In this paper, the Linear Exponential Quadratic Gaussian with Loop Transfer Recovery (LEQG/LTR) methodology is employed for the design of high performance induction motor servo systems. In addition, we design a speed sensorless induction motor vector controlled driver with both the extended Kalman filter and the LEQG/LTR algorithm. The experimental realization of an induction servo system is given. Compared with the traditional PI and LQG/LTR methods, it can be seen that the system output sensitivity for parameter variations and the rising time for larger command input of the proposed method can be significantly reduced.

This paper describes a method of predicting transmission performance to be obtained by applying RAKE reception and parallel transmission in realistic urban multipath environments. Delay profiles measured in metropolitan Tokyo at microwave frequencies were used to obtain the impulse responses of radio channels, and the closed-form equations corresponding to the performance of these anti-multipath techniques were derived, by means of the characteristic function method, under the assumption that the phases of the impulse responses are uniformly distributed. Results show that RAKE reception provides bit error rates 100 times lower than bare transmission does, whereas the improvement obtained by using parallel transmission should be especially valuable in broadband communication systems, such as those operating at data rates above 10 Mb/s.

In future multimedia mobile communication systems, heterogeneous users will require very different and time-varying transmission rates. Thus, they should be supported with a novel approach that can accommodate the fluctuating data rates in wireless channels. In this paper, a simple method that is used to admit the rates successfully is proposed. The method is also distributed in a sense that it can be implemented at each mobile without any interaction with other mobiles. The method consists of power control with a higher SIR (signal to interference ratio) target and periodic adjustment of the data rate. We prove a good rate admission property of the proposed method and verify its performance with numerical investigation.

Multi-path propagation structure in the urban mobile communication environment of 25 GHz band has been measured by means of newly developed "multi-path propagation parameter measurement equipment," which is capable of estimating coupled DOA (Direction Of Arrival), TOA (Time Of Arrival) and relative field strength by super resolution techniques. Before measurement, basic performance of the equipment has been evaluated in the anechoic chamber in order to ascertain limitation on measurement. For practice and verification of outdoor propagation characteristics, basic data have been collected in a works where accurate buildings and road layout is known. Sub-sequently, data have been collected in the urban mobile communication environment and following characteristics have been confirmed. 1) DOA and TOA of wave reflected by the side of building almost follow the ray-trace. 2) Street trees make 25 GHz band wave attenuate. 3) There are such unusual cases that it is possible to communicate in spite of out of line-of-sight by multi-path propagation. 4) Narrow streets have very complicated propagation structures. Finally, technologies that should be developed for the high-speed digital mobile communication are proposed based on the measurement results.

In this paper, we show two process allocation schemes to tolerate multiple faults when the primary-backup replication method is used. The first scheme, called multiple backup scheme, is running multiple backup processes for each process to tolerate multiple faults. The second scheme, called regenerative backup scheme, is running only one backup process for each process, but re-generates backup processes for processes that do not have a backup process after a fault occurrence to keep the primary-backup process pair available. In both schemes, we propose heuristic process allocation methods for balancing loads in spite of the occurrence of faults. Then we evaluate and compare the performance of the proposed heuristic process allocation methods using simulation. Next, we analyze the reliability of two schemes based on their fault-tolerance capability. For the analysis of fault-tolerance capability, we find the degree of fault tolerance for each scheme. Then we find the reliability of each scheme using Markov chains. The comparison results of two schemes indicate that the regenerative single backup process allocation scheme is more suitable than the multiple backup allocation scheme.

We have developed a diagnostic Case-Based Reasoning (CBR) system, Doctor, which infers possible defects in a home electrical appliance and lists up necessary service parts. The CBR is suitable to build a diagnostic system for the field service because the CBR imitates how experienced service technicians infer and is able to learn defect trends and novel repair cases from a service report database. In order to apply a CBR system to this real-world problem, Our system has the following new features: (1) Its CBR mechanism utilizes not only repair cases, but also diagnostic rules that are elicited from human experts so that accurate diagnosis can be achieved. (2) Its casebase maintenance mechanism updates the casebase and adapts it to the changing real world.

This paper proposes a coherent detection scheme that can reduce the estimation errors of the carrier phase due to Gaussian noise in communication systems where pilot symbol assisted modulation is employed to compensate for Rician fading distortion. This paper introduces two functions in addition to conventional fading estimation methods using Wiener interpolation, etc. The first is the weighted average function for reducing the estimation errors of the fading distortion detected by pilot symbols. The second is the moving average function for estimating the phase errors that are residual after being compensated for by the estimated fading distortion. This paper evaluates the bit error rate (BER) performance for the proposed method in both Rician fading channel and additive white Gaussian noise (AWGN) channel by computer simulation. Simulation results verify that the BER performance of the proposed method is superior to that of a conventional method in both Rician fading channel and AWGN channel. Simulation results also confirm that the degradation of the BER performance of the proposed method is only 0.1 dB in AWGN channel and only 0.3 dB in Rician fading channel compared with the theoretical curves even if we reduce the number of computations by simplifying the calculation of interpolation coefficients optimized for Wiener interpolation.

Up to now, a lot of efforts have been made for the management of telecommunication networks and equipment, but less effort has been made for the realization of higher-layer service and business management. Common Object Request Broker Architecture (CORBA) provides the infrastructure for interoperability of various object-oriented management applications in a distributed environment, and being widely used to develop distributed systems in many areas of information processing technologies. There are recently worldwide growing interests for applying CORBA technology for the realization of higher layer Telecommunication Management Network (TMN) management functions. In this paper, we propose a platform architecture for the efficient integration of CORBA technology within TMN framework, where CORBA-based management functions as well as TMN-based management functions can be realized efficiently. GDMO/ASN. 1 to IDL translator has been designed and implemented for translating TMN management information into OMG CORBA IDL interface. The CORBA/CMIP gateway has also been designed for realization of the interaction translation specification of JIDM task force with some additional extensions. Finally, we evaluate the performance of the CORBA-based network management system, and analyze the code reusability for the construction of the CORBA-based management system, in order to show the efficiency of the architecture.

As telecommunications companies face the rigors of competition, they soon find that their operational support systems play a critical role in providing new services faster, at lower cost and with better quality than their competitors. At TeleManagement Forum, the model for the successful service provider is 'the smooth operator' - a company whose processes and systems fully support its people to provide the best services possible at the lowest cost. Learning the importance of becoming a 'smooth operator' is hard, particularly as it requires giving up the old way of doing things - moving from an internal development environment to one that can take full advantage of 'off-the-shelf' software. The reasons for this shift include a shortage of resources, shortage of time, and the need to do business as part of a greater (and growing) global supply chain. Getting to 'smooth operator' status can be made easier with help from organizations like the TeleManagement Forum. In this paper, a twelve-step method is outlined to give pointers to service providers and their suppliers on how to make the journey successfully.

An approximate formula is proposed for the equivalent susceptance of a circular iris in a parallel plate waveguide when the TEM mode cylindrical wave is incident from the center of the iris. Schwinger's variational method for a linear iris is generalized to the cylindrical case, and an approximate closed form formula is obtained which recovers the result of the linear iris when the radius of the circular iris is sufficiently larger than the wavelength. For verification of the formula, an exact integral equation is formulated and solved numerically by Galerkin's method. A comparison between them shows good agreement.

In this paper, we design and implement a Web-based Internet/Intranet service management system which can support Quality of Service (QoS) contracted by users and service providers, using Service Level Agreement (SLA) concept. We have analyzed the requirements and management information for Internet/Intranet service management. Based on this analysis, we have defined the suitable QoS parameters for the management of Internet/Intranet services, and developed new WWW service Management Information Bases (MIBs) for QoS management by extending the existing IETF's MIBs. The support of QoS management is done by incorporating the SLA concept, which is measured, monitored and controlled systematically in a multi-domain environment. Finally, we have built a prototype system, and evaluated its performance. The prototype system utilizes Java and CORBA technologies, so that various benefits of these technologies such as platform independence and scalability can be obtained.

This paper proposes an implementation of the Telecommunications Information Networking Architecture (TINA) connection management system, based on our involvement of The TINA Trial (TTT). The system is used for managing ATM networks, which consist of network elements with SNMP interfaces. It provides setup, configuration, and release of ATM connection with a GUI-based network design tool that generates network resource data used for deploying TINA software components. This paper reports on a method of implementing TINA components over a Distributed Processing Environment (DPE) and an effective way to manage computational objects with multiple interfaces by using the Trading Service.

This paper discusses a design and an implementation of a MIB tester, a conformance test tool of Management Information Base (MIB) for TMN. A remote test method is used as a practical test configuration. We classify test purposes into three; basic interconnection test, capability test and behaviour test. Test items for the capability test are defined according to Managed Object Conformance Statement (MOCS) and Managed Relationship Conformance Statement (MRCS). Test items for the behaviour test is defined according to GDMO BEHAVIOUR clause. The MIB tester automatically generates test scenarios for capability tests, which are also used as those for the basic interconnection test, and supports the scenario creation of the behaviour test in an user-friendly manner. We evaluate the implemented MIB tester through its application to the actual TMN agents.

Today's complicated and heterogeneous telecommunication network environments need fully-integrated, cost-effective, user-friendly management systems. When developing such management systems in distributed environments, many telecommunication companies are carefully adopting CORBA and Java technologies. CORBA technology enables developers to create and manipulate distributed management system components easily while Java technology liberates human users from complicated and proprietary management system interfaces. In this paper, we propose a TMN-based integration framework for distributed network management by combining both CORBA and Java technologies. The framework generalizes a logically-layered architecture from the management agents layer to the user interface layer. It also provides generalized TMN management interfaces using inter-domain gateway systems for coordinating heterogeneous management protocols. By using these interfaces, TMN management function components can be easily constructed as CORBA objects to provide powerful TMN management services to administrators via user-friendly Web browsers. On the basis of this framework, we have designed and implemented a TMN alarm surveillance system which realizes our framework.

In this letter, the probability of error performance improvements by rain fade countermeasure techniques is analyzed in a Ka-band geostationary satellite communication system using synchronous CDMA scheme, when power control and macrodiversity are used as rain fade countermeasures. Numerical results show that the composite power control plus macroscopic selection diversity system is better than that of utilizing only one technique as a countermeasure of rain fading.

Internet communication is increasingly becoming an important element in daily life. Keeping this network safe from malicious elements is an urgent task for network management. To maintain the security level networks are generally, monitored for indications of usage with ill-intentions. Such indications are events which need to be collated, correlated and analyzed in real-time to be effective. However, on an average medium to large size network the number of such events are very large. This makes it practically impossible to analyze the information in real-time and provide the necessary security measures. In this paper, we propose a mechanism that keeps the number of events, to be analyzed, low thereby making it possible to provide ample security measures. We discuss a real-time Intrusion Detection System (IDS) for detecting network attacks. The system looks out for TCP ACK/RST packets, which are generally caused by network scans. The system can extract the tendency of network flows in real-time, based on the newly developed time-based clustering and Dynamic Access Tree creation techniques. The algorithm, implemented and deployed on a medium size backbone network using RMON (Remote MONitoring) technology, successfully detected 195 intrusion attempts during a one month period. The results of the pilot deployment are discussed. In this paper, the proposal, implementation and evaluation will be described.

This letter is concerned with a new algorithm which can be used to design a time-domain equalizer (TEQ) for xDSL systems employing the discrete multitone (DMT) modulation. The proposed algorithm, derived by neglecting the terms which do not affect the performance of a DMT system in ARMA modeling, is shown to have a good performance compared with the previous TEQ algorithms even with a significantly lower computational complexity. In addition, the proposed algorithm does not require the channel impulse response or training sequence, since all processing is made only with the received data.

In general, when many functions and services are added to a system, verification and validation become difficult. In design and development in telecommunication services, conflicts that arise from combined telecommunication services have been discussed from various viewpoints. However, correctly and efficiently detecting all conflicts is still not possible and the resolution of conflicts primarily depends on expert designers, who are finding that these problems are beyond their ability. Thus, the burden on the designer must also be alleviated at the design stage. Service interference, which is discussed in this paper, is a kind of conflict. A problem of service interference is that during service, other services interfere with the ongoing service behavior. That is to say, a strange state arises, or an input event doesn't work, or a strange transition occurs, etc. The detection of service interference by only comparing states among services is not enough since the state transition must be considered in the service interference. This paper proposes how to automatically detect the service interference with a rule-based system and an extended adjacency matrix. The proposed method uses and combines features of both the adjacency matrix and rule-based system. The method first generates the extended adjacency matrix by the rule application, then extracts sequences of the state, the event, and the rule applications, and then detects the service interference with the extracted sequences.

With the proliferation of the transistor count in VLSI design, more and more design groups try to figure out an efficient way to combine their designs. The Internet features distributed computing and resource sharing. Consequently, a hierarchical design can adequately be solved in the Internet environment. In this paper, we demonstrate the facilitation of the Internet environment by solving the area minimization floorplan problem. We propose the RMG algorithm taking advantage of the Internet. Based on the model of transfer latencies, the RMG algorithm reduces the computing time by shortening the critical path in the floorplan tree. Our experimental results show that the Internet is suitable for Electronic Design Automation (EDA).

The complexity of designing communication protocols has lead researchers to develop various techniques for designing and verifying protocols. One of the most important techniques is a compositional technique. Using a compositional technique, a large and complex protocol is designed and verified by composing small and simple protocols which are easy to handle, design and verify. Unlike the other compositional approaches, we propose compositional techniques for simultaneously composing service specifications and protocol specifications based on Formal Description Techniques (FDTs) called LOTOS. The proposed techniques consider alternative, sequential, interrupt and parallel composition of service specifications and protocol specifications. The composite service specification and the composite protocol specification preserve the original behaviour and the correctness properties of individual service specifications and protocol specifications. We use the weak bisimulation equivalence (), to represent the correctness properties between the service specification and the protocol specification. When a protocol specification is weak bisimulation equivalent to a service specification, the protocol satisfies all the logical properties of a communication protocol as well as provides the services that are specified in the service specification.