This paper presents an improved method of speaker verification using the sequential probability ratio test (SPRT), which can treat the correlation between successive feature vectors. The hidden Markov model with the mean field approximation enables us to consider the correlation in the SPRT, i. e. , using the mean field of previous state, probability computation can be carried out as if input samples were independent each other.

This paper presents a performance evaluation of NAK-based reliable multicast communication protocols operating in an environment where end-to-end delay are heterogeneous. In the case of heterogeneous delay, performance of a timer-based retransmission control scheme may become worse. We show that a counter-based retransmission control scheme works well in the case of heterogeneous transmission delay. We also compare two NAK-based protocols and show that a NAK-multicasting protocol outperforms a NAK-unicasting protocol from the viewpoint of scalability even when delays are heterogeneous.

A new UEP technique for image transmission using trellis code based on Hamming distance criterion has been proposed. The simulation results comparing the image quality and bit-rate for UEP and EEP have been provided. The results show that UEP performs better than EEP in terms of bit-rate without any significant depreciation in image quality.

We prove that binary images of irreducible cyclic codes C over GF(2m) and binary concatenated codes of C and a binary [m+1,m,2] even-parity code are optimal (in the sense that they meet the Griesmer bound with equality) and proper, if a root of the check polynomial of C is primitive over GF(2m) or its extensions.

In this paper, we consider sufficient conditions for ruling out some useless iteration steps in a class of soft-decision iterative decoding algorithms for binary block codes used over the AWGN channel using BPSK signaling. Sufficient conditions for ruling out the next single decoding step, called ruling-out conditions and those for ruling out all the subsequent iteration steps, called early termination conditions, are formulated in a unified way without degradation of error performance. These conditions are shown to be a type of integer programming problems. Several techniques for reducing such an integer programming problem to a set of subprograms with smaller computational complexities are presented. As an example, an early termination condition for Chase-type decoding algorithm is presented. Simulation results for the (64, 42, 8) Reed-Muller code and (64, 45, 8) extended BCH code show that the early termination condition combined with a ruling-out condition proposed previously is considerably effective in reducing the number of test error patterns, especially as the total number of test error patterns concerned grows.

Recently, it is widely known that the partial response maximum-likelihood (PRML) system has attracted much attention as one of indispensable signal processing technique for achieving high density digital magnetic recording. But, the performance of PRML system is degraded by many undesirable causes in recording channel. For improving the performance, it is desirable to use any high order PRML system or high rate code. Our proposed two-track recording method increases the coding rate over 1, and contributes to decrease these degradation effects. The recording code in our system adopts a turbo code which provides a substantial near-ML performance by the suboptimum iterative decoding algorithm. In this paper, the turbo coded class four partial response (PR4) systems using the rate 4/6, 8/10 and 16/18 codes for high density two track digital magnetic recording are proposed. The error rate performance of the proposed system is obtained by computer simulation taking account of the partial erasure, which is one of nonlinear distortions at high densities. The performance of our system is compared with that of the conventional NRZ coded PR4ML system. The result shows that the proposed system is hardly affected by partial erasure and keeps good performance in high density recording. In especial, the proposed system using the rate 16/18 turbo code can achieve a bit error rate of 10-4 with SNR of approximately 12.2 dB less than the conventional NRZ coded PR4ML systems at a normalized linear density of 3.

We propose a traffic measurement system which uses trap and polling methods. To obtain its performance we consider a queueing model with a single server and evaluate a packet delay. In our multi-cast traffic, packets are modeled as a batch with a batch size distribution {gk}. The batch arrival process is observed as two processes on the basis of batch size. For a batch whose size is more than or equal to a threshold L, the batch will be trapped by our traffic measurement system (in queueing model, it will enter a queue immediately after its arrival). For a batch whose size is less than L, it will be observed at a polling cycle T (in queueing model, it will be temporarily stored in a buffer and all these small batches will be cyclically noticed with a cycle T). We analyze this queueing model by a diffusion approximation and compare the packet delay observed by our traffic measurement system with the L=1 original batch arrival model. Evaluating the results of the diffusion approximation, we illustrate that our traffic measurement system has functions not only to give an accurate estimation of the mean waiting time but also reduce the number of measurements by choosing appropriate parameters L and T.

To realize S-band mobile satellite communications and broadcasting systems, the onboard mission system and equipment were designed for the Japanese Engineering Test Satellite VIII. The system performs voice communications using handheld terminals, high-speed data communications, and multimedia broadcasting through a geostationary satellite. To enhance system efficiency and flexibility, the onboard mission system features phased-array-fed reflector antennas with large antenna diameter and baseband switching through onboard processors. Configurations and performance of the subsystems and key onboard equipment, large deployable reflectors, feed arrays, beam forming networks and onboard processors, are presented. The S-band mobile systems and onboard equipment will be verified through in-orbit experiments scheduled for 2002.

Effective wavelets to solve electromagnetic integral equations are proposed. It is based on the same construction procedure as Daubechies wavelets but with mix-phase to obtain maximum sparsity of moment matrix. These new wavelets are proved to have excellent performance in non-zero elements reduction in comparison with minimum-phase wavelet transform (WT). If further sparsity is concerned, wavelet packet (WP) transform can be applied but increases the computational complexity. In some cases, the capability of non-zero elements reduction by this new wavelets even better than WP with minimum-phase wavelets and with less computational efforts. Numerical experiments demonstrate the validity and effectiveness of the new wavelets.

In this paper, fast algorithms for the CMA (constant modulus algorithm), which is one of the widely used algorithms for blind equalizationi are presented. We propose the FBCMA (frequency domain block CMA) which takes advantage of fast linear convolution in the DFT domain by using the overlap save method. For the FBCMA, a nonlinear error function in the frequency domain is derived using Parseval's relation. Also, an adaptive algorithm in the DFT domain is introduced to adjust the frequency domain filter coefficients. For a block size and filter length of N, the multiplications required for the conventional CMA and proposed FBCMA are on the order of O(N2) and O(N log N), respectively.

The relationships between lattice orientation of the electron-beam evaporated MgO layer used as protecting layer for ac plasma displays (ac-PDPs) and the discharge characteristics of color ac-PDPs were investigated by the measurements of ion-induced secondary electron emission. It is proved that values of γi for MgO are large in the order of (220) orientation, (200) orientation, and (111) orientation, that is, γi(220) > γi(200) > γi(111). The values of φ for different lattice orientation are obtained by the measurements of thermionic emission and photo emission. The aging measurements for testing panels with the different lattice orientation of MgO layer revealed that performance of those panels are excellent in the order of (220), (200), and (111). In particular, luminance and luminous efficiency become larger in the order of (220), (200), and (111). It is pointed out that the degree of longevity, sustaining voltage, and memory margin for ac-PDPs with protecting materials as MgO are estimated by the measurements of γi.

Recently, optical loss increases have appeared at high temperatures in some of the optical drop cables, introduced for FTTH field experiments. Optical drop cable is installed from homes to aerial facilities, and consists of an optical fiber cable part and a self-supporting wire part. Fiber micro-bending is caused by cable sheath buckling in high temperature environments when the cable is bent with the cable part inside. Moreover, adhesion between the steel reinforcing wires and the cable sheath is effective in preventing this fiber micro-bending, which induces loss increases. This paper also shows the most suitable range of adhesive ability in terms of both practical construction and environment.

In this paper, we state some noteworthy facts in connection with simplification of the BCJR algorithm using the bidirectional Viterbi algorithm (BIVA). That is, we clarify the necessity of metric correction in the case that the BIVA is applied to reliability estimation, where information symbols uj obey non-uniform probability distributions.

In pattern recognition using neural networks, it is very difficult for researchers or users to design optimal neural network architecture for a specific task. It is possible for any kinds of neural network architectures to obtain a certain measure of recognition ratio. It is, however, difficult to get an optimal neural network architecture for a specific task analytically in the recognition ratio and effectiveness of training. In this paper, an evolutional method of training and designing feedforward neural networks is proposed. In the proposed method, a neural network is defined as one individual and neural networks whose architectures are same as one species. These networks are evaluated by normalized M. S. E. (Mean Square Error) which presents a performance of a network for training patterns. Then, their architectures evolve according to an evolution rule proposed here. Architectures of neural networks, in other words, species, are evaluated by another measurement of criteria compared with the criteria of individuals. The criteria assess the most superior individual in the species and the speed of evolution of the species. The species are increased or decreased in population size according to the criteria. The evolution rule generates a little bit different architectures of neural network from superior species. The proposed method, therefore, can generate variety of architectures of neural networks. The designing and training neural networks which performs simple 3 3 and 4 4 pixels which include vertical, horizontal and oblique lines classifications and Handwritten KATAKANA recognitions are presented. The efficiency of proposed method is also discussed.

In this paper, we present simulation algorithms among enhanced mesh models. The enhanced mesh models here include reconfigurable mesh and mesh with multiple broadcasting. A reconfigurable mesh (RM) is a processor array that consists of processors arranged to a 2-dimensional grid with a reconfigurable bus system. The bus system can be used to dynamically obtain various interconnection patterns among the processors during the execution of programs. A horizontal-vertical RM (HV-RM) is obtained from the general RM model, by restricting the network topology it can take to the ones in which each bus segment must be along row or column. A mesh with multiple broadcasting (MWMB) is an enhanced mesh, which has additional broadcasting buses endowed to every row and column. We present two algorithms:1) an algorithm that simulates a HV-RM of size nn time-optimally in θ(n) time on a MWMB of size nn, and 2) an algorithm that simulates a RM of size nn in θ(log2 n) time on a HV-RM of size nn. Both algorithms use a constant number of storage in each processor. Furthermore, we show that a RM of size nn can be simulated in θ((n/m)2 log n log m) time on a HV-RM of size mm, in θ ((n/m)2 m log n log m) time on a MWMB of size mm (m < n). These simulations use θ((n/m)2) storage in each processor, which is optimal.

This paper reports on the development of an eyeglass-type infrared-controlled telephone communication interface for the disabled. This system is comprised of four major components: A) a headset; B) an infrared transmitting module; C) an infrared receiving/signal-processing module; and D) a main controller, the Intel-8951 microprocessor. The headset with a tongue-touch panel, a wireless earphone, and a wireless microphone. The infrared transmitting module utilizes a tongue touch panel via tongue-touch circuitry which is converted to an infrared beam and a low power laser (<0.1 mW) beam. The infrared receiving/signal-processing module, receives the infrared beam and fine tunes the unstable infrared beam into standard pulses which are used as control signals. The main controller is responsible for detecting the input signals from the infrared receiving/signal-processing module and verifying these signals with the mapping table in its memory. After the signal is verified, it is released to control the keys of the telephone interface. This design concept was mainly based on the idea that the use of an infrared remote module fastened to the eyeglasses could allow the convenient control of the dialing motion on the keys of a telephone's dialing-pad which are all modified with infrared receiving/signal-processing modules. The disabled are competent for some of work, such as a telephone operator. The increase of opportunity to do a job for the disabled would help them live independently.

Dynamical theory of cellular automata on groups is developed. Main results are non-Euclidean extensions of Sato and Honda's results on the dynamics of Euclidean cellular automata. The notion of the period of a configuration is redefined in a more group theoretical way. The notion of a co-finite configuration substitutes the notion of a periodic configuration, where the new term is given to it to reflect and emphasize the importance of finiteness involved. With these extended or substituted notions, the relations among period preservablity, injectivity, and Poisson stability of parallel maps are established. Residually finite groups are shown to give a nice topological property that co-finite configurations are dense in the configuration space.

In this paper, we consider an integrated voice and data system over CDMA Slotted-ALOHA (CDMA S-ALOHA). We investigate its performance when multi-code CDMA (MC-CDMA) is applied as a multi-rate scheme to support users which require transmission with different bit rates. Two different classes of data users are transmitted together with voice. Performance measurement is obtained in respect of throughput for data and outage probability for voice. Moreover, we consider the Modified Channel Load Sensing Protocol (MCLSP) as a traffic control to improve the throughput of data. As a result, we show that the MC-CDMA technique is an effective one to obtain good throughput for data users at an acceptable voice outage probability. Furthermore, we show that with MCLSP, the throughput of data can be improved to reach a constant value even at a high offered load of data users.

Feature interaction detection determines whether interactions occur or not between the new and existing telecommunication services. Most of conventional detection methods on state transition model utilize an exhaustive search. The exhaustive search is fundamentally very powerful in the sense that all interactions are exactly detected. However, it may suffer from the state explosion problem due to the exponential growth of the number of states in the model when the number of users and the number of features increase. In order to cope with this problem, we propose a new detection method using a state reduction technique. By means of a symmetric relation, called permutation symmetry, we succeed in reducing the size of the model while preserving the necessary information for the interaction detection. Experimental evaluation shows that, for practical interaction detection with three users, the proposed method achieves about 80% reduction in space and time, and is more scalable than the conventional ones especially for the increase of the number of users in the service.

In this paper, we propose a preemptive priority handoff scheme for integrated voice/data cellular mobile systems. In our scheme, calls are divided into three different classes: handoff voice calls, originating voice calls, and data calls. In each cell of the system there is a queue only for data calls. Priority is given to handoff voice calls over the other two kinds of calls. That is, the right to preempt the service of data is given to a handoff voice call if on arrival it finds no idle channels. The interrupted data call returns to the queue. The system is modeled by a two-dimensional Markov chain. We apply the Successive Over-Relaxation (SOR) method to obtain the equilibrium state probabilities. Blocking and forced termination probabilities for voice calls are obtained. Moreover, average queue length and average transmission delay of data calls are evaluated. The results are compared with another handoff scheme for integrated voice/data cellular mobile systems where some numbers of channels are reserved for voice handoff calls. It is shown that, when the data traffic is not very light, the new scheme can provide lower blocking probability for originating voice calls, lower forced termination probability for ongoing voice calls, and shorter average queue length and less average transmission delay for data calls.