This paper presents novel phase-continuous frequency hopping (FH) control for a direct frequency synthesizer (DFS) using a quadrature mixer driven by two direct digital synthesizers (DDSs). To achieve wideband FH in both of the lower and the upper sidebands of a local frequency in a quadrature mixer, the proposed DFS decreases or increases the phase of DDS output signals corresponding to frequency offset from a local frequency of the quadrature mixer. To realize phase decrement, the proposed method adds a complement number in a phase accumulator of a DDS, while a conventional DDS does not use phase decrement but uses a switchable combiner. In addition, as the phase accumulator output changes continuously by summing phase increment, the proposed method always assures phase continuity of a DFS output signal, which ends up suppressing sidelobe level of frequency hopped signals. The calculation and measurement results indicate that a sidelobe of a signal spectrum using the proposed phase continuous method is approximately 10 dB better than that using a conventional phase discontinuous method.

In this letter, we focus on non-pilot-symbol assisted integer frequency offset estimation for multicarrier orthogonal frequency division multiplexing (OFDM) systems. We introduce a frequency offset estimator that is based on the guard interval (GI) present in OFDM signals. We show by simulation that the frequency offset estimator can accurately estimate the frequency misalignment at the sacrifice of limited estimation range.

This paper proposes a method to determine a single frequency for interconnect RL extraction. Resistance and inductance of interconnects depend on frequency, and hence the extraction frequency strongly affects the modeling accuracy of interconnects. The proposed method determines an extraction frequency based on the transfer characteristic of interconnects. By choosing the frequency where the transfer characteristic becomes maximum, the extracted RL values achieve the accurate modeling of the waveform. Experimental results show that the proposed method provides accurate transition waveforms over various interconnect topologies.

This paper presents a numerical analysis of reverse link capacity by obtaining a closed form of ICI (InterCell Interference) over OFDM (Orthogonal Frequency Division Multiplexing)-based broadband wireless networks. In the analysis, shadowing factors are taken into account for determining the home BS (Base Station) of each MS (Mobile Station) over multicell environments. Under the consideration, a more accurate analysis of link capacity can be performed compared to Gilhousen's approximation. In the numerical results, it turns out that the actual interference is lower than Gilhousen's approximation with a decrease of around 20% in the interference.

Frequency-domain equalization (FDE) based on the minimum mean square error (MMSE) criterion can replace the conventional rake combining while offering significantly improved bit error rate (BER) performance for the downlink DS-CDMA in a frequency-selective fading channel. However, the presence of residual inter-chip-inference (ICI) after FDE produces orthogonality distortion among the spreading codes and the BER performance degrades as the level of multiplexing increases. In this paper, we propose a joint MMSE frequency-domain equalization (FDE) and ICI cancellation to improve the BER performance of the DS-CDMA downlink. In the proposed scheme, the residual ICI replica in the frequency-domain is generated and subtracted from each frequency component of the received signal after MMSE-FDE. The MMSE weight at each iteration is derived taking into account the residual ICI. The effect of the proposed ICI cancellation scheme is confirmed by computer simulation.

Frequency-variation method (FVM), reported in [1], was further studied for simultaneously measuring the both complex permittivity and complex permeability by intentionally changing the test frequency to obtain different reflections. An enhanced coaxial-probe-based in-situ measurement system has been established. The spectral domain full-wave model is derived to take place of the quasi-static one. A novel coaxial probe is designed so that the one-port calibration could be performed with Agilent-supplied precise cal-kit instead of the liquid standard. Criterions for a right order of the interpolation polynomial used to approximate the frequency-dependent EM parameters; measures to reduce the residual mismatch errors and random error in reflection measurements and to suppress the ambiguities in solving the transcendent equation system were experimentally studied to resolve the problems and improve the accuracy in dispersive absorbing materials' test. Several typical dispersive absorbing coatings have been tested via FVM. The good comparison between the measured results and reference ones validate the feasibility of the proposed improved technique.

Diversity transmission using space-time block coding (STBC) shows a degraded performance in frequency selective fading (FSF) channel. In this paper, assuming the CSI is unknown at both transmitter and receiver while a pilot signal is available during the training period, we propose a MIMO transmission scheme using STBC by adopting subband adaptive array (SBAA) processing. The receive signal is converted into the frequency-domain and adaptive processing is done at each subband. A novel construction of SBAA is introduced to process received signal based on STBC. Simulation results demonstrate that the proposed scheme has a better performance compare to conventional STBC, and has a better performance and less computational load compare to STBC-TDLAA.

In this letter, a blind frequency offset estimation algorithm is proposed for OFDM systems. The proposed method exploits the intrinsic phase shift between neighboring samples in a single OFDM symbol, incurred by a frequency offset. The proposed algorithm minimizes a novel cost function, which is the squared error of the candidate frequency offset compensated signals from two different observation windows. Also, the solution of the proposed algorithm is given by an explicit equation, which does not require any iterative calculation. It is shown that the performance of the proposed method is better than those of the conventional methods, especially in the presence of multipath channels. This is due to the fact that the proposed method is insensitive to inter-symbol interference (ISI).

Orthogonal Frequency Division Multiplexing (OFDM) systems are very sensitive to the frequency offset of the local oscillator at the receiver while the symbol timing offset can be absorbed in the guard interval. For the same reason, estimation of the frequency characteristics, needed for OFDM to be adapted to the frequency selective fading, can only be carried out conventionally after the frequency offset has been compensated. And accurate estimation of large frequency offset certainly requires high precision estimate of the frequency characteristics. In this paper, we propose a new joint estimation method of the frequency offset and the channel frequency response using an Expectation-Maximization (EM) algorithm for OFDM systems. The proposed algorithm overcomes the limitation of the thus far proposed algorithm. By computer simulations, we show the proposed algorithm provides estimation accuracy close to its lower bound in a wide range of the frequency offset.

Multiple-input multiple-output (MIMO) systems using eigenbeam space division multiplexing (E-SDM) perform well and have increased capacities compared with those using conventional space division multiplexing (SDM). However, channel state information (CSI) is required at a transmitter, and the performance of E-SDM systems depends much on the accuracy of the CSI at a transmitter and a receiver. In time-varying fading environments, the channel change between the transmit weight determination time and the actual data transmission time causes the system performance to degrade. To compensate for the channel error, a linear extrapolation method has been proposed for a time division duplexing system. Unfortunately, the system performance still deteriorates as the maximum Doppler frequency increases. Here, two new techniques of channel extrapolation are proposed. One is second order extrapolation, and the other is exponential extrapolation. Also, we propose maximum Doppler frequency estimation methods for exponential extrapolation. Simulation results for 4tx 4rx MIMO systems showed that using the proposed techniques, E-SDM system performs better in a higher Doppler frequency region.

This paper discusses the on-line frequency identification problem for a measured sinusoidal signal by using the adaptive method and filter theory. The proposed method is based on an identity between the sinusoidal signal and its second order derivative. For a set of chosen parameters, the proposed method is robust to the initial phase, the amplitude, and the frequency in a wide range. The convergence rate can be adjusted by the chosen parameters. The estimation error mainly depends on the frequency of the sinusoid, the measurement noise and a key design parameter.

In this paper, we compare two signal designs for uplink quasi-synchronous code division multiple access (CDMA) channels in order to optimize the trade-off between bandwidth efficiency and power efficiency. The design we call band-limited DS/CDMA design, is based on the time-domain assignment of Gold sequences, just as in the ordinary DS/CDMA, but with band-constrained cyclic chip interpolation functions, which is unlike the ordinary DS/CDMA. The other design, MC/CDMA design, is based on frequency-domain assignment of the sequences, as in the ordinary MC/CDMA. In both designs, we assume insertion of guard intervals at the transmitter and frequency-domain processing in reception. Assuming quasi-synchronous arrival of CDMA signals at the CDMA base station and FFT in the effective symbol interval, the intersymbol interference is evaded in both designs. First we identified the signal parameters that optimize bandwidth efficiency in each of the band-limited DS design and MC design. Second, we clarified the signal parameters that optimize the power efficiency as functions of frequency efficiency in each of the two designs. Finally, we derived and compared the trade-off between the bandwidth efficiency and power efficiency of band-limited DS and MC designs. We found a superiority of band-limited DS design over MC design with respect to the optimized trade-off.

The purpose of this research is to propose an effective color metric which can predict the perceptual image quality for Retinex method. In this paper, we first give a brief introduction of three kinds of typical single Retinex methods to improve the color reproduction. And then, we state the process for obtaining the observer rating value from the subjective evaluation experiment performed under the sRGB illumination condition. Next, we introduce the S-CIELAB metric and propose a new metric on the basis of S-CIELAB metric that considers the gazing information. The average S-CIELAB color differences with and without the consideration of gazing information were calculated as the objective image quality measures. The correlations between the observer rating values and the objective image quality measures were calculated. The result shows that all of the average S-CIELAB color differences based on the gazing information are better correlated to the observer rating value than the average S-CIELAB color difference over the whole area. The average S-CIELAB color difference weighted by the gazing frequency over the gazing area shows the strong correlation with the observer rating value.

In the reverse link of orthogonal frequency division multiplexing (OFDM)/ space division multiple access (SDMA) systems, each receive antenna of a base station receives a multiplexed version of signals transmitted from users, where the transmitted signals have individual amounts of frequency offset. Therefore, a frequency offset compensation scheme which is different from those used in general OFDM systems is required. For this requirement, frequency offset compensation schemes using the feedback transmission from the base station to user terminals have been proposed for multiuser OFDM systems. These schemes work with good precision when the feedback information is correct and is transmitted without errors. However, when the offset information is incorrectly received at user terminals, the frequency offset is not accurately compensated for. In OFDM/SDMA systems, one user is enough for causing inter-carrier interference to all users. Therefore, a frequency offset compensation scheme without feedback transmission is sometimes preferable. In this paper, we propose a frequency offset compensation scheme without feedback transmission. To compensate for frequency offset in every transmitted signal, the multiplexed received signals must be separated into each user's component before the offset compensation. Thus, we adopt the principle of the parallel interference cancellation (PIC). By employing PIC, the received signals can be separated before the offset compensation. Thus, the frequency offset of every user's signal can be compensated for. Simulation results show the bit error rate performance of the proposed scheme attains almost the same as that of the conventional scheme using the feedback transmission without errors.

We introduce an extension of Golay complementary sequences in which, for each sequence, there exists another sequence such that the sum of aperiodic autocorrelation functions of these two sequences for a given multiple L-shift (L≥1) is zero except for the zero shift. We call these sequences multiple L-shift complementary sequences. It is well-known that the peak-to-average power ratio (PAPR) value of any Golay complementary sequence is less than or equal to 2. In this paper, we show that the PAPR of each multiple L-shift complementary sequence is less than or equal to 2L. We also discuss other properties of the sequences and consider their construction.

In this letter, we introduce frequency-domain space-time transmit diversity (STTD) encoding/decoding to orthogonal frequency division multiplexing combined with time division multiplexing (OFDM/TDM) on a frame-by-frame basis (i.e., over several concatenated OFDM signals in the frequency-domain) to achieve both spatial and frequency diversity gains and improve the bit error rate (BER) performance. The theoretical BER performance is evaluated by numerical computation using the derived conditional BER and confirmed by computer simulation.

In this letter, two types of blind adaptive frequency offset estimator for multicarrier code division multiple access systems are proposed that do not need any specific training sequence. It can not only accurately estimate the frequency offset, but also improve the revision capability and convergence rate. Several computer simulations confirm the effectiveness of the blind estimate approaches.

This letter proposes non-pilot-aided symbol timing and carrier frequency estimation methods in a multicarrier transmission system. To do this, multicarrier system uses a frequency diversity scheme over two consecutive data symbols with the combination of a cyclic time shift. Using the multicarrier signal equipped with frequency diversity, however, time and frequency are accurately estimated without any training symbol.

We present a novel precomputed radiance transfer method for efficient relighting under all-frequency environment illumination. Environment illumination is represented as a set of environment lights. Each environment light comprises a direction and an intensity. In a preprocessing step, the environment lights are clustered into several clusters, taking into account only the light directions. By experiment, we confirmed that the environment lights can be clustered into a much smaller number of clusters than their original number. Given any environment illumination, sampled as an environment map, an efficient relighting is then achieved by computing the radiance using the precomputed clusters. The proposed method enables relighting under very high-resolution environment illumination. In addition, unlike previous approaches, the proposed method can efficiently perform relighting when some regions of the given environment illumination change.

In direct sequence code division multiple access (DS-CDMA), variable rate transmission can be realized by simply changing the spreading factor SF for the given chip rate. In a frequency-selective fading channel, the transmission performance can be improved by using rake combining. However, when a very low SF is used for achieving a high transmission rate, error floor is produced due to insufficient suppression of inter-chip interference (ICI). In this paper, decision feedback chip-level maximum likelihood detection (DF-CMLD) is proposed that can suppress the ICI. An upper-bound for the conditional bit error rate (BER) is theoretically derived for the given spreading sequence and path gains. The theoretical average BER performance is numerically evaluated by Monte-Carlo numerical computation using the derived conditional BER. The numerical computation results are confirmed by computer simulation of DS-CDMA signal transmission with DF-CMLD.