A novel adder-free architecture for realizing a small-size π/4-shift QPSK signal generator IC is presented. In order to realize an adder function, analog current-mode addition is utilized instead of digital adders. Impulse responses of a roll-off filter are stored in a ROM as a Δ-Σ modulated one-bit data stream. This can greatly reduce the die size to 0.8mm 0.8mm while maintaining high modulation accuracy. The test chip was fabricated by using the standard 0.8µm CMOS technology, and the chip achieved 1.8% vector modulation error with a 2.7V power supply.

In portable applications such as W-CDMA cell phones, high performance and low standby leakage are both required. We propose an automated design technique to selectively use multi-threshold CMOS (MTCMOS) in a cell-by-cell fashion. MT cells consisting of low-Vth transistors and high-Vth sleep transistors are newly introduced. MT cells are assigned to critical paths to speed up, while High-Vth cells are assigned to non-critical paths to reduce leakage. Compared to the conventional MTCMOS, the gate delay is not affected by the discharge patterns of other gates because there is no virtual ground to be shared. We applied this technique to a test chip of a DSP core for W-CDMA baseband LSI. The worst path-delay was improved by 14% over the single high-Vth design without increasing standby leakage at 10% area overhead.

A frequency drift of open-loop PLL is an issue for the direct-modulation applications such as Bluetooth transceiver. The drift mainly comes from a temperature variation of VCO during the transmission operation. In this paper, we propose the optimum location of the VCO, considering the temperature gradient through the whole-chip thermal analysis. Moreover, a novel temperature-compensated VCO, employing a new biasing scheme, is proposed. The combination of these two techniques enables the power reduction of the transmitter by 33% without sacrificing the performance.

A 2.4 GHz 0.13 µm CMOS transceiver LSI, supporting Bluetooth V2.1+enhanced data rate (EDR) standard, has achieved a high reception sensitivity and high-quality transmission signals between -40 and +90. A low-IF receiver and direct-conversion transmitter architecture are employed. A temperature compensated receiver chain including a low-noise amplifier accomplishes a sensitivity of -90 dBm at frequency shift keying modulation even in the worst environmental condition. Design optimization of phase noise in a local oscillator and linearity of a power amplifier improves transmission signals and enables them to meet Bluetooth radio specifications. Fabrication in scaled 0.13 µm CMOS and operation at a low supply voltage of 1.5 V result in small area and low power consumption.