Precise direct mounting of laser diode (LD) and photodiode (PD) chips on silica planar lightwave circuits (PLCs) has been investigated for application to transceiver modules. To achieve submicron optical alignment, self-aligned index marks on the PLCs and LDs were directly detected by transmission infrared light. The repeatability of the positioning was measured to be within 0.125 µm. The output power of the resultant module was 0.2 mW at 80 mA. A waveguide-type PD was also mounted in the same way, and module sensitivity of 0.25 A/W was demonstrated.

In this paper, a feasible optical code-division multiple-access (CDMA) technique is proposed for high-speed computer networks using prime codes and optical signal processing to guarantee real-time data communications. All-optical architectures for fastly tunable CDMA encoders and decoders are presented, which can be feasibly implemented in the optical domain by using electrooptic switches and optical delay lines. This can support an ultrahigh throughput and a very fast reconfiguration time. Furthermore, we present a self-synchronized sample technique to ensure the correct phase synchronization between optical clock stream and asynchronous electronic data at each electrooptic modulator of an optical CDMA transmitter.

This paper proposes Channel Reservation for Ahead Cells (CRAC)" scheme for street micro-cellular systems. The scheme enables mobiles to reserve the same channel over several cells at once. This paper analyzes both CRAC and FCA (Fixed Channel Assignment) in a ring-shaped service area where high speed mobiles and low speed mobiles move. In the analysis, the priority control which prioritizes hand-off calls and reservation calls over new calls over new calls is also taken into account. Obtained results include the blocking rate, the forced call termination rate, the average number of channel changings and the system utilization. From numerical results, CRAC is found to perform better than FCA with regard to the average number of channel changings and the forced call termination rate.

Video services such as video-on-demand are expected to be a motivation for deploying multimedia services in residential areas. These services should increase customer demand for video channels as customer demands become more sophisticated and diverse in the future. Therefore, it is important to determine how network configurations (i.e. network transition scenarios) should evolve in response to changes in access network demand. This paper proposes economical deployment of access networks based on transition scenarios. We conclude that transition scenarios offer more economical deployment than single-network configurations. Two transition scenarios, from passive double-star to fiber single-star, and from hybrid fiber-coax to fiber single-star, are evaluated as examples. These transition scenarios are economical even when customer demand changes. The transition starting time affects the present worth of annual charges (PWAC) of access networks more than the transition period does.

In this paper, we present an exact analysis and an efficient matrix-analytic procedure to numerically evaluate the performance of cellular mobile networks with hand-off. In high-capacity micro-cell cellular radio communication networks, a cell boundary crossed by moving users can generate many hand-off attempts. This paper considers such a priority scheme that some channels and buffers are reserved for hand-off calls to reduce the forced termination of calls in progress. Performance characteristics we obtained include blocking probability, channel utilization, average queue length and average waiting time for hand-off calls. Using the matrix-analytic solution for the stationary state probability distribution, we also derive the probability distribution of the waiting time of a hand-off call. Numerical results show how priority can be provided to hand-off calls according to the number of reserved channels and buffer size. They also clarify the effect of the hand-off priority scheme on the standard deviation of waiting time of a hand-off call.

Storage system in a multimedia server must satisfy two contradicting requirements: real-timeliness and large number of parallel user requests. Efficient algorithms for data placement, disk head scheduling, and request admission control schemes are needed to support the requirements. In this paper, we propose efficient schemes to maximize system resource utilization and service availability: cyclic placement scheme, subgroup retrieval scheme, and measurement-based request admission control scheme. Performance analysis through simulation revealed that the amount of system buffers required can be reduced by 70% approximately.

An analysis of an imperfectly power controlled DS/CDMA slotted cellular system over the frequency selective Rician fading channel with an error correction coding is performed. The user capacity and packet throughput of reverse link are estimated to show the sensitivity to the power control error in a DS/CDMA system with Rician fading channel. The power control error are modeled with Gaussian random variables, which is a reasonable choice for its proved validity. The relative capacity decrease from the power control error in Rician channel are presented and compared with the results from flat fading channel. Performance results for the model considering multicell interference, pathloss exponent and power ratio of scattered component to direct component are presented.

The Michelson-interferometer (MI) optical resonator has been applied, together with physical interests, to a low pressure and slow-flow type CO2 laser for specifying the system to a probe laser source. The fundamental characteristics online-selection, oscillation power and transverse mode are also investigated in comparison to the CO2 laser obtained for various resonators such as an open-ended reflective-multiple interferometer (RMI), an open-sided MI, a Fox-Smith interferometer and soon. Consequently, it is confirmedthat the MI type laser proposed can be one of the promising scheme, without losing oscillation power much and transverse mode quality as a probe laser towards lineshape (or laser) parameter analysis. Translating one of the MI mirror by a slight distance on the order of a micron meter along the gain axis, we can not only switch either a single rotational-vibrational line or combination of multiple lines, but also obtain different combination of lines by translating a large amount of the translation distance of the order of 100 µm. Moreover, elimination of one of the side-mirrors in the MI resonator enables us to switch the oscillation lines at the expense of some output power.

This paper is concerned with bandwidth reservation for circuit groups which handle calls requesting asymmetric forward and backward multi-connections. A model of circuit group with sub-group configuration is treated, and two types of the bandwidth reservation schemes for the model are studied in this paper. One is a global scheme with monitoring the whole circuit group, and the other is a local scheme with monitoring each sub-group independently. The problems of optimizing the reservation parameters are formulated, and optimization methods for the problems are proposed. Numerical example are presented, and effectiveness of the reservation schemes with using the optimized parameters is numerically examined.

We have investigated the gain and noise figure characteristics of a Nd-doped silica single-mode fiber amplifier (NDFA) at 1.06 µm which is applicable to various systems using a Nd: YAG laser light source at 1.06 µm, such as free-space laser communications, a fiber sensing system, and a lidar system. A fluorescence spectrum observation of the Nd-doped fibers with various co-dopants shows that the Nd-A1 co-doped fiber is suitable for realizing a high-gain amplifier for the 1.06-µm wavelength region. The pump wavelength tolerance at around 0.81 µm , the gain bandwidth and the sufficient value of the Nd concentration and length product for achieving maximum small signal gain are clarified. A noise figure of almost 3 dB and small signal gain of more than 30 dB are attained by 50-mW pump power. The unique four-level system characteristics, even in low pumppower conditions, provide low noise amplification in the NDFA. These gain and noise characteristics are well described by a simple theoretical model. We also demonstrated high-power operation of the NDFA with four pump LD modules adoptinga polarization-multiplexing technique. More than 100-mW signal output power is available for 1-mW signal input power at 200mW launched pump power. These features of the NDFA as a compact, polarization-independent, spatial-beam -distortion-free amplifier, will allow it to replace the solid sate laser in various applications using a Nd: YAG laser light source at 1.06µm.

Full-search block-matching motion estimation is a popular method to reduce temporal redundancies in video sequence. Due to its excessive computational load, parallel processing architectures are often required for real-time processing. One of the architectures is Hsieh's architecture based on systolic array processor and shift register arrays. Serial input characteristic of his scheme can reduce the number of pixel inputs to one, at the expense of significantly increasing the initialization time. This paper presents a modified and generalized Hsieh's architecture to reduce the initialization time. The proposed architecture can easily control data flows by rearranging shift register arrays and input-pin counts by using multiplexers on input stage, while retaining good properties of Hsieh's. The proposed architecture has the following advantages: (1) it allows controllable data inputs to save the pin counts, (2) it is flexible to the dimensional change of the search area via simple control, (3) it can operate in real time for video conference applications, and (4) it has simple and modular structure which is quite suitable for VLSI implementation. For verification of the proposed architecture, VHDL simulations are performed and some results are given.

The benefits of ATM techniques have been widely recognized and many organizations envisage the introduction of ATM techniques into their telecommunication networks. The ATM benefits can, however, be fully exploited only after effective network resource management techniques have been developed. This paper focuses on CBR-VP management techniques. The ATM transport network architecture and VP roles are summarized. Next, the issues of VP accommodation design are described. The point is how to create a design that accommodates cell loss and cell delay jitter, both of which depend on various network parameters and conditions. For this purpose, analytical procedures based on an M/D/1 queueing model are adopted. The approximation method is shown to be very effective in practical use through computer analysis. The method guarantees conservative QOSs. Finally, the proposed method is applied to several design examples to illustrate VP management issues. The proposed method will enable ATM techniques to be introduced to our telecommunication networks by the mid-1990's.

Rate-based congestion control is a promising scheme as data transfer service in ATM networks, and has been standardized in the ATM Forum. To migrate the existing upper layer protocols to ATM networks, however, further investigation is necessary. In particular, when ABR service class is applied to TCP (Transmission Control Protocol), duality of congestion control schemes in different protocol layers, i.e., conventional window-based congestion control in the Transport layer and ratebased congestion control in the ATM layer, may have a unexpected influence on performance. As an alternative approach for supporting TCP protocol, EPD (Early Packet Discard) has been recently proposed, which adds the function to the UBR (Unspecified Bit Rate) service. It does not have a "duality problem" since EPD only discards cells selectively to improve packet-level performance. In this paper, we exhibit performance of TCP protocol over ATM networks by using a simulation technique. We first compare rate-based control of ABR service and EPD applied to UBR service, and show that rate-control achieves better fairness and higher throughput in most circumstances. However, rate-based control requires careful tuning of control parameters to obtain its effectiveness and a duality problem leads to unexpected degradation of TCP-level performance. By the rate-based congestion control, temporal congestion at the switch is quickly relieved by the rate down of the source terminals. However, our simulation explores that if the parameter set of the rate-based congestion control is not appropriately used, the congestion is also recognized at TCP due to packet drops and TCP unnecessarily throttles its window size. To avoid this sort of the problem, we develop the appropriate parameter set suitable to TCP on ABR service, and point out that some modification of TCP may be necessary for further performance improvement.

Both available bit rate (ABR) service and unspecified bit rate (UBR) service with early packet discard (EPD) schemes have been considered for supporting data applications in ATM networks. Since transmission control protocol (TCP) is perhaps the most widely used transport layer protocol in existing data networks, the performance of TCP over ATM using ABR service and UBR service with EPD schemes is of great interest to ATM equipment vendors and service providers. In this paper, we present a simulation study of this interesting issue in a LAN environment using some benchmark network configurations proposed in the ATM Forum. Our simulation results show the following: (1) With UBR service and EPD schemes, TCP suffers significant performance degradation in terms of fairness and requires relatively large switch buffer even with a small number of active virtual connections over a LAN configuration, and (2) for the same set of network configurations and with ABR service using explicit rate feedback schemes, TCP achieves good performance in terms of fairness and link utilization, and requires relatively small switch buffer.

In this letter, we propose an adaptive multiuser receiver using a Hopfield network for code-division multiple-access communications and its performance is compared with that of the other types of multiuser receiver via computer simulation. The proposed adaptive receiver estimates both the signal amplitudes and spreading sequences for all the users using training data.

We propose burst based bandwidth reservation method called FRP (Fast Reservation Protocol) in ATM LAN with general topology, and evaluate its performance. In FRP, the bandwidth is allocated on each link on burst basis, not on call basis. This enables an effective use of network resources when it is applied to highly bursty traffic, which can be typically found in data communications. The problem of FRP is that VCs traversing the different number of links experience different blocking probabilities as can be found in the conventional circuit-switching networks. In this paper, we treat a fairness issue in FRP-based ATM local area networks. The Max-Min flow control is adopted as the fair bandwidth allocation method to accomplish the fairness in the throughput. However, the original Max-Min flow control works in a centralized fashion, which is not desirable in the FRP-based ATM LAN. We therefore propose a "semi"-distributed Max-Min flow control suitable to FRP, in which each switch maintains its own local information about bandwidth usage of the connected links. Through simulation experiments, we show that the proposed semi-distributed Max-Min flow control can achieve the fairness among VCs as the original Max-Min flow control when the propagation delays are not large and the number of VCs is not so much.

With increases in the speed of semiconductor devices and integrated circuits, the importance of internal testing with sufficient temporal resolution has been growing. This paper describes recently established electro-optic testing technologies based on pulse lasers and electro-optic crystal probes. Practicability, limitation and future issues are discussed.

A new transmit permission control scheme applicable in multi-cell communication systems is proposed. In this scheme, by prohibiting the transmissions from the users with relatively high propagation loss to their connecting hub stations, level of multiple access interference is decreased, and hence throughput characteristics are improved. Moreover, we continue our discussion to propose two adaptive forms of the transmit permission control scheme, in which the prohibition condition becomes more intelligent by considering the level of the offered traffic loads to hub stations. These methods are utilized in a slotted Aloha random transmission of the spread spectrum packets, and on the uplinks of a low earth orbit satellite communication system as an example of the multi-cell systems. It is shown that the adaptive schemes exhibits significantly improved characteristics at all offered traffic loads in these systems.

We have proposed a multiplexed fiber-optic sensor system using an optical loop with a frequency shifter. The measured output power spectrum of the system has shown that the multiprexed signals superimpose upon a noise pedestal which is like a series of hill peaks. In this paper, the output power spectrum is theoretically analyzed from the output intensity autocor-relation function. It displays that the noise pedestal originates from the laser phase-induced intensity noise. The noise level depends on the coherence time of the laser source. The positions of peaks are decided by the working frequency of the frequency shifter in the optical loop. The sensitivity of the system are related to the bandwidth B, the coherence time Tc, the sensor number n to be multiplexed, the loop loss α, and the fiber coupler parameters. Properly choosing these parameters is beneficial to improve the sensitivity of system.

This paper presents a method of employing a priority scheme in a random access environment. A prioritized nonblocked stack collision resolution algorithm with binary feedback is developed and tested using simulations. The algorithm accommodates an n-level priority scheme which makes it attractive in mobile data systems. The effectiveness of the algorithm is described on its ability to first, reject the lowest priority class when the system load is near or on the maximum value and second, minimize the delay spread of the higher class users. The performance of the algorithm is characterized using the throughput/delay and cumulative delay for each class of users.