This paper proposes a novel differential active self-interference canceller (DASIC) algorithm for asynchronous in-band full-duplex (IBFD) Gaussian filtered frequency shift keying (GFSK), which is designed for wireless Internet of Things (IoT). In IBFD communications, where two terminals simultaneously transmit and receive signals in the same frequency band, there is an extremely strong self-interference (SI). The SI can be mitigated by an active SI canceller (ASIC), which subtracts an interference replica based on channel state information (CSI) from the received signal. The challenging problem is the realization of asynchronous IBFD for wireless IoT in indoor environments. In the asynchronous mode, pilot contamination is induced by the non-orthogonality between asynchronous pilot sequences. In addition, the transceiver suffers from analog front-end (AFE) impairments, such as phase noise. Due to these impairments, the SI cannot be canceled entirely at the receiver, resulting in residual interference. To address the above issue, the DASIC incorporates the principle of the differential codec, which enables to suppress SI without the CSI estimation of SI owing to the differential structure. Also, on the premise of using an error correction technique, iterative detection and decoding (IDD) is applied to improve the detection capability while exchanging the extrinsic log-likelihood ratio (LLR) between the maximum a-posteriori probability (MAP) detector and the channel decoder. Finally, the validity of using the DASIC algorithm is evaluated by computer simulations in terms of the packet error rate (PER). The results clearly demonstrate the possibility of realizing asynchronous IBFD.

Bluetooth is a common wireless technology that is widely used as a connection medium between various consumer electronic devices. The receivers mostly adopt the Viterbi algorithm to improve a bit error rate performance but are hampered by heavy hardware complexity and computational load due to a coherent detection and searching for the unknown modulation index. To address these challenges, a non-coherent maximum likelihood estimation detector with an eight-state Viterbi is proposed for Gaussian frequency-shift keying symbol detection against an irrational modulation index, without any knowledge of prior information or assumptions. The simulation results showed an improvement in the performance compared to other ideal approaches.

This work presents an FSK inductive-coupling transceiver using a load-modulated transmitter and LC-oscillator-based receiver for energy-budget-unbalanced applications. By introducing the time-domain load modulated transmitter for FSK instead of the conventional current-driven scheme, energy reduction of the transmitter side is possible. For verifying the proposed scheme, a test chip was fabricated in 65nm CMOS, and two chips were stacked for verifying the inter-chip communication. The measurement results show 0.64fJ/bit transmitter power consumption while its input voltage is 60mV, and the communication distance is 150μm. The footprint of the transmitter is 0.0016mm2.

We consider a distributed transmission of data packet to a sink where the distance of a sensor node to a sink is much longer than the maximum communication range of each sensor node. We give a simple modification to the transmitter, i.e., multiplication of random phase before the transmission. Thanks to Turbo Code, it is possible to extend the transmission range as the received amplitude varies symbol by symbol for our scheme while whole data packet may be lost for the conventional scheme. In this letter, we report the experimental results of our scheme equivalently developed using visible light communication.

This paper provides an overview of CSEMs FM-UWB PHY-MAC proposal to IEEE802.15.6, Task Group 6, Body Area Networks. The proposed solution provides for an ultra low power, yet robust and reliable solution for low data rate medical BAN. The paper examines the key features and performance aspects of the proposal.

In this letter, a simple binary Fast Frequency Shift Keying (FFSK) modulator and its coherent demodulator is proposed. The performance of the proposed modem is in between a coherently detected and a non-coherently detected binary FSK, but its bandwidth requirement is the same as for the Minimum Shift Keying (MSK) modulation.

An entire dual-mode transceiver capable of both the conventional GFSK-modulated Bluetooth and the Medium-Rate π/4-DQPSK-modulated Bluetooth has been investigated and reported. The transmitter introduces a novel two-point-modulated polar-loop technique without the global feedback to realize reduced power consumption, small chip area and also high modulation accuracy. The receiver shares all the circuits for both operating modes except the demodulators and also features a newly-proposed cancellation technique of the carrier-frequency offset. The transceiver has been confirmed by system or circuit simulations to meet all the dual-mode Bluetooth specifications. The simulation results show that the transmitting power can be larger than 10 dBm while achieving the total power efficiency above 30% and also RMS DEVM of 0.050. It was also confirmed by simulation that the receiver is expected to attain the sensitivity of -85 dBm in both modes while satisfying the image-rejection and the blocker-suppression specifications. The proposed transceiver will provide a low-cost, low-power single-chip RF-IC solution for the next-generation Bluetooth communication.

A frequency drift of open-loop PLL is an issue for the direct-modulation applications such as Bluetooth transceiver. The drift mainly comes from a temperature variation of VCO during the transmission operation. In this paper, we propose the optimum location of the VCO, considering the temperature gradient through the whole-chip thermal analysis. Moreover, a novel temperature-compensated VCO, employing a new biasing scheme, is proposed. The combination of these two techniques enables the power reduction of the transmitter by 33% without sacrificing the performance.

The use of a two-point modulator with variable PLL loop bandwidth as a GFSK signal generator is proposed. Delta-sigma modulation is adopted for the modulator. Through the combination of a variable PLL feedback loop and delta-sigma modulation, both a fast settling time and very clear eye opening are achieved for the modulator. We fabricate it in 0.35-µm BiCMOS process technology. The two-point modulator has a center-frequency drift of only 14.9 kHz, much lower than the 178-kHz result for a single time slot in the case of direct VCO modulation. This is due to the PLL feedback loop. Evaluation also confirmed that the circuit satisfies the various characteristics required of a Bluetooth transmitter. The two-point modulator is also applicable to other transceivers which use FSK or PSK modulation, i.e. forms of modulation where a constant signal level is transmitted, and thus contributes to the simplification of a range of wireless transmitters.

This paper describes a 2.4-GHz downconverter that runs on a 1-V supply. The downconverter integrates an LNA, a quadrature mixer, a complex channel-select band-pass filter (BPF), a limiting amplifier, and a frequency doubler using 0.2-µm CMOS/SOI technology. The frequency doubler doubles the frequency deviation of FM signals as well as the frequency itself, which in turn doubles the modulation index. This improves the sensitivity of FM demodulation. The power consumption of the downconverter is 23 mW with a 1-V power supply. A bit-error-rate (BER) measurement using the downconverter and a demodulation IC shows -76.5-dBm sensitivity at a 0.1% BER.

Satellite communication can be operated with various levels of on-board processing in order to transmit the signal effectively. In this paper, the BER performances of the bent pipe transponder (BPT), dehop only transponder (DOT) and dehop and rehop transponder (DRT) systems with FH-MFSK modulation are investigated in the presence of broad band interference, narrow band interference and tone-type interference. In this case, the BER performances are compared for the variants of the data rates, spreading bandwidth and interference power. The numerical results show that DRT outperforms BPT and DOT. DOT is less sensitive to uplink interference power under broad band interference environment than DRT. In the case of narrow band interference, the DRT system is more sensitive to ρ value, i.e., the ratio of the interference bandwidth to the spreading bandwidth, than DOT. Among various interference types, the performance in n = 1 band multi-tone interference is shown to be the worst.

In fast frequency hopped (FFH) non-coherent MFSK systems, the diversity combining scheme can be used effectively in order to combat the interference, especially jamming noise. In this paper, we simulate and discuss the BER performance of FH/MFSK system for different diversity combining schemes, such as linear combining, clipped-linear combining, normalized envelop detection (NED), order statistics (OS) NED and product combining receiver (PCR), in the presence of both the worst case partial band jamming (PBJ) and the fading channel. The performances of those combining schemes except for linear combining are similar each other in the worst case PBJ without the fading. In the existence of both the worst case PBJ and the fading channel, the clipped-linear combining scheme suffers a larger drop in performance than other combining schemes. It is noteworthy that the performances of OSNED and PCR are the best in Rayleigh fading channel among those combining schemes.

A digital noncoherent demodulation scheme is presented for reception of Gaussian frequency shift keying (GFSK) signals with small modulation index. The proposed differential demodulator utilizes oversampled signals to estimate the symbol timing and to compensate the frequency offset. The performance of the proposed receiver is evaluated in terms of the bit-error rate (BER). Numerical results show that the proposed demodulator provides performance comparable to that of conventional baseband differential demodulator, while significantly reducing the implementation complexity suitable for single chip integration with direct conversion radio frequency module. Finally the performance of the proposed receiver is improved by adding a simple decision feedback module.

The stage 3/2 decoding scheme, originally suggested by U. Timor, is modified for a Rayleigh fading channel to improve the performance of a fast frequency-hopped multiple access/multilevel frequency shift keying system. When signal-to-noise ratio per bit is 30 dB, the simulation results show that the modified stage 3/2 decoding scheme increases the spectral efficiency by 11% compared to the modified stage 1 decoding scheme at bit error rate of 10-3. Further, the performance comparisons are made between the modified multistage decoding scheme and the diversity combining methods, where the modified stage 3/2 decoding scheme shows better performance.

In this paper, we analyze the error performance of coherent M-ary FSK (MFSK) signals using the union bound which is an upper bound on the bit error probability over frequency-nonselective slow Nakagami and Rician fading channels with additive white Gaussian noise (AWGN), respectively. Furthermore, the performances of uncoded coherent and noncoherent signals are compared under the fading channels. The error probability of noncoherent MFSK signals over slow and flat fading channels when AWGN is present can be derived and evaluated from the new probability density function (PDF) for the envelope of the received signals.

Phase locked loops (PLL's) are well known as a threshold extension demodulator for analogue FM signals. This capability may lead to the low bit error rate demodulation for digital FM signals. A PLL has also its native frequency tracking ability and is suited to the demodulation of the signals having large Doppler shifts, for example signals from Low Earth Orbit (LEO) satellites. In this paper, we study the demodulation scheme of Continuous Phase FSK (CPFSK) and Gaussian filtered MSK (GMSK) signals using a Digital Signal Processing type Digital PLL (DSP DPLL). First we propose a DSP DPLL completely equivalent to an Analog PLL (APLL). Next we adopt the sequence estimation scheme to compensate the Inter-Symbol Interference (ISI) associated with the finite loop bandwidth of the DSP DPLL. Through computer simulations it is clarified that the proposed DSP DPLL with sequence estimator can achieve better BER performance compared with the conventional Limiter Discriminator (LD) detection on the AWGN channel. We have also shown that the DSP DPLL with sequence estimator has excellent BER characteristics on Rician fading channels having actual large Doppler shifts.

In this paper we propose a new lattice based second-order adaptive infinite impulse response (IIR) notch filter that uses a simplified adaptation algorithm. Steady-state analysis of the proposed structure is then studied based on the mean-squared error analysis of the steady-state variable coefficient fluctuations. The analysis is used to derive simple analytical expressions for steady-state variable coefficient variance and an upper bound for the step size adaptation constant. The results are shown to be useful in designing an FSK demodulator using the proposed structure. Computer simulation results are shown to confirm derived analytical expressions.

A simple near-orthogonal code is used as frequency-hopping patterns for the frequency-hopped multiple access systems. Extended RS code is used as channel coding to deplete the effects of hits from simultaneous users. Packet error probability and channel throughput for the system utilizing the near-orthogonal code are evaluated and compared to the corresponding values obtained from the system utilizing random patterns. Results show that the former can provide substantial improvement over the latter. In our illustrated examples, we also show that under the constraint of packet error probability PE 10-2, the maximum achievable number of users with most (n,k) RS codes of interest is less than the number of distinct codewords in the near-orthogonal code. Thus, the number of codewords of the near-orthogonal code is large enough to support the practical application.

This paper presents a new approach to computing symbol error probability of fast frequency-hopped M-ary frequency shift keying (FFH/MFSK) systems with majority vote under multitone jamming. For illustrating the applications, we first consider the case in which the source data rate is fixed and the hopping rate is allowed to vary. In this case, the optimum orders of diversity for several values of M are examined. Results show that M=4 outperforms other values. Then, we treat another case in which the hopping rate is fixed and the data rate is adjusted so as to obtain maximum throughput under a given constraint of error probability. In addition to the case of diversity alone, we also evaluate the performances of the fixed hopping rate case with channel coding using convolutional code and BCH code.

This paper presents the performance of FH/MFSK systems, which exploit silent gaps in speech to accommodate more users, over Rayleigh fading channels. Two kinds of receivers are considered: one uses a threshold on the received signal strength to declare whether the signals were present or not, and the other is assumed to have perfect transmitter-state information obtained from using additional bandwidth. Results show that, if the codeword dropping and codeword error are assumed to be equally costly, the former can achieve slightly better performance than the latter in the decoding error probability. This finding suggests that, for the system to exploit silent gaps in speech, it is advantageous for the receiver to use a threshold to declare whether signals were present or not instead of relying on the transmitter-state information.