As means to control interface reactions between HfO2 and Ge(100), chemical vapor deposition (CVD) of ultrathin Ta-rich oxide using Tri (tert-butoxy) (tert-butylimido) tantalum (Ta-TTT) on chemically-cleaned Ge(100) has been conducted prior to atomic-layer controlled CVD of HfO2 using tetrakis (ethylmethylamino) hafnium (TEMA-Hf) and O3. The XPS analysis of chemical bonding features of the samples after the post deposition N2 annealing at 300 confirms the formation of TaGexOy and the suppression of the interfacial GeO2 layer growth. The energy band structure of HfO2/TaGexOy/Ge was determined by the combination of the energy bandgaps of HfO2 and TaGexOy measured from energy loss signals of O 1s photoelectrons and from optical absorption spectra and the valence band offsets at each interface measured from valence band spectra. From the capacitance-voltage (C-V) curves of Pt-gate MIS capacitors with different HfO2 thicknesses, the thickness reduction of TaGexOy with a relative dielectric constant of 9 is a key to obtain an equivalent SiO2 thickness (EOT) below 0.7 nm.

We have fabricated Pt/Si-rich oxide (SiOx)/TiN stacked MIM diodes and studied an impact of the structural asymmetry on their resistive switching characteristics. XPS analyses show that a TiON interfacial layer was formed during the SiOx deposition on TiN by RF-sputtering in an Ar + O2 gas mixture. After the fabrication of Pt top electrodes on the SiOx layer, and followed by an electro-forming process, distinct bi-polar type resistive switching was confirmed. For the resistive switching from high to low resistance states so called SET process, there is no need to set the current compliance. Considering higher dielectric constant of TiON than SiOx, the interfacial TiON layer can contribute to regulate the current flow through the diode. The clockwise resistive switching, in which the reduction and oxidation (Red-Ox) reactions can occur near the TiN bottom electrode, shows lower RESET voltages and better switching endurance than the counter-clockwise switching where the Red-Ox reaction can take place near the top Pt electrode. The result implies a good repeatable nature of Red-Ox reactions at the interface between SiOx and TiON/TiN in consideration of relatively high diffusibility of oxygen atoms through Pt.

Identification of early aspects is the critical problem in aspect-oriented requirement engineering. But the representation of crosscutting concerns is various, which makes the identification difficult. To address the problem, this paper proposes the AspectQuery method based on goal model. We analyze four kinds of goal decomposition models, then summarize the main factors about identification of crosscutting concerns and conclude the identification rules based on a goal model. A goal is crosscutting concern when it satisfies one of the following conditions: i) the goal is contributed to realize one soft-goal; ii) parent goal of the goal is candidate crosscutting concern; iii) the goal has at least two parent goals. AspectQuery includes four steps: building the goal model, transforming the goal model, identifying the crosscutting concerns by identification rules, and composing the crosscutting concerns with the goals affected by them. We illustrate the AspectQuery method through a case study (a ticket booking management system). The results show the effectiveness of AspectQuery in identifying crosscutting concerns in the requirement phase.

We demonstrated the reduced surface roughness of poly (3-hexylthiophene) (P3HT):(6,6)-phenyl-C61-butyric acid methyl ester (PCBM) thin films with different ratios fabricated by the electrospray deposition (ESD) method. Aggregated structures were observed at the lower voltage, and the uniformity became bad at the higher voltage. Anyway, the minimum root mean square (RMS) roughness was 1.46 nm by optimizing the applied voltage.

We address the global asymptotic stability of FAST TCP, especially considering cross traffics, time-varying network feedback delay, and queuing delay dynamics at link. Exploiting the inherent dynamic property of FAST TCP, we construct two sequences that represent the lower and upper bound variations of the congestion window in time. By showing that the sequences converge to the equilibrium point of the congestion window, we establish that FAST TCP in itself is globally asymptotically stable without any specific conditions on the tuning parameter α or the update gain γ.

After brief introduction of our new microscope unit with an immersion objective and ionic liquid used as a refractive index matching medium, in this paper, we describe the studies on dipole orientation imaging of single molecules under high vacuum conditions as one of the important applications of our microscope.

In situ UV-vis. absorption spectra of cytochrome c adsorbed on ITO electrode was observed with slab optical waveguide spectroscopy combining pulse potential step (PPS) between 0.3 and -0.45 V vs. Ag/AgCl. The amount of cytochrome c adsorbed on ITO electrode was estimated from the amount of coulomb of the peaks in cyclic voltammogram to be about a monolayer coverage in this experimental condition. Spectral change between oxidized and reduced cytochrome c by PPS was finished in about 20 msec with phosphate buffer solution. The results strongly proved that SOWG spectroscopy should be effective for in situ observation of ET reaction kinetics of surface adsorbed molecules.

The three-bit balanced ternary quantum voltage generator was designed and tested. This voltage generator is based on zero-crossing Shapiro steps (ZCSSs) in asymmetric two-junction SQUID. ZCSSs were observed on the current-voltage curves, and maximum and minimum current of ZCSSs were almost same, respectively for the three bits. 27-step quantum voltages from -13Φ0f to +13 Φ0f were observed by combinations of inputs of bit1, bit2 and bit3.

The contradictions created by the differences in mass P2P data and transfer capability of wireless networks, and mismatch of overlay network topology and physical network topology are the main barriers hindering the implementation of P2P resource sharing in wireless multi-hop networks. This paper investigates the problem of enabling P2P resource sharing in WMNs with two-tier architecture. SpiralChord, the DHT approach implemented through routers in the upper tier, is proposed to address the major problems of wireless resource sharing – how to efficiently find resources currently available and reduce redundant messages as much as possible. SpiralChord uses an ID assignment technique to integrate location awareness with cross-layering. Location awareness aims at alleviating mismatch in physical network topology and overlay network topology, and it is designed to map neighboring routers to close-by IDs in the logical ring. Cross-layering aims at speeding up resource lookup operations in the application layer by exploiting the information that is available at the MAC layer, and it tends to be more effective when physically neighboring routers have faraway IDs in the logical ring. An ID assignment strategy based on spiral curve is proposed to meet the contradictory requirements of location awareness and cross-layering, mapping a peer's neighbors in the overlay network to peers which are its physical neighbors and distributing the remaining physical neighbors as widely as possible in the overlay network. In addition, a mobility management mechanism is proposed to address the adverse effect of the movements of clients in lower tier on resource sharing. A client is assigned a managing router to take the responsibility for the location of the client. Simulations show SpiralChord is more effective in reducing message overhead and increasing lookup performance than Chord, and mobility management for mobile clients performs well at reducing message overhead caused by mobile clients in SpiralChord.

The overall performance of multi-hop cognitive radio networks (MHCRNs) can be improved significantly by employing the diversity of orthogonal licensed channels in underlay fashion. However, the mutual interference between secondary links and primary links and the congestion due to the contention among traffic flows traversing the shared link become obstacles to this realizing technique. How to control congestion efficiently in coordination with power and spectrum allocation optimally in order to obtain a high end-to-end throughput is motivating cross-layer designs for MHCRNs. In this paper, by taking into account the problem of joint rate adaption, power control, and spectrum allocation (JRPS), we propose a new cross-layer optimization framework for MHCRNs using orthogonal frequency division multiple access (OFDMA). Specifically, the JRPS formulation is shown to be a mix-integer non-linear programming (MINLP) problem, which is NP-Hard in general. To solve the problem, we first develop a partially distributed algorithm, which is shown to converge to the global optimum within a reasonable time interval. We next propose a suboptimal solution which addresses the shortcomings of the first. Using numerical results, we finally demonstrate the efficiency of the proposed algorithms.

This paper presents a new simple method for reducing mutual coupling between dual-element microstrip antennas (MSAs) for bistatic radar using a wave absorber. The two elements are closely placed on a substrate by the distance of λ0/4 through the wall-shaped absorber. The height and width of the absorber were optimized for minimum mutual coupling with the electromagnetic simulator. It was found that less than -60 dB minimum mutual coupling can be achieved by the impedance matching of the absorber in a near field. The influence for the reflection characteristics from the absorber is small enough, and the reduction of the antenna gain is only 1.1 dB. The rate of the lost power characteristics showed that the absorption improves the mutual couplings. Then the proposed structure for a practical configuration was investigated. The measurement results of the optimized structure tallied well with the simulation results.

The Generalized cross-correlation (GCC) method is most commonly used for time delay estimation (TDE). However, the GCC method can result in false peak errors (FPEs) especially at a low signal to noise ratio (SNR). These FPEs significantly degrade TDE, since the estimation error, which is the difference between a true time delay and an estimated time delay, is larger than at least one sampling period. This paper introduces an algorithm that estimates two peaks for two cross-correlation functions using three types of signals such as a reference signal, a delayed signal, and a delayed signal with an additional time delay of half a sampling period. A peak selection algorithm is also proposed in order to identify which peak is closer to the true time delay using subsample TDE methods. This paper presents simulations that compare the algorithms' performance for varying amounts of noise and delay. The proposed algorithms can be seen to display better performance, in terms of the probability of the integer TDE errors, as well as the mean and standard deviation of absolute values of the time delay estimation errors.

To better understand antenna properties in a narrow space such as in a densely-packed device, a circular microstrip antenna in a narrow parallel-plate waveguide is theoretically studied. An analytical expression is derived for the input impedance in a parallel-plate waveguide by using the cavity model with surface admittance on the side wall. The surface admittance is defined by the external magnetic field due to the equivalent magnetic current at the aperture and takes into account the contribution of the parallel plates to the antenna. The magnetic field external to the antenna, that is in the parallel-plate region, is determined by using a dyadic Green's function. The input impedance is then calculated by a basic definition based on the conservation of the complex power. An analytical expression which couples the resonant frequency and the surface susceptance is also formulated. Presented expressions are validated by comparison with experimental results.

To clarify the characteristics of high-speed electrostatic discharge (ESD) events, we use two kinds of discharge electrodes: sphere- and cylinder-shape ones. We measure the energy level of ESD waveforms with charging voltages of 0.25, 0.5, and 1.0 kV. We find that the cylindrical electrode yields higher high-speed ESD energies, especially when the charging voltage is high; this indicates that the discharge gap shape is an important factor in ESD events.

Histopathology is a microscopic anatomical study of body tissues and widely used as a cancer diagnosing method. Generally, pathologists examine the structural deviation of cellular and sub-cellular components to diagnose the malignancy of body tissues. These judgments may often subjective to pathologists' skills and personal experiences. However, computational diagnosis tools may circumvent these limitations and improve the reliability of the diagnosis decisions. This paper proposes a prostate image classification method by extracting textural behavior using multifractal analysis. Fractal geometry is used to describe the complexity of self-similar structures as a non-integer exponent called fractal dimension. Natural complex structures (or images) are not self-similar, thus a single exponent (the fractal dimension) may not be adequate to describe the complexity of such structures. Multifractal analysis technique has been introduced to describe the complexity as a spectrum of fractal dimensions. Based on multifractal computation of digital imaging, we obtain two textural feature descriptors; i) local irregularity: α and ii) global regularity: f(α). We exploit these multifractal feature descriptors with a texton dictionary based classification model to discriminate cancer/non-cancer tissues of histopathology images of H&E stained prostate biopsy specimens. Moreover, we examine other three feature descriptors; Gabor filter bank, LM filter bank and Haralick features to benchmark the performance of the proposed method. Experiment results indicated that the performance of the proposed multifractal feature descriptor outperforms the other feature descriptors by achieving over 94% of correct classification accuracy.

In this paper, we analyze the existing results to derive the cross-correlation distributions of p-ary m-sequences and their decimated sequences for an odd prime p and various decimations d. Based on the previously known results, a methodology to obtain the distribution of their cross-correlation values is also formulated.

An equivalent network analysis for an arrangement that combines a microstrip line and coaxial conductor for the purpose of measuring permeability is discussed in this paper. The measurement circuit used consists of a coaxial conductor with a sample housed inside and a short microstrip line connected to both sides. The coaxial conductor is composed of an electrically grounded coaxial metal pipe with open ends and a center conductor. Equivalent networks for this arrangement are investigated to determine the complex permeability from the impedance of the measurement circuit. We have employed a π network composed of a resistor and an inductor connected in series, and shunt capacitors as the equivalent circuit for the measurement portion. It has been found that the measurement error ratio of less than a few percent can be obtained for most frequency ranges of 10 MHz to 500 MHz.

Recently, asymmetric zero-correlation zone (A-ZCZ) sequence sets that are composed of several sequence subsets have been proposed. In A-ZCZ sequence sets, the zero-cross-correlation zone (ZCCZ) length between different sequence subsets is larger than the zero-correlation zone (ZCZ) length in each sequence subset. However, the ZCCZ length between different sequence subsets was not precisely shown in previous studies. The present letter shows precisely the ZCCZ length between different sequence subsets. This information is useful for estimating the magnitude of inter-cell interference when designing approximately synchronized code-division multiple-access (AS-CDMA) systems.

This paper observes electrostatic discharge (ESD) events in terms of electromagnetic interference (EMI) assessments. To characterize the high frequency oscillations present in ESD waveforms, we use two kinds of discharge electrodes: copper and stainless steel spheres. Based on data gathered under charging voltages of 0.25, 0.5, and 1.0 kV, we examine the energy levels of ESD waveforms. As a result, we find that the high-frequency energy, which is related to the high frequency oscillations in the ESD waveform, was affected by the material of discharge electrodes and the fast movement of discharge electrodes.

In this paper, a capacitive-cross-coupling common-gate (CCC-CG) LNA using capacitive feedback is proposed to improve the noise figure (NF). In the conventional CCC-CG LNA, the transconductance gm is determined by the input-matching condition while a lager gm is required to improve NF. gm of the proposed LNA can be increased and NF can be improved by using the added capacitive feedback. The analytical calculation shows that the proposed LNA can perform better than the conventional CCC-CG LNA. In the measurement results using a 0.18-µm CMOS technology, the gain is 10.4–13.4 dB, NF is 2.7–2.9 dB at 0.8–1.8 GHz, and IIP3 is -7 dBm at 0.8 GHz. The power consumption is 6.5 mW with a 1.8-V supply.