We consider a circuit composed of linear capacitors, nonlinear resistors, and dc voltage sources and show the possibility that the total energy dissipated at resistors in the above circuit is smaller than the energy stored at capacitors. Linear passive circuits cannot possess such a property.

In digital modulation for mobile radio telephone services frequency modulation with continuous phase with small modulation indices (MSK/GMSK) is sometimes used. Extension of the synchronization subsystems' pulling band in a coherent receiver and reducing synchronization delay is important for the mobile communication. At this moment there are only two possible synchronization schemes for the coherent MSK/GMSK receiver: Costas and de Buda's. This paper presents a new method (a possible alternative to both of them) where the frequency discriminator with decoupled carrier and bit synchronizing subsystem are combined to handle the task. For comparison, this paper also describes performances of the Costas carrier recovery scheme, which is widely employed for MSK/GMSK coherent demodulation. Discrimination and fluctuation characteristics for frequency, phase, and symbol delay synchronization subsystems are shown and the BER degradation from the conventional Costas scheme is calculated. This paper demonstrates with simulation results that the proposed scheme improves RF carrier acquisition performances, and at the same time, for large signal-to-noise ratios (SNR's) provides similar or better tracking performances than the Costas one. While limited to higher SNR ratios, the proposed synchronization scheme is suitable for many applications and can be implemented with simpler circuitry, well suited to integrated circuit implementation.

This paper explores a possibility of constructing massively parallel molecular computing systems using molecular electronic devices called enzyme transistors. The enzyme transistor is, in a sense, an artificial catalyst which selects a specific substrate molecule and transforms it into a specific product. Using this primitive function, various active continuous media for signal transfer/processing can be realized. Prominent examples discussed in this paper are: (i) Turing pattern formation and (ii) excitable wave propagation in a two-dimensional enzyme transistor array. This paper demonstrates the potential of enzyme transistors for creating reaction-diffusion dynamics that performs useful computations in a massively parallel fashion.

In this paper, we present the theoretical development to stabilize a class of uncertain time-delay system. The system under consideration is described in state space model containing distributed delay, uncertain parameters and disturbance. The main idea is to transform the system state into an equivalent one, which is easier to analyze its behavior and stability. Then, a computational method of robust controller design is presented in two parts. The first part is based on solving a Riccati equation arising in the optimal control theory. In the second part, the finite dimensional Lyapunov min-max approach is employed to cope with the uncertainties. Finally, we show how the resulting control law ensures asymptotic stability of the overall system.

This paper presents two competitive learning methods with the objective of avoiding the initial dependency of weight (reference) vectors. The first is termed the refractory and competitive learning algorithm. The algorithm has a refractory period: Once the cell has fired, a winner unit corresponding to the cell is not selected until a certain amount of time has passed. Thus, a specific unit does not become a winner in the early stage of processing. The second is termed the creative and competitive learning algorithm. The algorithm is presented as follows: First, only one output unit is prepared at the initial stage, and a weight vector according to the unit is updated under the competitive learning. Next, output units are created sequentially to a prespecified number based on the criterion of the partition error, and competitive learning is carried out until the ternimation condition is satisfied. Finally, we discuss algorithms which have little dependence on the initial values and compare them with the proposed algorithms. Experimental results are presented in order to show that the proposed methods are effective in the case of average distortion.

This paper reports on time-space conversion-based differential processing of optical signals using a high-resolution arrayed-waveguide grating (AWG) and a spatial filter at a wavelength of 1.55 µm. We clarify the advantages of the AWG device and show where it is applicable. In order to reduce loss at the spatial filter, we propose a new phase-only filter that functions as a differential filter. The difference between the exact differential filter and the proposed phase-only filter is calculated theoretically. We confirm experimentally that the optical pulse can be differentiated by the proposed filter. For application of differential processing, we also proposed a phase modulation to amplitude modulation (PM-AM) conversion and demonstrated the PM-AM conversion at 10 Gbit/s signals using a PSK-non-return-to-zero (NRZ) format.

Recent status of the polymer optical fiber (POF) for high speed data communication and telecommunication is reviewed. The GI POF was proposed for the first time 20 years ago at Keio University, and several methodologies to fabricate GI POF have been currently proposed worldwide. In this paper, we both theoretically and experimentally verify that the most transparent GI POF can be obtained by the polymer-dopant system. The relation between the refractive index profile and the dispersion characteristics of the GI POF was quantitatively clarified. The refractive index profile of the GI POF obtained by the interfacial-gel polymerization process was controlled to enable to transmit the order of gigabit per second bit rate. Furthermore, the accurate approximation of the refractive index profile and consideration of mode dependent attenuation enabled to precisely predict the dispersion characteristics of the GI POF.

It is an important problem in signal processing, system realization and system identification to find linear discrete-time systems which are consistent with given covariance parameters. This problem is formulated as a problem of finding discrete-time positive real functions which interpolate given covariance parameters. Various investigations have yielded several significant solutions to the problem, while there remains an important open problem concerning the McMillan degree. In this paper, we use more general input-output characteristics than covariance parameters and consider finding discrete-time positive real matrix functions which interpolate such characteristics. The input-output characteristics are given by the coefficients of the Taylor series at some complex points in the open unit disk. Thus our problem is a generalization of the interpolation problem of covariance parameters. We reduce the problem to a directional interpolation problem with a constraint and develop the solution by a state-space based new approach. The main results consist of the necessary and sufficient condition for the existence of the discrete-time positive real matrix function which interpolates the given characteristics and has a limited McMillan degree, and a parameterization of all such functions. These are a contribution to the open problem and a generalization of the previous result.

An approach to an MPEG decoding system with reduced memory capacity will be presented. This method relies on the simple technique of one-dimensional DPCM to recompress reconstructed Macro Block (MB) prior to being stored on frame memory. Simulation results suggest that image quality is subjectively acceptable when using approximately one-half of the memory size required by that of conventional decoder. The degradation in the signal-to-noise ratio introduced by this compression method ranged from 0.1 dB to 0.7 dB for MPEG MP@ML standard test sequences at 4 Mbps. This technique can be implemented to achieve a cost effective MPEG decoder.

This paper presents an approach to the blind identification of multichannel communication systems by using partial knowledge of the channel. The received signal is first processed by a filter constructed by the known component of the channel and then a blind identification algorithm based on the second-order statistics is applied to the filtered signal. It is shown that, if the unknown component satisfies the identifiability condition, the channel can be identified even though the channel does not satisfy the identifiability condition. Simulation results are presented to show the performance of the proposed approach. A comparison to the existing approaches is also presented.

In some applications, such as the echo cancellation problem of satellite-linked communication channels, there occurs a problem of estimation of a long impulse response, which consists of a long flat delay and a short dispersive response region. In this paper, it is shown that the use of the adaptive algorithm based on the frequency domain sampling theorem enables efficient identification of the long impulse response. The use of the proposed technique can lead to the reduction of both the number of adaptive weights and the complexity of flat delay estimation.

We proposed a new model for non-stationary time series analysis based on the IAR (inhomogeneous autoregressive) model, and a method for model parameter estimation when the set of basis is given. In this paper, we further propose a method for parameter estimation including that of basis set: we set a new condition that power of the input sequence is concentrated in low-frequency domain, and developed an iterative estimation method. We firstly select an initial set of basis, from which new sets are created in order to minimize the difference between the model and data. Among new sets of basis, we select a good one that gives minimum standard deviation of estimated frequencies.

The problem of transient scattering caused by abrupt extinction of a terminative conducting screen in a waveguide is considered. First, a boundary-value problem is formulated to describe the transient phenomena, the problem in which the boundary condition depends on time. Then, application of the Fourier transformation with respect to time derives a Wiener-Hopf-type equation, which is solved by a commonly known decomposition procedure. The transient fields are obtained through the deformation of the integration path for the inverse transformation and the results are represented in terms of the incomplete Lipschitz-Hankel integrals. Numerical examples showing typical transient phenomena are attached.

This paper proposes adaptive line enhancers with new coefficient update algorithms on the basis of least-square-error criteria. Adaptive algorithms by least-squares are known to converge faster than stochastic-gradient ones. However they have high computational complexity due to matrix inversion. To avoid matrix inversion the proposed algorithms adapt only one coefficient to detect one sinusoid. Both FIR and IIR types of adaptive algorithm are presented, and the techniques to reduce the influence of additive noise is described in this paper. The proposed adaptive line enhancers have simple structures and show excellent convergence characteristics. While the convergence of gradient-based algorithms largely depend on their stepsize parameters, the proposed ones are free from them.

WDM transmission experiments over cascaded sections of optical links including wavelength converting 2R-transponders have been carried out in a loop testbed. Using dispersion compensated links and simple direct modulated transponder lasers, up to 11 cascaded crossconnects and 1750 km trunk lines have been bridged with 2.5 Gbit/s NRZ signals. The limitations are given mainly due to the accumulated jitter as it is shown by numerical simulations. The results indicate, that 2R-transponders are a useful approach to a flexible WDM network design using bitrate-transparent wavelength conversion.

This paper reports on time-space conversion-based differential processing of optical signals using a high-resolution arrayed-waveguide grating (AWG) and a spatial filter at a wavelength of 1.55 µm. We clarify the advantages of the AWG device and show where it is applicable. In order to reduce loss at the spatial filter, we propose a new phase-only filter that functions as a differential filter. The difference between the exact differential filter and the proposed phase-only filter is calculated theoretically. We confirm experimentally that the optical pulse can be differentiated by the proposed filter. For application of differential processing, we also proposed a phase modulation to amplitude modulation (PM-AM) conversion and demonstrated the PM-AM conversion at 10 Gbit/s signals using a PSK-non-return-to-zero (NRZ) format.

A clock recovery circuit is a key component in optical communication systems. In this paper, an optoelectronic clock recovery circuit is reported that monolithically integrates a resonant tunneling diode (RTD) and a uni-traveling-carrier photodiode (UTC-PD). The circuit is an injection-locked-type RTD oscillator that uses the photo-current generated by the UTC-PD. Fundamental and sub-harmonic clock extraction is confirmed for the first time with good clock recovery circuit characteristics. The IC extracts an electrical 11.55-GHz clock signal from 11.55-Gbit/s RZ optical data streams with the wide locking range of 450 MHz and low power dissipation of 1.3 mW. Furthermore, the extraction of a sub-harmonic clock from 23.1-Gbit/s and 46.2-Gbit/s input data streams is also confirmed in the wider locking range of 600 MHz. The RMS jitter as determined from a single sideband phase noise measurement is extremely low at less than 200 fs in both cases of clock and sub-harmonic clock extraction. To our knowledge, the product of the output power and operating frequency of the circuit is the highest ever reported for injection-locked-type RTD oscillators. These characteristics indicate the feasibility of the optoelectronic clock recovery circuit for use in future ultra-high-speed fully monolithic receivers.

This paper describes design techniques for suppressing crosstalk in an optical transceiver module using PLC-hybrid-integration technologies and for achieving burst-mode operation with high sensitivity and wide dynamic range using CMOS-IC technologies. An arrangement that reduces the electrical crosstalk to less than -100 dB was designed using three-dimensional electromagnetic field analysis. The configurations of a newly developed instantaneous-response CMOS LD driver circuit is also described and instantaneous-response CMOS receiver circuit techniques are reviewed. With these techniques, we have succeeded in building optical transceiver modules for ATM-PON systems using PLC-hybrid-integration and inexpensive standard CMOS-IC fabrication processes. Under full-duplex operation at 156 Mb/s, fabricated transceiver modules showed receiver sensitivity of better than -34 dBm and dynamic range of over 28 dB, which satisfy both the class-B and class-C specifications recommended by ITU-T (International Telecommunication Union-Telecommunication standardization sector) G983.1 for the optical transceiver module for an ONU (optical network unit).

Modern micro-architectures employ superscalar techniques to enhance system performance. Since the superscalar microprocessors must fetch at least one instruction cache line at a time to support high issue rate and large amount speculative executions. There are cases that multiple branches are often encountered in one cycle. And in practical implementation this would cause serious problem while there are variable number of instruction addresses that look up the Branch Target Buffer simultaneously. In this paper, we propose a Range Associative Branch Target Buffer (RABTB) that can recognize and predict multiple branches in the same instruction cache line for a wide-issue micro-architecture. Several configurations of the RABTB are simulated and compared using the SPECint95 benchmarks. We show that with a reasonable size of prediction scope, branch prediction can be improved by supporting multiple / up to 8 branch predictions in one cache line in one cycle. Our simulation results show that the optimal RABTB should be 2048 entry, 8-column range-associate and 8-entry modified ring buffer architecture using PAs prediction algorithm. It has an average 5.2 IPC_f and branch penalty per branch of 0.54 cycles. This is almost two times better than a mechanism that makes prediction only on the first encountered branch.

Technical advances in the development of portable computers and wireless communications enable users to take part in distributed computing even while moving. The resulting environment is subject to be constrained by the mobility of users and the nature of the cordless medium. In this paper we propose a commit protocol for providing low-powered mobile hosts with two phase commit service which is a powerful technique to implement atomic actions in distributed systems, with some important aspects such as low power consumption, efficient mobility management, subject oriented service binding and effective disconnection handling to well adapt to a mobile computing environment.