Changing vehicle structures and backgrounds makes it very difficult to correctly extract a license plate region from a vehicle image. In this paper, we propose a simple method to extract the license plate region using edge properties of wavelet subband. The High Frequency Subband (HFS) of an image has edge information for each direction. Edge information is concentrated in each direction of the Headlight-Radiator-Headlight (H-R-H) and the license plate region compared to other regions in the vehicle image. This paper shows a license plate region extraction method using these edge properties and our experimental results with various vehicle images.

This paper describes a new context clustering technique for average voice model, which is a set of speaker independent speech synthesis units. In the technique, we first train speaker dependent models using multi-speaker speech database, and then construct a decision tree common to these speaker dependent models for context clustering. When a node of the decision tree is split, only the context related questions which are applicable to all speaker dependent models are adopted. As a result, every node of the decision tree always has training data of all speakers. After construction of the decision tree, all speaker dependent models are clustered using the common decision tree and a speaker independent model, i.e., an average voice model is obtained by combining speaker dependent models. From the results of subjective tests, we show that the average voice models trained using the proposed technique can generate more natural sounding speech than the conventional average voice models.

As a typical planar antenna in Japan, a microstrip antenna and radial line slot antenna are chosen and some original technologies are introduced for them. About the microstrip antenna, the analyzing method is described first and the method based on the theory of microstrip planar circuit born in Japan is introduced. According to the formulas derived by this method, the design procedure considering the bandwidth is established. In addition, it is shown clearly that a microstrip antenna can produce the circular polarizations at two kinds of frequencies with a single feed. Furthermore, two kinds of broadband techniques born in Japan are picked up. About other unique microstrip antennas, they may be introduced in a suitable section each time. As for the RLSA, the history on invention is briefly presented. The radiation mechanisms depending on the slot-set arrangement and the excitation mode are discussed. The slot-coupling analysis to simulate the excitation of a two-dimensional uniformly-excited slot array is explained. The simple design based on the operation with traveling-wave propagation is also described. The technical progress to keep high efficiency in a wide gain range for satellite-TV reception is reviewed. Extensions of the RLSAs to millimeter-wave bands and plasma etching systems are finally summarized.

A new analysis method for random dopant induced threshold voltage fluctuations by using Monte Carlo ion implantation were presented. The method was applied to investigate Vt fluctuations due to statistical variation of pocket dopant profile in 0.1µm MOSFET's by 3D process-device simulation system. This method is very useful to analyze a statistical fluctuation in sub-100 nm MOSFET's efficiently.

The density gradient (DG) model is tested for its ability to describe tunneling currents through thin insulating barriers. Simulations of single barriers (MOS diodes, MOSFETs) and double barriers (RTDs) show the limitations of the DG model. For comparison, direct tunneling currents are calculated with the Schrodinger-Bardeen method and used as benchmark. The negative differential resistance (NDR) observed in simulating tunneling currents with the DG model turns out to be an artifact related to large density differences in the semiconductor regions. Such spurious NDR occurs both for single and double barriers and vanishes, if all semiconductor regions are equally doped.

This paper reviews antenna technologies for cellular phone terminal in Japan. In regard to the technologies two technical subjects are addressed: a diversity system and miniaturization of terminal size. These subjects provide motivation for studies on design methods for diversity antennas, development of built-in antennas, and control methods for surface current on terminal cavity. These studies are progressing.

Appropriate test signals defined by formula or generated by algorithm are used for measuring objective QoS (Quality of Services) for voice operated telecommunication devices such as telephone and speech codec (coder-decoder). However, that for measuring residual echo characteristics in hands-free telecommunications equipped with acoustic echo canceller is under study in ITU-T Recommendation G.167. This paper describes comparative assessment of test signals for measurement of residual echo characteristics. In hands-free telecommunications, acoustical echo canceller has been developed to remove a room echo signal through the loudspeaker to the microphone in the receiving end. Performance of the echo canceller system is evaluated by residual echo characteristics expressed in echo return loss enhancement (ERLE). The ERLE can be conventionally measured by putting white noise into the echo canceller system. However, white noise is not adequate as the test signal for measuring the performance of the echo canceller, since the performance may depend on the characteristics of input test signal, and the characteristics of the white noise differ from those of real voice. Therefore, this paper discusses appropriate characteristics of real voice required for objective quality evaluation of echo canceller system. The test signals used for this verification tests were real voice (RV), white noise (WN), frequency weighted noise (FWN), artificial voice (AV), and composite source signal (CSS) depending on the approximation of real voice characteristics. As the comparative assessment results, the ERLE characteristics measured by artificial voice conforming to ITU-T Recommendation P.50 having average characteristics of real voices in time and frequency domains are almost equivalent to those of real voice and best among those test signals. It is concluded that artificial voice P.50 is satisfied with measurement of residual echo characteristics.

In this letter, we study the performance of the iterative receiver as applied to the space division multiplexing/orthogonal frequency division multiplexing (SDM/OFDM) systems. The iterative receiver under consideration employs the soft in/soft out (SISO) decoding process, which operates iteratively in conjunction with channel estimation for performing data detection and channel estimation at the same time. As opposed to the previous studies in which the perfect channel state information is assumed, the effects of channel estimation are taken into account for evaluating the performance of the iterative receiver and it is shown that the channel estimation applied in every iteration step of the iterative receiver plays a crucial role to warrant the performance, especially at a low signal-to-noise power ratio (SNR).

In the Internet, the routing system consists of the Interior-domain and the Inter-domain. Within the Inter-domain routing, Autonomous System (AS) represents the administrative network domain, which is managed by a single institution with its operational policy. ASs exchange the ASs' reachability information to each other. Without the Inter-domain routing scheme, the nodes in the Internet can't communicate across the multiple ASs. The Inter-domain routing is an essential functional element in the global Internet operation. However, due to several reasons such as miss-configuration at the routers, the Inter-domain routing becomes unstable. This occurs that one AS (say AS1) propagates the prefix that has been already assigned to another AS (say AS2) and other peers receive its routing update and inject the misconfigured AS information to their peering routers. Since the routing information associated with AS1 is over written by AS2, AS1 loses the network connectivity. This problem is known as the Conflict Origin AS prefix or the Multiple Origin AS. We recognize that this is a serious problem which degrades the quality of Internet backbone infrastructure. We focus on this problem and propose the mechanism that can detect the Conflict Origin AS prefix automatically using the policy database. Based on the evaluation using the prototype system, we demonstrate that the proposed mechanism can work well with the existing Internet's Inter-domain routing system.

The ATM-ABR service category provides minimum cell rate (MCR) guarantees and robust connections even with insufficient network resources. Recently proposed rate-management algorithms for supporting multimedia applications over ABR mainly aim at minimizing the cell loss and delay. However, jitter is also an important element of QoS for multimedia applications. In this paper, we focus our attention on the arrival point of the critical cell corresponding to the end of data packet and propose a simple cell scheduling scheme for source node to reduce the jitter on application level over the ATM-ABR service class. In our proposed method, critical cells are delayed intentionally and the packet stream at application level becomes smooth. We verify the effectiveness of our proposed algorithm by an analytical model and simulation. From those results, we find that our proposed scheduling algorithm is effective in reducing the application level jitter even when the tagged cell stream is transmitted along the path with multiple nodes.

For an uncertain discrete event system (DES) modeled as a set of some possible nondeterministic automata, we address robust supervisory control problems. Based on language models, this paper presents the existence conditions of a robust nonblocking (RN) supervisor that guarantees the absence of blocked states in a closed-loop system. We show that an RN supervisor achieves both a given language specification and the nonblocking characteristics of any nondeterministic automata of the set.

As multimedia and high-speed traffic become more popular on the Internet, the various traffic requiring different qualities of service (QoS) must co-exist. In addition, classified services based on Diff-Serv (Differentiated Service), MPLS (Multi-Protocol Label Switching), etc., have come into wide use. Today's Internet environment requires routers to perform control mechanisms in order to guarantee various QoSs. In this paper, we propose a smart buffer management scheme for the Internet router that uses hierarchical priority control with port class and flow level. Furthermore, since the proposed scheme must operate at very high speed, we first propose several design policy for high speed operation and the hardware implementation is performed in VHDL code. Implementation results show that the proposed scheme can scale with high-speed link, achieving the maximum rate of 4.0 Gbps by using the 3.5 µm CMOS technology.

Adaptive antenna is a promising to increase the spectral efficiency of mobile radio systems. We developed a compact, cost effective planar Butler Matrix as a beam forming network of a multi beam antenna. This circuit consists of a thin substrate that the conductor attaches to both sides, and two thick substrates that the ground conductor attaches to one side. In this circuit, coupling by crossover causes amplitude and phase error of the Butler Matrix. By narrowing the strip width of the crossover, crossover coupling can be suppressed 10 dB. The measurement results of the experimental 88 Butler Matrix were 0.75 dB amplitude deviation, 9.5 degree phase deviation and VSWR of less than 1.15 within the relative bandwidth of 10% at 900 MHz band.

Based on a modified step-by-step decoding procedure, a high-speed pipelined Reed-Solomon decoder is presented. The decoder requires only the delay time of three 2-input XOR gates for decoding each coded symbol. The decoder can be operated in a bit rate of Gbits/sec order and thus suitable for the very high speed data transmission systems.

The square-law characteristics of MOSFET in the saturation region have a parameter of threshold voltage VT. However, it introduces some complexities to the circuit design since it depends on kinds of MOS technology and cannot be controlled easily. In this paper, we show an equivalent MOSFET cell which has VT-programming capability and some application instances based on it. The simulation is carried out using CMOS 0.8 µm n-well technology and the results have shown the feasibility of the proposed structure.

In wireless communications, a smart antenna system utilizes an antenna array to acquire the spatial signatures of transmitted signals. This system uses the difference in the spatial signatures or the direction of arrival (DOA) of signals to correctly obtain the desired signal. This can reduce co-channel interference, mitigate the fading phenomenon caused by multipath transmissions, improve the communication quality and increase the system capacity. The purpose of this paper is to evaluate the performance of smart antennas using four beamforming algorithms applied to a wideband code division multiple access (W-CDMA) system. The simulation results show that, based on the same power consumption at the transceiver and using a Rake receiver, a W-CDMA system with a smart antenna can operate at a lower bit error rate at the specific signal to noise ratio (SNR). Moreover, the smart antenna system accommodates more users at the specific signal to interference ratio (SIR), even though a certain angle difference exists between the actual DOAs and the estimated DOAs.

A simple phase detector reducing the pattern dependent jitter in clock recovery circuit is developed in this paper. The developed phase detector automatically aligns the recovered to clock in the center of the data eye, while producing no ripple to the control voltage in locked condition of the PLL based clock recovery circuit. The UP and DOWN signals are separately generated to align them in locked condition. Thus, no explicit transient waveforms do not exist at the output of the phase detector. The elimination of high frequency ripple improves the jitter characteristics of the clock recovery circuit. The delay unit used in our phase detector requires no accurate control of the delay time. This feature eliminates the use of DLL to generate the precise delay time, which reduce the power consumption and area of the phase detector. The simulation shows that the RMS timing jitter is reduced by more than four times when compared with the conventional scheme. The rms jitter is 32 ps for the proposed phase detector and 133 ps for the phase detector in conventional scheme. In conventional scheme, even when the lock is achieved, the phase detector produces a triwave transient on the control voltage of the VCO, which depends on the data pattern. In the proposed phase detector, no such transient waveforms do not exist. The proposed phase detector can be incorporated in high performance clock recovery circuit for data communication systems.

A CMOS current-mode continuous-time band-pass filter using the positive feedback Q (quality factor) - enhancement technique is presented in this paper. Q of the proposed filter can be mainly determined by the ratio of the two MOSFETs' transconductances in a Q-setting part, not by the ratio of two capacitance values similar to most of conventional band-pass filters. This filter can realize high Q value in spite of small chip area. Therefore, when higher value of Q is needed, the proposed filter does not need large capacitor which occupies large area on an IC chip. The proposed filter spends smaller chip area than the conventional one under the condition of Q>2. The proposed circuit is simulated by Spectre to confirm its characteristics.

A new analog equalizer supporting 10Base-T central office and remote terminal (Category-3) LAN applications is developed. It provides robust 10 Mbps data transmission (10Base-T) at loop length up to 400 meters. The equalizer with high frequency gain boost capability is controlled automatically by the proposed AZC (Adaptive Zero Control) loop according to cable length. It is implemented using AMS 0.8 µm CMOS technology.

In fractal image coding, for each range block, the best matching domain block is identified, and information from the best matching domains and range blocks are transmitted to the decoder for image reconstruction. In this paper, the similarity between range blocks and domain blocks is evaluated according to their centers of gravity. The number of searched domain blocks are reduced by limiting the candidates for the best matching domain blocks to those domain blocks whose similarity to the range block are high. Using simulation experiments, the number of candidates for the best matching domain blocks were reduced to about 10-23% of the current method. Thus, our proposed method had significantly reduced the number of searched domain blocks below the current method and at the same time it turns out that degradation of the reconstructed image was seldom observed.