We consider a system of coupled two oscillators with external force. At first we introduce the symmetrical property of the system. When the external force is not applied, the two oscillators are synchronized at the opposite phase. We obtain a bifurcation diagram of periodic solutions in the coupled system when the single oscillator has a stable anti-phase solution. We find that the synchronized oscillations eventually become in-phase when the amplitude of the external force is increased.

This paper proposes a new robust adaptive beamformer applicable to microphone arrays. The proposed beamformer is a generalized sidelobe canceller (GSC) with a variable blocking matrix using coefficient-constrained adaptive filters (CCAFs). The CCAFs, whose common input signal is the output of a fixed beamformer, minimize leakage of the target signal into the interference path of the GSC. Each coefficient of the CCAFs is constrained to avoid mistracking. In the multiple-input canceller, leaky adaptive filters are used to decrease undesirable target-signal cancellation. The proposed beamformer can allow large look-direction error with almost no degradation in interference-reduction performance and can be implemented with a small number of microphones. The maximum allowable look-direction error can be specified by the user. Simulation results show that the proposed beamformer, when designed to allow about 20of look-direction error, can suppress interference by more than 17 dB.

Enhancement of resonance is shown by coupling and summing in sinusoidally driven chaotic neural networks. This resonance phenomenon has a peak at a drive frequency similar to noise-induced stochastic resonance (SR), however, the mechanism is different from noise-induced SR. We numerically study the properties of resonance in chaotic neural networks in the turbulent phase with summing and homogeneous coupling, with particular consideration of enhancement of the signal-to-noise ratio (SNR) by coupling and summing. Summing networks can enhance the SNR of a mean field based on the law of large numbers. Global coupling can enhance the SNR of a mean field and a neuron in the network. However, enhancement is not guaranteed and depends on the parameters. A combination of coupling and summing enhances the SNR, but summing to provide a mean field is more effective than coupling on a neuron level to promote the SNR. The global coupling network has a negative correlation between the SNR of the mean field and the Kolmogorov-Sinai (KS) entropy, and between the SNR of a neuron in the network and the KS entropy. This negative correlation is similar to the results of the driven single neuron model. The SNR is saturated as an increase in the drive amplitude, and further increases change the state into a nonchaotic one. The SNR is enhanced around a few frequencies and the dependence on frequency is clearer and smoother than the results of the driven single neuron model. Such dependence on the drive amplitude and frequency exhibits similarities to the results of the driven single neuron model. The nearest neighbor coupling network with a periodic or free boundary can also enhance the SNR of a neuron depending on the parameters. The network also has a negative correlation between the SNR of a neuron and the KS entropy whenever the boundary is periodic or free. The network with a free boundary does not have a significant effect on the SNR from both edges of the free boundaries.

This paper proposes a newly developed dual-frequency antenna for 800 MHz and 1500 MHz band use. A uniformly spaced array configuration, originally designed for a 800 MHz analog system, is extended to yield dual frequencies operations. An important characteristic of a base station antenna is low sidelobe level in order to suppress inter-cell interference. In the case of a uniformly spaced array configuration, sidelobe levels are increased by the emergence of grating lobes at higher frequencies. Electrical beam tilt also degrades the sidelobe level. As does the change in the excitation coefficients of the array elements at higher frequencies. These three factors are studied theoretically to yield practical sidelobe levels. One more important beam characteristic is the sector beam in the horizontal plane. The same beam width in two frequency bands is achieved by designing the novel reflector shape and determining the proper array element positions in front of the reflector. Practical antenna characteristics are confirmed by designing, manufacturing, and testing a base station antenna.

In this paper, we consider the working VP and backup VP routing problems jointly and employ the integer programming based approach to maximize the system resource utilization and the network survivability. The VP planning problem is formulated as a nonlinear combinatorial optimization problem. The objective function minimizes the resource usage while maximizing the network survivability. By proper transformation of the objective function and applying cutting plane method, the original formulation is transformed into an integer linear programing formulation which is suitable for applying Lagrangian relaxation techniques. After Lagrangian relaxation, the problem is further decomposed into several tractable subproblems. Unlike others' work, the candidate path set does not need to be prepared in advance and the best paths are generated while solving subproblems in our approach. Heuristic algorithms based on the solving procedure of the Lagrangian relaxation are developed. Closely examining the gap between the heuristic upper bounds and the Lagrangian lower bounds reveals that the proposed algorithm can efficiently provide a nearly optimal solution for the survivable VP layout design in ATM networks.

Although there are many multimedia presentation systems on the market, they have some shortcomings and most of them only can work on one single computer, and few of them can work on Web. Thus, in the thesis we develop a network multimedia presentation system to let users easily design the multimedia presentation without restriction on technology or presentation time and place. Our system includes 3 main components: User Interface that includes temporal specification editor, spatial specification editor and multimedia object interface, Presentation Interface and Knowledge Base. There is a dynamic homepage generator in our system and we propose a displaying algorithm based on the Allen's theory, that there exist 13 temporal relationships between two intervals, for synchronizing the media objects.

We have investigated the operation of a reflection type magnetostatic wave signal-to-noise enhancer in detail. It has good enhancement characteristics, low insertion loss, and low operating power. It is also composed of a transducer using a ceramic substrate having a high dielectric constant and an LaGa-YIG film with low saturation magnetization to enable direct operation in the 400-MHz band (the IF band of current DBS receivers). Enhancement of 8 dB was achieved over a 40-MHz bandwidth. Although its operating frequency range depends critically on device temperature, we can compensate for the temperature dependence by adjusting the bias magnetic field. Experiments showed that the enhancer improved the received carrier-to-noise ratio by 2 to 3 dB, providing good noise reduction in DBS reception.

A new method of designing a microphone array with two outputs preserving binaural information is proposed in this paper. This system employs adaptive beamforming using multiple constraints. The binaural cues may be preserved in the two outputs by use of these multiple constraints with simultaneous beamforming to enhance target signals is also available. A computer simulation was conducted to examine the performance of the beamforming. The results showed that the proposed array can perform both the generation of the binaural cues and the beamforming as intended. In particular, beamforming with double-constraints exhibits the best performance; DI is around 7 dB and good interchannel (interaural) time/phase and level differences are generated within a target region in front. With triple-constraints, however, the performance of the beamforming becomes poorer while the binaural information is better realized. Setting of the desired responses to give proper binaural information seems to become critical as the number of the constraints increases.

We show by numerical calculations that a chaotic neuron model driven by a weak sinusoid has resonance. This resonance phenomenon has a peak at a drive frequency similar to that of noise-induced stochastic resonance (SR). This neuron model was proposed from biological studies and shows a chaotic response when a parameter is varied. SR is a noise induced effect in driven nonlinear dynamical systems. The basic SR mechanism can be understood through synchronization and resonance in a bistable system driven by a subthreshold sinusoid plus noise. Therefore, background noise can boost a weak signal using SR. This effect is found in biological sensory neurons and obviously has some useful sensory function. The signal-to-noise ratio (SNR) of the driven chaotic neuron model is improved depending on the drive frequency; especially at low frequencies, the SNR is remarkably promoted. The resonance mechanism in the model is different from the noise-induced SR mechanism. This paper considers the mechanism and proposes possible explanations. Also, the meaning of chaos in biological systems based on the resonance phenomenon is considered.

This paper reports on the use of microelectronic test structures to characterise a novel fabrication technique for thin-film electronic circuit boards. In this technology circuit tracks are formed on paper-like substrates by depositing films of a metal-loaded ink via a standard lithographic printing process. Sheet resistance and linewidth for both horizontal and vertical lines are electrically evaluated and these compared with optical and surface profiling measurements.

The frequency offset estimation is used to correct any frequency error of the local reference oscillator. In this letter, a frequency offset estimation algorithm utilizing the peak phase error detection and frequency offset smoother is proposed for burst data transmission. The basic idea of frequency offset estimator is to use a curve fitting method. The proposed peak phase error detection avoids a large phase error which yields a bad value for FOE. In order to control the AFC, frequency offset smoother by a simple filter is used. Simulation results show that the proposed algorithm is adequate for frequency offset estimation of burst data transmission.

Packet contention is one of the fundamental problems that must be overcome in designing packet switches. In banyan network, which has multistage interconnection structure of many small switch elements, we must be concerned with output port conflicts and internal collisions. Dilated banyan network which provides multiple path for internal link can reduce packet loss due to internal collisions in loss system. However, under hot-spot traffic higher packet loss probability is measured at the hot-spot port and the ports close to the hot-spot as coefficient h increases due to the heavy traffic to hot-spot port. In order to moderate the packet loss probability at the hot-spot port we propose the method to disperse the packets which concentrate on the hot-spot route by altering address field of a half of incoming packets. These packets are switched along detour routes. Thus, the traffic concentration toward hot-spot is mitigated and the packet loss probability at the hot-spot port is moderated.

The self-healing capability against network failure is one of indispensable features for the B-ISDN infrastructure. One problem in realizing such self-healing backbone network is the inefficient utilization of the large spare capacity designed for the failure-restoration purpose since it will be used only in the failure time that does not occur frequently. "Pool-capacity" is the concept that allows some VPs (virtual paths) to efficiently utilize this spare capacity part. Although the total capacity can be saved by using the "Pool Capacity," it is paid by less reliability of VPs caused by the emerging influence of indirect-failure. Thus, this influence of indirect-failure has to be considered in the capacity designing process so that network-designers can trade off the saving of capacity with the reliability level of VPs in their self-healing networks. In this paper, Damage Rate:DR which is the index to indicate the level of the influence caused by indirect-failure is defined and the pool-capacity design scheme with DR consideration is proposed. By the proposed scheme, the self-healing network with different cost (pool-capacity) can be designed according to the reliability level of VPs.

This paper proposes a traffic-adaptive dynamic routing method, which we have named RAG, for connectionless packet networks. Conventional traffic control methods discard the packets which cause congestion. Furthermore, conventional routing methods propagate control messages all over the network for gathering global topology information, and this causes more congestion. In contrast, RAG estimates traffic conditions all over a network without any communication between nodes and makes the best use of free links so that packets make detours to avoid congestive sites. RAG adopts distributed control based on game theory (non-communication, non-zero-sum, two-person). With RAG, nodes play a packet-forwarding game without any communication with each other, and each node controls ordering and routing of the forwarding packets based on the node's individual payoff table which is dynamically reconstructed by observation of surrounding nodes. Nodes cooperate with each other, except for punishment for disloyalty. Repetition of these local operations in nodes aims at the emergence of the gradual network-global traffic balancing. The results of experiments in comparison with the conventional shortest path first (SPF) routing method show that the throughput is about 1.58 times higher with the new method.

A new method using new test structure, which is connected 15.4 million MOS transistor, for evaluating extrinsic oxide breakdown is proposed. The active gate area which is needed to predict reliability will be shown. And by using this new method, activation energy not only for the intrinsic breakdown but also for the extrinsic breakdown are obtained.

We proposed Reversible Energy Recovery Logic (RERL) using an 8-phase clocking scheme, which is a dual-rail reversible adiabatic logic for ultra-low-energy applications. Because we eliminated non-adiabatic energy loss in RERL by using the concept of reversible logic, RERL has only adiabatic and leakage losses. In this paper we explain its operation and logic design and present its simulation and experimental results. We also present an energy-efficient 8-phase, clocked power generator that uses an off-chip inductor. With simulation results for the full adder, we confirmed that the RERL circuit consumed substantially less energy than other logic circuits at low-speed operation. We evaluated a test chip implemented with a 0.6-µm CMOS technology, which integrated a chain of inverters with a clocked power generator. In the experimental results, the RERL circuit consumed only 4.5% of the dissipated energy of a static CMOS circuit at an optimal operating speed of 40 kHz. In conclusion, RERL is suitable for the applications that do not require high performance but low-energy consumption because its energy consumption can be decreased to the minimum by reducing the operating frequency until adiabatic and leakage losses are equal.

Today, many kinds of real-time applications are available over IP networks. It is important to measure the network performance for such applications before making use of real applications. Authors developed the general purpose traffic measurement tool for IP networks. This system can generate any kinds of traffic flexibly and calculate the network performance such as throughput, delay and loss ratio according to received packets. In this paper, the concept of this traffic measurement tool is described in detail, and several examples of network measurements are shown.

This paper evaluates the performance of a reliable multicast protocol for bulk-data transfer over unreliable networks via IP-multicast. Bulk-data type reliable multicast appears promising for commercial publishing and large-scale data replication. The proposed reliable multicast transport protocol (RMTP) provides high-performance due to the use of IP multicast while also providing confirmed and error free transfer by end-to-end controls. The protocol includes a multi-round selective repeat scheme dedicated for bulk-data multicast applications. This paper examines the multicast retransmission procedures in RMTP through analysis and tests on an implemented system and clarifies the basic performance behavior of the protocol. Evaluations are conducted with regard to retransmission redundancy, transfer time, and packet processing load with various error conditions and number of receivers. Against the response concentration problem seen in end-to-end communication, the backoff time algorithm is applied to the protocol; the limits it places on system scalability are clarified.

An ATM buffer management scheme with logically separated buffers is proposed to guarantee various Quality of Services such as CBR, rt-VBR, nrt-VBR, ABR, and UBR and to make efficient use of system resources in ATM switching systems. By assigning proper priorities based on the count indicator (CI) and the time indicator (TI), respectively, the scheme can afford ABR services without cell loss and real-time services with controllable delay.

This paper proposes an adaptive microphone array using blind deconvolution. The method realizes an signal enhancement based on the combination of blind deconvolution, synchronized summation and DSA (Delay-and-Sum Array) method. The proposed method improves performance of estimation by the iterative operation of blind deconvolution using a cost-function based on the coherency function.