The multiple-input-multiple-output (MIMO) Gaussian wireless network with K users and an intermediate relay is investigated. In this network, each user with available local channel state information (CSI) intends to convey a multicast message to all other users while receiving all messages from other users via the relay. This model is termed the MIMO K-way relay channel with distributed CSI. For this channel, the sum capacity is shown as MK/(K-1)log(SNR)+o(SNR) where each user and the relay is equipped with M antennas. Achievability is based on the signal space alignment strategy with a K-1 time slot extension. A most general case is then considered, in which each user intends to recover all messages required within T time slots. We provide an improved scheme called fractional signal space alignment which achieves MK/(K-1) degrees of freedom in the general case and the feasibility condition is also explored.

This paper proposes a novel approach for implementing an ultra-low-power voltage reference using the structure of self-cascode MOSFET, operating in the subthreshold region with a self-biased body effect. The difference between the two gate-source voltages in the structure enables the voltage reference circuit to produce a low output voltage below the threshold voltage. The circuit is designed with only MOSFETs and fabricated in standard 0.18-µm CMOS technology. Measurements show that the reference voltage is about 107.5 mV, and the temperature coefficient is about 40 ppm/, at a range from -20 to 80. The voltage line sensitivity is 0.017%/V. The minimum supply voltage is 0.85 V, and the supply current is approximately 24 nA at 80. The occupied chip area is around 0.028 mm2.

This paper proposes a reduced-complexity multiband multiple-input multiple-output (MIMO) receiver that can be used in cognitive radios. The proposed receiver uses heterodyne reception implemented with a wide-passband band-pass filter in the radio frequency (RF) stage. When an RF Hilbert transformer is utilized in the receiver, image-band interference occurs because of the transformer's imperfections. Thus, the imperfection of the Hilbert transformer is corrected in the intermediate frequency (IF) stage to reduce the hardware complexity. First, the proposed receiver estimates the channel impulse response in the presence of the strong image-band interference signals. Next, the coefficients are calculated for the correction of the imperfection at the IF stage, and are fed back to the IF stage through a feedback loop. However, the imperfection caused by the digital-to-analog (D/A) converter and the baseband amplifier in the feedback loop corrupts the coefficients on the way back to the IF stage. Therefore, the proposed receiver corrects the imperfection of the analog devices in the feedback loop. The performance of the proposed receiver is verified by using computer simulations. The proposed receiver can maintain its performance even in the presence of strong image-band interference signals and imperfection of the analog devices in the feedback loop. In addition, this paper also reveals the condition for rapid convergence.

This letter proposes a low-complexity soft-detection algorithm for modified dual-carrier modulation (MDCM) in WiMedia ultra-wideband (UWB) systems. In order to reduce the complexity of soft-output maximum-likelihood detection (soft-MLD), which gives the optimal performance for MDCM symbols, the proposed algorithm utilizes the following three methods: real/imaginary separation, multiplierless distance calculation, and candidate set reduction. Through these methods, the proposed algorithm reduces the complexity of soft-MLD by 97%, while preventing the deterioration of its optimality. The performance of the proposed algorithm is demonstrated by simulations of 640–1024 Mbps transmission modes of the latest Release 1.5 standard of the WiMedia UWB.

High phase noise is a common problem in ring oscillators. Continuous conduction of the transistor in an analog tuning method degrades the phase noise of ring oscillators. In this paper, a digital control tuning which completely switches the transistors on and off, and a 1/f noise reduction technique are employed to reduce the phase noise. A 14-bit control signal is employed to obtain a small frequency step and a wide tuning range. Furthermore, multiphase ring oscillator with a sub-feedback loop topology is used to obtain a stable quadrature outputs with even number of stages and to increase the output frequency. The measured DCO has a frequency tuning range from 554 MHz to 2.405 GHz. The power dissipation is 112 mW from 1.8 V power supply. The phase noise at 4 MHz offset and 2.4 GHz center frequency is -134.82 dBc/Hz. The FoM is -169.9 dBc/Hz which is a 6.3 dB improvement over the previous oscillator design.

In this letter, we propose a non-cooperative limited feedback precoding and subchannel selection scheme for non-reciprocal multiple-input multiple-output (MIMO) interference channels. At each iteration of the proposed scheme, each user updates its precoder selection for each subchannel and then chooses the predetermined number of subchannels in a distributed and non-cooperative way. We present simulation results to verify the performance of the proposed scheme.

A novel and compact electro-optic modulator implemented by a combination of a 12 multimode interference (MMI) coupler and an integrated Mach-Zehnder interferometer (MZI) modulator consisting of a microring and a phase modulator (PM) is presented and analyzed theoretically. It is shown that the proposed modulator offers both ultra-linearity and high output RF gain simultaneously, with no requirements for complicated and precise direct current (DC) control.

In this letter, we consider a control problem of a chain of integrators where there is an uncertain delay in the input and sensor noise. This is an output feedback control result over [10] in which a state feedback control is suggested. The several generalized features are: i) output feedback control is developed instead of full state feedback control, ii) uncertain delay in the input is allowed, iii) all states are derived to be arbitrarily small under uncertain sensor noise.

In this letter, we derive a lower bound on the diversity multiplexing tradeoff (DMT) in multiple-input multiple-output (MIMO) nonorthogonal amplify-and-forward (NAF) cooperative channels with resolution-constrained channel state feedback. It is shown that power control based on the feedback improves the DMT performance significantly in contrast to the no-feedback case. For instance, the maximum diversity increase is exponential in K with K-level feedback.

In this letter we propose a practical sensing-based opportunistic spectrum sharing scheme for cognitive radio (CR) downlink MIMO systems. Multi-antennas are exploited at the secondary transmitter to opportunistically access the primary spectrum and effectively achieve a balance between secondary throughput maximization and mitigation of interference probably caused to primary radio link. We first introduce a brief secondary frame structure, in which a sensing phase is exploited to estimate the effective interference channel. According to the sensing result and taking the interference caused by the primary link into account, we propose an enhanced signal-to-leakage-and-noise ratio (SLNR)-based precoding scheme for the secondary transmitter. Compared to conventional schemes where perfect knowledge of the channels over which the CR transmitter interferes with the primary receiver (PR) is assumed, our proposed scheme shows its superiority and simulation results validate this.

In this note, we introduce the integral term of system outputs into an output feedback controller for sampled-data linear systems with unknown disturbances. The proposed method does not use any observer and can prevent the high gain actions in control inputs. Provided the variation of the disturbance in the two consecutive sampling instances is not changed significantly, it is shown that system states and system outputs are finally constrained in small bounded regions, respectively. Simulation results support the theoretical developments.

This paper proposes non-coherent multiple-input multi-ple-output (MIMO) communication systems employing per transmit antenna differential mapping (PADM), which generates an independent differentially encoded sequence for each of the multiple transmit antennas by means of space-time coding and mapping. At a receiver, the proposed PADM employs adaptive maximum-likelihood detection (MLD). The features of PADM are as follows: 1) it has excellent tracking performance for fast time-varying fading channels, because it can detect transmitted data without needing channel state information (CSI); 2) it can be applied not only to transmit diversity (TD) but also to spatial multiplexing (SM). In this paper, we analyze the adaptive MLD based on pseudo matrix inversion and derive its metric for data detection. In order to satisfy requirements on multiple transmitted sequences for the adaptive MLD, this paper proposes a mapping rule for PADM. Next, this paper describes a receiver structure based on per-survivor processing (PSP), which can drastically reduce the complexity of adaptive MLD. Finally, computer simulations confirm that the proposed non-coherent MIMO communication systems employing PADM have excellent tracking capability for TD and SM on fast time-varying fading channels.

In this letter we design a new family of space-time block codes (STBC) for multi-input multi-output (MIMO) systems. The complex orthogonal STBC achieves full diversity and full transmission rate with fast maximum-likelihood decoding when only two transmit antennas are employed. By combining the Alamouti STBC and the multidimensional signal constellation rotation based on the cyclotomic number field, we construct cyclotomic orthogonal space-time block codes (COSTBCs) which can achieve full diversity and full rate for multiple transmit antennas. Theoretical analysis and simulation results demonstrate excellent performance of the proposed codes, while the decoding complexity is further reduced.

In this letter, we consider a control problem of a chain of integrators by output feedback under sensor noise. First, we introduce a measurement output feedback controller which drives all states and output of the considered system to arbitrarily small bounds. Then, we suggest a measurement output feedback controller coupled with a switching gain-scaling factor in order to improve the transient response and retain the same arbitrarily small ultimate bounds as well. An example is given to show the advantage of the proposed control method.

In this paper, we propose a soft-decoding near-ML MIMO demodulation scheme that achieves near optimal performance with fixed and low complexity. Exploiting the regular structure of bit-to-symbol mapping, the proposed scheme performs hard demodulation to find the first candidate symbol for each stream followed by selection of nearby candidate points such that at least one candidate exists for the computation of likelihood information of bit 0 and 1 without intermediate calculation of the Euclidean distance. This demodulation scheme enables an improvement in performance by guaranteeing the existence of candidates and a significant reduction in the number of distance calculations which is a major complexity burden. The performance is evaluated by computer simulation, and computational complexity is also assessed in terms of the number of complex multiplication.

In this letter, a post-detection signal to noise ratio (SNR) is considered for transmit antenna selection, when a sorted QR decomposition (SQRD) algorithm is used for signal detection in spatial multiplexing (SM) ultra-wideband (UWB) multiple input multiple output systems. The post-detection SNR expression is obtained using a QR factorization algorithm based on a sorted Gram-Schmidt process. The employed antenna selection criterion is to utilize the largest minimum post-detection SNR value. It is shown via simulations that the antenna selection significantly enhances the BER performance of the SQRD-based SM UWB systems on a log-normal multipath fading channel.

The authors have proposed Multi-Input Multi-Output (MIMO)-Constant Envelope Modulation, (MIMO-CEM), as a power and complexity efficient alternative to MIMO-OFDM, suitable for wireless backhaul networks in which relay nodes are fixed in their positions. One of the major problems hindering the real application of MIMO-CEM is to estimate MIMO channel characteristics. MIMO-CEM is based upon two contrary schemes; one is nonlinear equalization such as maximum likelihood sequence estimator, which needs accurate channel information to replicate the received signal passing through it. The other is a low resolution analog-to-digital converter (ADC), e.g., 1-bit in the default operation that removes the received signal amplitude fluctuation. In this paper, as a solution to the channel estimation problem in MIMO-CEM with low resolution ADC receiver, we propose an adaptive MIMO-CEM channel estimation scheme where iterative adaptive channel estimation is carried out to minimize the error between the received preamble signal and the replicated one. We also prove that Code Division Multiplexing (CDM) preamble transmission is effective in estimating MIMO channel parameters in the presence of large quantization noise. Computer simulation results show that MIMO-CEM with the proposed channel estimator using CDM preambles achieves identical BER performance to that with the ideal channel estimation even in presence of severe quantization noise caused by a low resolution ADC.

The conventional semi-orthogonal user pairing algorithm in uplink virtual MIMO systems can be used to improve the total system throughput but it usually fails to maintain good throughput performance for users experiencing relatively poor channel conditions. A novel user paring algorithm is presented in this paper to solve this fairness issue. Based on our analysis of the MMSE receiver, a new criterion called “inverse selection” is proposed for use in conjunction with the semi-orthogonal user selection. Simulation results show that the proposed algorithm can significantly improve the throughput of users with poor channel condition at only a small reduction of the overall throughput.

This letter considers a two-way relaying network where two nodes exchange their information based on the principle of physical layer network coding (PNC). We study the amplify-and-forward (AF) relay filter design with multiple-input multiple-output (MIMO) system. In order to maximize the sum-rate for information exchange, we propose a relay filter for two-way relaying network. Simulation results show that the proposed scheme performs better than the conventional schemes for two-way relay channel.

We propose a 2Nr MIMO ARQ scheme that uses multi-strata space-time codes composed of two layers. The phase and transmit power of each layer are assigned adaptively at each transmission round to mitigate the inter-layer interference and improve the block error rate by retransmission. Simulation results show that the proposed scheme achieves better performance than the conventional schemes in terms of the throughput and the block error rate.