, and muscular dystrophy. In this paper, we designed and implemented a wireless environmental control aid system using the Morse code as an adapted access communication tool, which includes three types of switch: single-switch, double-switch, and six-switch types. People with disabilities can easily control all types of electronic appliance without restrictions owing to spatial arrangements using a signal transmission based on radio frequency (RF). Experimental results revealed that three participants with disabilities were able to gain access to electronic facilities after six weeks of practice with the new system.

In this paper, a new dimming algorithm for the electronic ballast of an electrodeless fluorescent lamp is proposed. The proposed method is based on the burst dimming method that controls the duty ratio for the two switches of the electronic ballast by intermittently modulated pulse signal. This paper presents a fully digital circuit using an erasable programmable logic device (EPLD). To verify the validity of the proposed method, the implemented control circuit was applied to the electronic ballast for a 100 W electrodeless fluorescent lamp. As a result, a dimming method with a wide illumination range from 5 to 100% was obtained.

A communication support interface controlled by eye movements and voluntary eye blink has been developed for disabled individuals with motor paralysis who cannot speak. Horizontal and vertical electro-oculograms were measured using two surface electrodes attached above and beside the dominant eye and referring to an earlobe electrode and amplified with AC-coupling in order to reduce the unnecessary drift. Four directional cursor movements --up, down, right, and left-- and one selected operation were realized by logically combining the two detected channel signals based on threshold settings specific to the individual. Letter input experiments were conducted on a virtual screen keyboard. The method's usability was enhanced by minimizing the number of electrodes and applying training to both the subject and the device. As a result, an accuracy of 90.1 3.6% and a processing speed of 7.7 1.9 letters/min. were obtained using our method.

This paper describes a low-loss submarine optical fiber cable for a long-distance submarine repeaterless transmission system that employs remote pumping. The features of this system are that it has an increased signal power budget and is cost effective and easy to maintain. First, we investigated the relationship between the signal and pump losses and the Raman gain efficiency of optical fiber needed to achieve a submarine repeaterless transmission system operating at 2.5 Gbps and over a distance exceeding 370 km. We manufactured a submarine optical fiber cable based on the results and confirmed that it had low-loss characteristics. Second, we evaluated the long-term loss stability of the optical fiber with a high-power continuous wave (CW) laser light as the pump source. We confirmed that the loss remained unchanged after 1900 hours of exposure to 8 W CW laser light at a wavelength of 1.48 µm. This submarine optical fiber cable is being employed in a commercial submarine repeaterless transmission system between Okinawa and Miyakojima.

In this letter, we derive an efficient audio/video synchronization method for video telephony. For synchronization, this method does not require any further RTCP packet processing except for the first one. The derived decision rule is far more compact than the conventional method. This decision rule is incorporated in an actual video telephony system adopting Texas Instruments (TI) OMAP 1510 processor and Qualcomm MSM 5500. The computational requirement was compared with the conventional method and through simulations the superiority of the proposed method is proved.

The rapid hybrid acquisition of PN sequences is proposed for DS/CDMA systems. The system introduces the excision CFAR method into the background power estimation. A mathematical analysis is done for the single path and multipath environments. The detection performance of the proposed scheme is compared with that of other acquisition schemes. Results show that the proposed method has better detection performance if the excision coefficient is properly selected.

We describe attempts to have robots behave as embodied knowledge media that will permit knowledge to be communicated through embodied interactions in the real world. The key issue here is to give robots the ability to associate interactions with information content while interacting with a communication partner. Toward this end, we present two contributions in this paper. The first concerns the formation and maintenance of joint intention, which is needed to sustain the communication of knowledge between humans and robots. We describe an architecture consisting of multiple layers that enables interaction with people at different speeds. We propose the use of an affordance-based method for fast interactions. For medium-speed interactions, we propose basing control on an entrainment mechanism. For slow interactions, we propose employing defeasible interaction patterns based on probabilistic reasoning. The second contribution is concerned with the design and implementation of a robot that can listen to a human instructor to elicit knowledge, and present the content of this knowledge to a person who needs it in an appropriate situation. In addition, we discuss future research agenda toward achieving robots serving as embodied knowledge media, and fit the robots-as-embodied-knowledge-media view in a larger perspective of Conversational Informatics.

In this paper, the confinement loss of octagonal photonic crystal fibers (PCFs) with an isosceles triangle lattice of air-holes are numerically investigated. Taking into account the confinement loss, the mode field diameter (MFD), the effective area (Aeff) and the chromatic dispersion of octagonal PCFs are calculated, compared to conventional hexagonal PCFs. It is found from confinement loss and MFD results that the octagonal PCFs can confine the field strongly than the hexagonal PCFs due to the different air filling fraction. Moreover, it is shown that the octagonal PCFs are obtained not only positive but also negative larger dispersion values and smaller Aeff values compared to the hexagonal PCFs.

Post-FFT type orthogonal frequency division multiplexing (OFDM) adaptive array antennas can reduce the co-channel interference with a few antenna elements under multi-path fading environments. However, the Post-FFT type OFDM adaptive array antennas require a lot of pilot symbols in order to determine the optimal weights in each subcarrier. In packet communication systems, since the data are transmitted burst by burst, the ratio of the effective data in a channel decreases when the long pilot symbols are used. Recursive least squares (RLS) algorithm is one of the weight optimization algorithm with fast convergence based on minimum mean square errors (MMSE). However, the optimal weight determination with a few pilot symbols is difficult. Therefore, in this paper, we propose a novel multi-stage RLS OFDM adaptive array antenna for realizing weight determination with a few pilot symbols. In the proposed method, the weights are optimized by using a multiple stage structure with the stored pilot symbols. Here, the initial weights and the initial inverse matrix of correlation matrix are decided by the results of the weight determination in the adjacent subcarriers of the previous stage. As a result, the weight determination with a few pilot symbols can be achieved.

In this paper, we propose a protocol for multicast communication called Multicast Datagram Transfer Protocol (MDTP) to provide multicast for video broadcasting service on the Internet. MDTP is a one-to-many multicast communication protocol, which is constructed based on IPv4 unicast protocol by utilizing IP Router Alert Option, and it uses unicast addressing and unicast routing protocol. A mechanism is presented to allow a router to remove identical video stream, to duplicate a video stream, and to forward each copy of the duplicated video stream to its destinations. Ordinary IP routers that do not support MDTP will treat the MDTP packets as normal unicast packets. Hence, gradual deployment is possible without tunneling technique. With a delegation mechanism, MDTP router is also able to handle request from clients, and serve the requested video stream. The simulation results show that the average bandwidth usage of MDTP is close to the average bandwidth usage of IP multicast. MDTP also has greater efficiency than XCAST, and its efficiency becomes significant for a large number of clients.

In this paper, we present a novel forwarding scheme to enhance communication stability based on geographic routing in mobile ad hoc networks, which is called "Position-based Heuristic Forwarding" (PHF). For alternative solutions to traditional ad hoc routings, many geographic routing algorithms have been proposed. Most of the existing routings impose a certain restriction, planarity, on the graph structure of network for delivering messages to destination definitely. PHF achieves the guaranteed packet delivery over Unit Disk Graph, which is more widely employed graph model for the study of ad hoc networks. Accordingly, to eliminate the restriction of the routing algorithms enhances the probability to deliver messages successfully in networks with high nodes' mobility rate. In the simulation of PHF, we have evaluated the performance comparisons between PHF and its related work, Greedy Perimeter Stateless Routing (GPSR) and Dynamic Source Routing (DSR), which are the prominent geographic and conventional topology-based routing protocols, respectively. The results show that PHF provides higher packet delivery success rate indicating better communication stability and equal or less overhead than these work.

Blood pressure is one of the most important indicators of human health condition. A patient with hypertension in long term tends to have various kinds of vessel pathological changes such as coronary heart disease, apoplexy, and nephropathy. Consequently, the blood pressure measurement is important in daily health care for hypertension patients. Traditionally, the design and implementation of blood pressure monitor mostly focuses on the accuracy of pressure measurement and does not deal with the requirement of hypertension health care services with two-way communication via instant messages between the patient and the medical center. In this paper, a mobile-care system integrated with Bluetooth blood pressure and pulse monitor, and cellular phone is designed and implemented to transmit the physiological parameters of the patient in real time via wireless networks. The health care provider can monitor the blood pressure, body temperature, and heart rate of the patient and provide services by intelligent health care systems. The intelligent system constantly manages the health care data and periodically reports the status of the patient to the patient's family members. By the above care mechanism, the patients with hypertension can easily obtain long-term and constant monitoring of the physiological parameters and thus better health care services. A questionnaire survey has been conducted among medical personnel in Taipei municipal Wang-Fang hospital to collect their opinions of using our proposed and implemented blood pressure monitor with Bluetooth transmission function. An average of 95% of the medical personnel agree that long-term monitoring of the patients' physiological information such as blood pressure can be helpful to reduce medical cost, to provide useful reference data, and to provide long-distance health care. This thus shows strong support of the usefulness of our proposed device. Our proposed and implemented device has also been submitted to US FDA for medical device approval.

In the European Telecommunication Standards Institute (ETSI), Distributed Speech Recognition (DSR) front-end, the distortion added due to feature compression on the front end side increases the variance flooring effect, which in turn increases the identification error rate. The penalty incurred in reducing the bit rate is the degradation in speaker recognition performance. In this paper, we present a nontraditional solution for the previously mentioned problem. To reduce the bit rate, a speech signal is segmented at the client, and the most effective phonemes (determined according to their type and frequency) for speaker recognition are selected and sent to the server. Speaker recognition occurs at the server. Applying this approach to YOHO corpus, we achieved an identification error rate (ER) of 0.05% using an average segment of 20.4% for a testing utterance in a speaker identification task. We also achieved an equal error rate (EER) of 0.42% using an average segment of 15.1% for a testing utterance in a speaker verification task.

The performance of the vehicular communication links used for Intelligent Transport Systems is investigated. Intervehicle communication (IVC) and combined vehicular communication implemented by IVC and additional communication media are studied and their performance is explicitly described. Through numerical studies, it is shown that performance varies according to parameter values such as the mean space headway, the speed of the vehicles, and the penetration ratio of the IVC device. To achieve a given level of performance, I propose (i) a design of the information delivery delay of additional communication media and (ii) a method determining the appropriate delay.