Novel thermopiles based on modulation doped AlGaAs/InGaAs, AlGaN/GaN, and ZnMgO/ZnO heterostructures are proposed and designed for the first time, for uncooled infrared image sensor application. These devices are expected to offer high performances due to both the superior Seebeck coefficient and the excellently high mobility of 2DEG and 2DHG due to high purity channel layers at the heterojunction interface. The AlGaAs/InGaAs thermopile has the figure-of-merit Z of as large as 1.110-2/K (ZT = 3.3 over unity at T = 300 K), and can be realized with a high responsivity R of 15,200 V/W and a high detectivity D* of 1.8109 cmHz1/2/W with uncooled low-cost potentiality. The AlGaN/GaN and the ZnMgO/ZnO thermopiles have the advantages of high sheet carrier concentration due to their large polarization charge effects (spontaneous and piezo polarization charges) as well as of a high Seebeck coefficient due to their strong phonon-drag effect. The high speed response time τ of 0.9 ms with AlGaN/GaN, and also the lower cost with ZnMgO/ZnO thermopiles can be realized. The modulation-doped heterostructure thermopiles presented here are expected to be used for uncooled infrared image sensor applications, and for monolithic integrations with other photon detectors such as InGaAs, GaN, and ZnO PiN photodiodes, as well as HEMT functional integrated circuit devices.

The use of the in-phase synthetic method is proposed for antenna calibration using the three-antenna method (TAM) in order to make the TAM applicable even in a semi-anechoic chamber (SAC) or on an open-area test site. Suitable antenna arrangements are theoretically investigated for this improved calibration method. Experimental analyses demonstrate that the in-phase synthetic method can remarkably reduce unwanted effects of the ground-reflected wave. Therefore, even on a metal ground plane, the proposed TAM with the in-phase synthetic method can yield an accurate actual gain of a double ridged guide antenna at frequencies from 4 GHz to 14 GHz with differences of +0.16/-0.37 dB from the results of the conventional TAM performed in an fully anechoic room (FAR).

There has been much interest in a spatial query which acquires sensor readings from sensor nodes inside specified geographical area of interests. A centralized approach performs the spatial query at a server after acquiring all sensor readings. However, it incurs high wireless transmission cost in accessing all sensor nodes. Therefore, various in-network spatial search methods have been proposed, which focus on reducing the wireless transmission cost. However, the in-network methods sometimes incur unnecessary wireless transmissions because of dead space, which is spatially indexed but does not contain real data. In this paper, we propose a hybrid spatial query processing algorithm which removes the unnecessary wireless transmissions. The main idea of the hybrid algorithm is to find results of a spatial query at a server in advance and use the results in removing the unnecessary wireless transmissions at a sensor network. We compare the in-network method through several experiments and clarify our algorithm's remarkable features.

The robust reduced order observer for a class of discrete-time Lipschitz nonlinear systems with external disturbance is proposed. It is shown that the proposed observer design can suppress the effect on the estimation error of external disturbance up to the prescribed level. Also, linear matrix inequalities are used to represent sufficient conditions on the existence of the proposed observer. Moreover, the maximum admissible Lipschitz constant of the proposed design is obtained for a given disturbance attenuation level. Finally, an illustrative example is given to verify the effectiveness of the proposed design.

The large signal performance and model for GaN FET devices was evaluated with DC, S-parameters, and large signal measurements. The large signal model was extended with bias and temperature dependence of access resistances, modified capacitance and charge equations, as well as breakdown models. The model was implemented in a commercial CAD tool and exhibits good overall accuracy.

A digital spiking neuron is a wired system of shift registers that can generate spike-trains having various spike patterns by adjusting the wiring pattern between the registers. Inspired by the ultra-wideband impulse radio, a novel theoretical synthesis method of the neuron for application to spike-pattern division multiplex communications in an artificial pulse-coupled neural network is presented. Also, a novel heuristic learning algorithm of the neuron for realization of better communication performances is presented. In addition, fundamental comparisons to existing impulse radio sequence design methods are given.

The construction of annotated corpora requires considerable manual effort. This paper presents a pragmatic method to minimize human intervention for the construction of Korean part-of-speech (POS) tagged corpus. Instead of focusing on improving the performance of conventional automatic POS taggers, we devise a discriminative POS tagger which can selectively produce either a single analysis or multiple analyses based on the tagging reliability. The proposed approach uses two decision rules to judge the tagging reliability. Experimental results show that the proposed approach can effectively control the quality of corpus and the amount of manual annotation by the threshold value of the rule.

We have developed a new computer-aided diagnostic system for differentiating oral borderline malignancies in hematoxylin-eosin stained microscopic images. Epithelial dysplasia and carcinoma in-situ (CIS) of oral mucosa are two different borderline grades similar to each other, and it is difficult to distinguish between them. A new image processing and analysis method has been applied to a variety of histopathological features and shows the possibility for differentiating the oral cancer borderline grades automatically. The method is based on comparing the drop-shape similarity level in a particular manually selected pair of neighboring rete ridges. It was found that the considered similarity level in dysplasia was higher than those in epithelial CIS, of which pathological diagnoses were conventionally made by pathologists. The developed image processing method showed a good promise for the computer-aided pathological assessment of oral borderline malignancy differentiation in clinical practice.

The influence of noise is an important problem on image acquisition and transmission stages. The traditional image denoising approaches only analyzing the pixels of local region with a moving window, which calculated by neighbor pixels to denoise. Recently, this research has been focused on the transform domain and feature space. Compare with the traditional approaches, the global multi-scale analyzing and unchangeable noise distribution is the advantage. Apparently, the estimation based methods can be used in transform domain and get better effect. This paper proposed a new approach to image denoising in orthonormal wavelet domain. In this paper, we adopt Stein's unbiased risk estimate (SURE) based method to denoise the low-frequency bands and the feature patches distance constraint (FPDC) method also be proposed to estimate the noise free bands in Wavelet domain. The key point is that how to divide the lower frequency sub-bands and the higher frequency sub-bands, and do interscale SURE and intrascale FPDC, respectively. We compared our denoising method with some well-known and new denoising algorithms, the experimental results show that the proposed method can give better performance and keep more detail information in most objective and subjective criteria than other methods.

We investigated the effect of a high-speed power line communication (PLC) signal induced into a very high-speed digital subscriber line (VDSL) system by conductive coupling based on a network model. Four electronic devices with AC mains and telecommunication ports were modeled using a 4-port network, and the parameters of the network were obtained from measuring impedance and transmission loss. We evaluated the decoupling factor from the mains port to the telecommunication port of a VDSL modem using these parameters for the four electric and electronic devices. The results indicate that the mean value of the decoupling factor for the differential and common mode signals were more than 88 and 62 dB, respectively, in the frequency range of a PLC system. Taking the following parameters into consideration; decoupling factor Ld, the average transmission signal powers of VDSL and PLC, desired and undesired (DU) ratio, and transmission loss of a typical 300-m-long indoor telecommunication line, the VDSL system cannot be disturbed by the PLC signal induced into the VDSL modem from the AC mains port in normal installation.

This work presents a statistical model for the radiated susceptibility (RS) of an unshielded twisted-wire pair (TWP) running above ground, illuminated by a random electromagnetic field. The incident field is modeled as a superposition of elemental plane waves with random angular density, phase, and polarization. The statistical properties of both the differential-mode (DM) and the common-mode (CM) noise voltages induced across the terminal loads are derived and discussed.

This paper treats a band-broadening design technique of a dual-band branch-line coupler with matching networks composed of an impedance step and a short-circuited stub based on the equivalent admittance approach. By replacing each right-handed transmission line (RH-TL) with a composite right/left-handed transmission line (CRLH-TL), very flat couplings over a relative bandwidth of about 10% can be obtained at two arbitrary operating frequencies in comparison with previous CRLH-TLs branch-line couplers. Furthermore, by adding periodical open-circuited stubs into RH-TLs of the designed CRLH-TLs branch-line coupler with matching networks, the entire size of the coupler can be reduced to about 50%. Verification of these band-broadening and size-reduction design techniques can be also shown by an electromagnetic simulation and experiment.

Orthogonal frequency division multiplexing (OFDM) signals have high peak-to-average power ratio (PAPR) and cause large nonlinear distortions in power amplifiers (PAs). Memory effects in PAs also become no longer ignorable for the wide bandwidth of OFDM signals. Digital baseband predistorter is a highly efficient technique to compensate the nonlinear distortions. But it usually has many parameters and takes long time to converge. This paper presents a novel predistorter design using a set of orthogonal polynomials to increase the convergence speed and the compensation quality. Because OFDM signals are approximately complex Gaussian distributed, the complex Hermite polynomials which have a closed-form expression can be used as a set of orthogonal polynomials for OFDM signals. A differential envelope model is adopted in the predistorter design to compensate nonlinear PAs with memory effects. This model is superior to other predistorter models in parameter number to calculate. We inspect the proposed predistorter performance by using an OFDM signal referred to the IEEE 802.11a WLAN standard. Simulation results show that the proposed predistorter is efficient in compensating memory PAs. It is also demonstrated that the proposal acquires a faster convergence speed and a better compensation effect than conventional predistorters.

A method to realize the fine frequency-tuning steps using tiny capacitors instead of Metal-Insulator-Metal (MIM) capacitors is proposed for a digitally controlled oscillator (DCO). The tiny capacitors are realized by the coplanar transmission lines which are arranged unsymmetrical in a 6 metal layers (M6) foundry of 0.18 µm CMOS technology. These transmission line based capacitors are designed by using electro-magnetic field simulator, and co-designed by using SPICE simulator. Finally, these capacitors are employed to design 15 bit DCO and fabricated the proposed DCO in 0.18 µm CMOS technology, and tested. The measured phase noise of DCO was -118.3 dBc/Hz (@1 MHz offset frequency), and the oscillating frequency tuned from 4.86 GHz to 5.36 GHz in the minimum frequency-tuning step of 18 kHz.

The use of image contrast enhancement has become increasingly essential due to the need to better show the visual information contained within the image for all vision-based systems. This has lead to motivation for the design of a powerful and accurate automatic contrast enhancement for a digital image. Histogram equalization is the most commonly used contrast enhancement method. However, the conventional histogram equalization methods usually result in excessive contrast enhancement, which causes the unnatural look and visual artifacts of the processed image. In this paper, we propose a novel histogram equalization method using the automatic histogram separation along with the piecewise transformed function. The contrast enhancement results of the proposed method were not only analyzed through qualitative visual inspection and for quantitative accuracy, but are also compared to the results of other state-of-the-art methods.

Virtual Private Network (VPN) is a cost effective method to provide integrated multimedia services. Usually heterogeneous multimedia data can be categorized into different types according to the required Quality of Service (QoS). Therefore, VPN should support the prioritization among different services. In order to support multiple types of services with different QoS requirements, efficient bandwidth management algorithms are important issues. In this paper, I employ the Kalai-Smorodinsky Bargaining Solution (KSBS) for the development of an adaptive bandwidth adjustment algorithm. In addition, to effectively manage the bandwidth in VPNs, the proposed control paradigm is realized in a dynamic online approach, which is practical for real network operations. The simulations show that the proposed scheme can significantly improve the system performances.

In order to determine exposure compliance with the electromagnetic fields from a base station's antenna in the far-field region, we should calculate the spatially averaged field value in a defined space. This value is calculated based on the measured value obtained at several points within the restricted space. According to the ICNIRP guidelines, at each point in the space, the reference levels are averaged over any 6 min (from 100 kHz to 10 GHz) for the general public. Therefore, the more points we use, the longer the measurement time becomes. For practical application, it is very advantageous to spend less time for measurement. In this paper, we analyzed the difference of average values between 6 min and lesser periods and compared it with the standard uncertainty for measurement drift. Based on the standard deviation from the 6 min averaging value, the proposed minimum averaging time is 1 min.

The construction of EM absorber and frequency selective shielding has been investigated by using two dimensional metal fiber array (MFA) composites. The MFA composite shows a resonant type frequency dispersion in the complex relative permittivity spectra (εr = εr' - jεr") having a negative εr' region. The frequency characteristics of the conventional ferrite-rubber EM absorber can be improved by combining with the negative permittivity property of the MFA composite. A frequency selective shielding can be achieved by the evanescent EM wave propagation in the layered MFA composite structure.

Hypergraphs drawn in the subset standard are useful to represent group relationships using topographic characteristics such as intersection, exclusion and enclosing. However, they present cluttering when dealing with a moderately high number of nodes (more than 20) and large hyperedges (connecting more than 10 nodes, with three or more overlapping nodes). At this complexity level, a study of the visual encoding of hypergraphs is required in order to reduce cluttering and increase the understanding of larger sets. Here we present a graph model and a visual design that help in the visualization of group relationships represented by hypergraphs. This is done by the use of superimposed visualization layers with different abstraction levels and the help of interaction and navigation through the display.

Universal Slepian-Wolf coding for parametric general sources is considered. Our main result shows that under mild conditions on the family of sources, there exists a universal decoder that attains asymptotically the same random-coding error exponent as the maximum-likelihood decoder.