Ising machines have attracted attention, which is expected to obtain better solutions of various combinatorial optimization problems at high speed by mapping the problems to natural phenomena. A slot-placement problem is one of the combinatorial optimization problems, regarded as a quadratic assignment problem, which relates to the optimal logic-block placement in a digital circuit as well as optimal delivery planning. Here, we propose a mapping to the Ising model for solving a slot-placement problem with additional constraints, called a constrained slot-placement problem, where several item pairs must be placed within a given distance. Since the behavior of Ising machines is stochastic and we map the problem to the Ising model which uses the penalty method, the obtained solution does not always satisfy the slot-placement constraint, which is different from the conventional methods such as the conventional simulated annealing. To resolve the problem, we propose an interpretation method in which a feasible solution is generated by post-processing procedures. We measured the execution time of an Ising machine and compared the execution time of the simulated annealing in which solutions with almost the same accuracy are obtained. As a result, we found that the Ising machine is faster than the simulated annealing that we implemented.

Software copyright claims an exclusive right for the software copyright owner to determine whether and under what conditions others can modify, reuse, or redistribute this software. For Free and Open Source Software (FOSS), it is very important to identify the copyright owner who can control those activities with license compliance. Copyright notice is a few sentences mostly placed in the header part of a source file as a comment or in a license document in a FOSS project, and it is an important clue to establish the ownership of a FOSS project. Repositories of FOSS projects contain rich and varied information on the development including the source code contributors who are also an important clue to establish the ownership. In this paper, as a first step of understanding copyright owner, we will explore the situation of the software copyright in the Linux kernel, a typical example of FOSS, by analyzing and comparing two kinds of datasets, copyright notices in source files and source code contributors in the software repositories. The discrepancy between two kinds of analysis results is defined as copyright inconsistency. The analysis result has indicated that copyright inconsistencies are prevalent in the Linux kernel. We have also found that code reuse, affiliation change, refactoring, support function, and others' contributions potentially have impacts on the occurrence of the copyright inconsistencies in the Linux kernel. This study exposes the difficulty in managing software copyright in FOSS, highlighting the usefulness of future work to address software copyright problems.

We propose a system time synchronization method between ARM-based embedded Linux systems. The master Linux with reference clock sends its own system time to the slave Linux via Transmission Control Protocol communication along with a general-purpose input/output (GPIO) signal, and then the slave Linux corrects its own system time by the difference between its own system time at receiving the GPIO signal and the received reference time. The synchronization performance is significantly improved by compensating for the GPIO signal detection latency and the system time acquisition and setting latencies in Linux. These latencies are precisely measured by exploiting the function of Cycle Counter register in ARM coprocessor. Extensive experiments are performed with two ARM-based embedded Linux systems, and the results demonstrate the validity and performance of the proposed synchronization method.

Various software fault prediction models have been proposed in the past twenty years. Many studies have compared and evaluated existing prediction approaches in order to identify the most effective ones. However, in most cases, such models and techniques provide varying results, and their outcomes do not result in best possible performance across different datasets. This is mainly due to the diverse nature of software development projects, and therefore, there is a risk that the selected models lead to inconsistent results across multiple datasets. In this work, we propose the use of bandit algorithms in cases where the accuracy of the models are inconsistent across multiple datasets. In the experiment discussed in this work, we used four conventional prediction models, tested on three different dataset, and then selected the best possible model dynamically by applying bandit algorithms. We then compared our results with those obtained using majority voting. As a result, Epsilon-greedy with ϵ=0.3 showed the best or second-best prediction performance compared with using only one prediction model and majority voting. Our results showed that bandit algorithms can provide promising outcomes when used in fault prediction.

This paper is focused on constructing even-length binary Z-complementary pairs (EB-ZCPs) with new length. Inspired by a recent work of Adhikary et al., we give a construction of EB-ZCPs with length 8N+4 (where N=2α 10β 26γ and α, β, γ are nonnegative integers) and zero correlation zone (ZCZ) width 5N+2. The maximum aperiodic autocorrelation sums (AACS) magnitude of the proposed sequences outside the ZCZ region is 8. It turns out that the generated sequences have low PAPR.

Event-triggered control is a method that the control input is updated only when a certain condition is satisfied (i.e., an event occurs). In this paper, event-triggered control over a sensor network is studied based on the notion of uniformly ultimate boundedness. Since sensors are located in a distributed way, we consider multiple event-triggering conditions. In uniformly ultimate boundedness, it is guaranteed that if the state reaches a certain set containing the origin, the state stays within this set. Using this notion, the occurrence of events in the neighborhood of the origin is inhibited. First, the simultaneous design problem of a controller and event-triggering conditions is formulated. Next, this problem is reduced to an LMI (linear matrix inequality) optimization problem. Finally, the proposed method is demonstrated by a numerical example.

The relationships between producers and consumers have changed radically by the recent growth of sharing economy. Promoting resource sharing can contribute to finding a solution to environmental issues (e.g. reducing food waste, consuming surplus electricity, and so on). Although prosumers have both roles as consumers and suppliers, matching between suppliers and consumers should be determined when the prosumers share resources. Especially, it is important to achieve envy-freeness that is a metric indicating how the number of prosumers feeling unfairness is kept small since the capacity of prosumers to supply resources is limited. Changing resource capacity and demand will make the situation more complex. This paper proposes a resource sharing model based on a temporal network and flows to realize envy-free resource sharing among prosumers. Experimental results demonstrate the deviation of envy among prosumers can be reduced by setting appropriate weights in a flow network.

This paper presents a 26-GHz-band high back-off efficiency power amplifier (PA) IC with adaptively controlled bias and load circuits in 45-nm CMOS SOI. A 4-stacked-FET is employed to increase the output power and to conquer the low breakdown voltage issue of scaled MOSFET. The adaptive bias circuit is reviewed and the adaptive load circuit which consists of an inverter circuit and transformer-based inductors is described in detail. The measured performance of the PA IC is fully shown in this paper. The PA IC exhibits a saturated output power of 20.5dBm and a peak power-added-efficiency (PAE) as high as 39.4% at a supply voltage of 4.0V. Moreover, the PA IC has exhibited an excellent ITRS FoM of 82.0dB.

This paper studies a novel approach to analysis of switched dynamical systems in perspective of bifurcation and multiobjective optimization. As a first step, we analyze a simple switched dynamical system based on a boost converter with photovoltaic input. First, in a bifurcation phenomenon perspective, we consider period doubling bifurcation sets in the parameter space. Second, in a multiobjective optimization perspective, we consider a trade-off between maximum input power and stability. The trade-off is represented by a Pareto front in the objective space. Performing numerical experiments, relationship between the bifurcation sets and the Pareto front is investigated.

This paper proposes a novel weight derivation method to improve adaptive array interference suppression performance based on our previously conceived sample matrix inversion algorithm using common correlation matrix (CCM-SMI), by data-aided approach. In recent broadband wireless communication system such as orthogonal frequency division multiplexing (OFDM) which possesses lots of subcarriers, the computation complexity is serious problem when using SMI algorithm to suppress unknown interference. To resolve this problem, CCM based SMI algorithm was previously proposed. It computes the correlation matrix by the received time domain signals before fast Fourier transform (FFT). However, due to the limited number of pilot symbols, the estimated channel state information (CSI) is often incorrect. It leads limited interference suppression performance. In this paper, we newly employ a data-aided channel state estimation. Decision results of received symbols are obtained by CCM-SMI and then fed-back to the channel estimator. It assists improving CSI estimation accuracy. Computer simulation result reveals that our proposal accomplishes better bit error rate (BER) performance in spite of the minimum pilot symbols with a slight additional computation complexity.

Side-channel (SC) leakage from a cryptographic device chip is simulated as the dynamic current flowing out of the chip. When evaluating the simulated current, an evaluation by comparison with an actual measurement is essential; however, it is difficult to compare them directly. This is because a measured waveform is typically the output voltage of probe placed at the observation position outside the chip, and the actual dynamic current is modified by several transfer impedances. Therefore, in this paper, the probe voltage is converted into the dynamic current by using an EMC macro-model of a cryptographic device being evaluated. This paper shows that both the amplitude and the SC analysis (correlation power analysis and measurements to disclosure) results of the simulated dynamic current were evaluated appropriately by using the EMC macro-model. An evaluation confirms that the shape of the simulated current matches the measured one; moreover, the SC analysis results agreed with the measured ones well. On the basis of the results, it is confirmed that a register-transfer level (RTL) simulation of the dynamic current gives a reasonable estimation of SC traces.

In this paper, we investigate a model-free design of decentralized event-triggered mechanism for networked control systems (NCSs). The approach aims at simultaneously tuning the optimal parameters for the controller and the event-triggered condition, such that a prescribed cost function can be minimized. To achieve this goal, we employ the Bayesian optimization (BO), which is known to be an automatic tuning framework for finding the optimal solution to the black-box optimization problem. Thanks to its efficient search strategy for the global optimum, the BO allows us to design the event-triggered mechanism with relatively a small number of experimental evaluations. This is particularly suited for NCSs where network resources such as the limited life-time of battery powered devices are limited. Some simulation examples illustrate the effectiveness of the approach.

This paper proposes a route calculation method for a bicycle navigation system that complies with traffic regulations. The extension of the node map and three kinds of route calculation methods are constructed and evaluated on the basis of travel times and system acceptability survey results. Our findings reveal the effectiveness of the proposed route calculation method and the acceptability of the bicycle navigation system that included the method.

Input devices based on direct touch have replaced traditional ones and become the mainstream interactive technology for handheld devices. Although direct touch interaction proves to be easy to use, its problems, e.g. the occlusion problem and the fat finger problem, lower user experience. Camera-based mobile interaction is one of the solutions to overcome the problems. There are two typical interaction styles to generate camera-based pointing interaction for handheld devices: move the device or move an object before the camera. In the first interaction style, there are two approaches to move a cursor's position across the handheld display: move it towards the same direction or the opposite direction which the device moves to. In this paper, the results of a comparison research, which compared the pointing performances of three camera-based pointing techniques, are presented. All pointing techniques utilized input from the rear-facing camera. The results indicate that the interaction style of moving a finger before the camera outperforms the other one in efficiency, accuracy, and throughput. The results also indicate that within the interaction style of moving the device, the cursor positioning style of moving the cursor to the opposite direction is slightly better than the other one in efficiency and throughput. Based on the findings, we suggest giving priority to the interaction style of moving a finger when deploying camera-based pointing techniques on handheld devices. Given that the interaction style of moving the device supports one-handed manipulation, it also worth deploying when one-handed interaction is needed. According to the results, the cursor positioning style of moving the cursor towards the opposite direction which the device moves to may be a better choice.

For exploration of the functional use of dielectric anisotropy of liquid crystals (LCs), we investigated the dynamic response of molecular alignment in a nematic-phase LC cell with compressive force-induced flow behavior. The results showed that the initial alignment and thickness of the LC layer affect the capacitance of the cell when mechanical pressure is applied.

This letter presents an image quality assessment (IQA) metric for scanning electron microscopy (SEM) images based on texture inpainting. Inspired by the observation that the texture information of SEM images is quite sensitive to distortions, a texture inpainting network is first trained to extract texture features. Then the weights of the trained texture inpainting network are transferred to the IQA network to help it learn an effective texture representation of the distorted image. Finally, supervised fine-tuning is conducted on the IQA network to predict the image quality score. Experimental results on the SEM image quality dataset demonstrate the advantages of the presented method.

Universal filtered multicarrier (UFMC) systems offer a flexibility of filtering sub-bands with arbitrary bandwidth to suppress out-of-band (OoB) emission, while keeping the orthogonality between subcarriers in one sub-band. Oscillator discrepancies between the transmitter and receiver induce carrier frequency offset (CFO) in practical systems. In this paper, we propose a novel CFO estimation method for UFMC systems that has very low computational complexity and can then be used in practical systems. In order to fully exploit the coherence bandwidth of the channel, the training symbols are designed to have several identical segments in the frequency domain. As a result, the integral part of CFO can be estimated by simply determining the correlation between received signal and the training symbol. Simulation results show that the proposed method can achieve almost the same performance as an existing method and even a better performance in channels that have small decay parameter values. The proposed method can also be used in other multicarrier systems, such as orthogonal frequency division multiplexing (OFDM).

Image deformations caused by different steganographic methods are typically extremely small and highly similar, which makes their detection and identification to be a difficult task. Although recent steganalytic methods using deep learning have achieved high accuracy, they have been made to detect stego images to which specific steganographic methods have been applied. In this letter, a staganalytic method is proposed that uses hierarchical residual neural networks (ResNet), allowing detection (i.e. classification between stego and cover images) and identification of four spatial steganographic methods (i.e. LSB, PVD, WOW and S-UNIWARD). Experimental results show that using hierarchical ResNets achieves a classification rate of 79.71% in quinary classification, which is approximately 23% higher compared to using a plain convolutional neural network (CNN).

This letter proposes the use of a novel time-modulated array structure to estimate the direction of arrival (DOA). Such a time-modulated coprime array (TMCA) is obtained by exchanging a coprime array's phase shifter for a radio frequency (RF) switch. Compared with a traditional coprime array, the TMCA's structure is much simpler, and it has a higher degree of freedom and resolution compared with a time-modulated uniform linear array (TMULA) due to its exploitation of the virtual array's equivalent signals. Theoretical analysis and experimental results have validated the effectiveness of the proposed structure and method and have confirmed that a TMCA's DOA performance is better than that of a TMULA using the same number of antennas.

A differential on chip oscillator (OCO) is proposed in this paper for low supply voltage, high frequency accuracy and fast startup. The differential architecture helps the OCO achieve a good power supply rejection ratio (PSRR) without using a regulator so as to make the OCO suitable for a low power supply voltage of 1.38V. A reference voltage generator is also developed to generate two output voltages lower than Vbe for low supply voltage operation. The output frequency is locked to 48MHz by a frequency-locked loop (FLL) and a 3.3-ppm/°C temperature coefficient of frequency is realized by the differential voltage ratio adjusting (differential VRA) technique. The startup time is only 1.47μs because the differential OCO is not necessary to charge a big capacitor for ripple reduction.