The trench-gate type high-voltage (HV) MOSFET is one of the variants of HV-MOSFET, typically with its utility segments lying on a larger power consumption domain, compared to planar HV-MOSFETs. In this work, the HiSIM_HV compact model, originally intended for planar LDMOSFETs, was adequately extended to accommodate trench-gate type HV-MOSFETs. The model formulation focuses on a closed-form description of the current path in the highly resistive drift region, specific to the trench-gate HV-MOSFETs. It is verified that the developed compact expression can capture the conductivity in the drift region, which varies with voltage bias and device technology such as trench width. The notable enhancement of current drivability can be accounted for by the electrostatic control exerted by the trench gate within the framework of this model.

In LDMOS devices for high-voltage applications, there appears a notable fingerprint of current-voltage characteristics known as soft breakdown. Its mechanism is analyzed and modeled on LDMOS devices where a high resistive drift region exists. This analysis has revealed that the softness of breakdown, known as the expansion effect, withholding a run-away of current, is contributed by the flux of holes underneath the gate-overlap region originated by impact-ionization. The mechanism of the expansion effect is modeled and implemented into the compact model HiSIM_HV for circuit simulation. A good agreement between simulated characteristics and 2D-device simulation results is verified.

This report focuses on an optimization scheme of advanced MOSFETs for designing CMOS circuits with high power efficiency. For this purpose the physics-based compact model HiSIM2 is applied so that the relationship between device and circuit characteristics can be investigated properly. It is demonstrated that the short-channel effect, which is usually measured by the threshold-voltage shift relative to long-channel MOSFETs, provides a consistent measure for device-performance degradation with reduced channel length. However, performance degradations of CMOS circuits such as the power loss cannot be predicted by the threshold-voltage shift alone. Here, the subthreshold swing is identified as an additional important measure for power-efficient CMOS circuit design. The increase of the subthreshold swing is verified to become obvious when the threshold-voltage shift is larger than 0.15V.

We analyze the carrier dynamics in MOSFETs under low-voltage operation. For this purpose the displacement (charging/discharging) current, induced during switching operations is studied experimentally and theoretically for a 90 nm CMOS technology. It is found that the experimental transient characteristics can only be well reproduced in the circuit simulation of low voltage applications by considering the carrier-transit delay in the compact MOSFET model. Long carrier transit delay under the low voltage switching-on operation results in long duration of the displacement current flow. On the other hand, the switching-off characteristics are independent of the bias condition.

A predictive compact model of p-MOSFET negative bias temperature instability (NBTI) degradation for circuit simulation is reported with unified description of the interface-state-generation and hole-trapping mechanisms. It is found that the hole-trapping is responsible for the initial stage of the stress degradation, and the interface-state generation dominates the degradation afterwards, especially under high stress conditions. The predictive compact model with 8 parameters enables to reproduce the measurement results of the NBTI degradation under a wide range of stress bias conditions. Finally, the developed NBTI model is implemented into the compact MOSFET model HiSIM for circuit degradation simiulation.

Frequency dependent properties of accumulation-mode MOS varactors, which are key elements in many RF circuits, are dominated by Non-Quasi-Static (NQS) effects in the carrier transport. The circuit performances containing MOS varactors can hardly be reproduced without considering the NQS effect in MOS-varactor models. For the LC-VCO circuit as an example it is verified that frequency-tuning range and oscillation amplitude can be overestimated by over 20% and more than a factor 2, respectively, without inclusion of the NQS effect.