Power consumption has recently emerged as a first class design constraint in system LSI designs. Specially, leakage power has occupied a large part of the total power consumption. Therefore, reduction of leakage power is indispensable for efficient design of high-performance system LSIs. Since 2006, we have carried out a research project called “Innovative Power Control for Ultra Low-Power and High-Performance System LSIs”, supported by Japan Science and Technology Agency as a CREST research program. One of the major objectives of this project is reducing the leakage power consumption of system LSIs by innovative power control through tight cooperation and co-optimization of circuit technology, architecture, and system software designs. In this project, we focused on power gating as a circuit technique for reducing leakage power. Temporal granularity is one of the most important issue in power gating. Thus, we have developed a series of Geysers as proof-of-concept CPUs which provide several mechanisms of fine-grained run-time power gating. In this paper, we describe their concept and design, and explain why co-optimization of different design layers are important. Then, three kinds of power gating implementations and their evaluation are presented from the view point of power saving and temporal granularity.

This paper presents an adaptive cache architecture for wide-range reliable low-voltage operations. The proposed associativity-reconfigurable cache consists of pairs of cache ways so that it can exploit the recovery feature of the novel 7T/14T SRAM cell. Each pair has two operating modes that can be selected based upon the required voltage level of current operating conditions: normal mode for high performance and dependable mode for reliable low-voltage operations. We can obtain reliable low-voltage operations by application of the dependable mode to weaker pairs that cannot operate reliably at low voltages. Meanwhile leaving stronger pairs in the normal mode, we can minimize performance losses. Our chip measurement results show that the proposed cache can trade off its associativity with the minimum operating voltage. Moreover, it can decrease the minimum operating voltage by 140 mV achieving 67.48% and 26.70% reduction of the power dissipation and energy per instruction. Processor simulation results show that designing the on-chip caches using the proposed scheme results in 2.95% maximum IPC losses, but it can be chosen various performance levels. Area estimation results show that the proposed cache adds area overhead of 1.61% and 5.49% in 32-KB and 256-KB caches, respectively.

The quadtree-based variable block sized prediction makes the biggest contribution for dramatically improved coding efficiency in the new video coding standard named HEVC. However, this technique takes about 75–80% computational complexity of an HEVC encoder. This paper brings forward an adaptive scheme that exploits temporal, spatial and transform-domain features to speed up the original quadtree-based prediction, targeting at high resolution videos. Before encoding starts, analysis on utilization ratio of each coding depth is performed to skip rarely adopted coding depths at frame level. Then, texture complexity (TC) measurement is applied to filter out none-contributable coding blocks for each largest coding unit (LCU). In this step, a dynamic threshold setting approach is proposed to make filtering adaptable to videos and coding parameters. Thirdly, during encoding process, sum of absolute quantized residual coefficient (SAQC) is used as criterion to prune useless coding blocks for both LCUs and 3232 blocks. By using proposed scheme, motion estimation is performed for prediction blocks within a narrowed range. Experiments show that proposed scheme outperforms existing works and speeds up original HEVC by a factor of up to 61.89% and by an average of 33.65% for 4kx2k video sequences. Meanwhile, the peak signal-to-noise ratio (PSNR) degradation and bit increment are trivial.

Objective: The virtual slides are high-magnification whole digital images of histopathological tissue sections. The existing virtual slide system, which is optimized for scanning flat and smooth plane slides such as histopathological paraffin-embedded tissue sections, but is unsuitable for scanning irregular plane slides such as cytological smear slides. This study aims to develop a virtual slide system suitable for cytopathology slide scanning and to evaluate the effectiveness of multi-focus image fusion (MF) in cytopathological diagnosis. Study Design: We developed a multi-layer virtual slide scanning system with MF technology. Tumors for this study were collected from 21 patients diagnosed with primary breast cancer. After surgical extraction, smear slide for cytopathological diagnosis were manufactured by the conventional stamp method, fine needle aspiration method (FNA), and tissue washing method. The stamp slides were fixed in 95% ethanol. FNA and tissue washing samples were fixed in CytoRich RED Preservative Fluid, a liquid-based cytopathology (LBC). These slides were stained with Papanicolaou stain, and scanned by virtual slide system. To evaluate the suitability of MF technology in cytopathological diagnosis, we compared single focus (SF) virtual slide with MF virtual slide. Cytopathological evaluation was carried out by 5 pathologists and cytotechnologists. Results: The virtual slide system with MF provided better results than the conventional SF virtual slide system with regard to viewing inside cell clusters and image file size. Liquid-based cytology was more suitable than the stamp method for virtual slides with MF. Conclusion: The virtual slide system with MF is a useful technique for the digitization in cytopathology, and this technology could be applied to tele-cytology and e-learning by virtual slide system.

In this letter, we propose an error surface modeling-based segmentalized motion estimation for video coding. We proposed two algorithms previously, one was MBQME [1] and the other is HMBQME [2]. However, these algorithms are not based on locally quadratic MC prediction errors around an integer-pixel motion vector and the hypothesis that the local error plane is a convex function. Therefore, we propose an error surface considered segmentalized modeling algorithm. In this scheme, the tendency of the error surface is first assessed. Using the Sobel operation at the error surface, we classify the error surface region as plain or textured. For plain regions, conventional MBQME is appropriate as the quarter-pixel motion estimation method. For textured regions, we search the additional interpolation points for more accurate modeling. After the interpolation, we perform double precision mathematical modeling so as to find the best motion vector (MV). Experiments show that the proposed scheme has better PSNR performance than conventional modeling algorithms with minimum operation time.

BLOCKSUM, also known as KEISANBLOCK in Japanese, is a Latin square filling type puzzle, such as Sudoku. In this paper, we prove that the decision problem whether a given instance of BLOCKSUM has a solution or not is NP-complete.

This paper presents a joint linear processing scheme for two-hop and half-duplex distributed amplify-and-forward (AF) relaying networks with one source, one destination and multiple relays, each having multiple antennas. By using the minimum mean-square error (MMSE) criterion and the Wiener filter principle, the joint relay and destination design with perfect channel state information (CSI) is first formulated as an optimization problem with respect to the relay precoding matrix under the constraint of a total relay transmit power. The constrained optimization with an objective to design the relay block-diagonal matrix is then simplified to an equivalent problem with scalar optimization variables. Next, it is revealed that the scalar-version optimization is convex when the total relay power or the second-hop SNR (signal to noise ratio) is above a certain threshold. The underlying optimization problem, which is non-convex in general, is solved by complementary geometric programming (CGP). The proposed joint relay and destination design with perfect CSI is also extended for practical systems where only the channel mean and covariance matrix are available, leading to a robust processing scheme. Finally, Monte Carlo simulations are undertaken to demonstrate the superior MSE (mean-square error) and SER (symbol error rate) performances of the proposed scheme over the existing relaying method in the case of relatively large second-hop SNR.

A simple and efficient reduced-reference video quality assessment method based on the activity-difference of DCT coefficients is proposed. The method provides better accuracy, monotonicity, and consistent predictions than the PSNR full-reference metric and comparable results with the full-reference SSIM. It also shows an improved performance to a similar VQ technique based on the calculation of the pixel luminance differences performed in the spatial-domain.

This letter presents the ideas and methods of the winning solution* for the Kaggle Algorithmic Trading Challenge. This analysis challenge took place between 11th November 2011 and 8th January 2012, and 264 competitors submitted solutions. The objective of this competition was to develop empirical predictive models to explain stock market prices following a liquidity shock. The winning system builds upon the optimal composition of several models and a feature extraction and selection strategy. We used Random Forest as a modeling technique to train all sub-models as a function of an optimal feature set. The modeling approach can cope with highly complex data having low Maximal Information Coefficients between the dependent variable and the feature set and provides a feature ranking metric which we used in our feature selection algorithm.

In this paper, a symbol-rate clock recovery scheme for a receiver that uses an integrating decision feedback equalizer (DFE) is proposed. The proposed clock recovery using expected received signal amplitudes as the criterion realizes minimum mean square error (MMSE) clock recovery. A receiver architecture using an integrating DFE with the proposed symbol-rate clock recovery is also proposed. The proposed clock recovery algorithm successfully recovered the clock phase in a system level simulation only with a DFE. Higher jitter tolerance than 0.26 UIPP at 10 Gb/s operation was also confirmed in the simulation with an 11 dB channel loss at 5 GHz.

In this paper, we present a perceptual distortion measure (PDM) for polygon-based shape coding. We model the PDM as the salience of relevance triangle, and express the PDM by using three properties derived from the salience of visual part. Performance analysis and experimental results show that our proposal can improve the quality of the shape reconstruction when the object contour has sharp protrusions.

We propose a novel network traffic matrix decomposition method named Stable Principal Component Pursuit with Frequency-Domain Regularization (SPCP-FDR), which improves the Stable Principal Component Pursuit (SPCP) method by using a frequency-domain noise regularization function. An experiment demonstrates the feasibility of this new decomposition method.

This letter proposes a new mechanism that supports adaptive sending control using Real-Time Streaming Protocol (RTSP) and Transmission Control Protocol (TCP) for IPTV service over heterogeneous networks. The proposed mechanism is implemented on a mobile IPTV device and its performance is verified for providing seamless television watching in heterogeneous networks, even when in motion.

As sensitive magnetic sensors, magnetometers based on superconducting quantum interference devices can be used for the detection of weak magnetic fields. These signals can be generated by diverse origins, for example, brain electric activity, myocardium electric activity, and nuclear precession of hydrogen protons. In addition, weak current induced in the low-temperature detectors, for example, transition-edge sensors can be detected using SQUIDs. And, change of magnetic flux quantum generated in a superconducting ring can be detected by SQUID, which can be used for realization of mechanical force. Thus, SQUIDs are key elements in precision metrology. In Korea, development of low-temperature SQUIDs based on Nb-Josephson junctions was started in late 1980s, and Nb-based SQUIDs have been used mainly for biomagnetic measurements; magnetocardiography and magnetoencephalography. High-Tc SQUIDs, being developed in mid 1990s, were used for magnetocardiography and nondestructive evaluation. Recently, SQUID-based low-field nuclear magnetic resonance technology is under development. In this paper, we review the past progress and recent activity of SQUID applications in Korea, with focus on biomagnetic measurements.

After brief introduction of our new microscope unit with an immersion objective and ionic liquid used as a refractive index matching medium, in this paper, we describe the studies on dipole orientation imaging of single molecules under high vacuum conditions as one of the important applications of our microscope.

We outline a number of high temperature superconducting Josephson junction-based devices including superconducting quantum interference devices (SQUIDs) developed for a wide range of applications including geophysical exploration, magnetic anomaly detection, terahertz (THz) imaging and microwave communications. All these devices are based on our patented technology for fabricating YBCO step-edge junction on MgO substrates. A key feature to the successful application of devices based on this technology is good stability, long term reliability, low noise and inherent flexibility of locating junctions anywhere on a substrate.

The voltage biased SQUID Bootstrap Circuit (SBC) was recently demonstrated for direct readout of SQUID signals. The SBC combines current- and voltage-feedbacks in one circuit to suppress the preamplifier noise. It offers not only a good noise performance, but also wide tolerance of SQUID parameters. Using SBC gradiometer, the bio-magnetic signals were successfully measured. In this paper, we overview the concept of SBC and its applications.

This paper presents a novel decision feedback equalizer (DFE) with block delay detection for the joint transceiver design that uses channel state information (CSI). The block delay detection in the proposed DFE offers a degree of freedom for optimizing the precoder of the transmitter, provided the transmission power is constrained. In the proposed DFE, the feedforward matrix is devised to enable a block-based equalizer that can be cooperated with an intrablock decision feedback equalizer for suppressing the intersymbol interference (ISI) for the transmitted block with a certain block delay. In this design, the interblock interference (IBI) for the delay block is eliminated in advance by applying the recently developed oblique projection framework to the implementation of the feedforward matrix. With knowledge of full CSI, the block delay and the associated block-based precoder are jointly designed such that the average bit-error-rate (BER) is minimized, subject to the transmission power constraint. Separate algorithms are derived for directly determining the BER-minimized block delays for intrablock minimum mean-squared error (MMSE) and zero-forcing (ZF) equalization criteria. Theoretical derivations indicate that the proposed MMSE design simultaneously maximize the Gaussian mutual information of a transceiver, even under the cases of existing IBI. Simulation results validate the proposed DFE for devising an optimum transceiver with CSI, and show the superior BER performance of the optimized transceiver using proposed DFE. Relying on analytic results and simulation cases also builds a sub-optimum MMSE design of the proposed DFE using the BER-minimized block delay for ZF criterion, which exhibits almost identical BER performance as the proposed MMSE design in most of the signal-to-noise ratio (SNR) range.

Magnetospinography (MSG) is one of the most promising techniques to detect the nerve activity of spinal cords thanks to its noninvasiveness and high spatial/temporal resolutions. Multichannel superconducting quantum interference device (SQUID) MSG measurement systems optimized for supine subjects have been developed previously and employed in clinical applications in hospitals. Magnetic source analyses of MSG data based on spatial filter techniques reveal the transition of reconstructed current distributions adjacent to the spinal cord. The propagation of the neural signals was noninvasively visualized. The MSG measurements provide significant diagnostic information such as irregularities in the transitions of the reconstructed current distribution and/or considerable decreases in the current intensity at the lesion. Such functional imaging of the spinal cord in addition to conventional neurologic examinations and morphological imaging will be fairly effective in presurgical lesion localizations of the spinal cord.

The three-bit balanced ternary quantum voltage generator was designed and tested. This voltage generator is based on zero-crossing Shapiro steps (ZCSSs) in asymmetric two-junction SQUID. ZCSSs were observed on the current-voltage curves, and maximum and minimum current of ZCSSs were almost same, respectively for the three bits. 27-step quantum voltages from -13Φ0f to +13 Φ0f were observed by combinations of inputs of bit1, bit2 and bit3.