The dense wavelength division multiplexing (DWDM) technique is very attractive for effectively increasing the channel capability, even for access networks. Some DWDM radio-on-fiber (ROF) systems have been studied recently. In those systems, fiber Bragg gratings (FBG) or arrayed waveguide gratings (AWG) were used to demultiplex DWDM ROF signals. In this report, an alternative channel-selection scheme of DWDM millimeter-wave-band ROF signals by optical heterodyne detection with dual-mode local light is newly proposed. Error-free demultiplexing and transmission over a 25-km-long SMF of the DWDM signal, which consists of two 60-GHz-band, 155-Mb/s-DPSK ROF signals, are demonstrated.

Recently, layer-4 (L4) switches have been widely used as load balancing front-end routers for Web server clusters. The typical L4 switch attempts to balance load among the servers by estimating load using the load metrics measured in the front-end and/or the servers. However, insufficient load metrics, measurement overhead, and feedback delay often cause misestimate of server load. This may incur significant dynamic load imbalance among the servers particularly when the variation of requested content is high. In this paper, we propose a new content sniffer based load distribution strategy. By sniffing the requests being forwarded to the servers and by extracting load metrics from them, the L4 switch with our strategy more timely and accurately estimates server load without the help of back-end servers. Thus it can properly react to dynamic load imbalance among the servers under various workloads. Our experimental results demonstrate substantial performance improvements over other load balancing strategies used in the typical L4 switch.

A new technique for optical generation of high-purity millimeter-wave (mm-wave) signals--namely, by synthesizing the outputs from cascadingly phase-locked multiple semiconductor lasers--was developed. Firstly, a high-spectral-purity mm-wave signal was optically generated by heterodyning the outputs from two phase-locked external-cavity semiconductor lasers. The beat signal was detected by a p-i-n photodiode whose output was directly coupled to a coax-waveguide converter followed by a W-band harmonic mixer. By constructing an optical phase-locked loop (OPLL), a high-spectral-purity mm-wave signal with an electrical power of 2.3 µW was successfully generated at 110 GHz with an rms phase fluctuation of 57 mrad. Secondly, the frequency of the mm-wave signal was extended by use of three cascadingly phase-locked semiconductor lasers. This technique uses a semiconductor optical amplifier (SOA) to generate four-wave-mixing (FWM) signals as well as to amplify the input signals. When the three lasers were appropriately tuned, two pairs of FWM signals were nearly degenerated. By phase-locking the offset frequency in one of the nearly degenerated pairs, the frequency separations among the three lasers were kept at a ratio of 1:2. Thus, we successfully generated high-purity millimeter-wave optical-beat signals at frequencies at 330.566 GHz with an rms phase fluctuation of 0.38 rad. A detailed analysis of the phase fluctuations was carried out on the basis of measured power spectral densities. The possibility of extending the mm-wave frequency up to 1 THz by using four cascadingly phase-locked lasers was also discussed.

We developed compact high-power photonic millimeter-wave emitter (PME) modules for 60-GHz fiber radio links. The PME chip is a monolithic integration of a uni-traveling-carrier photodiode (UTC-PD) and an antenna. One module was fabricated by attaching the chip and a plastic housing to a metal substrate, and the equivalent-isotropic radiated power (EIRP) of over 8 dBm was obtained with weak directivity of the radiated pattern. This module is suitable for point-to-multi-point communication. It is very compact, 29 24 6 mm. A module whose antenna gain was increased by attaching a dielectric lens to it was also fabricated, and the estimated EIRP of 18 dBm was obtained. This type of module is suitable for point-to-point communication and it too is compact, 29 24 17.5 mm. We achieved high-speed error-free data transmission of 1.25- and 2.5-Gbit/s phase-shift keyed (PSK) signal. The maximum distances of free-space propagation were estimated to be 18.2 and 8.9 m at bit rates of 1.25 and 2.5 Gbit/s, respectively.

A novel RF CMOS high Q-value active inductor is proposed in this work by using simple cascode RC feedback compensation technique. The performance of this active inductor has maximum Q-value about 1.2E6, inductance value from 3.5 nH to 4.5 nH and 3E-5Ω of minimum total equivalent loss, in the range of 1.2 GHz to 2 GHz.

Radio access networks (RANs) for new generation mobile communication systems are required to construct economical high capacity networks. An optical wireless link is expected as a solution to the linking method in the construction of these networks. The optical wireless link provides high bit-rate transmission and allows for easy installation. However, optical-waves are severely attenuated in free-space transmission due to weather conditions and cannot provide a high level of link availability in long-distance communications. This paper describes the applicability of an optical wireless link to the RAN based on obtained atmosphere propagation properties from experiments on an 800-nm band optical wireless link from the viewpoint of link availability. The experimental results show that the BER performance of the optical wireless link exhibits a sufficiently low power penalty of less than 1 dB compared to that of the optical fiber link. Moreover, the results confirm that atmosphere attenuation of an 800-nm band optical wave due to fog and rainfall can be estimated by using a simple estimation equation. The optical wireless link could be used for RAN approach links with the range of less than 350 m to achieve the link outage rate of 0.004% from the viewpoint of the link budget design.

Recent advances of Web information systems such as e-commerce and e-learning have created very large but hidden demands on conceptual multiresolution analysis for more generalized information analysis, cognition and modeling. To meet the demands in a general way, its modeling is formulated based on modern algebraic topology. To be specific, the modeling formulation is worked out in an incrementally modular abstraction hierarchy with emphasis on the two levels of the hierarchy appropriate for conceptual modeling: the adjunction space level and the cellular structured space level. Examples are shown to demonstrate the usefulness of the presented model as well as an implementation of a flower structure case.

Adapting to the structure of 2-D H-Transform, this paper proposes a novel wavelet domain half-pixel motion compensation algorithm HMRME (Half-pixel Multi-Resolution Motion Estimation). The primary objective of this study is the reduction of the aliasing effect caused by the down-sampling in the wavelet transform under the complexity constraints. The conventional multi-resolution motion estimation scheme can be combined with the half-pixel interpolation method to generate a new high-performance wavelet video codec. The preliminary results show that the performance of HMRME rises above its counterparts, the Multi-Resolution Motion Estimation (MRME) and the Adaptive Multi-Resolution Motion Estimation (AMRME).

An optical FM system using an optical FM LD (laser diode) and an optical frequency discriminator (OFD), in which a nonlinear compensation scheme based on the interaction between its nonlinearities can minimize intermodulation distortion. This paper theoretically investigates the minimization influence for 3rd plus 5th order intermodulation distortion power for an optical FM radio-on-fiber system. The carrier to noise-plus-distortion power ratio (CNDR) is theoretically analyzed in employing the OFD whose transmission characteristic is controlled by a phase shifter. The results show that the designed receiver can achieve higher CNDR in the application of multicarrier transmission.

We present low-cost millimeter-wave (MMW) photonic techniques for implementing gigabit/s wireless links. A passive mode-locked laser consisting of a Fabry-Perot laser and a single-mode fiber is used to generate 120-GHz optical MMW signals. We modulated these MMW signals by controlling the bias voltage of the photodiode. The MMW generation and modulation methods do not need expensive photonic components or high-power drivers. A link employing these low-cost photonic techniques achieved 1.25-Gbit/s wireless data transmission.

One of the most basic characteristics of the image is accompanied by its blur. It was 1962 that I had discovered for the first time in the world that the blur was a Gaussian type. In this paper the outline is described about historical details concerning this circumstances.

The use of concatenated codes in non-coherent synchronous optical fiber CDMA networks is proposed. The concatenated code sequences are generated using Walsh code sequences and balanced Walsh code sequences, which are selected from Walsh code sequences. The selection of balanced Walsh code sequences is presented and the design of fully programmable electro-optical transmitter and receiver is reported. In the proposed network, sequence-inversion keying of intensity modulated unipolar concatenated code sequences is employed at the transmitter and unipolar-bipolar correlation is implemented at the receiver. The analysis of the system BER performance is presented and it is proved that multiple-access interference is completely eliminated. It is also shown that the BER performance of the proposed system is better than that of non-coherent synchronous optical fiber CDMA system using optical orthogonal codes with double hard-limiters.

Evaluating the generalization performance of learning machines without using additional test samples is one of the most important issues in the machine learning community. The subspace information criterion (SIC) is one of the methods for this purpose, which is shown to be an unbiased estimator of the generalization error with finite samples. Although the mean of SIC agrees with the true generalization error even in small sample cases, the scatter of SIC can be large under some severe conditions. In this paper, we therefore investigate the causes of degrading the precision of SIC, and discuss how its precision could be improved.

The present paper introduces a new approach to the construction of a class of ternary sequences having a zero-correlation zone. The cross-correlation function of each pair of the proposed sequences is zero for phase shifts within the zero-correlation zone, and the auto-correlation function of each proposed sequence is zero for phase shifts within the zero-correlation zone, except for zero-shift. The proposed sequence set has a zero-correlation zone for periodic, aperiodic, and odd correlation functions. As such, the proposed sequence can be used as a finite-length sequence with a zero-correlation zone. A set of the proposed sequences can be constructed for any set of Hadamard sequences of length n. The constructed sequence set consists of 2n ternary sequences, and the length of each sequence is (n+1)2m+2 for a non-negative integer m. The periodic correlation function, the aperiodic correlation function, and the odd correlation function of the proposed sequences have a zero-correlation zone from -(2m+1-1) to (2m+1-1). The member size of the proposed sequence set is of the theoretical upper bound of the member size of a sequence having a zero-correlation zone. The ratio of the number of non-zero elements to the the sequence length of the proposed sequence is also .

In order to increase the capacity of a DS-CDMA system, several kinds of interference suppression techniques have been studied, such as multiple access interference (MAI) cancellers and adaptive array antennas. However, their performance tends to degrade in high traffic-load situations. To compensate for the degradation, a receiver cascading an adaptive array antenna and a multistage parallel interference canceller (PIC) is studied in this paper. This receiver first uses an adaptive array antenna to suppress interference signals spatially, and uses a multistage PIC to suppress in-beam interference effectively. The performance of the cascaded receiver is evaluated with two schemes for antenna weight generation by computer simulations assuming a Rayleigh-distributed L-path channel. When antenna weights are generated for each user by an LMS algorithm, the cascaded receiver has shown better performance at the cost of a large number of pilot symbols and symbol by symbol weight update. Its performance degradation is 2.8 dB at the BER of 10-4 even when the number of users increases from one to 24. On the other hand, when antenna weights are generated for each path by a DMI algorithm, its performance is degraded due to the inaccurate weight generation which occurs when the SINR of the desired signal is small. This degradation can be mitigated by using all signals of the desired user received by all antenna patterns of desired user for RAKE combining when the difference among arrival angles of the paths of the desired user is small.

A clustering scheme for ad hoc networks is aimed at managing a number of mobile devices by utilizing hierarchical structure of the networks. In order to construct and maintain an effective hierarchical structure in ad hoc networks where mobile devices may move at high mobility, the following requirements must be satisfied. (1) The role of each mobile device for the hierarchical structure is adaptive to dynamic change of the topology of the ad hoc networks. The role of each mobile device should thus change autonomously based on local information in each mobile device. (2) The overhead for management of the hierarchical structure is small. The number of mobile devices in each cluster should thus be almost equivalent. This paper proposes an adaptive multihop clustering scheme for highly mobile ad hoc networks. The results obtained by extensive simulation experiments show that the proposed scheme does not depend on mobility and node degree of mobile devices in the network, which satisfy the above requirements.

A new multilayer artificial neural network learning algorithm based on the pattern search method is proposed. The learning algorithm is designed to provide a very simple and effective means of searching the minima of an objective function directly without any knowledge of its derivatives. We test this algorithm on benchmark problems, such as exclusive-or (XOR), parity and alphabetic character learning problems. For all problems, the systems are shown to be trained efficiently by our algorithm. As a simple direct search algorithm, it can be applied to hardware implementations easily.

A "rooted" plane triangulation is a plane triangulation with one designated vertex r and one designated edge incident to r on the outer face. In this paper we give a simple algorithm to generate all connected rooted plane triangulations with at most m edges. The algorithm uses O(m) space and generates such triangulations in O(1) time per triangulation without duplications. The algorithm does not output entire triangulations but the difference from the previous triangulation. By modifying the algorithm we can generate all connected (non-rooted) plane triangulations with at most m edges in O(m3) time per triangulation.

Immune system protects living body from an extraordinarily large variety of bacteria, viruses, and other pathogenic organisms. Based on immunological principles, new computational techniques are being developed, aiming not only at a better understanding of the system, but also at solving engineering problems. Our overall goal for this paper is twofold: to understand the real immune system from the information processing perspective, and to use idea generated from the immune system to construct new engineering application. As one example of the latter, we propose an artificial immune system architecture inspired by the human immune system and apply it to pattern recognition. We test the proposed architecture by the simulations on arbitrary sequences of analog input pattern classification and binary input pattern recognition. The simulation results illustrate that the proposed architecture is effective at clustering arbitrary sequences of analog input patterns into stable categories and it can produce stronger noise immunity than the binary network .

In an attempt to enhance the impedance bandwidth and gain, a notched patch antenna is proposed that has a pair of L-strip feeders, and it has been experimentally studied. The enhanced features were confirmed and proved by comparing the proposed antenna with the antennae that have been reported in the relevant literatures. The experimental results showed that the impedance bandwidth (SWR2) of 35.74% and the peak gain of 8.69 dBi (at 2.17 GHz) were obtained by the frequency band under 2.5 GHz. Designed originally for PCS and IMT-2000 service band, the proposed antenna, with its simple structure, may easily be mass-produced and may have various commercial applications.