In recent VLSIs, small-delay defects, which are hard to detect by traditional delay fault testing, can bring about serious issues such as short lifetime. To detect small-delay defects, on-chip delay measurement which measures the delay time of paths in the circuit under test (CUT) was proposed. However, this approach incurs high test cost because it uses scan design, which brings about long test application time due to scan shift operation. Our solution is a test application time reduction method for testing using the on-chip path delay measurement. The testing with on-chip path delay measurement does not require capture operations, unlike the conventional delay testing. Specifically, FFs keep the transition pattern of the test pattern pair sensitizing a path under measurement (PUM) (denoted as p) even after the measurement of p. The proposed method uses this characteristic. The proposed method reduces scan shift time and test data volume using test pattern merging. Evaluation results on ISCAS89 benchmark circuits indicate that the proposed method reduces the test application time by 6.89∼62.67% and test data volume by 46.39∼74.86%.

In recent years, the growing density and complexity of VLSIs have led to an increase in the numbers of test patterns and fault models. Test patterns used in VLSI testing are required to provide high quality and low cost. Don't care (X) identification techniques and X-filling techniques are methods to satisfy these requirements. However, conventional X-identification techniques are less effective for application-specific fields such as test compaction because the X-bits concentrate on particular primary inputs and pseudo primary inputs. In this paper, we propose a don't care identification method for test compaction. The experimental results for ITC'99 and ISCAS'89 benchmark circuits show that a given test set can be efficiently compacted by the proposed method.

At-speed scan testing is susceptible to yield loss risk due to power supply noise caused by excessive launch switching activity. This paper proposes a novel two-stage scheme, namely CTX (Clock-Gating-Based Test Relaxation and X-Filling), for reducing switching activity when a test stimulus is launched. Test relaxation and X-filling are conducted (1) to make as many FFs as possible inactive by disabling corresponding clock control signals of clock-gating circuitry in Stage-1 (Clock-Disabling), and (2) to equalize the input and output values in Stage-2 of as many remaining active FFs as possible (FF-Silencing). CTX effectively reduces launch switching activity and thus yield loss risk even when only a small number of don't care (X) bits are present (as in test compression) without any impact on test data volume, fault coverage, performance, or circuit design.

In this paper, a fault model for multiple-valued programmable logic arrays (MV-PLAs) is proposed and the equivalences of faults of MV-PLA's are discussed. In a supposed multiple-valued NOR/TSUM PLA model, it is shown that multiple-valued stuck-at faults, multiple-valued bridging faults, multiple-valued threshold shift faults and other some faults in a literal generator circuit are equivalent or subequivalent to a multiple crosspoint fault in the NOR plane or a multiple fault of weights in the TSUM plane. These results lead the fact that multiple-valued test vector set which indicates all multiple crosspoint fault and all multiple fault of weights also detects above equivalent or subequivalent faults in a MV-PLA.